I was told that fixing the reverse gear can be done without dropping the transmission. Is there anywhere I can see a video of this? My shifter locked up out of nowhere and when I got it back loose it started clicking in reverse only when I back up.
View 1 RepliesAfter my car has sit for a couple of days, it doesn't like to start. By, " doesn't like to start", I mean it doesn't even click when the key is turned. I put a new battery in it but that didn't work. If I get it to start it seems to always start after coming out of a store (knock on wood). This only seems to be a problem after it has sit for a while.
View 9 RepliesI drive a 2001 Toyota Tacoma 5 Speed manual and as recently as last Friday it seems to have developed a problem with third gear. Occasionally the gearshift will actually pop out of third gear back into neutral. It has happened randomly, but also it has happened at least once when I hit a rather large bump, it seemed to have literally knocked it loose from third gear. On one occasion I tested to see if I could pull it out of third gear without stepping on the clutch, and it worked once, but I have tried it again and it doesn't always let me.
To counter this problem I have been just pushing on the stick all the while in third gear to prevent it from popping out and that seems to work, but I'd like to find a real fix for it, and as usual, if possible, a cheap one.
I have a 94 4x4 v6 Toyota pickup the check engine light came on while I was driving it 20 miles later it shifted from 5 into 4.the tranny shifts smoothly into the other gears with no problem but now it won't go in the 4th or 5thmy transmission fluid is passed a full line...
View 1 RepliesI don't drive the Tig much as it is the wife's car. I have noticed on the occasions that I have driven it some unusual sounds when in R. Notice the sound when tapping the gas.
Video:
I believe the Tiguan uses the same 09G trans that I had in my prior vehicles, MKV 2.5 and B6 2.0T. I don't recall this noise before.
My 2011 toyota tacoma auto transmission downshifts on any slight decline, even to the point of losing traction in the rear end if I am on slippery pavement. How can I disable the electronic engine brake?
View 5 RepliesMy 2000 Toyota Tacoma 5 speed sometimes makes a squeaking noise when I let off the accelerator, most noticeably at speeds of between 25-35mph. If I press on the accelerator, the squeaking stops...it seems like it has to be related to the transmission. I was told it may be the U joint...
View 1 RepliesSo, I bought the truck used and everything about this truck is great minus the shifting difficulties in first. With the truck at a dead stop, the clutch depressed, and the shifter in neutral it can be near impossible to shift into 1st (it's possible with a lot - emphasis on a lot - of force). No grinding, clashing, knocking in the shift knob - it just wont go into gear. I can shift into 2nd-5th and reverse without too much difficulty. If the truck is in motion, once the vehicle gets between 2-5mph I can easily downshift into 1st. However, if I shift out of 1st and let the truck sit for, say, 5 seconds it is often very challenging to get the truck back into 1st.
I have tried to look up this problem online with limited success. What I found was it could be caused by:- something wrong with the clutch installation- a need to bleed the clutch (it's hydraulic and, although the reservoir is full, the fluid is a bit dirty)- perhaps a faulty clutch master cylinder- play in the clutch linkage- a broken spring in the pressure plate- a bearing that is starting to go out- worn synchros in 1st.
I am a machinist, not a mechanic, so it's hard for me to evaluate these ideas (beyond the cost associated with each). Given my limited knowledge of transmissions and my good mechanic friend's opinion, I think it's a broken spring in the pressure plate.
1990 Toyota Pickup 4x4 manual transmission. This is the original transmission in the truck, it has not been rebuilt (but has been maintained with regular fluid changes), and has a tad over 158,000 miles on it.
I am trying to find out which fuse is linked to the back door motor because the window works but the back door does not click, move or open. There is a motor on it that usually pulls it fully closed and none of it is responding.
View 1 Replies72 Ford F250 with big block 460. after three years my truck is ready to run as soon as i get my new fuel pump in today. was hooking up shift linkage and noticed the shift lever will only click back two times and then goes all the way forward. I put a shift kit in the c6 and it was beautiful condition inside cant figure out why it would only shift to two places.
View 2 RepliesI picked up a 2016 F250 Powerstroke in the first of March. I owned a 2011 before and loved it.
The 2016 has been great so far, but I've noticed a sound that wasn't present in my 2011.
When the transmission is warmed up, I get a "cla-click" sound from the transmission area when sifting from park to reverse. It doesn't do it all the time and I can only hear it, not "feel" it.
