The temperature gauge on the dashboard is jumping around after the car warms up. It rapidly goes from cold to normal in an unpredictable pattern. It never goes over the middle. I have had both the engine and the radiator replaced in the past year!
View 3 RepliesTruck has many issues, among them loose steering. I took it in for a checkup, and it needs a new steering gear. How difficult are they to replace?
View 1 RepliesWe had to jump start the truck and my buddy hooked up jumper cables wrong on his truck so I'm hoping the computer isn't fried. I turn the key and the only things that work are the door dinger and the dome light. Nothing on the gauge cluster and no radio. Dead silent when I turn the key to crank.
1994 toyota pickup 22re....
I have a 1994 Toyota Pickup DLX 3.0 V6 5spd. I love this truck to death since I inherited it from my grandfather.. however, I have a small problem. Whenever the truck sits for about 3 days without being driven; when I go to drive it the next morning, the clutch will go straight to the floor when I press it. Sometimes it'll even stick. After pumping it about 20 times (it's hydraulic) it'll be fine. It hasn't always done this. The clutch fluid level is fine.
View 4 RepliesMy son has a 1994 Toyota Pick Up, and it suddenly developed a rattle noise, but only when he is accelerating. I suggested he check for loose heat shields, or a broken engine mount, fan rubbing on radiator housing, but all of this is good. He had a new timing chain put in 30,000 miles ago, and a new clutch. It has 167,000 miles on it. The oil does not have flakes or coolant. It does not make the noise when not in gear and accelerating. Could it be u-joints? He said is sounds like it is coming from the Lft Front, not the undercarriage. Fuel injected. does not overheat, or lug, or lack power.
2wd. 5sd tranny.
My 94 truck (Toyota 6 cylinder 3VZ engine) is currently idling at ~2000 when I first start the engine. After warming up or driving for a substantial amount of time, this eventually drops to ~1000-1100. I had the throttle body removed and cleaned (twice). This stopped some up-and-down revving which was happening, but not the high idling. This is a relatively recent development, and I've gone to 3 mechanics AND the dealer, all of whom say, 'it's fine'. They say it should run 'a little higher when it's cold'.
I think some of these assessments were based on the simple lack of engine error messages (no codes from the computer = no problem). I admit that I'm no expert, but I've had the truck for a decade; I know what's 'fine' and what's not. The usual idle was ~800 (in agreement with specs) and I've driven this truck in temps down to -30F. It has never idled this high before. Since it gets close to normal RPMs after warming up, I don't want to turn the idle adjustment down. I moved from a very cold, very dry climate at 6000 ft to a very wet, moderately cold climate at sea level - is there some other adjustment I need to make? Or is it normal for this engine to run so differently in these two climates? I'm at the end of my rope since no one thinks it's a problem except me.
1996 Mazda Protege, 125,000 miles. Temperature gauge on dashboard moves very little.
Do I need to get this checked out, ie, if not what would happen? (I have had car in recently for other problems but no one n the shop mentioned it, even though they have had the car out for a drive).
I have a 2006 Jeep Liberty 2wd (V6-3.7L) that is showing an overheat on the temperature gauge on the dashboard. I replaced the radiator (which I noticed had pin hole leaks), the water pump, thermostat, and the temperature gauge sensor. The car is no longer running through coolant, but the temperature gauge on the dash still reads an overheat. I do not have any bubbling when the engine is cool, no white smoke, the fan turns on just fine, a/c and heater work, no visible leaks, equal heat from both rubber hoses to and from the radiator and fluid seems to be passing through them.
There is also no smoke and no weird sounds from the engine. The overheat on the gauge comes after about 10 minutes of operation and happens whether I am driving on the highway or stopped at light.The only thing that causes the temperature gauge to go down to normal is turning on the heater full blast.Is this issue just a short in a wire somewhere? Should I start thinking head gasket? If yes to head gasket, should I use the "sealants" that are out on the market as a temporary fix?
I've owned this Toyota Camry 2004 LE for two years now and this issue started couple of weeks ago , I the tempreture gague is always at cold , mean less than 25% . where it used to be always in the middle and at the 50% right in the middle . heat still works , have not tried AC yet , it is still in the 20-30s here in Minnesota . I am suspecting maybe a thermostat or some other heating cooling sensor somewhere .
View 5 RepliesI borrowed a friend's small Toyota truck for a few days of easy chores, and made a point to check the fuel at the beginning: the gauge showed 3/4 full. Four days and only 25 miles later, when I got in to return it, I noticed the fuel gauge was not working, I'm certain there's no fuel leak, I would have noticed that: the truck had been parked on my property the entire time, driven only a few hundred feet from one spot to another moving firewood around, so I would have smelled the gas if there was a leak.
When I added a couple gallons of fuel, the gauge didn't budge. Once on the road, I realized that the engine temperature gauge was also dead - no change on the gauge after 10 miles. So I have two non-functioning gauges which failed on my watch. This may not be directly my fault, but as my friend is kind enough to lend the truck whenever I need it, my contribution is to provide maintenance.
