Toyota :: 1991 Pickup Quit When Turned On AC
Nov 4, 2012
I have a 91 Toyota pickup. Few weeks ago setting in drive through truck quit when I turned on a/c. This happened coup,e times then next time I drove it ran fine. Then it stopped two days in row after driving 20 min. Truck would crank but shut down immediately. Waited few minutes and cranked and drove home no problems. Now truck will only run few min. Before stopping and if I turn on fan or lights the truck stops. Swapped battery from another vehicle but did not fix. Alternator seems to be charging fine, checked with meter output 14.5 volts charging. Checked for codes and no codes.
View 2 Replies
Advertisement
'91 Toyota 2wd Pickup, 22R-E Engine. 1 yr. ago out of the blue it would start and idle, but if I give it any gas it would die. Shop had trouble figuring it out, then replaced Mass Airflow Sensor; problem re-occurred after once after this repair, but could not be reproduced at shop. 1 yr. later, driving along and engine quits without any warning. Very hard to start, but restarts once, drives about one more block, dies. Unable to restart; engine will crank and catch, but after about 1 second dies. Tried unplugging Mass Airflow Sensor; no change. Left sitting overnight, next morning it starts right up. Problem seems similar to a year ago, though this time it wouldn't start and idle, it would just start and immediately die. In every instance it was rainy/slushy and cold.
View 8 Replies
I was driving yesterday and my Toyota pickup started losing power. If I let off the gas at a stop it would rapidly die. I managed to get it home but had to floor it just to get it going in 1st and 2nd gear, and if it was in neutral it would die without giving it a lot of gas. The only way it will start is if I give it a lot of gas while turning the ignition, and have to keep the RPM's up to keep it running. Looked under the hood while it was running and when I let off the throttle the entire motor would shake violently. Cant tell if it's just not getting fuel correctly or if it blew a head gasket maybe. Seems like it might only be firing on 2 or 3 cylinders.
View 3 Replies
I have a 1991 V6 automatic Toyota pickup. The transmission has ~230,000 miles, but the engine has been rebuilt and probably has less than 5,000 miles on it. I am having overheating issues in both departments.
Engine overheating: This has started fairly recently. My truck began overheating at idle (usually at longer traffic lights) and would cool down again once I began driving. My coolant was low, I took it to a shop, and they fixed a small leak. Fast forward a few weeks and it happened again, and this time when I turned on my heat full blast to take heat off the engine it blew cool air until I started driving. Took it back, they found no more leaks, and couldn't duplicate the overheating symptoms. They also said the fan and thermostat seemed to be working fine. It seems to happen sporadically, regardless of coolant levels.
Transmission overheating: Firstly, my truck tends to delay/hard shift when I first start it in the morning. Once the engine warms up it goes away for the most part. I took it on a 100 mile trip camping on a fairly curvy/hilly forest highway and the A/T Oil Temp light came on. This has happened before when I took it on forest roads, even after a recent ATF flush. Needless to say I had to stop a few times to cool it off. It felt like the transmission was working too hard at a flat 60MPH (2,500-2,800RPMs). A couple times the RPMs were pulsing like it was switching gears back and forth. The next day driving in town everything was back to working order.
I'm not sure if these two things are connected... but they never happen at the same time. I'm taking it to a transmission shop but I want to make sure they don't try to rip me off unless absolutely necessary.
View 3 Replies
I have a 91 Nissan pick up that is just making a clicking noise upon trying to start it. I replaced the battery. The inside light works, radio works, dash clock works, but still just clicking upon trying to start. Is there a clutch safety switch that could cause this, or starter, or ???
View 8 Replies
I have a 91 Honda civic hatchback base model 1.5L and I am having serious electrical problems. My wife took the car to town and when she got back all the lights quit working and it just sits there and clicks if I don't remove the main relay. But the main relay also controls the fuel pump. Have already replaced main relay?
View 2 Replies
I've offered to do a basic compression check on a 22R engine, '85 Toyota pickup, which is apparently low on power, won't go above 50 mph. Yes it could be a multitude of things. Chances are it's several of them.
I have not yet heard it run. I'll consider myself lucky if I hear the uneven cadence of running on three cylinders.
