Toyota - Corolla :: Front Crankshaft Oil Seal Leaking
Mar 19, 2011
I've got to replace a leaking front crankshaft oil seal. Haynes shows using a steering wheel puller with the two bolts installed, but without the center screw. Insert a socket and extension through the center screw hole. Hold the body of the puller with an adjustable to keep the crank pulley from turning while you loosen the pulley bolt. I've got an air impact. Would that hammer the pulley bolt loose without having to hold the pulley? I've also got a chain vise-grip, but I'm not sure yet if it would clear the other pulleys. Assuming I get this far, should I pry out the seal with a flat screwdriver wrapped in tape? Would it work to cut the rubber out of the seal first?
View 3 Replies
Advertisement
I have a 2006 Toyota Corolla with 183,000 miles on it. My mechanic noticed that the right front strut was leaking oil. In addition to replacing it recommended getting a strut mount installed as well. Is this an necessary component at the age of my car or can just replacing the strut do the trick?
View 14 Replies
When I took my Saturn L300 to the dealer recently for its regular oil change I was told that my right front axel seal was leaking and it will cost me $580 to replace. This seems awfully high to me. Am I getting fleeced by the GM dealer?
View 1 Replies
I've got an E4OD trans out of my 1994 F150 4x4. It has 145,000 miles on it. The reason why it came out was because the front seal was leaking terrible. Also the electrical connector for the transmission melted and there is a hole right there now. Other than that the trans shifted fine and worked when I drove it. My question is what can I do with the trans?
View 1 Replies
1977 F150 4x4 C6 transmission 351M
I just changed the front seal on my transmission, but its is still leaking as if I never did a thing? Did I miss something or is there something else that could be causing my problem?
View 4 Replies
I have a 1995 Celica GT, 5sfe engine, 5 speed manual. Front main crank seal appears to be leaking. I've replaced transaxles before but no timing chains or oil seals. Is the access from the wheel well and fairly straightforward?
View 2 Replies
I replaced the front mail seal on my 2003 Hyundai Elantra. It was running beautifully until I put it gear to take a test drive. It dumped half the oil in about a minute. After reading online that there may be a problem with the thrust bearings, I pulled the oil pan and found a thrust bearing in the pan. Is this something I could fix without pulling the engine. Every thing looks good and there are no metal shavings or signs of wear. The car has 170k.
View 2 Replies
2004 Hyundai Elantra. Working on crankshaft seal keeps coming out !
View 27 Replies
Replacing the crank shaft and camshaft oil seals on a 2001 - 2006 2.4L engine?
I'm in the process of installing a timing belt kit w/water pump, pulleys and all seals. My engine has 190,000 Km with no signs of oil in the timing area, but I figure the oil seal would be worn and or cracked/dried so it would make sense to change them, plus it was included in the kit.
View 2 Replies
I have a 2006 Ford Fusion SE (2.3L 4-cyl.) 5-speed Manual, with 280,000 miles on it. It's been a great car with very little repairs, etc. I've noticed a little oil on the driveway - nothing big, but certainly consistent. At my last oil change, they told me I had a leak in the crankshaft seal and that I should take it to an engine shop. I'm not a 'do it yourself' kind of person when it comes to big repairs. I'd love to keep the car going another year... If I don't fix it, should I avoid oil changes? The leak doesn't seem bad and it doesn't drive any different.
View 4 Replies
I have a 2006 gmc sierra, 4x4, 1/2 ton, has 155,000 miles on it. I recently changed both front hubs on my truck. They didn't have any play in them just noise. I had one new front hub that was leaking grease out of the rear seal. I took that one back off and got a new one. Must have had a bad rear seal. Now I'm getting a front end vibration at highway speeds. Between 70-75mph. It gets worse when turning left when highway turns. It goes completely away when turning right at highway speeds. It doesn't shake in the steering wheel. Feels like its coming from the left front area or left front tire. More in the floor boards. So i rotated my tires, and its not as bad but still is there in the same spot. I've checked everything.
Cv axles have no tears in the boots and aren't spinning out any grease. I turn the steering back and fourth while the truck was on the ground and I didn't notice any play in any of the front end components. The only thing I did notice was the passenger side inner tie rod boot had a bunch of grease built up on it. But the boot was actually full. Could one of the bad wheel bearings caused something else to go bad? Warped rotor? Truck doesn't shake or vibrate when braking either.
View 3 Replies
So I am on my way home after an honest 8, and I make it a mile down the road and goose the old girl a little off a stop light. Well next thing I know we have smoke rolling out under the hood, well it turns out the "smoke" was r134 refrigerant. The guy that recharged it said that the compressor failed and that its common with retrofits because 134a runs at a higher pressure.
Now I don't need a/c, and I might just leave it as is, but it would be nice to have the old girl working 100%. It also turns out that the front seal of the transmission is leaking, I am debating whether or not to just have the transmission rebuilt. it shifts fine but its gotta come out anyway. Its a 700r4 and the trans guy recommends stronger 3-4 clutches and a shift kit to make the holding pressure higher.
View 13 Replies
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 Replies
Couple weeks ago found some oil drops in the drive way so I got Underneath to see this disappointment. Hope the pictures come through for you all to see. She's been in the shop since Monday.
front crank case seal gone bad! what a mess.
View 14 Replies
I took the front axle shafts out a couple months back and remember NOT seeing any differential fluid in the axle shaft housing. But then when I took the tire off tonight.. I noticed diff fluid leaking from from the axle shaft dust seal ?
1. I didn't think diff fluid flowed up near those front dust seals ?
2. That's a brand new dust seal so I'm guessing some debri must be in the connection causing the leak ?
View 4 Replies
How hard is it to replace the front diff cover seal in an 03? Mine is leaking like a sieve... On a better note, it's the only leak I could find under my new-to-me Explorer.
Also found a broken coil spring in the rear, explains why it's leaning to one side. That is getting fixed later this week.
View 3 Replies
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 6 Replies
I had my truck at the shop today and it was determined that the transfer case front driveshaft seal is leaking and the gasket between the transmission and transfer case has also failed. The shop wants a reasonable amount to fix it but they need the truck for 2-3 days. It doesn't appear to be that difficult of a job to remove the transfer case. Am I missing something? Dropping off the truck and leaving it for a few days is the difficult portion......if they could do it in a day I'd just pay them and be done with it. So my thought was to pull it and just drop it off so they can replace the seals and fix any other issues.
View 1 Replies
After researching this for weeks, I think I've found that the pollen filter seal is worn and that's why I'm having water leaking onto my front passenger side floor. My car alarm has been going off randomly too. Every time it rains the floor is soaked. It's not the sunroof drain plugs. I already tried that. I need to fix this ASAP!!! How do I fix a worn pollen filter seal? I have a caulk gun ready!
View 11 Replies
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
View 12 Replies
I have a 2000 Toyota corolla with about 170,000 miles and it is using about one quart of oil every 500 miles. The last couple places I took it to said the compression was bad in the number 4 cylinder. Another place said it was a leaking head gasket. Which is most likely, and is it worth getting it repaired given its age and mileage?
View 13 Replies
