Toyota :: 1987 - Oil Cap Left Off?
Mar 19, 2014
Loaned my 1987 2wheel drive Toyota PU to someone. They drove 30 miles to get to my house to return it yesterday with the oil cap off. Oil spewed all over the engine. The cap was sitting next to the oil fill hole on the engine block. (Nope, it didn't fall out). Dipstick with cold engine has not a drop of oil on it. Person didn't hear any noises while driving here like that. What assorted problems could this cause with the engine and with any parts now covered with oil? after the oil is cleaned off, what should be done next: fill it? Tow it to a mechanic? Fill it and drive it to a mechanic? Don't fill it and tow it to a mechanic? (They have no idea why the cap was off or how it got that way)
View 10 Replies
Advertisement
I drive a 1987 MR2 and as of late the CEL has been going on and then off.The only times I've noticed it come on is early in the morning when driving to work (430am) and usually its a somewhat rushed start (get in the car, start her up and go... no time to warm up).I checked for codes and it just flashes once then resets.The CEL comes on when the RPM's get to/go over 3K-3.5K and then it goes off once I let off and the RPM's drop below said RPM's... The car idles a little rough and I've noticed a slight smell of gas in the cabin when I start the car... don't know what is causing it but I just roll down the window and carry on...
View 1 Replies
My 1987 Toyota Celica ST will not seem to turn over. When it has the push button addition that takes the power from the battery straight to the seloniod it works. But when i set the starter back up to the ignition switch and set it up factory style it will not spin over. it sends the 12 volts needed to start it but yet will not turn it over.
View 3 Replies
1987 Toyota Celica GTS 2.0 manual Transmission The Problem ... The power cable to alternator sparked on the side of the engine when I was connecting it. I did not think the battery cable was connected at the time but it was.. Now I have NO SPARK I have changed all the fuses at the battery could not find any that were blown but still changed them and checked all the fuses under kick panels none were blown. What should I look for now?
View 4 Replies
My 1987 Toyota Tercel wagon works very well -- except that it won't start in wet weather. Maybe this is condensation somewhere, maybe not.
View 3 Replies
i have an 87 toyota 4runner with the 22re last week the starter stuck on and drained the battery and burned the starter up so i replaced the battery and starter and now it will start and run for about 3 seconds and run out of gas
View 5 Replies
I have a 1987 Ford Ranger 2.3L, it's the truck I learned to drive in (stick at 13yo) and the 1st car I crashed too... So now this baby is almost 30 years old and recently had a minor restoration...
Engine was pulled out and all gaskets were changed, spark plugs, wire... All that stuff... It has been running pretty good, however last week a water line broke on the Left side near the spark plugs (if you are looking at the truck)
Since then It has absolutely Zero power. The slightest hill and even when pedal to the floor will lose power. Yesterday went from the start of a hill at 60mph in 4th to 20mph in 2nd because it didn't have the guts to go 1/3 mile uphill... I checked everything I could, and my brother took it to the exhaust guy who made a small hole on the Catalytic Converter and said it was good, but he could tell it was running too rich...
I replaced some of the vacuum lines last night, I found a lose one on the fuel pressure regulator (I think that's what it is, Its towards the engine firewall on top).
Idles beautifully, drives great, no rough shifting, pinging or knocking, no misfires. So that's what has me stumped... Runs great but just no power... Also before water line broke it was running fine with power...
1987 Ford Ranger
2.3L FI
5sp manual, Rwd
View 11 Replies
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 Replies
I drive my pickup (87 Toyota 4-cylinder carburetor 5-speed Xtracab Deluxe) occasionally. When it's sat for a week or more it takes a few tens of seconds to start. I bought a booster battery. The charging light comes on, but it goes out as soon as the engine starts. I'm used to hard-to-start cars charging for a while after a long start. The voltage coming out of the alternator is okay. The battery is new; the density of the electrolyte is right.
View 19 Replies
I borrowed a friend's small Toyota truck for a few days of easy chores, and made a point to check the fuel at the beginning: the gauge showed 3/4 full. Four days and only 25 miles later, when I got in to return it, I noticed the fuel gauge was not working, I'm certain there's no fuel leak, I would have noticed that: the truck had been parked on my property the entire time, driven only a few hundred feet from one spot to another moving firewood around, so I would have smelled the gas if there was a leak.
When I added a couple gallons of fuel, the gauge didn't budge. Once on the road, I realized that the engine temperature gauge was also dead - no change on the gauge after 10 miles. So I have two non-functioning gauges which failed on my watch. This may not be directly my fault, but as my friend is kind enough to lend the truck whenever I need it, my contribution is to provide maintenance.
Is there anything in common between the two gauges which would explain the synchronized failure? Or is this total coincidence? This one is outside my experience, so don't know where to start. It's a 4 cylinder, 5 speed manual, base model truck, about 150k, generally runs just fine. There are no other gauges, and I don't recall what warning lights there might be, but I didn't see any after I realized there was a problem. Would the whole instrument cluster die at once, or could this be something like a bad ground for the cluster? I don't mind investing effort into tracking down and solving a problem, but if it needs a new cluster, that will cost more than I'd like to contribute, yet the problem occurred while I was using the truck (gently). My total use of this truck for all the times I've borrowed it is certainly less than 300 miles, so I'm reluctant to fund the entire repair if this is something that just comes with age.
View 10 Replies
I recently bought an 87 Toyota corolla fx 16 as I totaled out my other car hitting a deer when I test drove this car I had no issues on this car it had high miles at 197k but it seemed to purr like a kitten it wasn't until I started to drive it back and forth to work that I noticed the issue when the car is cold it runs and idles fine a little bit of shift hesitation but figured that might be a dirty transmission filter as the fluid appeared discolored however when the car warms up it shifts fine and begins to cut out and the Rpms dip under 1k every 20-30 seconds.
