My airbag light came on in my 2006 Tacoma, had it fixed, as my dealer told me:
1. It would not deploy during a accident.
2. Could not get a inspection sticker.
3. It was not covered by my warranty.
4. It was diagnosed as a faulty spiral cable.
We religiously wear seat belts on the road. BUT, on my 4WD Tacoma, driving around a farm they are not needed. Can you simply unplug the underseat sensor to defeat the annoying chime and yet not disable the airbag system?
View 3 RepliesI looked up the service history of a Sienna 2006 (have been planing to buy the minivan) and found that it had a few incidents with AIR BAG ON. When I initially searched for 2006 Sienna I mostly hit the door latch problems. Looks like the airbag issue has been reported on several blogs and there is no recall yet on this issue.
My question is, if I buy extended warranty, whether this would cover the repair cost or not. Or, should I stay away from 2006 Siennas? If so, which models/years should I avoid?
So my 2006 toyota tacoma prerunner v6 was working fine i could drive it a bit but after i changed the drive belt it starts and shuts off after 3-4 seconds. if you accelerate immediately after you turn it on then it wont stop till you stop accelerating...
View 1 RepliesI get a "dinging sound" like a warning when my truck is places in Four Wheel Dive Low. I do not hear the sound in 4 WD High. The sound will not stop and it makes things rather annoying when climbing up the huge hill leading out from my property. I check the Owner's Manual and it says nothing about a dinging sound; or at least I didn't find anything.
2006 Taco, Automatic, 127,000 miles
I have a 2006 2WD V6 Tacoma Pre Runner with 42,000 miles. The truck runs great, but has an annoying noise problem. After I drive the truck about 10 minutes, and slow down to stop or turn, I hear an odd noise that sounds like a rattle and grinding sound mixed together. It is a brief noise and goes away once I increase my speed above 20mph. Sometimes I hear the noise briefly after stopping and increasing the engine RPM. I checked the rear brakes and they are fine, I changed the differential fluid, there are no leaks. I inspected the exhaust system and it seems fine, Using a rubber mallet, I pounded on the cats and muffler and I hear very little noise. What is causing this problem.
View 3 RepliesAll the gauges on the dash will die for a second and the engine cuts out and the car jerks then it will come back on and everything is fine. Sometimes the gauges turn off completely and the car will die and will not start for several minutes. I will try to start the engine but it will not start until the dash lights come back on. The first time this happened to me I changed the air filter and the car ran fine for a month. So when it happened again I took my air filter out put it back in and again the car worked fine for a couple of weeks. Now, It doesn't work to mess with the air filter at all. The car is cutting out more and more.
View 2 RepliesI have a 1997 toyota tacoma. The truck runs great. Last year I replaced the front calipers and breakpads. I drive the truck maybe 3,000 miles per year. The issue I have is that the brake light will not turn off. I checked the hand brake and it works fine. The switch on the handbrake is fine too. The really unusual thing is that randomly it will turn off. usually around 30-40MPH or when I have slammed on the brake. The brake fluid is fine. Is there a sensor in the rear on the rear pads that I may need to replace?
View 6 RepliesPassenger side brake light is not working. Bulb is fine. Seems that the "plunger action" in the socket may be lacking. I put some WD in there.....worked for a day or so....now not working. Can I replace this socket or do I need an entire lens assembly?
View 2 RepliesI took my truck in because the tire pressure monitor light was on. I tried resetting it and that didn't work. I took the truck to the tire store where I purchased the tires. They checked all the sensors with test equipment and 4 out of 5 were bad. So I had them replace all the sensors including the spare. The light is still on. I followed the reset procedure and confirmed all 5 tires were at 32 psi. when I perform the reset the light blinks once and then stays on. What Now?
View 1 RepliesAfter having the rear axle seal replaced 3rd time, my 2004 Toyota makes a sound/noise behind the dash, drivers side, in the engine compartment. Noise is intermittent and only when braking. Hard to describe....electronic sound. Brake pedal feels like ABS system is kicking in. But no ABS light comes on. Mechanics all tell me, "when light comes on, bring it back". Had the brake system flushed today? Still makes the noise.
View 3 RepliesI installed a new engine in my pre runner. upon completion and a thorough check of fluids connections and such we lite it off ran beautiful and everything seemed to function.Put the hood back on and installed the skid plates and got ready to pull it out of the garage that's when things went pear shaped!!!My son fired it up it ran for a few seconds then shut its self off. the idiot lights would stay on even after you turn off the key and remove it.
Put the key back in turn it to run but not to start position and that will reset everything. the only thing un effected is the door lights. if the key is in it you can step on the brake and the ac clutch comes in and everything goes goofy. turn the key off then back on and try any function be it headlights ac brakes pedal or attempting to start and it goes all goofy. Where to start looking. Ran great for an hour before all of this started.
