Toyota - Camry :: 2002 - Clunking Sound Near The Front Left Of Car
Jan 26, 2013
My 2002 Toyota Camry started making a clunking sound near the front left of the car (and I could barely feel it, too) at low speed over slight bumps. My mechanic, who I trust, said I had two broken engine mounts. He replaced them. Sound continued. He said I needed new struts. He replaced them. Sound continued. Decided to take it to a Toyota dealer. They said I needed new lower control arm bushings but couldn't guarantee that was the source of the sound and they would just have to see. I opted to ask yet another mechanic, who said the control arm bushings are NOT the problem, but he would have to spend some time (could be several hours) exploring to find out what the problem is...at $70+ per hour. The car only has 86,000 miles on it, but I'm getting concerned that I might end up paying for a new car without the new car smell if I keep spending money on "possible" causes.
View 12 Replies
Advertisement
I've been trying to track down this clunking sound, its only really happening when I am going at about 30-40mph speeding up or slowing down in that vicinity..
Its a light clunk clunk sound that seems to be coming from the front left of my car...
It cant be the struts, because I've just put new ones in a few months ago... What could it be? some sort of CV joint or bushing?
View 10 Replies
I've had a rattling/clunking sound from my front left wheel recently so I jacked up that corner. As soon as the tire elevated off the ground the bottom fell inward. I could easily push the top of the tire inward and pull the bottom of the tire outward. Does this lead to a bad hub or bad ball joint(s)?
View 10 Replies
I changed the front brake rotors & pads on my wife's 2009 Toyota Camry & everything seems fine except when doing sudden or slightly hard stops it seems to do a clunk/knock type sound from the front brakes. It also only does it sometimes not every hard/sudden stop.
One thing that comes to mind is that when I went to tighten one of the guide pin bolts it was a real pain, the big bolt that the screw threads into kept spinning making it hard to tighten the bolt into & none of the others did this. I thought I tightened it down but possibly not?
View 5 Replies
Over the past month or two, I've noticed a clunking sound coming from the front brakes when you apply the brakes. It seems to only happen when you're backing up and after the car has sat a while.
View 3 Replies
My girlfriend's 2002 Honda Civic. Whenever she and I make a turn in it, a clunking sound is heard and felt on the front passenger side in the area of the floorboard, and it seems to come from an area between the seat and the wheel well and seems to be getting slowly but surely/progressively worse/more noticeable as time passes. I checked underneath the car earlier today, and there aren't any observable leaks to report anywhere.
View 4 Replies
I have a 1999 Toyota Sienna. For the last year or more, at times -- especially when going over small bumps -- there's a rattling sound that sounds like it's coming from the left front wheel. The steering is tight and there's no vibration in the steering wheel itself. My mechanic checked everything -- including the brakes (and the caliper pins). I am not eager to replace the struts on the hunch this might be the cause, because it might not be, and that's expensive, especially on an old car which we don't drive much.
View 4 Replies
My 2005 Camry started to make a, for a better work, "grinding" noise that appears to come from the left front side. It seems to appear around 40mph. Other symptoms:- the noise is not present when the car is in park even when revving up the engine- the noise appears to be correlated to the car/wheel speed - if placing the shift in neutral, the noise does not change while the speed doesn't change- if starting in 2nd gear, the noise only appears around 40mph when the engine is about 4500rpm.
Here it is a little hard to distinguish as the engine masks it- if switching the the 3rd gear, the noise does not change- if switching to "D", the noise does not change- coasting at neutral at more than 40mph still gives out the noise- when going over higher spots in the road (when the load of the wheels is reduced) the noise intensity goes down
There is no (or very low) noise at low speeds. Also, no noise when taking sharp turns. Had both front wheel bearings changed and the break pads, and the noise did not go away. I will be taking the car to a transmission place soon.
View 6 Replies
I have an '02 Camry with 82,000 miles. I recently noticed a clicking from the front left wheel starting at 68-70 mph. The click varies in frequency with slight bumps in the road. It seems to stop if I touch the brakes, and it might get less if the road turns enough to increase the G force (not too many times on highway going this speed on a curvy road, so I'm not sure.) It never happens under 65 mph.
We recently had local flooding and I drove through about 8 inches of water. The noise was a few days later in dry weather at 80 degrees. It did not occur when the car was starting off cool, but not until I was driving for about 5-10 minutes. The tire and wheel look OK, but it has not been on a lift nor have I been to a mechanic yet. I don't want to get talked into expensive repairs that I don't need, but I don't want to put off something now that is dangerous or will turn into a bigger expense later.
View 2 Replies
2002 Volvo S40. My son bought his first car. It was inspected a week before he bought it, and has about 50,000 miles. It seemed to drive fine when he purchased it, but after a few days, he heard a squeaking/ chirping sound (that seemed to be coming from the left front side of the car) when he accelerated. The sound stops when he brakes hard. He took the car to a mechanic who told him that he needed new brake pads (front and rear).
