I recently purchased 96 Toyota Tacoma 108 K miles. I discovered that it is totally missing all the front fender liners on both sides. Looking for info as to the number of parts needed for each side. No need to include the clips because they are bought by the 10 pack. Maybe how many 10 packs.
View 2 RepliesI just recently dropped my car on BC racing coilovers 16k fronk and 14k rear. I am having slight rubbing issues in the Front only. For everyone that's dropped on coils, if you were rubbing what did you do? I currently have my dampening set on 16/32. The rubbing is actually only on my front fender liners. I love the comfort with 16/32 and don't want to turn it up stiffer and I don't want to raise it up too much. I was told to raise it, turn up stiffness or heat up fender liner and push it up or in a bit. Also for the rear since its 2 piece suspension, to raise or lower the rear 1/2 inch would you adjust the height on the BC struts or the BC springs (the one that's sitting in the bucket)? A shop installed mine and I've only owned 1pc rear suspension for my other cars.
View 5 RepliesThis is a 1996 Toyota Tacoma, 2WD, 2.4L. When I apply the brakes I get a very heavy vibration in the front end, almost like a wobble. The vehicle otherwise stops fine. No noises. The vibration occurs at pretty much any speed over 20 mph. The frequency does not seem tied to the actual speed but it's hard to tell for sure. It does not do it when I apply the emergency brake only.
I replaced the front disk brake pads, with new clips and shims. There were worn down pretty far and needed replacing. Unfortunately that did not make any difference in the vibration. Rotor runout and minumum thickness were checked while changing the disk brake pads and both were within specs. I did a quick inspection of the ball joints and tie rod ends by trying to move the tire and everything seems tight enough.
I'm not very proficient on suspension issues. What else can I look for.
I'm lowered on coils with 20mm spacers in the front and I'm rubbing my liners not a whole lot but still bothers me. There's a lot of people here with dropped and flush "F's" so what have yall done? Or do yall just let it rub away
View 14 RepliesI bought a used 2007 Tacoma truck from a Toyota dealer in July with 53,000 miles. After driving it for 5000 miles, I took it to my local mechanic for an oil change. He, being the good mechanic that he is, checked the air filter. To his surprise, there was no filter element in there! He put one in and told me about his discovery. My question to you is this - how much damage could have been done to the motor in the 5000 miles I drove it without an air filter? I intend to tell the dealer, but first I'd like to know what effects this missing filter could have on the truck so I know how much to ask for from the dealer.
View 13 RepliesIf the driver's side fender liner is supposed to have an access panel cover? I was swapping out my side markers today and noticed that my passenger's side has one but not the driver's side. Didn't think to check for something like that during delivery although from looking at the one from the passenger's side, it doesn't seem hard to believe that it could have fallen out due to spirited driving.
View 3 RepliesThis truck misses in the morning when I first start it. It acts like it did when the catalytic converter went bad. Only so much gas can be given, before it sputters and misses. This only happens when it is humid or raining. When the truck warms up, the problem goes away, and once it is warm, it doesn't happen again during the day. I would suspect an exhaust problem, but I just replaced the entire system from the exhaust manifold back.I'm now suspecting a problem with the ignition, but I don't know where to start to find that problem... 1995 Tacoma i4 5spd manual 2wd...
View 5 RepliesMy 96 Tacoma has recently developed an issue where the starter doesn't engage when I turn the key. If I let out the clutch/break and start over, it typically works.
The weird part is that I never had this issue until I had the clutch replaced. The day after I got it back was the first time I had any issues. It is intermittent and doesn't happen anywhere close to all the time. I took it back to the shop that did my clutch and they told me I needed to replace my starter but I'm wondering if there is any other explanation for what's happening that would make sense given the timing of the whole thing. Could work they did replacing the clutch be causing this?
I have a 1996 Toyota Tacoma, 5 speed manual pickup.
Occasionally I use the air conditioner. I'll be driving along and it's working fine but then it stops putting out cold air. I pulled into the mechanic one day and confirmed that when it is not putting out cold air, the compressor still seems to be running.
If I go into a store for about 15 minutes and then come out again, it works again. What might be happening?
This is a great little truck we only use occasionally. It has 145,000 miles and runs great, but the a/c temperature is very sporadic, and this week it is 100 degrees! One day it will work fine, and the next day it will only blow hot air. Sometimes the air starts out cold, but after 5 min of driving, it turns hot. I have had the freon checked and my mechanic said part of the compressor (forget what he called it) was probably getting stuck at times, and he would have to pull it all out and possibly replace...
View 3 RepliesGot a 07 Tacoma with front end wheel bearing noise. How far can I push this ....
View 7 RepliesI bought new tires for my 2005 Tacoma 4x4 and went up from 265's to 275's with some really nice Pirelli Scorpion ATR's, problem was, I started noticing some serious wobbling in both the steering wheel and the front end in general, it seemed to be at certain speeds. I had done some research online to find that some people had trouble with the balancing on those Scorpions so I naturally thought they needed to be rebalanced. But balance after balance, nothing seemed to improve. In total I went in for balancing 6 times! Even went to different places to make sure I didn't get a machine that was somehow calibrated wrong. I also took it in to the dealer and had them look at everything to make sure all was well with the truck, they said everything looked fine.