This AM I heard a similar click sound when I came to a complete stop. I only heard it while stopping, not while taking off. I could repeat it almost every time I stopped. I was in drive the whole time I heard the click sound while stopping.
What it may be? I know sounds are one of the hardest things to communicate/diagnose.
I have a 2013 Tacoma TRD with 18k miles, totally stock after driving awhile intermittently the front left wheel has been locking up like I tapped the brake just on that wheel. I've taken it to Toyota and they cant duplicate the problem. This last weekend I drove several hundred miles and the right side started doing it about two to three seconds after the left side for about five minutes then ran fine. It actually makes a chirping noise and slightly jerks the wheel in that direction. This has only happened going over 65mph. Since Toyota claims to have never seen this problem there basically telling Me to drive the truck until it gets worse. They checked the brakes and bearings out.
View 1 RepliesI've got a 1996 Tacoma - manual transmission, 4 cylinder, 2.7 liter engine with close to 170,000 miles on it - owned it for 10 years and 100,000 miles. Wonderful, great truck. Except.....
It has two starting problems and I can't seem to sort them out. The first is it's incredibly hard to start when the outside air is hot. Living in San Francisco, I usually forget about this problem until I drive to the central valley to visit my mom in August. Nothing like coming out of the rest stop, trying to start the engine and then having the feeling of doooh! again!. Seems to be worse when the outside air temp is over 85 or 90 degrees and the engine has been running than sits for 5-10 minutes. Cranks fine but won't catch. When it finally catches, it's like it's really slow to fire - can't quite explain it, but it's like it's doing a lot of thinking about actually running and has to talk itself into the idea. Can take 5-10 minutes to finally get it going, but usually 30 seconds to a minute. Always worried this'll be the time it doesn't want to go. My mechanic has looked at it a few times - but it's almost impossible to recreate in San Francisco when I get home due to the lack of warm days.
Second problem is trouble cold starting. When I come out in the morning, the engine takes two or three attempts to get it to start. Once it again, it cranks fine, but it's as if there's no fuel getting to the engine. If I just keep cranking, it won't fire but if I crank it, turn it off, crank it, turn it off and crank it again it'll always catch on the second or third go. Once the engine is at temp, it seems like less of a problem and easier starting. My mechanic say's "It's an old truck and it always starts eventually, so don't worry about it."
I have a 1995 Toyota Tacoma with a manual transmission that will not go into gear. How can you tell if it is the clutch or the slave cylinder that is bad?
View 2 RepliesI have a wobble in steering at 55 mph and have gone thru 2 sets of tires. After 1st set i changed front struts, no luck . When i rotate tires from rear to front it goes away for 6 months and tires start to wear wavy and wobble starts.
View 3 RepliesMy 97 toyota tacoma will not start. have fuel, changed plugs, has spark. still will not start.
View 2 RepliesI have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
My 2002 Tacoma has recently been experiencing transmission trouble. Between 45-60 MPH at various revs, the truck begins to shudder and shake. The severity depends on how aggressively I accelerate. After several weeks of this, the check engine light came on. It has remained on since, except when it flashes if I accelerate too quickly. Throughout the shuddering, the revs remain constant. By roughly 60-70 mph, the truck runs smoothly again. In a (possibly) unrelated note, the parking brake indicator is lit almost constantly, particularly in wet or cold weather, although the brake is not engaged.
View 7 RepliesI just bought a 2003 Tacoma 2.4l engine and it has terrible gas mileage.I haven't checked the numbers yet, drive for but it cost medrive for 2 hours. Where do I start looking? The air filter is clean, the tires have plenty of air.
View 5 RepliesI changed the coil on cylinder 4 on my 2004 V6 Tacoma and the p0304 code keeps coming back along with the hesitation and missing when I accelerate. The wires were replaced a month ago. What now?
View 3 RepliesMy 1987 Toyota motorhome has an inconsistent shimmy which starts between 47 and 55 mph. This is a one ton chassis. I replaced the front tires and had them balanced.An independent mechanic said that everything was tight and could not find the problem. I took it to Toyota and they also said everything was tight. They checked steering, suspension, wheel bearings, brakes, and U joints. When the shimmy starts, accelerating or decelerating does not stop the shimmy.At one time I took it rapidly from 55mph down to a full stop. As I slowed the shimmy and thumping got more intense all the way down to a dead stop.The shimmy will start on smooth, even pavement and hitting bumps does NOT seem to start the shimmy.The RV has 75000 miles on it.
View 6 Replies