Toyota - Pickup :: 1993 Won't Start / Even With A Push - Engine Would Not Engage
May 31, 2012
When I turned the key to start my car, I got zero activity from it. No ticking, no lights, nothing. So I tried to do a push start, and the engine wouldn't engage. I took the key out, and suddenly my dome light popped on (though it was dim). I put my key back in and turned it, and dash lights looked normal and at full power, but as soon as I pressed the clutch down and tried to turn the key, everything went dead. I took the key out, put it back in, and turned it, but got nothing.
I pushed my truck up to the top of an incline, and turned the key. All the lights looked normal, so I thought I may be able to push start it. Key was in proper position, clutch was engaged, and gear shift was sitting in first. I got a decent speed, released the clutch... and everything went dead.
I can't decide if it's my starter or my ignition system, though I suppose it could be the wiring, or even something else.
View 9 Replies
Advertisement
1993 Geo Prizm, manual transmission: Intermittent failure to start over a two year period, gradually becoming more frequent. The engine turns over every time the key is turned to start the engine, i.e. the starter motor/battery/battery connections work flawlessly. Once started the engine runs flawlessly without misses or shut downs. The only possible problem may be the engine idle speed that seems at times to be too high even after the engine is warmed up. Without predictability, the engine may fail to start when the key is turned.
Remember the engine still turns over normally. It just does not fire up. Two options exist for my predicament. That which is resorted to the most because of the speed of recovery: step out of the vehicle and push start the car by popping the clutch. The other alternative which I have been forced to utilize before because of the physical impossibility of push starting (i.e. if I had been able to push, I would have popped the clutch to start) at the time has been to wait for a protracted period and re-attempt to key start the car. This has been successful a couple of times.
View 1 Replies
I recently had a new engine and radiator installed in my 1993 toyota pickup. I checked the coolant and oil every day since the install, then drove it 250 miles or so without checking the coolant, and found that all the coolant was gone from the reserve tank, and there was a sludge at the bottom. I don't see any leaks, and the thermometer indicator was normal.
I don't understand where the coolant could have gone, given that it's a totally new motor and new radiator, new hoses. I'm worried about the competence of my mechanic, not noticing a dirty coolant reservoir and maybe messing something else up.
View 16 Replies
I was driving when my 1993 Toyota Pickup's brake and battery light came on simultaneously. As far as I could tell, nothing changed in the way the car was handling, nor any smoke, smells, or sounds. I was about an hour from home, so I continued on my way. After about half an hour, the check engine light popped on. I still didn't notice any change in the car.
View 11 Replies
I drive my pickup (87 Toyota 4-cylinder carburetor 5-speed Xtracab Deluxe) occasionally. When it's sat for a week or more it takes a few tens of seconds to start. I bought a booster battery. The charging light comes on, but it goes out as soon as the engine starts. I'm used to hard-to-start cars charging for a while after a long start. The voltage coming out of the alternator is okay. The battery is new; the density of the electrolyte is right.
View 19 Replies
I have a 79 toyota pick up, that will not run. the engine turns but does not start. It has spark, though not the best should start. The carb is old but there is gas in the engine when i try to start. compression in all the cylinders is fine. A friend thinks maybe the timing chain jumped a tooth. I cant find the bright link on it so im having trouble knowing if that is the problem. What it could be?
View 5 Replies
My 94 truck (Toyota 6 cylinder 3VZ engine) is currently idling at ~2000 when I first start the engine. After warming up or driving for a substantial amount of time, this eventually drops to ~1000-1100. I had the throttle body removed and cleaned (twice). This stopped some up-and-down revving which was happening, but not the high idling. This is a relatively recent development, and I've gone to 3 mechanics AND the dealer, all of whom say, 'it's fine'. They say it should run 'a little higher when it's cold'.
