Vacuum Diagram For A 2000 Blazer?
Sep 20, 2013
Looking for vacuum diagram for a 2000 blazer 4.3 need to trace a leak?
View 2 Replies
Sep 20, 2013
Advertisement
Ford Ranger / B-Series :: Vacuum Hose Diagram?
Where I might be able to find a vacuum hose routing diagram for a 2.9? I have searched high and low but with no luck.
View 14 RepliesChevrolet - Blazer - Transmissions :: Replacing Vacuum Actuator (switch) For 4WD Automatic Trans
What is the easiest (DIY) way to replace the Vacuum Actuator (switch?) in a 1995 Chev Blazer with an Automatic Transmission, 4WD?
View 2 RepliesFord A/C :: 2000 XLT V8 - Heater Hose Diagram
2000 Ford Expedition, XLT, 4WD, V8, 5.4 Liter. Had heater core bypassed, changed, am re-assembling, but need diagram for where all hoses connect on block, etc.
View 1 RepliesChevrolet - Blazer :: 2000 4wd Won't Engage
Our 2000 blazer LT 4.3L 4 door 4wd has 190,000 km (about 115,000 miles). 3 Button dash control. Transmission was rebuilt at 100,000 miles (main troque converter spline was shot). The 4 wd will not engage in either hi or lo.
Whether moving or not, press 4 wd lo, light stays on. but nothing happens. I cannot hear the transfer case engaging.
Had a previous problem, (withflashing light): found the vacuum hose under battery case was worn through.
I do have a service engine light on the dash. This may be unrelated, because 4wd stopped working long before service engine light came on. I have changed the Oxygen sensor, but no reset the fault yet. Where to start.
Ford F-150 - 1997-2003 :: 2000 - ECM Pinout Diagram?
Looking for a diagram for the ecm pinouts for a 2000 5.4 4x4 f150? Im mostly trying to find the TCC for the tranny.
View 1 RepliesFord Excursion :: 2000 - Diagram Of The Steering Column?
Looking for a diagram of the steering column? I am looking to see what is behind the ign tumbler that sends power to the ign switch module. I believe a problem might be there . this is for a 2000 x limited 7.3.
View 1 RepliesS-10 :: 2000 Chevy Blazer - No Air Conditioning Just Keeps Blowing Out Hot Air
Okay I am having a problem with my A/C in my Blazer I've had my compressor replaced finally got all of my leaks fixed and replaced all the visible vacuum hoses and still without by passing my heater core I have no Air Conditioning. It just keeps blowing out hot air. Why my Air Conditioner is working. I really like my blazer but after having invested a little over 600.00 into just getting the A/C up and going with no luck is just getting frustrating. I am considering selling it and getting a truck. I would like to keep it if I can get the A/C up and going but I don't want to have to invest a whole lot more money into it.
View 1 RepliesChevrolet - Blazer :: 2000 - Transmission Is Slipping
My daughter drives my old 2000 Chevy Blazer with a reconditioned transmission I paid for in Aug 2010. The new (rebuilt) transmission is now slipping. Could this be as simple as a fuse (electrical signal issue) or not having enough transmission fluid?
View 7 RepliesChevrolet - Blazer :: 2000 - Cylinder 4 And 6 Misfiring?
I have a 2000 Chevy blazer 4.3L 4 wheel drive. 4 of the 6 cylinders are misfiring and the car has completely lost power. Before this issue occurred it was running fine and the next morning when I went to start it the car was turning over and wouldn't start. My dad and uncle believe it's a distributor or computer issue but I would like other opinions about this issue.....
View 3 RepliesFord F-150 - 1997-2003 :: 2000 - Key Less Entry Wiring Diagram?
I am trying to add a keyless entry to the already equip, power door locks but am having problems figuring the wiring schematic
View 8 RepliesFord Excursion :: 2000 V10 - Fuel Pump Wiring Diagram
Looking for a link to the fuel pump wiring for a 2000 V10 Ex? I'm trying to pinpoint my no start issue and want to make sure I don't miss anything. I think it goes from 20 amp fuse under hood to inertia switch to relay under hood to pump? 20 amp fuse has power but at the inertia switch I have no voltage, just approx 35 ohms resistance to ground on both outside wires. Does the inertia switch close a ground or should it have voltage?
View 10 RepliesChevrolet - Blazer :: 2000 - Alarm Going Off / Unable To Shut Off With The Key Fob
2000 Blazer LT 4wd, 118000 miles
During a severe thunder storm the factory alarm went off. I was unable to shut off the alarm with the key fob. The power door locks did not work either with the door switch or the key fob. I disconnected the battery and let it sit for 30 minutes.
After I reconnected the battery the door locks worked using the key fob or door switch. I took it for a drive with no further problems. About 10 minutes later the alarm went off again. I could hear the door lock solenoids attempting to lock/unlock the doors and there was a clicking under the dash. I disconnected the battery again, after the battery was reconnected the power door locks were still not working. The truck starts up and runs normal, everything seems to work except for the door lock?