Is there anything in common between the two gauges which would explain the synchronized failure? Or is this total coincidence? This one is outside my experience, so don't know where to start. It's a 4 cylinder, 5 speed manual, base model truck, about 150k, generally runs just fine. There are no other gauges, and I don't recall what warning lights there might be, but I didn't see any after I realized there was a problem. Would the whole instrument cluster die at once, or could this be something like a bad ground for the cluster? I don't mind investing effort into tracking down and solving a problem, but if it needs a new cluster, that will cost more than I'd like to contribute, yet the problem occurred while I was using the truck (gently). My total use of this truck for all the times I've borrowed it is certainly less than 300 miles, so I'm reluctant to fund the entire repair if this is something that just comes with age.
I just bought a 1997 Toyota Tercel 5-speed stick, with 175,000 miles, and the temperature gauge moves from its lowest possible position to its highest possible position when the key is turned on, although the engine does not overheat, and no coolant is leaking or being burned. I replaced the coolant temperature sensor, but the actions of the gauge were not affected. I don't know if it is somehow related, but the heater blows cold, regardless the setting of the temperature dial on the dash. What I might try next?
View 3 Repliesis it possible to install an analog temperature gauge on a 2001 Toyota Echo? I live right on the Canadian border here in Mn. and it gets very cold. I have plenty blast from the heater fan but I don't think it's running warm enough. I had a new thermostat installed but it didn't seem to make any difference.
View 1 RepliesMy 94 Camry 4 cyl fuel gauge seems to be broke. It always shows empty. The "fuel warning" light doesn't come on however. The last time it worked, I had about 1/2 tank and filled it up. It took several minutes for the gauge to creep up to full. It worked for a few days and then when i started the car this evening, the gauge showed empty and tays on empty.
What is the most likely issue here? I've read that it could be the sending unit, bad wiring or the gauge itself. All other dashboard gauges are working fine.
The needle in temp gage on my 2005 Toyota is now facing the opposite direction. This happened right after the most recent oil change. Is this a gauge or a sending unit problem?
View 11 RepliesI've had a Scan Gauge II in the truck for the last 3+ years and usually have it showing ECT EOT FICM main power and volts. For all that time, my numbers have been normal until last month. With the engine up to temperature (ECT at 190 or higher), my EOT is lagging behind - sometimes 20* cooler. I've also noticed the EOT jumping around for no apparent reason.
From what I understand of the 6.0 cooling system, the oil is cooled by the coolant and what I'm seeing shouldn't happen if the engine is up to temperature. The obvious fix is to swap out the EOT sensor but I figured I'd ask the experts first. Any thoughts?
2005 dually crew cab with 105k.
Just about every trip i take my temp gauge pegs and dinger goes off and check gauges lights up in the message center. It eventually will go back to normal or if i shut key off and restart truck it goes to normal. im guessing it is the temperature sensor for the gauge but not sure?? If it is, where is the gauge sensor located?
View 14 RepliesCoolant temperature gauge bounce up and down.
View 6 RepliesI have a strange problem, my boost guage needle is jumping like crazy, there is no vacuum leak and the max boost i get is 0.5 bar, when the guage needle is not jumping I get a boost of 1.4 bar. I have mechanical boost control.
97' passat B5 1.8T AEB with FMIC,K04-15,2.75",chip (that was made for the original k03).
My wife left her overhead light on over the weekend and the battery drained. Once we charged the battery, everything seems to be just fine except the fuel usage gauge keeps jumping around at random. I reset the trip meters but that didn't do anything. What to do? This is a 2013 Prius V 2.
View 4 Replies1997 Nissan pickup 2.4 liter auto.gas gauge drop to all most empty when driving.then i can hit a bump in the road and it will go back to normal.
View 2 RepliesI've offered to do a basic compression check on a 22R engine, '85 Toyota pickup, which is apparently low on power, won't go above 50 mph. Yes it could be a multitude of things. Chances are it's several of them.
I have not yet heard it run. I'll consider myself lucky if I hear the uneven cadence of running on three cylinders.
My job Tuesday is to screen it for the most obvious things like a clogged air intake or air filter, choke stuck closed, worn spark plugs, etc, and do a simple compression test. I will again try to persuade the owner to take it to the skilled mechanic I've recommended, which he has resisted thus far, even though he's about to set off on a long trip through desolate terrain.
I already suspect low compression based on what the owner has implied, but also wondering about ignition timing and vacuum advance. This is a carbureted engine, so does that mean that it also has a distributor and needs to have the timing set? I have a timing light, but only vaguely remember the procedure...disconnect vacuum line from carb and plug hose leading to distributor? Any marks on the harmonic balancer to align?
Evidently it has a bogus exhaust system too - no cat - making me wonder if there's a problem there. I'm not going to get too deep into this, but if I can at least spot the problem I want to be able to convince the owner that there's a clear explanation, so he'll get it resolved.