Toyota - Pickup :: 1994 Truck Idling At 2000 When First Start The Engine
Jan 25, 2011
My 94 truck (Toyota 6 cylinder 3VZ engine) is currently idling at ~2000 when I first start the engine. After warming up or driving for a substantial amount of time, this eventually drops to ~1000-1100. I had the throttle body removed and cleaned (twice). This stopped some up-and-down revving which was happening, but not the high idling. This is a relatively recent development, and I've gone to 3 mechanics AND the dealer, all of whom say, 'it's fine'. They say it should run 'a little higher when it's cold'.
I think some of these assessments were based on the simple lack of engine error messages (no codes from the computer = no problem). I admit that I'm no expert, but I've had the truck for a decade; I know what's 'fine' and what's not. The usual idle was ~800 (in agreement with specs) and I've driven this truck in temps down to -30F. It has never idled this high before. Since it gets close to normal RPMs after warming up, I don't want to turn the idle adjustment down. I moved from a very cold, very dry climate at 6000 ft to a very wet, moderately cold climate at sea level - is there some other adjustment I need to make? Or is it normal for this engine to run so differently in these two climates? I'm at the end of my rope since no one thinks it's a problem except me.
View 1 Replies
Advertisement
1995 pickup truck 2.4 liter 4 cal 4WD. I have a new problem- I drove out to a favorite spot in the mountains (up a dusty road) and when I got to the end of the road my truck was suddenly idling REALLY rough. I was able to drive it home and it runs "OK" as long as you stay on the gas (I say OK but it does want to die and especially wants to die after it warms up and then harder to restart until it cools)- as soon as you let off the gas the idle is on the extreme side of rough. It did not act like a fuel filter has historically (hesitate when giving gas), but I had a filter so I replaced the fuel filter anyway.
I also pulled the air duct work and cleaned it all out, put a new air filter in and used CRC MAF sensor cleaner on the MAF sensor. I did pour in a Chevron fuel system cleaner but it would likely take a tank full at least to work and it does not run good enough to run a tank full through. I put in all new plugs (gapped) and checked resistance on the plug wires and cap- all seems to be acceptable. I checked all the vacuum lines and did replace a couple that were dry and crumbly. I am now at a loss,
View 7 Replies
The temperature gauge on the dashboard is jumping around after the car warms up. It rapidly goes from cold to normal in an unpredictable pattern. It never goes over the middle. I have had both the engine and the radiator replaced in the past year!
View 3 Replies
Truck has many issues, among them loose steering. I took it in for a checkup, and it needs a new steering gear. How difficult are they to replace?
View 1 Replies
We had to jump start the truck and my buddy hooked up jumper cables wrong on his truck so I'm hoping the computer isn't fried. I turn the key and the only things that work are the door dinger and the dome light. Nothing on the gauge cluster and no radio. Dead silent when I turn the key to crank.
1994 toyota pickup 22re....
View 8 Replies
I drive my pickup (87 Toyota 4-cylinder carburetor 5-speed Xtracab Deluxe) occasionally. When it's sat for a week or more it takes a few tens of seconds to start. I bought a booster battery. The charging light comes on, but it goes out as soon as the engine starts. I'm used to hard-to-start cars charging for a while after a long start. The voltage coming out of the alternator is okay. The battery is new; the density of the electrolyte is right.
View 19 Replies
When I turned the key to start my car, I got zero activity from it. No ticking, no lights, nothing. So I tried to do a push start, and the engine wouldn't engage. I took the key out, and suddenly my dome light popped on (though it was dim). I put my key back in and turned it, and dash lights looked normal and at full power, but as soon as I pressed the clutch down and tried to turn the key, everything went dead. I took the key out, put it back in, and turned it, but got nothing.
I pushed my truck up to the top of an incline, and turned the key. All the lights looked normal, so I thought I may be able to push start it. Key was in proper position, clutch was engaged, and gear shift was sitting in first. I got a decent speed, released the clutch... and everything went dead.
I can't decide if it's my starter or my ignition system, though I suppose it could be the wiring, or even something else.
View 9 Replies
I have a 1994 Toyota Pickup DLX 3.0 V6 5spd. I love this truck to death since I inherited it from my grandfather.. however, I have a small problem. Whenever the truck sits for about 3 days without being driven; when I go to drive it the next morning, the clutch will go straight to the floor when I press it. Sometimes it'll even stick. After pumping it about 20 times (it's hydraulic) it'll be fine. It hasn't always done this. The clutch fluid level is fine.
