I have a 1997 vw cabrio. I'm having problems with my signal lights. They start blinking super fast or not at all. When they do work if I hit the brake they stop working until I release the brake.
View 6 RepliesWhile I know this has been covered before, I could not find anything pertinent to 2011-2015 model years.
So, I changed my turn signals to LEDs, and now I have the fast-blink behavior. I realize this is because of the significantly decreased amperage and resistance of the LED modules. I did a similar mod on my 2007, and simply found a replacement low-current blinker relay (on eBay, I think), and replaced it (it was physically located behind the extra small glove box near the middle of the dash.
My questions are, 1) for a 2015, should I use the same method of replacing the blinker relay? 2) Any brand and model that will work for this application and/or where one can be purchased and 3) Where is that relay located on the 2015 model? If not, should resistors be used?
Brake lights do not work on my 1997 vw cabrio fuse lights and break switch are good.....
View 13 RepliesMy friend is willing to lend me her Cabrio that she had let sit for about a year. I replaced the battery and tried to start it. The alarm went off (we lost the key-remote thingy) and it did not start. The lights all worked but once we tried to turn it over it just went Click-click. The alarm shut off once we disconnected the battery.
View 8 Replies2006 F250 Diesel 125000. Got truck back from dealer pulling out noticed blinkers blinking fast. Figure classic burnt bulb. But upon further inspection no tail lights when headlights on. Ooh and a driver side mirror with blinker that has a crack over the lower light which is side the marker/running light, the light does work. After I Google the issue and see that the MFS is a big culprit I replaced it and have same issue. What I do have working and when:
Brake lights work when headlights off - no key in ignition
Brake lights work when headlights on with blinker on - no key in ignition
Brake lights do not work with headlights on - koeo, koer
Blinkers (rear) when selected both blink
Ignition switch?
This is in reply to a question I just heard on the radio show from Stash (sp?) I believe. He has a jetta and the there is a fast clicking coming from the turn signal after it is used and returns to the "neutral" position. I have a GTI of similar vintage and replacing the blinker did not work. What does work is even cheaper! Get some CRC electronics cleaner from the local auto store and spray out inside of the turn signal switch. What happens is, over the years the lube inside of the switch wears away, allowing the contacts to wear against each other, creating little metal debris that ends up completing the circuit. The CRC cleaner dissolves all of the gunk and gives the necessary clearance inside the switch to allow it to function properly.
View 1 RepliesMy 2002 Volkswagen Cabrio won't start when it is hot, only when it is cold. Several times in the last few months, similar experiences such as the following has occurred. Yesterday, I drove approximately 15 miles, ran into a store for about 10 minutes and went back to the car and it started. Then drove about 10 miles and shopped for groceries for about 45 minutes, returned to car and it started. Drove about 10 more miles and went into a store for about 30 minutes...car wouldn't start. The engine does turn over. As the temperature gauge descends each line, I try to start the car and it will not start again until the gauge is completely at the cold line. My husband has replaced the battery, both temperature sensors, changed the fuel filter, changed the ignition coil and the starter in March.
One other time it gives me problems which is different than the above scenario is I have driven the car just one or two miles and had it off for only two minutes to five or ten minutes and could not start it for an hour or so.
An OBD scanner at an auto parts store gives several code readings, some of which say it is the fuel pump primary circuit, cylinder 1,2,3 & 4 injector circuit low, secondary air injection system relay A control circuit, evaporator emission system purge control valve circuit is shorted and, finally, evaporator emission system leak detection pump control circuit low. I have had readings done before by an OBD scanner and the problem didn't have anything to do with what the scanner said so I don't have much trust in those readings.
I've been having an electrical issue for the past few months that I've decided to address now that the weather is getting a little warmer.
What happened is the left turn signal was blinking fast, so I assumed bad bulb, and later that day it stopped blinking fast and now I press the lever down to indicate a left turn and there is a quite loud buzzing sound. Sounds like it's coming from where the relays are, but I've replaced them and the bulbs and still nothing has changed.
I've also replaced the multifunction switch to see if that was an issue, but a new one did the same thing so I returned it.
Running lights work all around, but now there are no left blinkers, and also my left brake light doesn't come on. Pulling a trailer I have the same problem, I had the plug tested and only 3 of the pins have anything to them.
I know nothing about auto electrical systems.
1998 F150 ....Left signal lights flash supper fast or not at all but if I pull the arm down (for left side again) but stop before it clicks in place, signal lights work normal. 4 ways work good; right side works good 95% of the time; all bulbs are good. So like Spotty suggested it's the signal arm switch? Does that sound right? Many years ago I changed it twice in my old Ford Taurus; twice because I was buying used from a wrecker.
View 6 Replies2000 VW cabrio, and the car alarm has been going off and why? It has gone off in empty parking lots, and much to my neighbors annoyance, several times in the middle of the night. Other than unplugging the battery when I get home what can i do about my alarm?
View 2 RepliesMy 88 VW Cabriolet convertible has been having car problems since I got it, 1st the Clutch went out. Then we had the hoses in the engine fixed and a new Alternator. After that 5th and 3rd gear would pop out of it's gear, and that was fine because I could hold it in gear, but now the car can't move, you can turn on the car but you can't get it to move in any direction, the gears make sounds, as if they are moving but the car doesn't move.
