Toyota - Starting - Tundra :: 2006 - Won't Start Intermittently?
May 28, 2013
2006 Toyota tundra starting problem only intermittently, id say about half the time recently it does this. Ill go to crank my truck, turn the key over and it makes a loud CLICK/thud under the hood. Lights go dim, clock shuts off etc. Turn the key off and back on, CLICK. I have to repeat this 3-4 times before starting sometimes. And once or twice the starter would turn over for 3-4 seconds before finally firing up. Ive check the battery and alternator at the local auto zone and a local dealership, both checked out fine. The starter is under the intake manifold. I have checked grounds/connections etc but dont see problem.
View 3 Replies
Advertisement
My 07 tundra starts and then stops running it does this intermittently. I recently put in new battery.
View 2 Replies
I have a 2008 Toyota Tundra which is vibrating intermittently about 5 to 10% of the time. I have had the tires rotated, and balanced, plus the front end looked at by a dealer. Still does it.
View 1 Replies
Our Honda Odyssey will have an occasional delayed start where you turn the key but no sound occurs. All the lights come on like normal and the automatic doors can all close and open without any issues. Originally we didn't know that we could eventually get the car to start by turning and holding the key in the start position. It happens every couple days to couple weeks and without holding the key in the on position it will be anywhere from 30 minutes to 3 days before the car will start normally again. We've spent about $1,000 at the Honda dealer to have the battery, battery cables, starter, and starter relay replaced but we're still having the problem.
View 2 Replies
I have a 2003 Toyota Tundra V8 - 2 wheel drive. I have 121,000 miles runs great, uses no oil at all. However, on cold mornings when I start it, there is knocking in the engine for two or three minutes. Is it serious? Is it a weak oil pump? Rod bushings? I had an '01 Tundra with 165,000 miles that never knocked.
View 9 Replies
My 2006 Tundra with 45000 miles on it has an engine vibration in neutral between 1400 and 1750 RPMs. It does not feel or sound like a miss fire rather a definite vibration. I have heard this is common with Toyota 4.7 litre engines. What might be some things that could cause it? It has always done it and after 8 years hasn't resulted in any engine failures.....yet.
View 5 Replies
Periodically my 1994 Toyota Corolla 5-speed manual will not start. Other times it seems to hesitate before starting. The rest of the time it starts fine.
When it does not start: I turn the key, and hear the fuel pump relay click, and hear the fuel pump on the gas tank energize, but the car does not try to crank. I do not know if the starter solenoid is engaging at this time, as I could not listen for it while in the car. When I did try to listen for it while under the hood with someone else starting the car, it actually started (did not exhibit the issue)
When it hesitates before starting: However, sometimes, when I turn the key I hear the fuel pump relay click and the fuel pump energize, after about 1-1/2 seconds of holding the key, it does start.
When it does start it sounds normal, not like a low battery. The battery is new. I had the charging system checked at Advance Auto and they said the battery was good as was the alternator and starter. Plenty of cranking amps.
I disconnected the main wire on the starter motor and cleaned it with a wire brush. I also cleaned up the battery terminals.
I did find that the switch on the clutch pedal that allows the car to start when pressed has some fluid leaking on it (clutch fluid I think). Could that be causing the intermittent starting issue? If so, can I just clean it with WD-40 or something like that?
View 1 Replies
I have a 1988 Toyota (4 cylinder) Pickup truck, with a very intermittent starting problem, that is driving me crazy. It has had the starting problem for over a year now. Normally is starts easily, within one second with the starter motor, no gas needed, and it starts smoothly.
When it has the problem, I turn key, and I only hear a click, and the dash lights are lit, but no starter motor sound.
Early on I would call for a tow truck, but it usually started when they arrived.
I got angry one time and turned the on and off rapidly, nothing. Meditated for about 10min to calm down. Nope, still angry, so turned the key rapidly again, and the starter motor engaged, but the engine didn't start.
So I did that again and gave it some gas, then a lot of gas. The engine was running very rough, like all cylinders were not firing, then it spews out a huge cloud of blue smoke, and the engine evens out. That's my usual pattern now: turn the key like crazy wait a few minutes or even an hour, and keep trying.
It is usually fine for 2 to 7 days with no problems. But a couple of times it has had the problem twice in the same day. The problem seems to happen most when the engine is cold, or after a short trip. A few times, it has had the problem even after a long trip, when the engine was still hot.
What has been replaced in the last year? In this order: starter motor, battery, hot lead to fuse box, battery terminal clamps and wires, fuel pump, mass air flow (don't know what that is), catalytic converter, and master relay. (OK the master relay probably isn't related because rain water leaked in and dripped on the fuse box in the cab.) (Also it has 133,080 miles, and a rebuilt engine put in 4 years ago.)
After the mass air flow and catalytic converter change, the truck has started with no problems for 3 months. Now the problem is back! Same symptoms.
When they last worked on the truck they did a tune-up and they said the starting problem could have been caused by the starter motor not being lined up properly so it would "jam". That would explain why the starter motor wouldn't go, but it doesn't explain the miss-firing when it does finally start going.
I also notice that after they do some work on the truck, it starts fine for about 2 weeks with no problem. So maybe something is getting wiggled into a happy position when they work on it?
If this is an "electrical" problem, what can be done to find this very intermittent problem? Also, just before the the problem started happening again, I noticed there would sometimes be about a 1/2 sec to 1 sec delay from when I turned the key, to when the starter motor would go.
Attached is an audio file of what it sounds like.
1) starting normal,
2) turning key and only clicks,
3) the rough start after many tries.
