Toyota - Starting - Celica :: 1990 - No Restart After Driven For A While
Mar 25, 2014
I have a 1990 Toyota Celica that won't seem to start after I've driven it awhile. After sitting, it takes around 4 or 5 hours for it to start again (although this is highly variable). The first start of the day is always normal. Recently it will stall at idle, then have trouble starting up. The engine seems to "try harder" to start if I press the gas.
The weird thing is that I was able to start it up easily today by popping the clutch. This has been a problem I've been struggling with for a few months, and over that time I have replaced the starter, battery, fuel pump, spark plugs and wires, and EFI/Main Engine relays. It always cranks, just no start.
View 3 Replies
Advertisement
1990 Celica 2.2 liter, 5SFE manual trans car with 239k miles.The car occasionally stalls after it is warm and won't restart. When is is cold she fires right up as it does most of the time when she is warm. To restart he sprays starter fluid in the intake or waits until it cools down. Also as the car gets warm the idle decreases to around 650. Adjusted idle speed to 750 but no effect. The only code is 1-2, low or no RPM, measured the RPM sensor air gap and within spec, measured the sensor resistance and within spec. sensor wiring and connector looked good, measured the temp sensor and within spec, disconnected the EGR vacuum line and no effect. Problem occurs once or twice a week but at the most embarrassing place.
View 4 Replies
My 1990 Toyota Corolla which I hate to retire has only 64,000 miles on it. Starts and runs but while I am driving the dash lights up and the engine shuts off and won't restart. He thinks it is the NEC (?) switch but he said he is not really sure. Spending all that money and then finding out it is not fixed would not be worth it. It also is dangerous what if I am on the expressway?
View 19 Replies
I just got a 1990 toyota celica and it turns over but dont start. its getting fuel up to the motor. i got it from a friend that gave up on it and he got it from a guy that replaced the 2200 with a 2000 engine. everything looks to be connected but i dont know where to start.
View 1 Replies
I have a 1990 Toyota Celica, and I've been having trouble with it not starting after driving. There are no symptoms when the car is running, aside from a very slight rough idle. The car starts fine after sitting for 3-4 hours, but for short trips where it's off for under 1-2 hours, it cranks but will not start. The cranking also seems weak unless I floor the gas while trying to start, and sometimes it will eventually start if I hold the gas while cranking. It always starts at the beginning of the day.
This leads me to believe I'm dealing with a flooded engine, but I'm not sure how to diagnose why. I thought it might be leaky fuel injectors, but wouldn't that cause symptoms when running?
View 7 Replies
I have a 90 celica, and while I driving today, the engine started smoking. I pulled over and took a look. The smoke was coming from behind the smoke and air filter area. I let it sight for about 2 hours and drove it back home and it wasn't smoking. Both times, it was on the road for about 20 minutes. I got a buddy of mine to take a look and he said that it was caused from the coolant boiling(I didn't think coolant coils boil). And it rained for a week straight, and I haven't driven it since it started raining. Could that have anything to do with it?
View 6 Replies
I have a 1990 toyota celica. The parking attendant somehow locked the steering wheel and the key will no longer turn in the lock. I tried everything i could think of: turning the wheel whilst turning the key, putting car in all positions other than park and then turning the wheel and key, changing the key, etc....The steering wheel remains locked and will not unlock.
View 11 Replies
got a sweet deal on it but only 1 problem with the car. when i shift into 2nd gear there is a grinding noise, however it doesnt grind if i drive super slow... it doesnt really matter if i upshift or downshift into 2nd it will make the noise either way... also the grinding noise is only there WHILE shifting the lever into 2nd gear so its only there for a second, once the lever is shifted into 2nd gear there is no grinding noise at all...not sure if this is related but the clutch pedal also feels very lose just when its about to hits the floor...
View 4 Replies
I have a 90 toyota celica st. I was driving it the other day and it died on me while driving... twice! The second time was going down a steep hill and it was freaken scary for a minute as the breaks were not working, the car started again and I was able to stop! Anyway I know enough about cars that once your car starts it should not die. Could it be the alternator? It seems to start up just fine. I did notice though that when the car died on me both times I was taking a pretty sharp right turn. And when it died every thing blinked twice then out went everything. Im sure that it is a code for something but I do not have the owners manual as I was not the original owner. I just started it up today again and it makes a weird clicking noise before I even turn the key.
View 4 Replies
I've got a friend with a 1990 Toyota 4Runner Manual transmission with ~170k miles on the clock. He's been having an issue for quite some time that he hasn't been able to be resolved. Basically he's got an issue with the vehicle erratically NOT starting when it is hot outside. The vehicle starts fine when it is cold outside, but when it is hot he erratically (only happens sometimes) get a "click" noise from the engine compartment with no engine turn over or anything. He is then at the mercy of the vehicle and sometimes just has to try multiple times or wait it out for awhile and try again. Sometimes just opening the hood, looking around a minute, closing it, and re-trying is able to get it to start, but other times not. Other times, and I quote from him, "sometimes i just get really upset and stomp on the clutch, get out of the truck and just shake/rock it, sometimes that'll do it." It happens if the engine is cold or hot, it only matters that it is hot outside, above ~90 degrees. Below is a list of stuff that has been done to try and resolve the issue, but hasn't really worked.
Steps taken:
Replace Battery
Replaced the Alternator 2 years ago
Replaced the Battery Connectors (some were corroded)
Possible Starter Replacement within the past 5 years (double checking paperwork)Rewired jumper wire from battery to starter
Seems sensor or solenoid related to me, but I'm unfamiliar with this vehicle/quirks.....
