Toyota - Celica :: 1987 - Suddenly Revved Into Higher RPMs While Slowing Down
Jan 17, 2012
I was driving home from campus yesterday, and as I approached about 50mph, the Celica suddenly revved into higher RPMs, all the while slowing down. I pushed the gas pedal, which only worsened the problem. I was able to limp the car home. About an hour later, I tested the car again, and the problem remains: Accelerate to about 35-50, then get high RPMs while the car slows down and jumps forward.
I suspect a transmission problem, accentuated by a loose wheel bearing that I haven't been able to afford to get fixed yet. My Celica is an automatic, with about 213000 miles on it.
View 10 Replies
Advertisement
I have a 1987 Convertible Celica GT, with Manual Transmission. The car will not idle at lower RPM. I had someone look at it, and they have it where it will idle at 2000 RPM, but anything lower than that, and the engine will die when not giving it gas.
The engine accelerates great and runs great at any speed, but if you push in the clutch without giving it gas, it will die, unless the idle speed is cranked up like it is now. What this might be?
View 4 Replies
While driving with cruise control set at 80 mph in my 2002 Toyota Camry, the engine suddenly revved up to 4200 rpm while going up a hill on the freeway. I was wondering if this sudden high rpm could do damage to the engine? The car has 163,000 miles on it.
View 8 Replies
My 1987 Toyota Celica ST will not seem to turn over. When it has the push button addition that takes the power from the battery straight to the seloniod it works. But when i set the starter back up to the ignition switch and set it up factory style it will not spin over. it sends the 12 volts needed to start it but yet will not turn it over.
View 3 Replies
1987 Toyota Celica GTS 2.0 manual Transmission The Problem ... The power cable to alternator sparked on the side of the engine when I was connecting it. I did not think the battery cable was connected at the time but it was.. Now I have NO SPARK I have changed all the fuses at the battery could not find any that were blown but still changed them and checked all the fuses under kick panels none were blown. What should I look for now?
View 4 Replies
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 Replies
I borrowed a friend's small Toyota truck for a few days of easy chores, and made a point to check the fuel at the beginning: the gauge showed 3/4 full. Four days and only 25 miles later, when I got in to return it, I noticed the fuel gauge was not working, I'm certain there's no fuel leak, I would have noticed that: the truck had been parked on my property the entire time, driven only a few hundred feet from one spot to another moving firewood around, so I would have smelled the gas if there was a leak.
When I added a couple gallons of fuel, the gauge didn't budge. Once on the road, I realized that the engine temperature gauge was also dead - no change on the gauge after 10 miles. So I have two non-functioning gauges which failed on my watch. This may not be directly my fault, but as my friend is kind enough to lend the truck whenever I need it, my contribution is to provide maintenance.
Is there anything in common between the two gauges which would explain the synchronized failure? Or is this total coincidence? This one is outside my experience, so don't know where to start. It's a 4 cylinder, 5 speed manual, base model truck, about 150k, generally runs just fine. There are no other gauges, and I don't recall what warning lights there might be, but I didn't see any after I realized there was a problem. Would the whole instrument cluster die at once, or could this be something like a bad ground for the cluster? I don't mind investing effort into tracking down and solving a problem, but if it needs a new cluster, that will cost more than I'd like to contribute, yet the problem occurred while I was using the truck (gently). My total use of this truck for all the times I've borrowed it is certainly less than 300 miles, so I'm reluctant to fund the entire repair if this is something that just comes with age.
View 10 Replies
I got a 87 Toyota Celica 1600 GT, with a TVIS 4A-GE engine in.
My problem: when i just start the engine cold, it revs to 2500 RPM, and stays there for 1-2 minuttes and then falling to about 1500 RPM, and when the engine is completely warm my idle is about 1000 RPM.
first i think that 2500 RPM cold is a bit to much, and i dont know what to do with it. but my biggest problem is when the engine is fully warmed up, and i rev it to lets say 3000 RPM and then lets the gas of, the engine falls to about 500 RPM sometimes it stalls but if it not stalls then it would slowly gain some RPM and then it goes up to 1000 RPM again.
How can i prevent the engine falling that much when i let the gas off? it's quite annoying when i drive the car and comes to a stop it sometimes stall.
View 2 Replies
I have a 98 Celica GT convertible that had suddenly lost fifth gear, and what I mean by loosing fifth gear is not that it pops out of fifth or that it will not go into fifth, the gear shift lever goes into the fifth gear position just fine and stays in that position, yet the car responds as if it is in neutral. This is what happened while driving home recently. The first time this happened was within a week or so of having my clutch replaced, so I took it back to the mechanic that replaced my clutch.
Upon investigation he found that the nut that holds fifth gear in was loose. He tightened this nut and it fixed the problem for awhile. This was now over two years ago, and to make a long story short, I eventually ended up having to replace that transmission with another used transmission from a salvage yard. The current transmission has been in the vehicle just over a year and a half with no problems until now. I am getting this same problem again, with no fifth gear.
View 11 Replies
I recently had some brake work done on my 2003 Jeep Grand Cherokee (139k miles), and they installed a new master cylinder. The following day, I was driving (very cold these days) and noticed the car had difficulty getting into higher gears and the engine revved up but would not accelerate. I had to stop, put in reverse, and start driving again. Then, the engine light popped on (P1763 - Governor Pressure Sensor) and has remained on for three days. The car runs fine most of the time, but occasionally experience the loss of acceleration. What should I do?