I have a 2011 Toyota tacoma with 35k miles. Yesterday while driving at about 70-75mph on the freeway with no warning the vehicle shut down and the engine light came on. It made a clunk about the the time it shut off, it wasn't very loud but I could feel it. I'n not sure if that noise was just the vehicle powering down or transmission kicking from the change in torque? I pulled off the freeway, there were no fluids leaking, serpentine belt was in place. The truck will turn over but not start. The check engine light flashes rapidly.
View 1 RepliesI have a 2007 Toyota Camry LE, and the seat belt light keeps on flashing and the airbag light is solid. We have tried literally everything possible, tried replacing the seat, replaced the seats sensors, tried a airbag module out of another 07 camry with exact same part #. Toyota have diagnosed that all the systems for airbag is fine, except it has something to do with the seat belt of the drivers side/or module but all that's been checked and still no luck. My car is due for Safety inspecting coming month and need this to fixed. How to handle this. Btw light came on because we had a blown fuse for the drivers power seat, and my mechanic thought that it was the motor so we replaced the seat and noticed that it wasn't the motor. Was just the fuse and we put back the original seat and everything is functional except the lights came on. No accidents on it to the extent i know. and the wiring is all plugged back properly without anything like wiring damage.
View 9 RepliesA few years ago I bought a used 2006 Toyota Rav4. I was rear ended in 2010 and my air bag did not deploy. Only damage was to back bumper. Yesterday I was again rear ended. I am guessing the only problem will be a damaged bumper, but once again the air bag did not deploy. This time I had an elderly couple in my car and both said the impact was hard enough that my air bags should have deployed. No one was hurt. How much force does it take to make the air bags deploy? Should I be concerned? If so, can the body shop check my air bags or do I need to go to the dealer for that?
View 10 RepliesI have a 2009 Toyota Prius. The airbag/srs light came on a couple weeks ago and would come and go. Eventually it came and did not go. This didn't really bother me as I don't drive it much anymore and I figured it would be gone by the next time I went to start it up. (I also heard about connections under the seat being loose and hoped that was the problem.) Well I was wrong. Today I noticed it was still there so I decided to start diagnosing. I jumped the connector as my obd2 scanner only reads regular and abs codes (not srs apparently).
The only code that came up was 51. Which is the driver side squib circuit. Many say that code 51 usually just ends up being the spiral cable. I simply find this odd as every button on my steering wheels works. Cruise control works fine etc. Idk how only 1 or 2 wires get messed up in that thing and how they turn out to be the ones for the airbag but I suppose its possible. My next step is to take a continuity tester to the 2 plugs that connect to the airbag to see if they are getting power.
I have a Toyota 2004 Prius and I have been having the airbag warning light on my dash for the past few days. I have 140K miles and do not have manufacturer warranty. What could it be causing it? Faulty seat weight sensor? Calibration issue?
View 15 RepliesI just purchased a used 2010 Toyota Corolla with Airbag Light ON (not blinking). Yes car was in an accident, but Air Bags did not deployed as per the seller. It needs to re-calibrate by Dealer.
As a novice, and avid Toyota person, since it's a good deal I decided to take the car with the airbag lights on. I have seen on youtube, the cause is likely the spiral cable.
A squirrel chewed through some wires in my 2009 Toyota Corolla. My left headlight went dim and my airbag light came on, all within a matter of days. I had the wires repaired and the airbag light never went off. I waited for months until I found out that my airbags won't deploy if I am in an accident. I did some research and from what I gathered until the problem is fixed the light will remain on, (Problem cannot be reset).
I took it to the same guy who fixed the wires .The code that came up was a faulty module. He said since my bags did not deploy the module most likely tripped and he could try to reset it. He tried to do it manually and by the SRS reader with no luck and told me I should go to a shop with a more advanced reader so they could try to reset the module and if that doesn't work go to Toyota.
Can this problem be reset? If it is reset how do I know there still is not a problem that needed to be fixed?
My 09 Matrix passenger seatbelt/Airbag Alarm light started to come off intermittently a few months ago. It often came off in a cold morning (when temperature dropps below 40F) after driving for 30+miles. I have taken it to a mechanics and they found an airbag code. They cleared the code but cannot find the root cause. I saw from some online forum that it happened to a lot 05 Matrix and repair involves replacing the clock assembly eventually. It seems to be odd since it only happened to me when it is cold and after some driving. I suspect that it has something to do with the battery since the battery output voltage may be the only thing I can think of that can be temperature dependant.
View 5 RepliesI have a Sonata v6 3.3 2007 Its passenger Air Bag light is on, how much its gonna cost me to fix it ?? and sometimes when i stop at the signal light the oil light starts blinking, why is that, and as soon as I start driving it goes away.
View 11 Replies