While raising both front doors windows, both windows stopped moving. Checked power locks and they didn't work either. Manual said to reset circuit breaker for this problem but where it's located and the manual doesn't specify either. Just need to know where the circuit breaker for the power windows and locks is located.
View 1 RepliesWe have an 86 Chevy Silverado C10, all of the lights work on the truck except the headlights. We have replaced the switch, it has new head lamps. We hear that there is no fuse for these lights, that there is a circuit breaker but how to locate it or if it is really the issue. How to get the lights back on?
View 2 RepliesTroubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 RepliesI have a 2000 Taurus and recently the power windows and power locks stopped working. They won't work from any door switch but when I use the key fob to unlock or lock the car the locks will work. However, the windows won't work from any door switch. I didn't see a fuse marked for the windows or locks.
View 3 RepliesI have a 2003 jetta GLI (vr6 6 speed) that i received from a friend because of some body damage to the doors mainly. so i replaced the doors with some from a 2001 jetta glx, but the power windows don't work with the switches inside the car. However, when I put the key in the door and turn it, all of the windows will go up and down...(So the motors are good and they are getting power) the door locks, gas cap lid, trunk, sunroof all work and the interior lights work as well.
So i researched it and everyone said fuse #14 or ccm... so i replaced the fuse.... multiple times now just to make sure... After that didn't work, i bought a new ccm with the same part #. that didn't work at all... still same problems... I was wondering if maybe the new doors are or aren't CAN-BUS? if that even matters?
White 1997 Explorer XLT 4 door 4x4 4.0 sohc 220,000 miles. The power windows and locks don't work. I've tried all of them in the whole car and nothing. Replaced all fuses at the inside panel and replaced all fuses and relays under the hood. Replaced master control switch on the drivers side and still nothing.
View 1 RepliesI've searched the inter tubes, trying to find out if there is a fuse or relay or even circuit breaker that needs replacing. From all I've checked, I can't find a fuse, relay or circuit breaker labeled to control window and door locks.all 4 windows don't work (with exception to front passenger window occasionally goes down but not up.)finally figured i should have come to this fine forum first! (especially after hearing 'car talk' today)some other pages with similar questions had answers referring to fuse #12 or relay F (mine aren't identified that way). I'm heading out to get a test light -- just so i can see if i can test anything...
View 13 RepliesI have an electrical issue on my 2007 F150.
The drivers door electrical switches (windows/locks/mirrors) have all stopped working. The locks on the other doors work but not the windows.
I have replaced all fuses with no luck. I'm thinking it's either a ground wire or the accessory delay relay.
We've got a 2006 Civic EX Coupe, and the power windows and power door locks have both stopped working. If I can remember correctly, they kind of faded out over the course of a few weeks, working intermittently then not working at all.
All window and door lock fuses (interior and under the hood) are still good.
What this could be? Is it something DIY fixable? I've removed door panels for random stuff, but haven't really done much with power window electronics.
All at once my power locks and windows on all doors and the power mirrors quit working. The Driver Info center also says "Unknown Driver" when I start the car. After that happened the check engine ligth came on and when I went to get that checked there was no power to the ODB port (not sure if it is related or separate). Also, the brake, ABS, and traction control lights are on...they have been so I'm sure that is a separate issue.
View 1 Replies1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
We just replaced an injector in my truck. Everything was fine, ran great, etc.
On the freeway home, the dash, windows, locks, radio all quit working. at first they'd stop and come back, stop and come back, etc. then finally they stopped. As I was getting off the nearest exit, the truck started dying on me. Once I got pulled over out of the way, it acted like the battery was completely dead.
After a few minutes of scratching my head and staring under the hood, I happened to look at the passenger side batter, and the crossover cable from the drivers side was broken off right at the terminal!! We must have broke it off while doing the injector. as I look closer at it, it had been broken before. Some idiot before me had actually taken a broken crimp style terminal, shoved it and crimped it into a new one and called it good.
I was able to redneck it back together so i could finish the last couple miles home. I fixed it properly with a new crimp terminal, heat shrink, etc. Why did the engine die with the crossover connection broken? was it because the series was not complete, and all the electronics were running off the battery(s) and not the alternator? I'm really confused. I've heard of people only running one battery before.
2006 F150 5.4 2WD extended cab tow package 24k miles
My power windows have stopped working from all locations. I checked and the fuses are good. I can no longer use the exterior keypad to unlock the truck, yet my remote keyring switch will electronically open both driver and passenger doors. Neither driver's nor passenger's interior door switches work.
So, I have a 2005 Toyota Camry remote locks have not worked for a while. Also started having the issue with the two front doors where the manual electric locks worked intermittently. I replaced the little RC car motors in the door lock actuators today and got that squared away so that works great now. I also ordered a new remote to program. I programmed the remote and everything seems to go fine with that (The locks cycle when they are supposed to etc.). However, once I program the remote it just doesn't work.
So, trying to figure out what is going on here. Should I just return the remote and try to get a different one...but would it even program if it the remote where not compatible.
Also, read some about about a Door control receiver module. which that is basically a wireless receiver right? I would think if it could receive a signal and cycle the locks during programming then it should work normally??
I drove the car for years and just did not worry about it but have passed it down to my teenage daughter and would like her to be able to unlock the doors while approaching the car so she can just hop in and go without having to fumble around with keys.
I have a 2007 Camry LE and the locks on the passenger doors and back doors stopped responding to the remote key UNLOCK OR the driver side UNLOCK button. I have to manually unlock the three doors. However, the key LOCK and driver side LOCK button works fine. The issue is only with the unlock. I had the same problem couple of years back and it became alright on its own. Now am having the problem again. The strange thing is that, sometimes it all works fine and sometimes I have the issue. Whenever I click on the Unlock button once, the driver side door unlocks. When I click it again, i hear the sound in all the doors and also the indicator light flashes / I hear the beep sound. But the passenger door and back door doesn't unlock.
View 6 RepliesWhat this thing is on the top of my power steering pump? It has 2 vacuum hoses going to it, "is it some sort of booster"? Fluid is leaking from this thing and I don't know if it can be tightened or replaced.
View 9 RepliesThe motor turns over but it just don't seem to have enough power to start. Have not tried to arc check from the plug wires. I believe the coil is internal on this model.
View 1 RepliesI have a 2011 Camry LE and recently both rear door locks stopped responding to any form whether using the key fob or driver door controls(I have to manual lock and unlock the rear doors)However the rear windows work fine, which indicates the rear doors receiving power. This is really inconvenient. Looking for a clue to what's going on? Only the front doors (driver and front passenger) are operating properly.
View 10 RepliesI also have a 2000 boneville and over the winter i discovered that those same three windows/locks/courtesy lamps doesn't work , I have went through all the fuses which are fine , I will call the dealership and check on the BCM. I also have the wet floor problem. But no sun roof, I read that it may be the connector under the pass seat, I see a connector above the carpet, could that be it or is it located under the carpet...
View 8 RepliesMy brothers window won't work from any of the switches and the locks won't work they only work from the driver side no window action though from either side, checked the fuse and relay but nothing.... 1996 Ford Escape 4wd....
View 1 RepliesLately I've been having issues with my windows, door locks and power mirrors not working. Here are the symptoms;
What works;
Driver window Sunroof Key fob unlock/lock (Also all of the doors unlock when I open the door)
What does NOT work;
All passenger windows (they were working intermittently before but now none of them work) Door locks from any panel (Sometimes I can unlock the doors but can never lock them) Side view mirror controls
Seems like it could be a faulty ecu. Plan on removing the door this weekend to inspect everything.