I checked the PW fuse, it was fine. The battery is fully charged at 12.6V. I've disconnected the battery and will have another look at it tomorrow. There was nothing useful in the Owner's Manual and the resync procedure did not work.
Update: Before driving to work this morning, I cleaned the positive and negative terminals. The locks worked and the truck ran normally during the 30 min drive to work. After reading the Owner's manual closely, I discovered the Theft Deterrent System can be disarmed by locking the car with the doors closed. The system is armed by locking the doors with a door open, i.e. pressing the lock switch when exiting the vehicle.
No further problems with the alarm or the door locks whether the Theft Deterrent System is armed or disarmed. Hopefully leaving the battery disconnected overnight was the fix.
Chevrolet - Blazer :: 2000 Cutting Out And Completely Died
I have a 2000 Chevy Blazer with about 180,000 miles on it. It has been running fine, then a few weeks ago we got gas at a small little station we had never been to. The day after it started cutting out. We took it to the shop and they put a new catalytic converter on it. They said it also needed a new water pump and something with oil seals, so we went ahead and did that. It drove fine for a while, then the next time we filled up with gas it started cutting out and completely died. They put a new fuel filter, spark plugs and wires and distributor cap, basically gave it a good tune up. It's been driving fine. We filled it up and with in a few miles it start stuttering. At the stop light it rattled but kept going. drove it another 3 miles and it stuttered again. We are out of money and at our wits end!
View 4 RepliesChevrolet - Blazer :: 2000 - Faded Plastic Grill?
I have a 2000 Chevy Blazer and the front grill is faded and yellow. I drove to a reputable body shop and the guy there told me that this type of plastic cannot be sanded or painted because will only fade again. He told me my only option was to buy a new or aftermarket grill which ranges from $360 to $450. Is there anything I can apply to the grill that will return it to its original black finish?
View 13 RepliesChevrolet - Blazer :: 2000 - Cruise Control Not Working
The cruise control on my 2000 Blazer LS 4X4 is not working. I just changed the multi-function switch and still nothing. I looked at the throttle cables and they seem to be fine. All the fuses are good as well.
View 4 RepliesChevrolet - Blazer :: 2000 - Volt Gauge Fluctuating
I recently had some issues getting my 2000 Blazer LS started. It would act as though the battery was dying. But if I let it set a few moments, it would start right up. Then a couple days later, I needed a jump start to get it going. I took it to my local Auto Zone to have the alternator tested because the battery was only 3 years old. (It was a 5 year battery.)
They determined that it was the battery. So I went to Walmart and bought a 700 CCA battery. And today the gauge is fluctuating again.... Considering it is cold and snowing here, heat, wipers, and rear defrost tend to be essential. But if I try to run all of them, the gauge dumps. And causes everything to bog down. I do not have any aftermarket electronics installed in the truck. And until last Thursday, this was not an issue.
Chevrolet - Blazer - Transmissions :: 2000 - Won't Start In 1st Gear?
2000 Chevy Blazer 4.3 (automatic) - When I bought it used, it shifted fine, has no issues other than the transfer case wouldn't engage every time. A few months later my overhead console display lights went out, then all the dash lights such as engine, 4x4, the gauges started lighting up and acting weird randomly, then a week later the truck started shifting funny.
Now 90% of the time, the truck won't start in 1st gear, it starts in 2nd, then while accelerating up to 30-35mph it will shift up way too soon and bog down, then shit back down to 2nd, then shift up again, and continue until it hits 30-35, then it fails to shift into overdrive. Also when coming to a stop, it kicks down a gear (into 2nd I assume) pretty hard and clanks pretty loud around 2mph just before a complete stop.
Weird thing is every once in awhile, it will go away and shift normal but the engine light is usually lit up during normal shifting.Could it be the ECM causing all these weird things?
Ford F-150 - 1997-2003 :: 2000 - Brake Controller Wiring Diagram?
I just bought a 2000 Excursion limited v10 4x4. I'm going camping this weekend so trying to install my brake controller. I found the plug but noticed these wires dangling. I can't see the back of the harness. I'm afraid the PO may have cut them to install a universal harness. How to recognize them? I don't want to buy a ford specific harness if the wiring has been cut.
View 3 RepliesFord Super Duty (1999-2016) :: 2000 V10 - Right Belts Diagram?
Having a problem finding the right belt diagrams for a 2000 F53 stripped chassis in a motor home and the dealer has been no assistance even after spending a bunch on parts...
View 4 RepliesChevrolet - Blazer :: 2000 - Knocking Noise For 15 To 20 Seconds After Start Up
2000 Blazer 4wd, automatic, 122000 miles
In the last couple of weeks, if the Blazer isn't driven for 3 or more days, there is a slight knocking noise for 15 to 20 seconds after start up. Oil level and pressure are fine. I'm guessing it's the lifters.....