My upper strut mounts have been failing after a year (about 12,000 miles, typical highway and local street driving, no off-road!). This seems to have started when I replaced shocks with Bilstein slightly stiffer variety. I also put a stabilizer bar on it at that time. Do you think the shocks are the fault? What else might I look for?
View 1 RepliesI have had the LF strut mount fail three times in the last three months. The strut has pushed through the upper mount. The guy a bought the car from said he had the struts replaced about a year ago. Could it be a bad strut?
View 1 RepliesI have purchased an UltraRacing strut bar for my hyundai accent 2005... The problem however is that my intake manifold sits higher than the throttle body and as a result of this i am unable to mount the bar... The bar has been made for an 03 accent but all points are identical, the only difference that i was able to see is that in the previous accent the throttle body was NOT plastic and sat FLUSH with the throttle body, whereas mine IS plastic and does NOT sit flush with the throttle body.
View 1 RepliesI am in the process of installing a 6" pro comp lift on my 04 supercrew 4x4. Things were going good until I got to the upper strut bolts. Trying to remove the 3 nuts, one came off on the passenger side. The other 2 just spin, the bolt and nut. Haven't tried the drivers side yet. The only idea I had was making a notch in the top with a dremel tool and small cutting wheel for a screwdriver but my dremel tool smoked..
View 5 RepliesI have a rear rattle that I cant figure out had the wheel off and levered and pounded on links bushings etc. How can I access the top strut mounts to check them? Nothing found on youtube. Original struts on rear show no leaks or broken spring. Bouncing car does nothing neither does grabbing the tire at 12 and 6 or 3 and 9 position.
View 3 RepliesI have to replace the torque strut mount in my 2008 Avalon XLS V6. I can't find the torque specs for the two bolts in my Haynes manual or at any online sites. Also, should I use either threadlocker or anti-seize on them?
View 1 RepliesWas tinkering on my car this morning, and at first noticed one side had a bigger gap than the other. Ok, I really need to change strut mount bushings, no big deal. Then I actually looked closer, and they both have some lean to them, but the drivers side is much more than the other one. Is this normal? I've never noticed any play in control arm bushings or anything. So what could be causing this? I would assume they are meant to sit flat but maybe not?
View 8 RepliesI hear a a series of "clunks" rather than "rattles" (not high pitched) when driving slow over bumpy roads. The noise is coming from the rear only. I think it is more evident in cold temperatures, but I'm not sure. I'll find out if it ever gets above freezing again in MN. Strut mounts? If so, DIY project?
View 6 RepliesIs this possible? I recently installed raceland ultimos and I get this weird muffled noise from the top of the rear suspension. Took it all apart, cut the bump stops shorter, and lubed the strut mounts. Sound went away for about 10 mins of driving, went for another drive and the sound was back. The next day the weather was warmer and the noise was gone. Should I just get new strut mounts?
View 6 RepliesI just installed my brand new coil overs. I went to drop the car from the jack and as it lowered I noticed my strut mount fully popped out of the strut mount housing. I can't even close my hood. Did I do something wrong?
View 1 RepliesI had my ST coilovers installed a while back. I love the ride, but a really annoying squeaking/groaning sound developed several weeks ago from the front strut mount area. The noise is heard at low speeds as I roll down the road (most likely high speeds, too) and sounds like its coming from both sides of the upper strut mount area. If you lift up/push down on the car, you can also hear the sound.
I purchased a set of 034 Density upper strut mounts from AMI Motorsports in hopes of eliminating the sound, but the sound got worse!! I still do not have a resolution. At this point, I'm thinking about putting the stock strut mounts back in, as the sound wasn't near as bad with the OE mounts in place.
I've lubricated the sway bar bushings and installed shorter end links (thinking the sound may be sway bar related), but the noise is still there. I even disconnected the end links all together - sound is still there. Could this be faulty coilovers? I tried to file a warranty claim through ST - they don't think their strut is faulty, and even if they did, I'm having a hard time with warranty coverage (long story). If it's the struts, then why did the sound get worse when the new 034 Density upper strut mounts were installed? Could it be faulty mounts?
At this point, I think it's either the mount or the strut, as I did not experience any issues prior to the coilovers.
Setup: WRD Street Advantage Coilover kit. Installed and sit at 24.75" all around. 034 Density mounts and new bearings. 19,xxx mi.
7 weeks ago I installed WRD Street Advantage coils. The install went great, no problems. Drove a week or so and decided to replace the strut mounts with 034's density strut mounts and new bearing to get rid of the creaking sound at low speed. Ordered them and put them on this weekend. After driving it I realized the creaking of the old weaker strut mount was gone. However, I inherited a rough clunking or knocking sound (as if something is loose and moving around), which seems to be coming from my passenger side. This happens at all speeds and not specific to turning the wheel. I unistalled/reinstalled everything in the front 4 times and went through everything with a fine tooth comb, but can't find anything loose. All bolts are torqued to spec.
