My 1988 Volvo 240 DL a/t 200000 miles does not shift into overdrive (4th gear ). Is there a relay between the switch and the solenoid?. Is it okay to drive over 40mph.
View 1 RepliesAuto/transmission will not shift to overdrive. Is there a relay between the o/d switch and the solenoid? Is it alright to drive on the freeway?.1988 Volvo 240 DL.
View 1 RepliesI have a 1998 F150 with auto lock 4x4 and a automatic transmission. The problem I am having is after setting for about a week I drove it and 1st to second shift normally but when the RMP's/MPH hits time ti shift to third I get RMP increase and no third. I have shifted it manually 1 then 2 and into drive same result RMP's increase just like it is in neutral.
Miles on trans is about 120K have been serviced about 10K ago with no poor color or smell. Mechanic said transmission and filter looked good no metal or junk in oil. I drive down the road and it shifts from first into second then about 35-40 it hits what should be third but nothing free RPM's. I let it slow down to below 35-30 second kicks back in and away we go again until it's ready to shift into third.
I have been told possible speed sensor problem, possible other sensor problems looking for leads on where to look and what items to check. Just had Shop Mechanic drive it and he was baffled for everything looks good that he checked such as oil, and how it drove until it tries to shift into third. No over drive light flashing or anything and no engine codes showing at all everything clean in memory.
Why does the automatic transmission stay in 3rd gear and not shift into overdrive until it gets warmed up? It is so annoying. This is the only car that has ever done this. Even the camry I don't think does this. Especially the fact that the rpms stay above 1k rpm until the engine is warmed up.
View 7 RepliesI have a 4r100 on in a 99 7.3 4x4. The shifting problem I have appears to be intermittant. it seems loose after warm up especially at the 4th shift overdrive and passing gear. possibly due to low presures ? sometimes (lately more often than not) hunts back and forth between 4th and o.d when passing or hill climbing. Under normal driving it shifts somewhat firm with 4th being an exeption.I have changed my crank position sensor filters and fluids which had turned dark and improved slightly. When I pulled the pan and replaced the filter the pan was spotless. No residue or signs of plates or debris. There is about 100,000 miles on the tranny and 350,000 on the truck. Questions: Is there a tcm for this transmission and if so could it cause these problems? I'm considering a purchase of an unlocked 1705 superchip to change the shifting but unsure if this will work for my issues...
View 14 RepliesVolvo Automatic 1992 240 - So, just started to back out of the garage and, all of a sudden, my gear shift got stuck in neutral and then started shifting without engaging the transmission at all. Pushed it back into the space and, taking a look underneath, I realize the control rod's completely detached from the lever in the transmission.
I can re-attach it, but it just comes loose again when I shift. It seems like something should be in there to hold the control rod in place with the transmission lever, but I don't know what because I can't seem to find any documentation on what everything should look like down there.
Attaching a couple shots, one with a circle around the area that's coming un-attached since the angle's a bit off.
Attached File(s)
IMG_8972.jpg ( 1.09MB )
IMG_8978.jpg ( 938.64K )
I am considering buying a 98 Passat, it has 140k kms (80,000 miles) on it. It is in mint condition, but the transmission, will not shift past 2nd gear, whether in Auto mode, or manual shifting? (5 speed tiptronic).
The current owner took it to a mechanic, he tested it, replace a sensor in the tranny, but the problem is still there, and the engine light is still on. Is it possible that the computer just needs to be reset with a proper Vag-com?
Recently I had a stuttering and squealing from a belt. I was able to shift into all gears with no problems. Before I could get it looked at, the squealing stopped and I was unable to go faster than 30 mph. The belt and pulley were replaced, but the car now will not shift out of 2nd gear. Transmission fluid is good, and has not been leaking. Does this indicate that I will need a new transmission? Or is there possibly a less expensive possibility? I've heard that some vehicles have what's called "limp mode". Also, is it safe to drive at 30-35 mph., and what damage might I do by driving it?
View 4 RepliesIt's a 1988 with a 3.0 engine and an automatic transmission. It doesn't want to shift. I can make it shift manually, but if I leave it in OD, it wants to stay in 1st gear . If you fiddle with the accelerator, you can get it to shift. Then it wants to stay in 2nd, and so on.
Like I said, if I use the gear selector to manually shift, it will go to all four gears just fine.
My thoughts are a vacuum leak (a big one) or a faulty vacuum modulator at the transmission. No, the vacuum line to it doesn't have tranny fluid in it, but I replaced it, and I wonder if it's bad. Yes, I made sure to put the little metal pin/link back in it.
