My 1990 Toyota 4runner won't stay running after I changed the air filter. Starts up for couple sec then dies. It ran the same morning then had problem after changing filter.
View 2 Replies1999 4-runner 6-cylinder. starts and then immediately dies.
View 2 RepliesI've got a friend with a 1990 Toyota 4Runner Manual transmission with ~170k miles on the clock. He's been having an issue for quite some time that he hasn't been able to be resolved. Basically he's got an issue with the vehicle erratically NOT starting when it is hot outside. The vehicle starts fine when it is cold outside, but when it is hot he erratically (only happens sometimes) get a "click" noise from the engine compartment with no engine turn over or anything. He is then at the mercy of the vehicle and sometimes just has to try multiple times or wait it out for awhile and try again. Sometimes just opening the hood, looking around a minute, closing it, and re-trying is able to get it to start, but other times not. Other times, and I quote from him, "sometimes i just get really upset and stomp on the clutch, get out of the truck and just shake/rock it, sometimes that'll do it." It happens if the engine is cold or hot, it only matters that it is hot outside, above ~90 degrees. Below is a list of stuff that has been done to try and resolve the issue, but hasn't really worked.
Steps taken:
Replace Battery
Replaced the Alternator 2 years ago
Replaced the Battery Connectors (some were corroded)
Possible Starter Replacement within the past 5 years (double checking paperwork)Rewired jumper wire from battery to starter
Seems sensor or solenoid related to me, but I'm unfamiliar with this vehicle/quirks.....
I am getting fumes in my 1990 4Runner SR5 6 cyl. I believe them to be exhaust or oil burning, not fuel. The condition does NOT exist when the windows are closed or when the fresh air vent is open or closed (recirculate).The fumes exist in the cab only when I open a window (driver side), and is mitigated some when I open the fresh air vent. This may mean that the leak is not coming through the ventilation system. What could be causing this?My mechanic says it is worn valve cover gaskets, dripping oil onto exhaust system and finding its way into the cab, it does leak oil. This may be true, but how are the fumes getting into the cabin the first place? The fumes came on suddenly, after a rear window repair at the shop - unrelated?The vehicle has been inspected by a muffler shop, no issues with the exhaust or manifold system.The fumes are inscrutable, not strong enough to easily detect, but persistent exposure gives me a headache and dizzy feeling, and then I get polluted enough, that I cannot really smell it anymore, hard to trouble shoot.Interior smells of exhaust, even when parked.?
View 4 RepliesI have a ’90 Toyota 4Runner with a 22RE fuel injected engine having 176000 miles. Cold start is fine and idles normally. However, after it has warmed up (hot soak) it will still start right up but will run rough and die unless I give it gas to 2000 RPM and hold it there for 5 seconds or so. Then it will return and hold normal idle. There is also a strong smell of gas. Basically it floods. I have replaced the distributor cap, rotor, spark plugs and distributor itself then ran two cans for fuel injector cleaner through it. I also disconnected the Cold Start Injector Timer Switch thinking that was the problem. Nothing had an effect. Compression is a little low in all cylinders (expected with this mileage) but nothing drastic. One last thing I don’t know if it deserves mentioning. The muffler has something broken inside because it rattles loudly. I have not gotten to that yet.
View 2 RepliesI have a 1990 Toyota 4-Runner, manual 5-speed transmission. About a week ago, while shifting gears, I heard a loud "popping" noise from the general vicinity of the clutch. I did not feel anything different in the clutch, it returned to the appropriate position and didn't feel any more or less "loose." However, after the "pop" it seemed difficult to get the vehicle into first gear and second gear, and I really had to "push" it to get it into gear, but it would not grind or anything else. Also, when shifting into reverse, it would grind loudly and be very difficult to get into reverse gear. If I turn the vehicle off, put it in reverse and then start the car, it works fine, though it seems like it "sticks" longer in reverse and takes a bit more muscle to get it out of reverse and into first again.
Additionally, when the shifter is in first gear, but the clutch is pressed, it seems as if the clutch is not disengaging entirely, because the car wants to move forward slightly when I take my foot off the brake, almost as if I'm letting my foot off the clutch a bit with it in gear. All of this has been happening pretty regularly, but the car has still been driving fine. However, today, the poor thing wouldn't start. This vehicle (like many manual transmissions) needs to have the clutch pedal pressed in order to start the vehicle. Even when I press the clutch all the way to the floor, the car won't start (and I know it is not a starter/battery issue). Given the other problems with the clutch and shifting gears, it almost feels as if the clutch was not getting disengaged all the way even when the pedal was pressed to the floor, and now that it won't start, I'm wondering what is going on. Does this model have a linkage adjuster that needs fixing? Is it something wrong with the clutch fluid? Or do I need a new clutch entirely?
I've had my car die twice on me lately. There is absolutely no warning - no sputtering, rough-running- just dies completely. I am still able to crank the engine after this happens, but it won't start immediately. After five or ten minutes, it will start and then run fine. 1990 Celebrity. what this could be and how to fix it?
View 1 RepliesI have an 1990 Toyota 4Runner. V6 engine. Automatic. 4wd. Today it blew an upper radiator hose. A few seconds after the initial pop of the hose and the spew of fluids the vehicle died. I replaced the upper radiator hose and the lower hose- and refilled the antifreeze. There are no leaks as of right now.
The engine will not start. The belts spin whenever the key is turned on. But the engine will not crank. You can hear the starter trying to start it up. Jumping the vehicle was of no luck. Charging the battery was of no dice.
The vehicle makes a whirring noise (belts spinning) when key is turned, but the engine does not crank at all. The noise stops as soon as you shut the key off. The oil is clean and full still.
