Toyota - 4runner :: Steering Wheel Turns A Little Bit When Pedal The Brake
Dec 7, 2011
I have my Toyota 2000 4 Runners having a slightly problem. When I paddle the brake at the Stop or traffic light, the wheel turns (mostly anti-clockwise) a little bit like 10 to 20 degrees. It doesn't turn all the time but especailly when the car is going slightly downhill such as when I paddle the brake and stop from parking lot onto the main road. The road is a little dip down or sometimes in front of the traffic light and it was slightly inclined. I don't know if this normal or not.
View 7 Replies
Advertisement
A 2000 Toyota 4Runner was stopping fine. A mechanic informed me that the brake pads were worn down. After the pads were replaced and bled the pedal sinks lower than before and the car requires more pressure to stop. I can pump up the pedal after 3 pushes. I took it back and he has since re-bled the brakes but the pedal still sinks low.
View 15 Replies
After some off-roading and hit some pretty big bumps at speed, and now my steering wheel is about 15 degrees off, but the car is not pulling.
I am in another country where I don't speak the language well, so what should be done to fix this. I took it into the shop, and they pulled the car onto some electronic sensors and said the alignment was fine. They did a very visual inspection (glance?) under the car as well, and were ready to send me on my way.
I showed them that the steering wheel was off, and their solution was to just take off the wheel and put it back on straight. Is this what should be done to fix this problem? I do believe the alignment of the cars is okay because it's driving fine, but I'm still not sure if there is something else going on that caused the steering wheel to be knocked out of line. I've been doing some online searching and I'm not so sure that they are doing the right thing.
View 2 Replies
I have a 2005 Toyota Avalon. When you turn the wheel it will make about 1 1/2 turns to the right and then locks, but when you turn left it will turn almost 2 1/2 full turns, if you move you will hear what I believe is the tire rubbing, haven't done it since I first noticed this problem. What could be causing this?
The alignment and everything seems fine on the car and there is no other issues with the steering. Just that the wheel turns too far to the left.
View 8 Replies
The CEL on my 3.0l 93 4runner intermittently turns itself off and on. I have had it to a shop and got error code 25 and error code 26. (If the numbers are wrong the codes meant lean/rich mix. The first time this happened the shop replaced the O2 sensor. When the light came back on the shop said the problem was the "mass air flow (something)". The shop ordered a new MAF and after testing the new one and the old one decided the MAF was not the problem. At this point I'm just ignoring the light and driving the vehicle. The vehicle does seem to run just fine.
View 11 Replies
I bought a 2010 toyota camry se. I have the most annoying vibration in the steering wheel, seats, gas pedal. Have taken it to several places, including a Toyota dealer.. They seem to not be able to find the cause. I've had wheels checked, balance, aligned, rotated. There is also an annoying clonking noise coming from the front passenger assembly. It's very sporadic as in only goes away when trying to have a technician hear it.
View 8 Replies
When I have to push on the brakes for a hard stop, I can feel the brake pedal and the steering wheel shake a whole lot. Also, he ABS light is on. Correlation between the 2 obviously?
View 10 Replies
I bought 09 GX-470 4K miles ago..has 50K on it. Ran perfect when we bought it. wife said it started doing it 1 week later. I drove it and felt like warped rotors to me. replaced front rotors and pads with cheap wearever brand...I Know...I was sort of trouble shooting..did nothing ...did the back rotors and pads and seemed to fix it..did proper bed-in of new parts but, never checked at speeds above 55mph. recent trip got us up to speeds above 55... at these faster speeds when brakes are applied we get a nasty wheel wobble and a pulsing pedal...braking below 55 it feels fine.. thought's ?? last car was a 4runner which has the the same rotors and pads and never had a problem...could it be ABS ?? should I go with new oem rotors and pads ?
View 10 Replies
I had a front brake job done on a 2002 Dodge Dakota pickup at 85000 miles. When I stepped on the brake, I felt pulsation in the pedal and a sort of wobbly feeling in the steering wheel. Also the brakes were making noises while driving. Classical sign of a warped rotor?! Long story short brand new rotors, brake pads and calipers, later the pulsation is mostly gone but the braking is still not smooth at one point while the tires are turning. Now i do have to older tires on the front but i just bought two brand new tires for the rear. Would it be wise to put the new tires on front to see if there might be some unevenness caused by the old tires before i take it back to the shop?
Also the feeling of the brakes catching on one point seems non existent or so minimal I can not be sure if the road surface interfering while driving slow of applying the brakes gently. But slowing down from higher speeds (above 40 mph) and using more then gentle braking ( not standing on the pedal with both feet) it is definitely there. Before the brake job braking caused the steering turning right. (sign of more braking action on the right - right?). Now with new stuff still pulls to the right but not as strongly. Should not this disappear with the brake job? Or get the new tires on front and see what gives?