View 8 Replies
Subaru Impreza 2004 2.5 TS170,000 km
For a couple of months now and every few days, my car turns over nicely but chokes. I can keep the engine running by pressing the gas pedal as lightly as possible without letting the engine stop or rev too high, and after about 15 seconds it stays on on its own. When it's running it runs very smoothly...no knocking or shuddering or poor idling at lights.
So there’s obviously a gas delivery problem at startup. I don’t know if I can but I would love to rule out the fuel pump since it's only at startup (fuel filter is new, battery is new, and sensors have been checked, even during a failure to start scenario) and it runs so well when driving. Also, it won’t start randomly, regardless of temperature, cold start or not, incline, etc. I read that a fuse can have intermittent problems but again it seems to me that it should be properly intermittent, not just at startup. Which leaves the relay and wires.
Now thinking about wiring, a few years ago I noticed I could no longer leave my highbeams on. I could hold the lever and make them stay on, but pushing the lever into the on position no longer works. Also, recently and only once, on a -26 C day, the air compressor was dead when I started the car. After stopping and starting for a half an hour I noticed that it had come back on. Does this sound like it could be connected? Where do I even start to diagnose this starting problem?
View 2 Replies
My 2001 tundra v8 4.7 liters. Will not go past 90 miles per hour.I'm not a speed person but I like to know my truck is in top shape.Odo reads 99073 on the i way I tried pushing it to a 100 mph but it not go, what's happening to my truck...
View 6 Replies
I have an 05 Tundra. I was backing out of my driveway and got into the street and put the truck into drive and nothing. I then tried reverse and again no movement. No prior problems with the transmission. I cannot even find the dip stick to check the fluid. What might be wrong with this trans or truck?
View 1 Replies
Okay, 2000 Tundra (185,000 miles) starts out with usual pressure. After driving a ways pressure drops down to dangerously low and stays there (not detectable when driving, other than gauge). Mechanics measure same pressure drop using alternate pressure gauge at engine. They assumed oil pump, which would mean pulling engine, but were advised bad oil pump is very unlikely on that Tundra (and I don't think the symptoms quite suggest that), and also advised that oil suction tube could be clogged, also necessitating pulling engine, but oil has been kept fairly clean. Car also sits for long periods.
View 4 Replies
I have a 2005 Tundra, 60K miles. Dealership just told me the frame is rusted out, with actual holes in frame under driver side. Said car was unsafe to drive or have on road. Called Toyota and opened case but said I was out of warranty and they were not accountable.
View 19 Replies
I can hear a "ringing" noise that appears to be coming from one of the wheels. I can hear the noise when I have my windows down and am driving at slower speeds. The noise sounds similar to a bell ringing and the sound disappears when I apply the brakes.
View 4 Replies
I had the oil changed recently in my 2008 tundra 5.7 v-8. I noticed the oil pressure gauge moving. When I started the truck, I noticed the gauge will move to the right of the indicator in the middle of the gauge and then it will go back to the middle mark on the gauge when it is warmed up. I also notice that it moves a little when I accelerate. Maybe it has done this in the past and I just have not noticed but was wondering if I should be concerned.
View 5 Replies
My Toyota Tundra 2011, driven enough to haul a horse locally (6000 plus miles) is now unable to go above 30 mph, it was fine last week. Toyota dealer says it is both of the air injection units and switch. Of course it is out of warranty 3 months.
View 10 Replies
Location of cabin filter 2003 toyota tundra....
View 4 Replies
I have a strange vibration that radiates from, i think, the drive line or transmission.
View 1 Replies
My 2003 Tundra is showing a fault light for the SRS. It only shows when the air temperature is high. After running the A/C for the drive home, I can turn off the truck and restart it and the fault light doesn't show. That seems to indicate the fault is related to cabin temperature. What is causing the fault?
View 18 Replies
1) Why is my neighbor's late model Tundra chirping and flashing the lights at regular (maybe 20 second) intervals?
2) Why can I hear it a house away but my neighbor (at home) cannot?
3) Can I stop it? If it something like hey idiot, you left it unlocked with the keys in the ignition, maybe I can.
4) If I resort to violent methods to stop it, will I be subject to criminal penalties. or would a jury of my peers find it justifiable truckicide?
View 6 Replies
2008 Tundra 5.7 only 55K miles – What is causing an intermittent misfire at startup? It’s been running great, then 2 weeks ago when I started it up I could feel a misfire. By the time I backed out of the driveway the check engine light came on. This is what I have learned so far:
•It only happens when you start the engine and the engine is NOT at operating temperature.
•The engine code always reports misfire on Cylinder #2 I put in a new plug and swapped coils but it still reports the misfire on cylinder #2.
•Once it starts to misfire it will continue to misfire until the engine is at operating temperature and you restart the engine. NOTE: You MUST restart the engine for the misfire to go away. It will be running rough, turn engine off/on once it is at operating temperature and it's as smooth as can be, no more misfire.
•One time I started the truck, I felt the misfire and drove it to a parts store to read the code. Engine was fully warm by the time I reached the parts store. I did not power off the engine, plugged in the tester and read the code which was a misfire on cylinder 2. I cleared the code and within 2-3 seconds it logged the misfire on cylinder #2 again. Cleared the code several times and it kept reporting misfire on cylinder 2. You could also feel the misfire happening. Turned engine off, started it right back up, like before no misfire, cleared the code and it no longer reported a misfire.
•This just started intermittently happening. This morning it happened again, I drove it for about 5 min, engine was about 75% it’s normal operating temperature, powered it off/on, still had the misfire. Once engine temp reached normal temp (about 9 min), I turned off engine, started it back and like before problem was gone.
What is causing this to happen?
View 19 Replies