I even removed the sway bar end links and drove it, still there. So it's not the end links. I also tried using the OEM endlinks which are longer than the ones from WRD to increase the space between the axle and the sway bar, possibly thinking it was hitting and causing the noise. No luck, still there. The only thing I noticed is that with the car on jack stands the strut mount is tight to the body but I still have slight play in the spring and it's perch. Is that normal? I'm assuming under load it's tight again. So the only variable in my situation is the new Density Mounts and bearing, can these cause heightened noises due to the increased heardness of the mounts?
I have a 1999 Chevy Silverado 1/2 ton 4 wheel drive truck. The upper rear shock mount bracket has rusted off.
View 2 RepliesI have a 1993 Toyota Celica GT I removed the strut tower to replace the upper tower mount and replaced the wheel bearing. my problem is that when i torque the axle nut tight the tire can be moved by pushing it up or down.
View 2 RepliesI have a set of ST coilovers, installed on my tiguan s4motion they ride great but have noticed clunk noise coming from tight strut and I'm pretty sure it's the pillow mount plate, is there anywhere to get replacements or a better plate? ST website doesn't have them separately...
View 1 RepliesI have a 1999 cadillac Deville that my mechanic says needs a new front strut mount. My symptoms are mostly in cold weather a very slight groan when parking the vehicle or turning into my driveway. It seems like it happens when the steering wheel is on its return back to center and it can be felt slightly in the wheel and heard as the sound a zip tie makes when pulled together with a slight groan. The car has been recently aligned and rides pretty good but sometimes can be a little noisy over bumps.
View 6 RepliesI have had the right rear strut replaced three times in the last year and a half. The second time I also bought a new set of tires. It drove much smoother after that, however, it still has the following problem. When I'm driving on even a slightly bumpy street, it sounds like the right side of the backseat is loose. It rattles and squeaks. I've had the backseat removed each time I've replaced the strut and nothing is wrong there. Recently, I had some body damage repaired to the rear bumper and told the guy about this problem. He took out the backseat and found that with it removed and while being driven, it still made the same squeaky, rattly, loose sound and that the strut is still leaking. I have been avoiding bumpy roads and speed bumps.
View 6 RepliesMy 2008 Santa Fe (3.3 2WD) produces a knocking sound from the front every time I go on a bump while the wheel is turned. I can pretty much reproduce it at will. Occasionally, I hear the same sort knock from the rear as well, but I cannot confirm that it is consistent.
I do suspect that something is wrong with the struts. The only issue is that the car has 67k KM (41k miles), and to me, that seems a little early for that sort of thing to happen. My driving is pretty standard on standard roads, although winters up here tend to produce potholes that I sometimes cannot avoid.
I've had my struts fail on my last car (2000 Mazda Protege), but that was 9+ years old and with almost 3 times as much mileage on it.
I got a call from the wife at work telling me the vehicle was making a loud noise when being driven. I told her it was a bit hard for me to diagnose since I was at work and to leave it parked till I got home. She really had to go out so she decided to drive it a short distance and come home.
I got home and discovered the drivers side spring was sitting on top of the inside of the front tire. The spring had done a superb machining job of the tire tread to the point I was amazed that the tire still held air. Anyway long story short the beast is in the shop having both front springs and struts,tires etc. being replaced. The spring actually broke.
I just bring this to the group as I did a search on google and this is not an uncommon, occurrence on these santys. We /she are just lucky this happened at a low rate of speed,as a highway speed incident like this would not have been pretty.
I purchased my 2004 XC90 2.5T today. it's got 150k miles.
1. there is a clunking sound coming from the driver strut, I'm thinking it is the bushing on top.
2. should i just replace the whole strut assembly? if so is there a diy? and a kit for this?
3. Rear window doesn't stay up, im thinking the sliders on the window are broken?
4. most importantly, whats the best iPod / iPhone hook up for the volvo.
5. also what mods for keeping it clean.
Attached File(s) : IMG_4763.jpg ( 1.44MB )
RE: 2007 Volvo XC90 90k miles
Pulled into my driveway last night with the power steering working intermittently for last 5 minute leg of my trip. Woke up this morning with no power steering and sqealing noise coming from engine.
No fluid leak on driveway. Drove to dealer with no power steering. Very hard to turn wheel - even while moving.
Dealer checked and said it was not a fluid issue and that they thought a screw might have fallen out and needed to take apart the rear of the engine (a 5-6 hour job) just to diagnose the problem.
A screw from the steering column in the rear engine?