View 4 Replies
My son has a 1994 Toyota Pick Up, and it suddenly developed a rattle noise, but only when he is accelerating. I suggested he check for loose heat shields, or a broken engine mount, fan rubbing on radiator housing, but all of this is good. He had a new timing chain put in 30,000 miles ago, and a new clutch. It has 167,000 miles on it. The oil does not have flakes or coolant. It does not make the noise when not in gear and accelerating. Could it be u-joints? He said is sounds like it is coming from the Lft Front, not the undercarriage. Fuel injected. does not overheat, or lug, or lack power.
2wd. 5sd tranny.
View 7 Replies
I have a 79 toyota pick up, that will not run. the engine turns but does not start. It has spark, though not the best should start. The carb is old but there is gas in the engine when i try to start. compression in all the cylinders is fine. A friend thinks maybe the timing chain jumped a tooth. I cant find the bright link on it so im having trouble knowing if that is the problem. What it could be?
View 5 Replies
My 1985 Toyota Pickup (manual shift) is stalling out when I put the truck in neutral or don't shift quickly enough. The battery light comes on after stalling followed by the oil light. After stalling, it does start back up and repeats the same problem. If I keep my foot on the gas and the truck in gear, it runs. I'm new to DIY repairs, and bought this truck for the purpose of learning more. I know the basics, am mechanically inclined, have a repair manual, and am a quick learner.
View 4 Replies
Ok, here is what happens to my car:
The engine wobbles when idling or at very low speed - some times the engine shuts down in stop and go traffic (very dangerous). Doesn't pick up speed when i try to accelerate from a stop position - the engine revs up and then the car lurches forward (suddenly) as the transmission seems to engage. The same happen when i slow down to almost very low speed and then tries to speed up. I also hear a kind of thud (transmission most probably).
The CEL is ON and some time blinks.
My OBD is showing the following codes: P0171 P0172 P1150 P0300 P0302 P0304 and P0306
View 6 Replies
I have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
View 6 Replies
My husbands GMC truck has an occasional ticking noise coming from the engine area. The noise happens when you crank up although it doesn't always happen. It will sometimes go several weeks without ticking/clicking. When it does start, the sound usually goes away after the truck "warms up" for a minute. The ticking/clicking does not change pattern when you accelerate. The mechanic said it just needed an oil change, but my husband has made sure to check the oil.
View 2 Replies
My Dad has a 1992 Toyota Pick-up with a 22RE engine it is a 2 wheel drive automatic. The truck stopped running while idling, he did code tests on it and they came up clear. He can get it to run on propane but not on gas. He did change all the spark plugs, distributor cap and rotor, and spark plug wires.
View 13 Replies
Got 10 gal. gas and pulled into drive-thru; idling in park, the engine stuttered once, then died. First retry it started, ran rough for 1 second and died; second retry i tapped repeatedly on gas and it ran VERY rough for 1 second and died, never to start again. It turns over fine. Where the fuel filter is to test pressure? BTW, it has nearly half million miles on it! 473k+
View 5 Replies
What may have my son fried by reversing the polarity while jumping the battery in his 95 GMC pickup? The smaller wire coming off the + terminal was burned through,so I spliced that. The engine cranks but there is no spark.
View 3 Replies
My 1994 Toyota Corolla idles at around 1500 and 2000 RPM just about anytime I drive it.
It is worst when I first start the car, and it gets better the longer I drive, however, it is still well above a normal idling range!!
I add oil regularly and do check the levels on most of my fluids on a weekly basis!
View 4 Replies
I have a 1997 Toyota Camry with over 200,000 miles. It is a manual: 5 speed. In the past few months it has started to idle at around 2000 RPMS, which is way too high. I took the car into a mechanic where I am currently living (Austin, TX), and they couldn't diagnose the problem, because, according to them, it didn't do it the whole time they had it. I admit, it doesn't do it all the time, but I know something is not right. It is beginning to idle high more frequently. How to diagnose this problem and to solve it!!
View 4 Replies
I bought a remfg denso starter for my 2000 toyota tacoma prerunner 3.4L V6. I spent hours without success trying to get the old starter out. Brought it to a shop and had the new one installed. When I do a cold start, there is a screech at the end when the engine catches that sounds exactly like starting a car that is already running. This happens on cold starts only. Warm starts work fine. Due to the fact that I bought this part separate, having to pay to have a new one installed again is annoying to say the least. I spent another 4 hours today trying to get it out without success. See YouTube link for video of the noise. It's actually the quietest one yet.
View 13 Replies
I have a 1994 Toyota Corolla, automatic transmission. I went to start it this afternoon and it made a clicking sound a few times then went completely dead. When I jumped it, the dashboard panels, radio, lights, doors, etc. began to work, but it still would not start. I have replaced the alternator about 1.5 yrs ago and had the battery checked then too (it was fine then). I have had this problem before about a year ago, but it did start when jumped. I didn't leave my lights on or any doors open, so I don't think I drained the battery.
View 2 Replies