Got a call from my little sister about two weeks ago that her Ford Explorer would not drive forward. Checked it out and put it into second to get it home.Last weekend me and my dad changed the filter and fluid and then drove it for a bit. It sounded a little better but still would go into drive or reverse. We shifted into second which we knew worked and then back into reverse immediately and now reverse worked, although sluggish. The same was true for drive. A few days later dad changed a solenoid and now it will go into drive and go up to 15mph, but will not shift from first to overdrive first. And still no reverse right away. She is able to get to school with second gear and pop into drive when she gets up to 40-45mph. If she has to backup from start, first she has to put it into second and then back to reverse. Something in overdrive doesn't seem to be doing its job right.
View 3 RepliesI have an issue, and I think the answer is to drain and fill the transmission fluid a few times. I have an automatic 2010 S with 87,000 miles. I did a drain and fill on the transmission fluid about 15,000 miles ago - just a single drain and fill.
Here's the issue. Normal driving down the road, everything feels and shifts great. However, if I'm rolling along and then floor it wide open, usually the car will shift straight from overdrive to second gear. If the car downshifts only one gear, like from OD to 3, or 3 to 2, it's nice and smooth. However, in the situations described above, if I really nail the throttle, I get a hesitation and a very rough shift almost every time from OD to 2. That said, if I'm going down the highway and know I'm going to need second gear to pass someone and I shift it into second manually while accelerating, it's smooth with no issues.
I looked at the fluid the other day. It's a little over filled on the dipstick and it's a dark red. Not brown, but it's definitely overdue for some TLC. I'm just wondering if the symptoms are classic for two or three back-to-back fluid changes or if this is a sign of a larger issue.
I have an '05 V10 with 74,000 miles. The overdrive button on the gear shift does not work and it keeps me in trailering mode. If I put it in park and jostle the shifter and steering wheel, sometimes it works. Also, the back-up sensors no longer work.
View 5 RepliesMy 2002 Explorer LTD with 155K miles on it is in terrific shape except for a worsening rough shift into overdrive (automatic transmission) and a clunk which occurs with increasing frequency when I shift into reverse. I would love to keep the car but don't want to spend the money for a new or rebuilt transmission. There is no access for owner approach to transmission fluid - I have already looked in the manual. I would need to take the truck to a garage as I cannot do repairs myself.
View 2 RepliesMy 95 ford Aerostar 3.0 automatic trans wont shift into overdrive, here's what happened. a small hose on the side of the transmission came off, this must have popped off when I was stepping on the gas with the brake on in drive and reverse. It took 2 months to find the hose off, during those 2 months I had to shift the van manually, you had to get high RPMS before it would shift.
About 2 weeks before I found the problem I notice the van would not kick into overdrive. When I finally found the issue and reconnected the hose the trans shifted fine but still would not kick into overdrive though. Is there another vacuum hose that goes to the main vacuum housing? or an adjustment on the linkage area? This has been like this for about 6 months now and I can go on a highway..
I have a 1998 C class RV that the downshift from overdrive is sloppy and slow when the button is pressed to release the OD or to put it back into overdrive mode. It seems to pause and then kick in or out of OD. Is this a common problem with E4OD transmission? What will fix it, fluid change? Solenoid replacement?
View 5 RepliesI have a 98 f150 4.6 v8. when i start driving and i hit about 40 my truck doesn't want to shift, i have to take my foot off the gas, let it shift then apply the gas again. if i don't it shifts real hard or the RPM's go real high. and then every so often my overdrive off light blinks. it shifts in and out of overdrive ok though.
View 2 Replies1999 5.4 ... I was just driving down road and truck suddenly wouldnt shift into overdrive/higher gear. pulled to side of road and the motor was revving very high at 2500 rpm. shut truck off and on a few times...kept doing it until finally after a while it went back to normal....
View 1 RepliesI have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
1995 Mercury Sable GS3 liter. The check engine light is on. More importantly, when I put the car into drive or overdrive, the transmission stays in 3rd gear, and will not shift up or down. When I put the car into first or reverse, they work normally.
View 2 RepliesI have an '01 F350 super duty dually, 7.3L, auto trans. Over the past weeks my overdrive light on the gearshift would flash intermittently, maybe once every couple weeks. I chalked it up to a prior theft attempt where the steering column was damaged, and had turn signal/hazards issues after that.
Over the past few days my reverse gear has taken longer to engage, and is hard getting into the higher gears at speed. As of yesterday, reverse is out and won't shift out of second. Fluid level is good and clear. Could this be a PCM issue, or some sensor or relay?
I have an automatic 1992 940 GL and it has been almost a year since the head gasket blew in the car. The gaskets and everything have been replaced as well as the fuel filter, transmission pulley, and timing belt. The car seems to run fine except for a small problem with the gears. When driving it's like it doesn't want to shift into the next gear unless you let off the gas a little bit which then it shifts over fine and it does this for all for gears. It has also recently started back to stalling out at a stop light or stop sign but very rarely.
View 1 Replies