I think some of these assessments were based on the simple lack of engine error messages (no codes from the computer = no problem). I admit that I'm no expert, but I've had the truck for a decade; I know what's 'fine' and what's not. The usual idle was ~800 (in agreement with specs) and I've driven this truck in temps down to -30F. It has never idled this high before. Since it gets close to normal RPMs after warming up, I don't want to turn the idle adjustment down. I moved from a very cold, very dry climate at 6000 ft to a very wet, moderately cold climate at sea level - is there some other adjustment I need to make? Or is it normal for this engine to run so differently in these two climates? I'm at the end of my rope since no one thinks it's a problem except me.
View 1 Replies
I have a 2003 Toyota Tundra with about 57,000 miles and noticed that it takes more "push" to get the brakes to engage. (The brake pedal has to travel further towards the floor) There is no squealing or any other sounds and the brake fluid tank is almost full, I have not added any brake fluid or had any brake work done since I bought the truck in the fall of 2008. I am wondering what the problem could be and the possible cost involved to get it fixed. Brake Pads Wearing? Air Bubble? I'm not sure. This has been ongoing for about 3 weeks, but it doesn't seem to be getting any worse.
View 6 Replies
A friend is stumped by a problem with his truck, so I thought I might get some insight here. I haven't actually seen the truck, all that follows is from what he described, I'm just the messenger here.
The truck had been running fine on a used engine installed about six months ago. Then he ran it out of gas, it hasn't run properly since. It cranks fine, but won't start. He says it WILL start when spraying starter fluid into the throttle body, but only while the starting fluid is supplied. He also says he disconnected the fuel line somewhere near the engine, cranked the engine, and got good fuel supply (but no fuel pressure gauge reading). He's done some logical things: new fuel pump, fuel filter, spark plugs and wires. No luck. Figuring that he'd sucked something ugly into the injectors, he decided to replace those with no change (yes, I cautioned him about throwing expensive parts at it with no clear reason).
He reasons that he must be getting spark based on the engine running with starter fluid, and there must be fuel based on his test with the open fuel line, so he thinks it's an electronic problem, presumably the signal to the injectors. This is out of my league...and my friend is a carpenter, not a mechanic. If he could get a scanner would this kind of problem register a code?
View 19 Replies
My 1995 Toyota Camry will not start, the engine turns but does not engage. I have had the fuel pump, fuel filter, and a relay switch replaced. After each repair the car runs for twp weeks and then will not start. I have had it towed and the mechanics start the car with no problem and they are unable to diagnose the problem. In a month and a half, I have had the car towed 3 times.
View 4 Replies
My 2003 Toyota Camry LE has been running fine. Recently I parked the car somewhere for about 5 minutes and when I returned the car would not start, i.e. when I turned the key in the ignition the engine would not engage. I called the tow truck. The tow truck driver takes a look and tells me that she can hear the engine trying to kick in. She thinks the battery is fine, the alternator is fine etc. etc. So she pops the hood, takes a long metal rod, places it on the starter and gives it a couple of gentle taps. Then she asks me to start the car. I do and it works. She tells me that the starter was stuck and that what she did freed it up.
The car runs okay now but I am concerned as to whether this could be a sign of things to come. Should I take my car in the get the starter looked at or maybe replaced? The dealer says that a new starter will run me 350 bucks but also said that I don't need to come in unless it happens again. What does the community think? Do I have a problem or was it a one off thing that I can ignore for now? And I don't know if its important or not but the weather here has been starting to get colder lately. Could that be responsible in any way? I have about 81000 miles on this car.
View 11 Replies
I have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
View 6 Replies
My '93 Ford Ranger died on the road three days ago. The motor simply stopped. Battery is good. the engine will crank but it will not engage. Had it towed to my Shade-tree mechanic he is puzzled. Says that trouble code 5931111111 indicates an air conditioning problem but that doesn't make any sense. The truck is 4 cylinder 2WD.