It becomes worse when the car is in gear driving down the road it randomly cuts out and seems to lose power while occasionally backfiring and if I come to a stop and leave it in gear it will die if I don't feather the throttle just right on takeoff or press it to the floor when I press it to the floor it's slow on take off and sounds like a mix of backfiring and missing and then suddenly takes off like a bat out of hell once I hit about 20 mph. When it dies the check engine light comes on but as soon as I start it it goes back off. I've already changed a bunch of the routine stuff since the car sat for a year such as fuel filter, air filter, plugs, wires, coil, rotor, valve cover gaskets, and replaced nearly all the vacuum lines trying to figure it out thinking its something simple.
View 6 Replies
What can I do to fix this? 1987 Supra. No brake lights go on when I press on the brake, including the middle light. Tail lights do work, but no brake lights. It has been somewhat intermittent as well...
View 8 Replies
Just bought for around town. Problem with starting. Turn ignition and sometimes hear grind. Second try in neutral and she starts right up. I don't know if it's problem with key ignition/coil, or the starter.
Also need to convert a/c, fan ok but no cooling. Is this major cost to convert?
View 4 Replies
I was driving home from campus yesterday, and as I approached about 50mph, the Celica suddenly revved into higher RPMs, all the while slowing down. I pushed the gas pedal, which only worsened the problem. I was able to limp the car home. About an hour later, I tested the car again, and the problem remains: Accelerate to about 35-50, then get high RPMs while the car slows down and jumps forward.
I suspect a transmission problem, accentuated by a loose wheel bearing that I haven't been able to afford to get fixed yet. My Celica is an automatic, with about 213000 miles on it.
View 10 Replies
My 1987 Toyota 4Runner 22RE has a weird cold starting issue. When the temperature is in the low 30s F or below I have to use the gas pedal when I first start it (for only a few seconds) in order to make the starter disengage. If I don't push the gas pedal it chugs at around 250 RPM and the starter remains engaged. If I kick in a little more gas (up to about 1,500 RPM) the starter will immediately disengage and then it runs just fine at around 800 - 900 RPM.
When it's warm out (40 F or higher) it starts up and runs perfectly without any of the aforementioned happening.
Maybe related is the following: when the weather is warmer out this SOMETIMES happens: the engine idles too high (1,100+, sometimes up to 1,700). If I "kick" the gas pedal this usually knocks the idle back down but not to 750 - 800 where is should be.
I have thought about replacing the (I think it's called) idle air control valve (the big metal thing with the flappy gate inside) that sits atop the air intake above the driver's side headlight I want to replace this only if it's going to fix it.
View 1 Replies
I got a 87 Toyota Celica 1600 GT, with a TVIS 4A-GE engine in.
My problem: when i just start the engine cold, it revs to 2500 RPM, and stays there for 1-2 minuttes and then falling to about 1500 RPM, and when the engine is completely warm my idle is about 1000 RPM.
first i think that 2500 RPM cold is a bit to much, and i dont know what to do with it. but my biggest problem is when the engine is fully warmed up, and i rev it to lets say 3000 RPM and then lets the gas of, the engine falls to about 500 RPM sometimes it stalls but if it not stalls then it would slowly gain some RPM and then it goes up to 1000 RPM again.
How can i prevent the engine falling that much when i let the gas off? it's quite annoying when i drive the car and comes to a stop it sometimes stall.
View 2 Replies
Now that the weather is cooling, and my windows are down, I am noticing an odd sound seemingly from the left rear of our Matrix. It is a fairly high (but indeterminately) pitched, sustained jingling or rattling. Somewhat like I am dragging a very light chain behind the car, or scraping a light metal rod along very finely corrugated, but thick (high pitched) metal. Or maybe like a really lousy triangle. It starts and stops unpredictably, but with changes: it may start or stop with the application of brakes or gas, or may do so randomly. I think. I have not been able to discern a consistent pattern.
We are about to take a short weekend road trip. Should I be very worried?
View 5 Replies
I installed a new battery in my 2009 Toyota RAV-4 a couple of weeks ago. I left for holiday a week ago and to my dismay received a text from my neighbor saying that my interior light is ON. By the time I get back it will have been on for 10 days. Given that the battery is brand new, will it be usable again or will I need to buy a new battery? What will be the best way to recharge it? I have a portable car battery charger.
View 1 Replies
I've got a 2005 Toyota Camry that was recently involved in a front end collision. Since it returned from the shop, it will occasionally stick when coming out of a left-hand turn. Basically the wheel stops for a second and you have to apply a little force to get it to turn back straight. It does not always do this, and it seems to be more evident at higher speeds.
View 3 Replies
I have 2010 toyota corolla le japan made, some time I turning left I hear the knocking noise. I already change wheel bearing both side, the strut also both side, the passenger side axle replace the cv boot 2 time with regrease since 2012 jan and left side axle change the whole new axle since 2011 jan , my driver side outer tie are changed since 2014 nov, the mechanic look at the suspension that is not leaking on every suspension parts. so what could be the noise from. I guess may be is the passenger side axle or right outter tie rod , or internal tie rod or ball joint. could you tell me what would be the noise come from or how to check. I have 220k mile with bad burning oil like 1k mile drive have to add 5w20 half quar to 1 quar. how to solve to reduce burn oil and the engine seal is not leak.
View 19 Replies
My Toyota land cruiser 1993 dies at low speed only turning left....ONLY leftSo, it started last year while in low turning left off road she suddenly died and I just about rolled her, but was able to turn her back on and keep going albeit in higher RPM. Now, she dies all the time when making a slow speed left turn and ONLY left turn. Also, in low she bucks and starts to die....
View 3 Replies
