Toyota - Corolla :: 1998 - Brakes Are Squeaking And Grinding Often
Sep 13, 2011
We have a 1998 Toyota Corolla with 170k miles. The brakes are squeaking and grinding often. In Feb. the front brake pads were replaced, but the noises continued. In May, they replaced the front pads again, within a week the grinding and squeaking continued. Finally, I took the car in late July and had the mechanic drive the car around. He said the back brakes were making the "grinding" noise and the front was squeaking. He said it was "cheap brake parts". When he looked at the brakes he said the back brakes needed adjusting and may not be working as well, therefore making the front brakes work hard. This caused the front brakes to get hot and develop a glaze. He adjusted the back brakes and scratched up the front brakes. The car was fine for about 2 weeks or so. The sounds have gotten progressively worse and I refuse to drive the car. The brakes seem to work, but the sound is so terrible like something is loose, or off and scraping metal. We have used this mechanic for years with a recommendation from our neighbors.
View 4 Replies
Advertisement
I have a '98 5-Speed Corolla. If I rev the engine when the car is in neutral and warming up I hear an odd grinding noise when I let off the gas and the engine goes down to idle. The noise does not occur if I put my clutch in. Is this something to worry about?
Also, I'm wondering what CV joints sound like when they're failing.
View 1 Replies
Replaced both rear calipers about 4 months ago, both were frozen. A few weeks ago I started getting some bad squeaking from the front brakes. The front calipers seemed fine when I did the rears.
Tonight I had even more fun with the beast. Drove to my sons baseball game and felt an odd "grinding" when braking. *Seems* to be coming from the front. On the way home, the grinding was worse and then the fun really started. Hit the brakes and the wheels started hopping enough to shake the whole friggin' truck. Leaving from a light, you could feel the brakes stick and then release, next stop was more shake n bake.
Not sure where to start on this one.
View 10 Replies
Don't the stock brake pads go for more than 12k miles? The brakes are squeaking when I first pull out of my driveway and after a while it goes away, but at lower speeds (stop and go traffic) they still squeal a little bit, but when I am braking at higher speeds I don't hear anything. about a year ago my friend drove my car with the E-Brake up for about a mile. Could it be that because my rear drums are worn that my front brakes are getting worked more? But when I pull my E-brake up it still works fine without going up too much.
View 7 Replies
2010 LE is having a brake squealing issue. The car only has 35,000 miles and the pads are at about 50% life left. I cleaned everything and lubed everything and they are still squealing. I would hate to have to replace the front brakes this early especially when the pads are only half worn. They are the factory pads and rotors btw.
View 5 Replies
So originally I was told it was my front brakes going bad, which was the case. To address the issue, I replaced the rotors and pads awhile back and the noise disappeared for a bit. Fast forward a month or so ago and I hear an on-and-off squeaking noise when the brakes are applied. It does not happen every time. Usually when I ease onto the brakes to a slow stop.
Figuring it could be my pads going bad for whatever reason, I decided to check my brake pads and rotors again. No odd signs of damage on the rotors and by the looks of it there was still plenty of pad left. I then sprayed some brake clean assuming it could be dust but there wasn't much.
I have not touched the drums yet but I'm thinking it could possibly be the drums or a bad bearing? The car is a 2012 with 38k miles which is the reason I'm doubtful of it being a bad wheel bearing. What could it be?
View 7 Replies
A few months ago I did some work to my rear wheels. I replaced the drums, shoes, springs, etc., and (though this probably isn't important) the strut assemblies. All is well. Within the last few weeks, my right rear wheel has been squeaking and squealing when I brake and just today it is so bad I am afraid to drive it. It even started to squeak (just slightly) while I drive after I let off the brakes. I just pulled the drum off and it all looked fine. I did not see any metal rubbing the drum nor did I see any unusual wear on the shoes. What the noise could be?
View 5 Replies
I have a 1980 Toyota Cressida and I am having problems with the brakes squeaking at almost all speeds while braking. I have two week old pads on the car, when I installed them I generously applied brake quiet to the backs of the pads.
View 9 Replies
I have a 98 toyota 4runner. Limited, automatic transmission, 4wd, 6cly. 3.4L. Recently my 4runner was towed and after picking it up from the impound lot I went to test the 4wd. This model has a separate shifter for 4wd with an on the fly button which you press to engage 4hi. Well, when I went to test it the 4wd the light did not come on and I felt no "clunk" as I normally do when engaging the 4wd, (this is even after driving a few feet.) So I went to test the 4lo. I put the transmission in neutral and pushed the 4wd shifter forward to the neutral position as I tired to go one more to the 4lo position it began producing a horrible grinding sound. I didn't push the shifter all the way forward for fear of further damaging something so I went to put it back into 4hi and again this horrid grinding sound. Basically the 4runner was stuck with the transfer case in neutral? It wouldn't even go into park with out making this horrible sound, so I had to shut everything down and put it back into park and hi mode. When I turned it on again I tried it again and still the same result.The 4runner works just fine in 2wd. And eventually the 4wd light came on after driving a few blocks with the button pressed although, I'm not sure the 4wd was even engaged because I never felt the "clunk." It is still grinding when trying to shift into 4lo. Fluids are changed regularly and it is very well maintained. It has 228XXX miles.