My job Tuesday is to screen it for the most obvious things like a clogged air intake or air filter, choke stuck closed, worn spark plugs, etc, and do a simple compression test. I will again try to persuade the owner to take it to the skilled mechanic I've recommended, which he has resisted thus far, even though he's about to set off on a long trip through desolate terrain.
I already suspect low compression based on what the owner has implied, but also wondering about ignition timing and vacuum advance. This is a carbureted engine, so does that mean that it also has a distributor and needs to have the timing set? I have a timing light, but only vaguely remember the procedure...disconnect vacuum line from carb and plug hose leading to distributor? Any marks on the harmonic balancer to align?
Evidently it has a bogus exhaust system too - no cat - making me wonder if there's a problem there. I'm not going to get too deep into this, but if I can at least spot the problem I want to be able to convince the owner that there's a clear explanation, so he'll get it resolved.
View 19 Replies
I have a 2003 Toyota Tacoma pickup. I bought it used in the spring of 2009. I drove it for a few months without any problems and one day this problem developed. It won't start on the first attempt. Or it will start and then immediately die. It will take two or three tries to get it running.
I took it in to my mechanic and he couldn't find anything wrong. I got a tune-up anyway and it drove like a champ. Until the next day when the problem came back. This persisted for a few weeks more and then went away.
This last summer it started happening again and continued up through October and went away again. I think the problem seems to happen when it's hot in the summer.
View 6 Replies
My 1992 Toyota pickup (138,000 mi) started popping out of first gear today. How big of a problem is this and what needs to be done??
View 4 Replies
I have a 1986 Toyota pickup. It's small 2 wheel drive with a stick shift. 6 weeks ago, it started lugging very slightly on hills after I had first started the car (only in the first 5 minutes of driving). Then that stopped, and now it loses power on hills so that I have to keep shifting down and going slower until I'm chugging uphill in 2nd gear at 30 mph. It only happens on long hills with a sustained uphill; smaller ones it keeps speed and power fine.
View 2 Replies
I recently had a new engine and radiator installed in my 1993 toyota pickup. I checked the coolant and oil every day since the install, then drove it 250 miles or so without checking the coolant, and found that all the coolant was gone from the reserve tank, and there was a sludge at the bottom. I don't see any leaks, and the thermometer indicator was normal.
I don't understand where the coolant could have gone, given that it's a totally new motor and new radiator, new hoses. I'm worried about the competence of my mechanic, not noticing a dirty coolant reservoir and maybe messing something else up.
View 16 Replies
I have 2009 tacoma pickup w/10k After starting fine and driving a few mins. and turning off it will not restart for aleast 10=15 mins. All the instr. lights come on like normal.....but it will not crank nothing? no starter noise ...nothing I contacted my dealer The service guy said (never heard that before)....
View 3 Replies
When adjusting valves on a 1986 22RE Toyota engine, the manual says to adjust intake to .008 and exhaust to .011 when the engine is "hot". I was doing some research and it seems to be a somewhat common practice to adjust valves on these engines to .007 intake and .011 exhaust when the engine is cold. The explanation being that the clearances will open up some when the engine warms up or gets to "hot". I always thought the clearances would get tighter as the engine warmed up but my "knowledge" is based on traditional pushrod engines and this is an overhead cam engine. If adjusted cold, will the clearances get smaller or larger when the engine is hot? And is it ok to adjust the valves cold? And how hot is correct amount of hot if I adjust them according to the manual?
View 11 Replies
I drive my pickup (87 Toyota 4-cylinder carburetor 5-speed Xtracab Deluxe) occasionally. When it's sat for a week or more it takes a few tens of seconds to start. I bought a booster battery. The charging light comes on, but it goes out as soon as the engine starts. I'm used to hard-to-start cars charging for a while after a long start. The voltage coming out of the alternator is okay. The battery is new; the density of the electrolyte is right.
View 19 Replies
I have a 1990 Toyota pickup. I've been told to always put the brake on when I park. The brake is a hand lever under the dash that I pull out and then to release, I push a button, pull a little and then push. Yesterday I got into the truck and went to release the brake and it was stuck. I had my foot on the brake, and it was in 1st which isn't out of the norm for how I start the truck. I did notice that the handle seemed loose. I eventually got it back in after starting the truck again and putting it into first and trying to pull forward with the brake on. I'm concerned that if I use it again it will stick again and not go back in! What has happened!?