View 3 Replies2002 VW Cabrio @80K miles no major repairs 1 1/2 years ago the car died while in motion - as if the ignition switch was turned off. While "dead in the water" I tried several things, cleaning battery cables (although horn & lights were strong), letting it cool, & jumper cables to no avail. It was towed to a local garage (who have been pretty good in the past) & the starter was replaced (they were puzzeled too, but that worked!!??). Fine for many months. Then another cutoff while in motion (30-40 mph). This time it started about 15 minutes later on its own. I drove it home & turned it off. When I went to move it into the garage it wouldn't start. After pushing it into the garage once again, cables were checked, the battery charged (again horn & lights were strong, but what the heck), checked all fuses, & looked for anything possibly suspicious. No luck.
In desperation I replaced the starter again (I know, it was probably just superstition at this point) & while at it cleaned every wiring connection I could find under the hood. It worked. The car started and ran fine, but I took it back to the original shop to see if they could find anything else - to avoid mid roadway flame outs! Understandably they were skeptical of finding the problem while it was still working. They ran it, drove, checked it, for several days & it did just fine. When I went to retrieve it wouldn't start!! Now they had it while in cardiac arrest, but before anything was diagnosed it came back to life on its own. It has been running fine for many months more.
It did it again today!! This time the 15 minute wait worked & it is back in our garage and as you can imagine my wife is not crazy about driving it again. Just some side notes: - When dead, all of the electrical system is out EXCEPT the ignition circuit - not even a click from the solinoid. - Previous to these "attacks" my wife has noticed some odd electrical occurences a day or two before, but not enough to disable the car. (dash lights flickering, acceleration stumble on takeoff, the radio going to safe mode when the power was never disconnected) - The only vague possible electrical anomoly is the installation of a Sirius radio receiver under the dash to the cigarette lighter. I haven't clue at this point.
When I fill my 2002 VW cabrio, the fuel nozzle keeps clicking off. I took it to the service department at the dealership and the service manager told me that there is no vent tube to clean out, no carbon filter and the sensor for the ORVR is at the inside bottom of the tank and the only POSSIBLE solution would be to replace the gas tank. This doesn't feel right given the other discussions on this board. Could the dealership be misleading me?
View 10 RepliesMy truck is a 1999 F-250 Super Duty 7.3 diesel. My left turn signal is fine. My right turn signal is going fast. The rear blinker lights up, but the front does not. So... no brainer... change the front bulb. I did. Twice. Sylvania 3157. It did not fix the problem...
View 11 Repliesfrom time to time when applying breaks there is a feeling and noise like I have hit an ice patch - pump breaks twice and all is well - Breaks are 1 year old / break fluid is full ?
View 8 RepliesSo my right blinker is blinking really fast, after working fine for about a week. Nothing changed. I checked all bulbs and they're working fine. I repeat: ALL BULBS ARE GOOD. Truck has a service body on it with LED brake lights. Thought maybe the LED lights didn't have enough draw for the system to detect a good bulb, but left side works fine. Swapped bulbs from left side to right, still right side blinks fast. I even removed left rear brake light and it still flashes normally.. So not sure what's going on. Light control module??
View 4 RepliesI have a 1998 Volkswagen Cabrio GLS 4Cyl2.0L. the wheel that raises and lowers the back of the seat has come out. The small plastic interior part appears to have snapped. Is there a way to order a replacement part and replace this myself?
View 4 Repliesmy 02 VW Cabrio has the nasty habit of the cruise control disconnecting at random. A tech supposedly diagnosed a faulty Cruise Control Module. Now the diagnostic is the vacuum pump. He did a throttle body alignment, the steering column switches check out, brake light circuit checks out, vacuum hoses all good, electrical connectors all tight and sealed with goop... so what could the problem be? It seems to work when cold and at lower speeds, but after warming up and doing freeway speeds, it's dead in the water and won't reset...
View 7 RepliesI have a 2002 VW Cabrio (convertible) and the back window is beginning to peel away from the canvas roof. We called a mechanic who says the entire roof needs replacing. This seems crazy as the the window just appears to be glued to the canvas.
View 3 RepliesMy '98 Cabrio recently had the headlights both go out while driving at night on a curvy state highway. I pulled onto a side street and tried to figure out a way to be able to continue my drive home safely with lights. I found that by turning the ignition key to the right and jiggling the key I could get it to temporarily stay in a position to allow my lights to remain on.
In time, that solution was no longer an option and I discovered that by pulling the brights lever (it should be noted that it usually clicks into place) and holding it towards me, the lights would work, albeit on bright mode which tends to irritate fellow motorists. Strangely, the heater fan and wipers would only work while in this new found method of illuminated driving by releasing the brights switch and pulling it a second time towards me (remember, it doesn't lock into place as it should). How to repair this problem? It defies all logic as to why things on this car work or don't work.
My Jetta has had an off-and-on clicky turn signal sound without turn signals or hazard lights actually blinking. I put up with it for a while, but recently it's been more clicky than not. I'm aware this is a common problem. I had already tried the cleaner spray "trick" which made the problem worse if anything. Today, I removed my signal stalk as described here and gave it a cleaning. After re-assembling, the clicky problem didn't go away, and now the high beams are always on (even with the key out of the ignition, and the car isn't running). I temporarily dealt with this by pulling fuses 18 and 19 for high beams. It's an ok short-term workaround. Low beams still work fine.
I'm considering replacing the hazard signal relay, but a while ago I messed up while trying to use ghetto removal keys to pull my radio.