He replaced the front pads, but the sound persisted. He went to another mechanic who told him that the pads were not put on properly and smoothed the rotor. The sound decreased for a short time and then returned. The mechanic says that the rotor looks fine, but is now recommending that he replace it since adjusting the brake pad and smoothing the rotor is not working.
View 7 Replies
02 Camry 261 thousand miles coming home yesterday on deceleration loud noise coming from front left front end drove two miles very very loud pulled in the driveway. does not make much noise on acceleration but very very not when coasting. I believe the left CV joint has gone out.
View 3 Replies
My car begins to shake violently and hum loudly at anything over 70mph. It used to be 80mph but it has slowly gotten worse. I have checked the motor mounts and none appear to be cracked or broken. I have also had tires balanced and replaced, rims replaced, and the problem continues to persist. I was curious if the right axle could be warped? or this issue may be caused by damage wheel bearings. At any rate it has gotten unbearable decided to finally extinguish the problem.
View 10 Replies
I applied brakes while car was moving slowly, less than 10 mph, and heard loud grinding sound coming from left front as car stopped. Shifted to reverse and car barely moved, less than 1 foot, which was accompanied by the loud grinding sound, then stopped. I could find nothing interfering with the wheels but did find pieces of brake pad on the ground along the path the left front wheel had followed. The left front wheel appeared as if the calipers were holding whatever remained of the brake pad and/or backing tight against the rotor. brake pad fell apart on 2002 at 43,561 miles...
View 19 Replies
I have a 2002 camry 4 cyl. I bought at 65,000 miles. I drove it for 2 years and had a clanging sound that would come and go. My timing chain needed replaced because the sludge in the bottom of the pan clogged up the tube taking the oil to the chain. I religiously changed the oil every 3,000 miles, but I still get sludge. Is this an engine that was recalled by Toyota?
View 3 Replies
2002 toyota camry 4 cylinder. I noticed that when I close the hood, right after I close it I hear a sound like a small amount of liquid is being poured (it doesn't sound like much, maybe as much as half a shot glass worth). I did it about 10 times and I don't see anything dripping onto the ground or under the hood. It sounds like it's coming from near the radiator (although with the hood closed it's hard to tell, also radiator is new with maybe 10,000 miles on it) I noticed it after changing my oil. What the sound could be? Something to be concerned about? There are no other problems with the vehicle.
View 16 Replies
I've noticed a clicking sound from the front end of my car. It occurs when I apply full left lock. I have a 2002 Camry V6 XLE. Could it be the CV joint???
View 2 Replies
I have a klunk/rattle in the drivers side front end when I go over a small bump at a slow speed. The dealer said it was the struts - they replaced them along with the upper support thing. Noise still there, next they said it was a worn motor mount - noise still there --
View 1 Replies
We have an '02 Toyota Camry with about 92,000 miles on it that is making a weird intermittent "Whooping" noise. The sound starts low and then goes high. It seems to come from the dashboard or the steering column I think.
A guy at the parts store said he thought it might be radiator core going bad, but admitted it's hard to know without him hearing it.
I've tried to record the "Whooping" sound but obviously the car never makes it when I'm trying to do this or can be easily heard on a recording. Additionally we took it to a mechanic and they didn't hear anything!
View 3 Replies
I have a klunk/rattle in the drivers side front end when I go over a small bump at a slow speed. The dealer said it was the struts - they repleced them along with the upper support thing. Noise still there, next they said it was a worn motor mount - noise still there
View 1 Replies
I have a 2000 Camry, 4 cyl. It was in an accident on the front right before I bought it. I took it to Sears for alignment and 4-6 adjustments were made to pull it to within spec. One evidently is not correctable (the caster). After I bought it and after the alignment, I replaced the sway bar link, as the upper ball and socket was very loose. The problem I am trying to solve now is when I turn at low speed, I get a sound like a plucking of a large rubber band. (BUNG) I jacked and blocked up both sides and turning both ways all the way made no sound or play, and nothing is touching like the wheel well plastic or other parts. Then, I lowered the front right (where the accident was) to put weight on it, and it no noise when turning. When I lowered the left side also, there was still no sound. No sounds or shaking at 50-60 mph.
View 5 Replies
I need to replace the rubber axle bumper guards. I have a clunking noise from the left front going over bumps. Troubleshooting I found the left front axle bumper guard is missing, right side is missing chunks and dry rotted. I had a question about how they attach. The one that is missing looks like a rusted bolt snapped off. Is it safe to assume a bolt goes right thru the center of the bumper guard into the frame? Couldn't tell on the right side it is in bad shape. Right front bolt may have sheared off on the bottom and just held in on the top by what is left.
View 5 Replies