So my frustration finally came to a head last month when after another balancing the wobble was still there, and I decided to change out the tires thinking I just got a bad set. I test drove the truck right after changing the tires and could feel a little wobble so I took it back and they re-did the balance. Sadly that was rush hour and I couldn't get up to the speeds that I normally felt the wobble. (usually between 55-65mph) The day after switching the tires, (new tires are back to 265's Falken Ziex all season). At first I thought the wobbling was speed dependent; BUT after setting the cruise control on the open road at 72mph I started to notice that the wobble would come and go seemingly at random. I started thinking that it may be the road surface but put that theory to rest when I felt the wobble on brand new paving (yes, believe it! The wobble just seems to come and go even at the same speed and on seemingly similar surfaces. It's driving me crazy! I have to believe it's not the tires that are causing this, but since the dealer can't seem to reproduce the problem when they test drive.
So to summarize; the problem seemed to start when I got new tires a year ago, rebalancing 6 times did not solve the problem, put new tires on and still getting the wobble. It doesn't seem to be as dependent on speed or surface, although the worst of it happens in the 55-65mph range. (If I go faster it seems to smooth out, but we're talking 75+) The wobbling is felt and seen in the steering wheel and the front end of the truck. (my gut tells me it's coming from the front right of the vehicle). I even had them do an alignment so it's not that either.
2004 Toyota Tacoma... I drive 40 miles each way to work daily and sometime, usually 20 minutes into the drive, I get a vibration in the front end and felt through the floorboards and steering wheel, that get progressively worse until the entire cab is shaking. It lasts approximately 10 minutes and then it stops only to happen again on the next drive. Wheels have been checked.
View 4 RepliesI own an '05 Prerunner with 56k miles. Had the front pads replaced and turned the rotors last Spring.
Now, after sitting for awhile, as I back up the front brakes squeal. (Sounds like a rock in a caliper its so loud.)
Toyota has a TSB to fix this.
I have a 1996 2.7L 4x4 Tacoma. About a month ago I had a problem pop up. I went to start my truck and nothing happened. All the dash lights came on(i.e. e-brake indicator, airbag light, check engine light) like they were suppose to when you turn on the key. I heard the fuel pump come on and the starter relay click, but the starter did not activate. My first thought was bad battery because it had the original from when I bought it used. So I replaced it. Thought problem was fixed, but it reappeared. Checked all the starter wires and alternator wiring and they all appear to be fine. Truck started fine for a week after I had inspected the wiring. Then the problem came back.Then I replaced the starter thinking maybe the solenoid was bad. Once again the truck started fine for a day or two then the problem resurfaced. I thought maybe the starter relay had a bad contact in it so I replaced that, with no luck. Then I replaced the ignition switch thinking maybe that had a bad contact in it. Once again no resolution to the problem. The final piece to the puzzle is that sometimes if you keep turning the key over and over the thing will start and other times it refuses.
View 11 RepliesLooking for info on these replacements and is there any manuals out there to assist with the process?
View 1 RepliesIt seems to be coming from the front passenger side wheel well area. It's only present during braking and coming to a stop. Seems to be also related to wheel speed. The brake performance doesn't seem to be impacted but it's very embarrassing creaking through a parking lot. The noise doesn't seem to be present on a cold start but once the brakes warm up it really comes to life.
I noticed with both wheels up off the ground that the front passenger side wheel (The side making noise) had more resistance than the drivers side when trying to spin. [URL]...............................
Several weeks ago someone backed into my '97 RAV4 in a parking lot. Body shop charged around $900 for the repair (estimate indicates labor for both headlights, but doesn't look like they replaced them). This afternoon one of the low beam headlights burned out. I went to change both sides just to be safe. On both headlight assemblies, grasping the wire assemblies to the low beam bulbs, the headlight assembly on both the left and right side is loose within its housing. I've changed the bulbs in the past, this is something new. Take it back to the body shop? What happened????
View 7 RepliesAfter my coilover install there is a small knock coming from both sides in the front that wasn't there before..sounds and acts like a swaybar link but they don't have play and I replaced them and the noise is still there. I also reused the the shock tops?
View 4 RepliesAt low speed driving and hitting a small bump I hear a clunking noise in the front on both sides. But when driving at faster speeds and hitting a bump it makes no noise at all. I can't seem to figure out what it is.
View 5 RepliesHaving rust issues? I just bought the car and noticed some was touched up with the rear hatch - under the window, right by the seal. Also, right by where the bottom of the door and front fender meet. Looks like it's inside, on the body/frame, not the fender.
I'll probably take it to dealer and hope to have it taken care of. Carfax came back clear so I'm pretty sure no work has been done on it before that would cause this.