View 9 Replies
I have an 04 6.0 psd and if I am stopped in drive with the brake pedal down I can't turn my steering wheel at all. If the truck is in park and my foot off the brake pedal I can turn the steering wheel both ways just fine. When I am driving I don't have any problems with the steering. I have checked the power steering fluid and it is full. This makes it kind of hard when I am trying to pull in and out of parking spots. What could be causing this and what the solution would be to fix it?
View 10 Replies
2001 F350 XL... Fitting on PS pump broke and I lost PS and PB with fluid everywhere. Replaced the hose with a new one from Autozone and I have no noticeable leaks.
I know I lost more than a quart but I could only add less than a quart (Mobil 1 Synthetic ATF). I'm also getting a whine from the steering wheel when I turn stop to stop. The power steering is back and there are no leaks (that I see) but the brake pedal is mushy. I've pumped and turned stop to stop for a while. Do I have to bleed the system like I'm doing a fluid flush? I hate to waste the synthetic fluid that I changed about two years ago.
View 7 Replies
Along with the many other quirks of my 98 Toyota 4Runner, whenever I have to hit the brakes suddenly and hard it takes my car at least 30 seconds to become responsive to the gas pedal. When I try to accelerate, I can hear the engine rev, but the car doesn't move. Is this a brake issue, or could it be a transmission issue? I have 230k on it.
View 8 Replies
My son and I were coming down the mountain on I-70 near Georgetown, Colorado in a snowstorm in his toyota 4runner. We had just gone through the Eisenhower Tunnel. There was alot of traffic, and driving conditions were terrible. We were traveling approximately 10 miles per hour when my son told me that his brakes were not working. We downshifted, and then slid into the guardrail on the median (we were in the left lane). Luckily we were not hurt, and we did not hit anyone else. Once the car was towed back to Denver, the brakes worked again. My son is getting the car checked by a mechanic, but why the brakes gave out and how he can avoid that happening in the future? Was it related to the cold weather (approximate 10 degrees)? I did not feel that he was riding the brakes as we descended. The road was icy at the time.
View 19 Replies
My 2003 Toyota 4 Runner with 104K miles recently started showing a brake light off and on. The brake fluid reservoir was at the minimum level and there was some residue leaking from the bottom near a silver disc. Took it to a mechanic and was told it was most likely the master cylinder leaking brake fluid. Is this normal wear and tear or is it unusual in this vintage vehicle? I do not notice any brake slippage at this point. Should I take this to the dealer and ask why this master cylinder is faulty? I thought Toyotas were long life vehicles?
View 2 Replies
2014 4Runner SR5, 4k miles... It is sporadic, but here in the Midwest the weather is frigid. Is it normal for brand new pads to squeal right when I pull out of my driveway? It goes away, but I never had this with any other vehicle.
View 6 Replies
My car has about 180K miles on it and it's a manual transmission. It's a champ, and I love it. But sometimes when you first drive it ( not sure if it's only when the weather is cold, but I don't think so) if you are sitting at a stop with your foot on the brake then engine surges up and down, if you take your foot off the brake it stops.
View 3 Replies
It seems to be coming from the front passenger side wheel well area. It's only present during braking and coming to a stop. Seems to be also related to wheel speed. The brake performance doesn't seem to be impacted but it's very embarrassing creaking through a parking lot. The noise doesn't seem to be present on a cold start but once the brakes warm up it really comes to life.
I noticed with both wheels up off the ground that the front passenger side wheel (The side making noise) had more resistance than the drivers side when trying to spin. [URL]...............................
View 1 Replies
I have a 2000 Toyota 4 Runner with 115k miles on it. While in Colorado a month ago, we were driving down a snow covered hill and some guy banged on the window telling us the right rear wheel wasn't spinning. We put it in reverse and it rolled fine that way but still didn't when we headed back in drive. I goosed it a little bit and it went "bam" and drove fine after that.
We were in 4 wheel drive at the time. Last night it happened again. I put the vehicle in drive and it wouldn't budge. I goosed it a little again and it went "bam" and drove several feet until I stopped. It froze up again for a few more minutes. It was NOT in 4 wheel drive this time. Is it time to dump this thing or get a new transmission in preparation for the inevitable?
View 3 Replies
I have a 1991 toyota 4runner with 4wheel drive stick shift and it has been making a loud rrrrrrrrrrrr sound. It seemed like it was coming from the front right wheel or somewhere close to that area, so I checked the brake pads and rotor for rocks or any other object that might have gotten stuck. There was nothing stuck, however I did notice that the boots were ripped. So I changed both front axles and I also replaced the wheel bearing only from where the noise appears to be coming from. The noise is still there. It makes the noise sometimes, if i'm going slow or fast. Other than that, the car drives well.
View 2 Replies
Passenger side rear brake light works when lights are off, but does not when lights are on. In looking at both lights while on, the passenger side seems to burn much dimmer than the driver side.
View 4 Replies
I have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 Replies