View 5 Replies
The temperature gauge on the dashboard is jumping around after the car warms up. It rapidly goes from cold to normal in an unpredictable pattern. It never goes over the middle. I have had both the engine and the radiator replaced in the past year!
View 3 Replies
When I turned the key to start my car, I got zero activity from it. No ticking, no lights, nothing. So I tried to do a push start, and the engine wouldn't engage. I took the key out, and suddenly my dome light popped on (though it was dim). I put my key back in and turned it, and dash lights looked normal and at full power, but as soon as I pressed the clutch down and tried to turn the key, everything went dead. I took the key out, put it back in, and turned it, but got nothing.
I pushed my truck up to the top of an incline, and turned the key. All the lights looked normal, so I thought I may be able to push start it. Key was in proper position, clutch was engaged, and gear shift was sitting in first. I got a decent speed, released the clutch... and everything went dead.
I can't decide if it's my starter or my ignition system, though I suppose it could be the wiring, or even something else.
View 9 Replies
Truck has many issues, among them loose steering. I took it in for a checkup, and it needs a new steering gear. How difficult are they to replace?
View 1 Replies
I was driving when my 1993 Toyota Pickup's brake and battery light came on simultaneously. As far as I could tell, nothing changed in the way the car was handling, nor any smoke, smells, or sounds. I was about an hour from home, so I continued on my way. After about half an hour, the check engine light popped on. I still didn't notice any change in the car.
View 11 Replies
I have a 1988 Toyota (4 cylinder) Pickup truck, with a very intermittent starting problem, that is driving me crazy. It has had the starting problem for over a year now. Normally is starts easily, within one second with the starter motor, no gas needed, and it starts smoothly.
When it has the problem, I turn key, and I only hear a click, and the dash lights are lit, but no starter motor sound.
Early on I would call for a tow truck, but it usually started when they arrived.
I got angry one time and turned the on and off rapidly, nothing. Meditated for about 10min to calm down. Nope, still angry, so turned the key rapidly again, and the starter motor engaged, but the engine didn't start.
So I did that again and gave it some gas, then a lot of gas. The engine was running very rough, like all cylinders were not firing, then it spews out a huge cloud of blue smoke, and the engine evens out. That's my usual pattern now: turn the key like crazy wait a few minutes or even an hour, and keep trying.
It is usually fine for 2 to 7 days with no problems. But a couple of times it has had the problem twice in the same day. The problem seems to happen most when the engine is cold, or after a short trip. A few times, it has had the problem even after a long trip, when the engine was still hot.
What has been replaced in the last year? In this order: starter motor, battery, hot lead to fuse box, battery terminal clamps and wires, fuel pump, mass air flow (don't know what that is), catalytic converter, and master relay. (OK the master relay probably isn't related because rain water leaked in and dripped on the fuse box in the cab.) (Also it has 133,080 miles, and a rebuilt engine put in 4 years ago.)
After the mass air flow and catalytic converter change, the truck has started with no problems for 3 months. Now the problem is back! Same symptoms.
When they last worked on the truck they did a tune-up and they said the starting problem could have been caused by the starter motor not being lined up properly so it would "jam". That would explain why the starter motor wouldn't go, but it doesn't explain the miss-firing when it does finally start going.
I also notice that after they do some work on the truck, it starts fine for about 2 weeks with no problem. So maybe something is getting wiggled into a happy position when they work on it?
If this is an "electrical" problem, what can be done to find this very intermittent problem? Also, just before the the problem started happening again, I noticed there would sometimes be about a 1/2 sec to 1 sec delay from when I turned the key, to when the starter motor would go.
Attached is an audio file of what it sounds like.
1) starting normal,
2) turning key and only clicks,
3) the rough start after many tries.
View 8 Replies
We had to jump start the truck and my buddy hooked up jumper cables wrong on his truck so I'm hoping the computer isn't fried. I turn the key and the only things that work are the door dinger and the dome light. Nothing on the gauge cluster and no radio. Dead silent when I turn the key to crank.
1994 toyota pickup 22re....
View 8 Replies