I have a 2000 v6 Tacoma.Three days ago I could only get it up to 60mph. Then it started running fine.I drove it about 100 miles an no problem I drove it a litte the next day with no problem.The third day I could only go about 40 mph.I changed the fuel filter and it ran fine. I went out to start it and it would not start. It has spark. I also unhooked the fuel line and it shot gas every where. Hook the gas line back up and nothing. It will turn over and not start.
View 30 Repliesi have an 87 toyota 4runner with the 22re last week the starter stuck on and drained the battery and burned the starter up so i replaced the battery and starter and now it will start and run for about 3 seconds and run out of gas
View 5 Repliesi have a vibration that starts about 45mph."When i put it in neutral it still vibrates". I did check the universals. Rig has 195,000 miles on it. Manual trans. It must be lifted because im running 265/7516s on it. Ive been busy changing fluids and such so i have been underneath it but didnt look for lift or factory.
View 9 RepliesI have a 90 toyota celica st. I was driving it the other day and it died on me while driving... twice! The second time was going down a steep hill and it was freaken scary for a minute as the breaks were not working, the car started again and I was able to stop! Anyway I know enough about cars that once your car starts it should not die. Could it be the alternator? It seems to start up just fine. I did notice though that when the car died on me both times I was taking a pretty sharp right turn. And when it died every thing blinked twice then out went everything. Im sure that it is a code for something but I do not have the owners manual as I was not the original owner. I just started it up today again and it makes a weird clicking noise before I even turn the key.
View 4 Replies1990 Toyota Camry.4cyl Starts normally drives about 50 or so miles and dies. It will not immediately restart. Turn off the ignition key for a few minutes and it starts back up and may travel 1 mile or 10 miles before it dies again. It appears after the first failure the interval between stalls gets shorter and shorter until the car is left alone over night. the next day i get 40-50 miles and it stalls. I loosened the fuel line at the filter under the hood and during the period it wont start there doesn't appear to be any fuel pressure. Is there a more acurate way to test if the fuel pump is failing or the sensors that control it are?
View 4 Replies'91 Toyota 2wd Pickup, 22R-E Engine. 1 yr. ago out of the blue it would start and idle, but if I give it any gas it would die. Shop had trouble figuring it out, then replaced Mass Airflow Sensor; problem re-occurred after once after this repair, but could not be reproduced at shop. 1 yr. later, driving along and engine quits without any warning. Very hard to start, but restarts once, drives about one more block, dies. Unable to restart; engine will crank and catch, but after about 1 second dies. Tried unplugging Mass Airflow Sensor; no change. Left sitting overnight, next morning it starts right up. Problem seems similar to a year ago, though this time it wouldn't start and idle, it would just start and immediately die. In every instance it was rainy/slushy and cold.
View 8 RepliesI own a 1996 Toyota Celica. When the car is cold it starts and run for about 5 minutes then dies. When I try to start the car, with the key in the 'on' position, I have no check engine light. If I crank the engine and release the key to the 'run' position, the 'check engine' light turns on. When the car is cold or I leave it to rest for a couple hours and I turn the key on the 'check engine' light turns on. it is after the car stalls out i have this problem. At this point if I spray some starter fluid into the intake the car attempts to start. I thought that it was the pump so I installed a new one. Fuel pressure is good. It seems to me that the injectors are not working.
Is it the computer? Given that fuel is getting to the injectors but the injectors are not firing, Given that I have ignition since when I spray starter fluid into the intake the car fires up and runs until it runs out of starter fluid. Where do I start? I have not used a noid light as yet to check the injector harness and as you all know the harness is a little difficult to get at because of its location under the intake.
2009 Toyota Camry LE 4 cylinder. Our car got flooded last week. Water only got inside to the floor mats and we vacuumed it out. Now the car wont start. It starts and then dies right away. Only when I remove the key from ignition and restart it comes on and goes off again. I was thinking about changing out the ignition module with key. Checked all fuses and they are OK.
View 6 RepliesI have a water leak in a 1990 4runner (3vze) at the back of the block i called the dealership and they said the headgasket had been done, i noticed this leak because the water is well orange rust colored to be exact my 4runner needs a new radiator but that's kind of self defeating until i fix the leak at the back of the engine, what it could be? or how to check if its the headgasket, the oil doesn't appear to have any water in it,i believe it's coming from above the head but there isn't much clearance between the injector plant and firewall.
View 13 RepliesHere' the low down. I have a 90 4runner v6 4wd. It is intermittently making a loud rubbing noise in the front right of the truck. It starts randomly and sometimes stops on its own or will start when I hit a bump,it will stop when shifted into 4wd, or when I brake or turn hard to the right. but happens only a portion of the time. took it to mech, he removed front drive shaft and said prob went away, it seemed the vacuum pump or the solenoid that activates shifting out of 4wd is defective. So he manually switched off the 4wd replaced the front shaft and all good! but on my way home the noise began again. super frustrated, 3rd mechanic in a week.
View 1 RepliesWhen to change the air filter for ICE? 10,000 mile? Does the Gen III need to change the transaxle fluid? if so, what is the service interval? I am putting a lot of miles on my new Prius. Really want it to serve a long time.
View 16 RepliesI have a 2009 Lexus ES 350. For the past couple of months since having my air filter changed at Jiffy Lube the air conditioner won't come on and there's a message on the screen that says to check the air conditioner connection. I took it to Lexus to check and they only gave me an estimate of charges for $384, but no explanation of the problem. What might be wrong and the cost to repair?
View 2 RepliesA friends car broke down. He has a 1990 ford escort. It would turn over, but would not crank. I took a look at it and the timing belt was off. Replaced it today, and the car is still turning over but not cranking. The timing is set right, its getting gas, and its getting fire. What else could be causing it to turn over but not crank?
View 19 Replies