View 3 Replies
My 2009 Toyota Corolla has started to make a grinding noise when starting. The sound is identical to when you try to start an idling car. What the problem is?
View 7 Replies
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.
View 4 Replies
I have 2009 corolla with 70000 miles on it. I replaced new brake pads. I have some metal grinding noise when i turn right only. I tried looking online and got few similar problem faced by other people. I am not sure if its exactly same issue. No accident damage. Mostly driven on freeway.
1) noise looks similar
2) I do not get noise when i accelerate
3) for car this old is it expected ?
View 5 Replies
When I start my car (usually a cold start) I hear a TERRIBLE grinding-like noise. Other times it sounds like a shuffling noise. And then other times it's like its over-exerting itself trying to start up. I've taken it to the dealer many times as it's a 2014 Corolla. They have no answers. The claim it's just a characteristic of the car. I call bull. This isn't normal for any car. My car has a CVT transmission by the way. Could it be the starter? Spark plugs? Note: the noise is about 1000x worse in winter. Audio is attached in separate comment.
View 19 Replies
I replaced the pads and rotors on my 1989 toyota camry yesterday. Took it out for a test drive and all appeared to be OK. I did not bleed the brakes, but did have to remove a small amount of brake fluid after installing everything.
On my way into work this morning there was quite a bit of grinding noise coming from the brakes. The noise was not consistent, happening both while brakes were depressed and also when not in use. It also would go away after a few minutes and didn't always happen while braking.
I'm thinking the piston may be locking up at times, but don't know. I'll also throw out there that this is my first brake job. I did follow my Haynes manual and don't think I did anything wrong.
View 8 Replies
I have an '04 Corolla with 206k with a slight grinding noise from the right front when I make a left turn. Is it the outer CV joint? The noise sounds like the tire is rubbing against a splash guard but it's not.
View 3 Replies
I recently brought my 2005 toyota corolla to my mechanic to give my car a check up as i will be going on a three week road trip soon.Upon assessment, my mechanic told me that my front right wheel bearing was making a strange noise and that i should replace it. I went ahead and had it replaced. after i had it replaced the front right wheel area was still making a grinding noise (louder than before it was replaced). I brought it back and he replaced it again with a new wheel bearing.
Again after the 2nd replacement it continued to make a load crunching, grinding noise when ever i brake the car. So once again, i brought it back. I thought perhaps it was my brake rotor and had him check that. He did just that and said the break was fine. He said it may be because the axl was not sitting true. so i had the axl replaced. well today i picked up the car and drove it approx 5 miles and the same crunching/grinding noise persists!!! I brought it back and it is once again being worked on. I need it fixed and am worried that my car won't hold up for my upcoming 4000mile road trip. I have attached a video clip of the sound to this post.
View 16 Replies
Our 05 Corolla, 160,000 miles, has started making a grinding sound when we upshift into 3rd, unless we let the rpms fall to below 1000. My husband said the clutch needed adjusting, but the dealer said this clutch is not adjustable. The dealer found nothing wrong and could not get the car to make the noise while in the shop. (It did actually get better for a while but got worse again almost immediately after the visit to the dealer.)
Our other car (a Saturn) has over 250K miles on the original clutch, so I don't think it's our driving. What could be wrong, and is this something that needs to be addressed soon lest we damage something irreparably? Also, this car has, since purchase, been nearly impossible to shift on the coldest mornings. Really, sometimes it is all I can do to get the lever in reverse to back out of the drive in winter (in Kansas). Warming up works, but it seems to take an inordinate amount of time before shifting is"normal."
View 3 Replies
Our 98 Corolla has recently become hard to start. Usually two or three starting attempts for a few seconds before starts and then idles roughly for a few seconds, then drives fine like it always has. Has 51k miles, oil changed regularly, 100k-mile tuneup/spark plug replacement not yet reached (maybe another 18 years, in 2034? Anyway, has performed great always until recently no longer starts immediately. Replaced battery, no change. Have BlueTooth OBD scan tool connects to Android phone - cool display, no codes, what to check, do next?
View 18 Replies
My 98 corolla has set for a year plus and the serpentine belt is stuck and will not let the motor turn over fast enough to start. The battery is fully charged, the gas tank is full, the belt is in good shape. The car ran just fine the one year I owned it before sitting so long. I sprayed the belt with belt dressing. Could the alternator or something else be stuck? Should I remove the belt and then reinstall it?
View 8 Replies
Just bought a 2010 Toyota Rav4 about 2 weeks ago. It rained the other day and the brakes made a grinding noise the first time I braked after starting the car but didn't make it after that. Did it again the same day, still raining, but only the first time I braked after starting the car. I have a 30 day guarantee on the vehicle and need to know quickly if the brakes are bad or not.
View 7 Replies
I was driving my car today, and I stopped at a stop sign. When I went to go, I pushed the gas, and my car revved up, moved forward, then all of a sudden it made a loud grinding noise (Like I was dragging metal sheets), and the gas stopped responding (but the engine was still running). The car still turns on, but whenever the gas is pushed, it doesn't go and makes that awful noise. What could be wrong?
View 2 Replies
