Did the 1996 t100 come with the rear bumper as a factory item or was it an option. I'm not sure if I should fail the vehicles inspection for missing the rear bumper. If the truck comes from the factory WITH a bumper and is no longer installed, the vehicle fails.
View 1 RepliesIs there a better option to the standard MDI insert in the centre console? I was sure I'd seen a photo of an insert that kept the MDI but didn't waste then entire console. Am I just crazy? I mean come on, it doesn't even fit an iPhone very well. I have to put the phone in head first and then bend the cable flat to close the arm rest...
View 2 RepliesI drive a '93 Toyota T100 with a manual transmission. Up until recently things were going great but I've noticed it is damn near impossible to shift from reverse back into first gear when I'm pulling out of my driveway. I've also found that shifting from first gear to second has become more difficult as well though not impossible. However if I'm shifting to third, fourth, or fifth gears I don't have any problem whatsoever. I had the transmission redone about a year ago after the clutch gave out so I'm hoping its not that.
View 9 RepliesEngine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 RepliesToday the engine light was on and vsc was blinking so i took off the battery wire for two mins and put it back the engine light went off and vsc stopped blinking. So my question is should i leave vsc option on or off??
View 1 RepliesHow to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?
View 2 RepliesI have a Matrix XR 2010 with front bumper sporty look . I like to change the front bumper to regular bumper and the reason is that for the last two winter seasons I have broken the spoilers and basically wreck the bumper.
View 2 RepliesI've had my 2010 Gen III for about five months. I play in a folk band and we do a lot of gigs in DC and Northern Virginia. We have to haul a lot of stuff, and my Prius holds it all.
But in just a few months my rear bumper has gotten all scratched up moving stuff in and out of the car. I looked around for something I could cover it with to protect it from scratches. The dealership said they could put a non-skid decal on the flat part, but I wanted something that covered a little more.
how to remove it.My wife backed into my truck and put a dent in the corner of it so I am hoping i can pop it out.
View 4 RepliesThe red ones that are in the rear bumper, Do I have to take off the whole bumper?
View 22 RepliesMy daughters 95 Volvo 850 had a sagging rear bumper. I prchased new mounting brackets and removed the bumper. It turned out the brackets were for a 5 door, and her car is a 4 door. I returned to the dealership and was told that they can only get the left side bracket and that the right side bracket is no longer available. The brackets look nearly the same except the mounting holes are opposite. I went ahead and ordered two left side brackets. I am hoping to be able to drill holes in one of them to fit it on. The bumper is now off the car and the old brackets are rusted to nothing.
View 3 RepliesLooking for info on removing the rear bumper cover of a 2012 Passat?
View 2 RepliesTaking off? Possibly for a diffuser install or any other reason. The reason I ask is because (now that I am not upgrading to an RCF) we are going to attempt an LFA style exhaust on my current RC F-Sport. We will be starting off using an RCF rear bumper due to there being more room in the area where the stock diffuser usually is.
View 7 RepliesI have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
I have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 RepliesDo you need to take off the bumper?
View 2 RepliesI need to remove the bumper to replace the reflectors for some lead breaking lights, so I'll also need to find the rear break lights cables to jump this leds.
View 14 RepliesI'm considering having both my front and rear bumper and possibly my hood to get repainted by a bodyshop in the spring just due to stone chips, and a couple small scuffs. The car still looks great but since I'm planning on keeping my 460 a while I want it to look perfect, my car is black, but I'd rather leave it as is than have a body panel that's a different shade.
View 12 RepliesI will be installing a Euro-type of hitch to my car and for that the rear bumper needs to be removed.
View 8 RepliesI'm in the process of buying a used 2008 Mini Cooper S with 44000 miles in good conditions but I wanted to get an opinion regarding a rear bumper crack. Please take a look at the attached photo and tell me what you think, not sure how serious it is or how much it will cost me to fix so I can negotiate the price.
View 7 RepliesSo I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 Replies