View 3 Replies
Just replaced the starter and battery on my old but loved 4Runner. I drove it for an hour and a half last week and couldn't restart it. Just nothing - one click I think. A friend tapped on the starter and it started...but I'm not sure whether the car just cooled down at that point. Took it to the garage and they said they couldn't find anything wrong (no surprise, right?) Now I'm afraid to take longer trips.
View 2 Replies
On my early 90's Corolla, when I turn the key to "on" but don't start the engine, the fuel gauge will -- for example -- read 1/4 full. It will stay at 1/4 indefinitely as long as the engine isn't running. Then when I start the engine and drive the car for a few minutes, I notice the gauge has gone up, so it will be reading 3/8 full within 5 minutes of driving. And I don't have to be moving, once it gets to 3/8, it says at 3/8 whether moving or idling at a stoplight. It has always done this, even since the car was new. It's not a problem, but I've always been curious what causes the fuel guaue to rise like this.
View 9 Replies
My Regency will randomly not start. No turn-over, interior lights nice and bright, all lights on dashboard come up. No security light shows up on dashboard thus does not appear to be security system.
Seems to occur more often when car is driven a short distance. Twice I have made short drives come back several hours later car does not start. I wait 7-10 minutes then try again and car starts right up.
View 3 Replies
We purchased a 1990 300 SL that has been cared for by all of the previous owners and runs excellent but recently the car developed a leak from the transmission. We had the local AAA shop replace the pan gasket. The car only leaks after being driven for a while and after being shut off not while it is running. The transmission shifts smoothly but we still can not locate the source of the leak? Could this be a hose or some other connection?
View 4 Replies
I have a 2003 Saab 9-3 convertible that is having intermittent starting problems. It seems to happen when the car has been driven long distances and the weather is hot or when it is raining. It cranks fine but will not start. When it is hot, I open the hood and it starts after about 10 minutes. When it is wet is starts after being cranked for a white. My mechanic has replaced the ignition cassette and the spark plugs and it has not fixed the problem.
View 4 Replies
I have a 1990 buick lesabre motor is a 3800 and it runs fine until the motor warms up and then when i shut it off it won't restart for about an hour after i shut it off. It's not over heating it has a new fuel pump.
View 4 Replies
I have a 90 gts celica, which the motor went in it, so i put a 93 5sfe into it. I took the old distributor out of the 90 5sfe and put it into the new motor. I wasn't getting any spark. So i replaced the distributor with a known good one. No spark. replaced the coil and igniter, no spark still.
View 10 Replies
Just acquired a 1990 celica gt at a steal lol and needing some troubleshooting answers. tonight was the first night we really had drove it, but my husband drove it to work which is an hour away and he noticed that when he comes to a stop the oil pressure light comes on. as soon as he starts to go again it goes off. the engine does not make any noises other than the typical 2200 lifter chatter and it does not leak oil.
We plan on doing an oil change so we are not sure if that could just be the issue or if it's something else. we had this issue with a dodge ram we had and it ended up being the oil pressure sending unit. he took the one off the car and it did need some tightening up but however when he put it back on the issue was still there.
We do not believe it's any low compression as the car cranks fine and normal with no rising of the cranking as you would get for a cylinder with low compression. we aren't really sure about the bearings because well that's not one of those things easily tested but the engine doesn't make a noise which I know at times you won't have one.
View 12 Replies
90 GTS - Manual Transmission. 5SFE
I have a vibration that rattles the cab of the car during start up. But if you get out, lift the hood and listen, you cant hear anything. Its only in the cab where you can even tell there's something not right. The motor runs great and seems very smooth to the touch and visually.
The vibration does seem to go down as the car warms up..... Somewhat....You can hear the vibration when driving and go down through slight dips in the road. Kinda like hitting the rumble strips on the side of the hwy.When I release the clutch and under power the vibrations go away. Under deceleration the vibrations are loud.After weeks of research, both TN and the web, I have done all this so far.
Changed Plugs, wires, cap. All four engine mounts were taken out, inspected, and 3 of the 4 were replaced from a donor car. All 4 looked good anyways....
Swapped harmonic balancer/pully from a donor car.
Compression check. 196 200 200 208
Cleaned IAC valve.
Pulled off exhaust manifold and verified CAT isnt broken.
Inspected exhaust from front to back and cant find anything.
Replace timing belt, tensioner bearing and idler bearing while I was in there.
Took both fan belts off and ran car to see if maybe power steering or AC, but car still rattled even though they weren't turning.
Did head gasket while building this car up because it was leaking oil from the front return tube area.
View 4 Replies
A friend has a '90 olds Ciera with the 3800 engine. The engine will quit running at a stoplight or almost any idle speed and then will be hard to start. May have to wait a few minutes before it restarts.
View 1 Replies
I recently took the engine apart and got the head resurfaced after the head got warped. New thermostat, waterpump, timing belt, serpentine belt, power steering belt, and gaskets for all sorts of stuff. After reassembling the engine everything worked fine. No strange noises. Only problem i am having now is that the cooling fan switches on really late, when the needle is 3/4 of the way towards H, sometimes even a little later. Fan is working as when i disconnect the cooling fan switch(bottom of radiator) and the fan does kick on. ECT was also replaced and nothing seems to work. I did replace the switch and the fans failed to kick on, unfortunately i got it from Autozone.This is a 1990 Celica GTS with the 5SFE 2.2L
View 8 Replies