View 1 Replies
My '93 Ford Ranger suddenly died while I was driving, no sputtering or bucking, it was just as though I had turned the key off. When i tried to restart, the engine would turn over but not engage. It's as though the engine is either getting no gas and/or spark. My shade-tree mechanic says he got a diagnostic code that was #539 followed by #1 seven times at two second intervals. he says he ran the test 6 times and got the same result every time. What this means?
View 10 Replies
The accelerator pedal on my 1993 Nissan pickup occassionally "sticks". Mainly when I'm leaving a (stop-sign/red light, etc) or if I let off pedal (in traffic etc) then push on it again to accelerate. I've changed the throttle cable (had a brand new one from brother in law...still in packing). I took it to Nissan dealership few years ago and they couldn't figure it out, same with a (highly recommended) local shop.
View 7 Replies
What may have my son fried by reversing the polarity while jumping the battery in his 95 GMC pickup? The smaller wire coming off the + terminal was burned through,so I spliced that. The engine cranks but there is no spark.
View 3 Replies
Santa Fe 2013. I bought it a few months ago and soon after a strange issue appeared from time to time. When I push the start/stop button it spins the engine but it wont start no matter how much I wait. Usually it start fine for the second time. This happens sometimes and sometimes not. About 2 months ago it didn't want to start for about 5-10 minutes no matter what I tried (push the button with the tip of the key), so I decided to go to a service station.
There they connected the car to a computer to check if there were any error codes logged. But they haven't find anything, after the second time I visited the station they replaced the battery in the key, told that maybe that was the problem.
I really don't know much about cars but it was a strange idea as I would expect the same behaviour when the battery is low than when the key is not present: Car not doing anything but displaying a message that the key is not present.
Anyway, it kinda worked, or I was lucky. For more than a month everything was fine, not a single issue. And today morning it started again. I brought my car to a hand washing, and after they cleaned the outside with steam they wanted to park the car inside the building to clean the interior, and the same issue occurred. And after that it happened with me as well several times this day.
View 21 Replies
Last week the coil went out. The housing had several cracks, and the heavy oil had filled the distributor cap. So the coil, rotor, and distributor cap were replaced. About 4 days later, all my engine would do was make a grating sound when I turned the key. My boyfriend said that it sounded like my starter had gone. It wouldn't start with hitting it or anything. So, he and I, while trying to save some money because we're both on disability, replaced the starter. Now, when I turn the key, nothing happens! We're pretty sure the battery is dead. We have it on a trickle charge right now. But a funny thing happened, all of a sudden the open door alarm started going off! The door had been open for several minutes when it started. So we think that it may be a short. The starter relay, when you look at it, has a spot of corrosion on the indicator. Tomorrow we're going to try cleaning them.
1993 Toyota Camry DX with 170,000 miles ....
View 4 Replies
I have a 93 Camry that quit on the highway. No spark, crack in condensor replaced distributer. Still not run. Rotor not turning, replaced timing belt, main engine fuse heating up replaced that. Now it starts right up but only runs 10 minutes. Then won't restart until several hours go by then it will start again. Runs like a champ when it starts.
View 1 Replies
The motor turns over but it just don't seem to have enough power to start. Have not tried to arc check from the plug wires. I believe the coil is internal on this model.
View 1 Replies
2001 Accent 1.5 GL 165K miles.
The clutch doesn't engage until it's on the floor. I have to push real hard to allow the gear to engage. It then shifts... sometimes smoothly, sometimes it takes a hard push of the gear shifter, or it grinds until getting into gear.
I've changed the master cylinder twice in about 3 years but those times the pedal had no spring and just fell to the floor and stayed. Now, the pedal has spring (I push it to the floor and it springs back) so I assume the MC is ok. I even bled it with fresh fluid.
I'm not sure if the tranny fluid has ever been changed. Would changing the fluid fix this problem or does it sound like I need a new clutch? I'm guessing it needs a new clutch (or corresponding parts) since I've had two MC's go bad in a few years.
The pedal, even when it's shifting smoothly is pretty non-responsive and still engages a little mushy (comparing it to my 2012 Elantra 6sp).
View 4 Replies