View 5 Replies
After successful 4kwh install I was coming off interstate at 65 mph avg. when red light began to show on phev switch. Of a sudden the ice revved to 3700 rpm and loss of power. I was only able to get up to 25mph after red light. The ice continued to rev and of course the dash lit up like a christmas tree. I got to top of hill and pulled over and shut it down. I started it up and every thing worked fine except the red triangle and check engine light were still on and all the other lights were off.
I pulled into BachmanToyota about five miles further and their tech said this: "There is a code poa92 detail 606//adv there is a cust.modified addtional battery,in which we cannot svc." He cleared the code and I drove it home a total of about 60 miles and it is fine. What went on ?
View 2 Replies
I have a 2002 Hyundai Elantra GLS with over 215,000 miles. About a month ago, I started my car and it revved up & down from 2 to 4 rpm. I took it to my mechanic and replaced the TPS, thinking it would fix it. What to do next. My mechanic fixes cars, but doesn't do it professionally. I don't have the money to take it to a dealership.
Now, after doing a tune-up and changing out other sensors the RPMs came down to 3 and will stay at 3 rpm when I start the car. When I drive it, it pulls on it's own without touching the gas pedal and is hard to brake. What else I need to fix or replace?
View 6 Replies
Ok, I have a 95 F150 5.0. It's sat for 6 months with the engine taken apart. I just finished putting everything back together with a new alternator. Well, I pulled a bone-head move and forgot to connect the harness when I fired the truck up. Other than not charging though, it ran fine. When I connected the harness, it began to chirp and shudder at low RPMs and squeal and vibrate at higher RPMs and it over heated VERY QUICKLY.
So hot the case was too hot to touch and the pulley smoked the belt. The engine didn't even have time to get up to operating temperature. I've had the alternator replaced twice, and this last one tested good putting out 14.5 volts. The work I did on the engine was to replace the valve springs, install a direct drive timing gear, replace a spun harmonic balancer, bypass the smog pump because it froze up, new distributor, a new ECU and O2 sensor.
View 7 Replies
Ok, I was driving down the interstate in my 2002 Ford Escape XLT 4X4 and I noticed my rpm's reved to about 5000 from my cruising rpm of 2200 and it was as if it went into neutral. I coasted with engine running fine to the right shoulder and called a tow truck to the nearest dealer. No reverse, D, 2 or 1 only Park that worked.
View 14 Replies
I've been working on a 04 Buick rendezvous and it has a very loud high pitch squeal when revved past 3000 rpms. Along with a serious power loss when the squeal starts. Has a new power steering pump as of today. And I took the belts off and revved it and the squeal is still there. That rules out the squeal coming from the belts. It is coming from some where in the engine bay and I'm stumped. I was almost positive it was the power steering pump since it sounded like it was about to go. But alas it was not. I does a little squeak when first started but nothing when idling. I've heard of a squeal coming from a clogged cat and it blowing out the egr valve. The squeal is so loud that you can hardly stand near the car.
View 13 Replies
How do I replace the oil pan in my Celica? I have a crossmember directly below it.
View 2 Replies
Well I've been noticing that when I'm slowing down from higher speeds (50 mph or so) my steering wheel is shimmying a bit. Also I just started to hear my front passenger brake squeal a little. Well when I went to visually check the brakes, the pads seem VERY thick! Is it normal for them to start to go bad even with such thick pads? They are like 1cm thick. Also the rotors did seem used for sure, maybe 1mm worn down or so from the outer lip which is raised (I hope you understand what I mean), but they weren't scoured or anything. I suppose they could still be warped? I figured with such big brakes I wouldn't run into that problem. The car has 70k on it and the pads have been replaced once and rotors turned at 25k by the previous owner.
View 6 Replies
1987 Celica ST
3sfe
auto trans
Last week the rad cooling fan stopped working. The fan itself is fine. It spins when connected directly to the batt. Relay tested good, and fuse isn't blown. I unplugged the temp. switch connector, and grounded it to the batt. to test the circuit, and nothing. Switched on the A/C, and both fans spin. So, where else should I look for the problem?
View 1 Replies
I have an '87 Celica and it takes a good 10 seconds of cranking to start. After being parked only 24 hours, it's the same thing. It won't even give a hint of a kick until about the 8 second mark. Then it'll give a couple of sputters and eventually fire right up. Is this the fuel pressure regulator that's the problem? Is it not keeping the fuel at the rail pressurized properly when sitting? It's just annoying having to sit there cranking for so long to get going. I would think if it was the pump, it would give me problems when running.
View 5 Replies
Today my transmission suddenly disengaged while slowing down from 3rd to 2nd as if i switched to neutral.Car revved freely when i pressed accelerator. Then suddenly after a second it engaged again and shifted normally. Never had this issue before i racked up 1,29,000 KM on my ride.
I can't see it as "slipping" as there was no change in speed and it revved freely. Also I 'm due for fluid change. What can be the issue?
View 8 Replies
I have had my 8 month old Prius for a week. I have used cruise control fine before and after the incident. All of a sudden we started slowing down. Doing any thing on the cruise control had no effect. I canceled it. But every time I pressed the accelerator I just got the amber warning light come up and the car beeped at me and no acceleration. The cruise control didn't get the car going either. I had to stop on the motorway. Put the car into park then put it into drive and drove off fine and the car has worked fine since.
View 10 Replies
