Suzuki - Xl7 :: Error Code P0122 And Computer In Dash Reads Engine Hot
Mar 21, 2013
2007 Suzuki XL7 luxury 6 cyl 3.6l - Error code reads p0122 and the computer in the dash reads Engine Hot- A/C off. It turned over earlier but Car wont start now. Battery is new, all fluid levels, fuses ok. So... looking for
1) PART NUMBER to search for to replace the TPS? or
2) SIMPLE STEP BY STEP instruction on how to ADJUST it?
View 1 Replies
Advertisement
I took the car to be inspected today (for extended warranty purposes) and asked for the mechanic to run the car through their code reader and print out all error codes. They did and this is the error code it gave for TPMS (FYI- They couldn't reset the error display either, and I've done the 'learning' procedure several times as suggested in these forums, but it doesn't work and the display eventually shows Tire Monitoring Pressure Fault) NONE of the tires show in the TPMS screen. I have no flats, nails, and all the pressures are up to level.
So here is the actual code from the Phaeton:
CODE001:
01325 Type pressure sporadic monitoring
Open contr.unit-j5-0 circuit 2
So what I am wondering is whether the Module has gone bad or perhaps the sensors? What the above means?
View 20 Replies
So got this P0A93 code when I was driving on the highway about 65mph, scared to me death when big yellow warning light came on so I returned home and turn the car back on after 30 mins the code and all the warning lights were gone I checked under the hood felt the pump everything was good. I just got done 90k maintance on the car from dealer. So my question is that could be computer error or it could be water pump malfunction? On warranty manual the warranty for inverter with converter covers under 100k so dealer should be able to cover the water pump if it's broken? I driven the car today again at normal temperature and full blast AC on, then again no engine check light on and warning light no message.
View 4 Replies
2005 F350 crew cab with 6.0 currently cranks but no start with a P2291 error code. Using scanguage 2 it shows icp 0, IPR 67.7, FICM 47.5 while cranking. Disconnected ICP and still no start. removed icp and hooked up air and I do not hear/see any signs of air leaking. When I disconnect the air it then whooshes out. About 2 months ago got a #1 cylinder contribution error code and changed out that injector and it has ran fine up until this issue.
Can this be a IPR? I am leading towards the HPOP, but as it costs a pretty penny would really love to make sure I tried every other avenue.
I have 197K on it, and 2 years ago did a EGR cooler delete. In May this year replaced the oil cooler, and then in August changed out the #1 fuel injector.
Oil cooler screen was broken. Cleaned the entire reservoir out. Could this just be a clogged IPR? or seeing the change while cranking an indication that it is working?
View 1 Replies
I have a 2007 Suzuki XL7 that's sending me messages whenever the car demons feel the need. From time to time, a message will come up on my console display saying, "TURN OFF ENGINE; OIL PRESSURE LOW." I shut off the engine and then it stops. Along with the message there is a continuous tone similar to when a door is open. The tone gets loud, then soft, repeat. I find it hard to believe that the oil pressure would equalize after the engine being shut down for about 30 seconds. Could I possible have an electrical problem? I ask this because, as I mentioned before, the tone is loud initially and then soft. When I use the turn signal, the same thing happens.
View 6 Replies
Just did some trading for a 97 f150 4x4 extended cab with a 5.4 and auto trans. The guy I got it from told me that the transmission in it shifts real fast and won't downshift once it gets going and shifts hard sometimes. From past experiences I figured it might be the tps and sure enough pulled codes and I got the 122 code for voltage to low on it. Checked the wires with my multimeter and had exactly 5.0 volts to the one wire and when I checked the ground back to the battery had 12.xx volts when i tested the signal wire it had 1.0 so all my wires checked out but I am still getting the code. I replaced the sensor once already so I guess it is possible I got a new sensor that is bad or is there a chance that maybe my plugin to it is bad?
View 13 Replies
Mine is a 99 gls with the v6 and manual trans. I have 108,000 miles on it and mostly performs great except that my cabin lights are dead (moon roof still works, dash lights even the lights in the doors for the windows and locks light up but not the cabin lights and I can't find a dead fuse anywhere and the dealer looked at it for an hour with no luck). [URL]...
Mine is pretty intermittent at least over the last 6 months, but my temp gauge no longer reads anything and I've gotten a CEL twice now, this second time I pulled the code at autozone with an answer of 1106. I've had my 90k maintenance with the timing belt/water pump/coolant flush service.
I've also noticed when starting it up in the morning I'm getting quite a varnish smell out of it that my wife's 07 Rabbit doesn't produce and my mileage is still around 25 mpg for a 5 mile commute.
Now I see this is a pretty cheap part, so I'm going to wrench it myself but... where the heck is it? I've done the electrical replacement on my 96 jetta wolfsburg that had the 2.0 in it which was pretty easy but my passat seems to be hiding everything under the hood with fancy engine covers and stuff.
View 3 Replies
98 Taurus, 6cyl, 3.0L OHV, 184K miles. Check engine light is on and code reads "P0411 - secondary air injection system - incorrect flow". This is my son's hand me down car and has a rather large exhaust leak that I plan on fixing. Could this code be related ?? I found out that the CEL has been on for quite sometime now and the car is due for emissions testing (state inspection) in October.
View 3 Replies
2004 Elantra AT ... 6 months ago top of the radiator cracked caused it to overheat and blow the head gasket and warp the head. Repaired that and compression is fine now. It ran great for 4 months but now it randomly stalls. at or near idle. Seems to do it more at operating temp rather then cold. Occasionally the check engine light will pop on and the code reads (random misfire). It acts just like it has been shut off. But immediately restarts.
View 3 Replies
My car was working fine except for occasional no dash lights. Unfortunately where my dash lights don't work sometimes I can't see my gas gauge and I ran out of gas today. I manage to make it to the gas station on battery power I presume. Filled the tank up with 11 gallons and the car seemed to work fine for the remainder of my trip(about 5 miles). So I parked at my destination and went inside for 30 minutes and then I went back out and started the car. I attempted to clear the out of gas error code and all of a sudden a whole Christmas trees of lights popped on my dash. I rescanned and these codes were read out
U0293
u0100
u0111
u0293
p0a1d.
History : I had the coolant pump inverter changed 2-3 months ago by a mechanic and hybrid battery and battery ecu changed 2 years ago by myself.
View 9 Replies
1997 Ford Ranger with 190K miles has check engine light on with P302 computer code, meaning misfire on cylinder 2. Engine runs rough at idle only once it warms up, which only takes a minute. It is usually fine while driving, but it's a lot easier to feel a misfire at lower RPMs than at higher ones. Added fuel injector cleaner to gas for a couple tanks, no change. My mechanic has checked spark plugs, fuel injector, o2 sensor, and everything is ok. Dry compression test shows good compression. He thinks it may be a valve sticking, which means a valve job: expensive. Is there anything else that can be done? Why is there no misfire when it is first started?
View 9 Replies
02 LSV8. 174k miles. Today it threw a Fuel Data Computer Error on the computer readout and the fuel gauge parked at E as if the engine was off. I am sure I have over 1/2 tank of gas.
View 14 Replies
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
View 2 Replies
-At first, the car stereo wouldnt turn off when the car was turned off (the battery died many times :P) -I learned my lesson, and manually turned it off every time I got out.
-Then the radio started acting weird an randomly shut off, switched modes etc.
-Then while driving one day.. the "Theft" light turned on while driving and the radio shut off. The odometer read "error". It would go back to normal, but stay for longer periods of time when it happened.
-Then the car had problems starting, AND the day lights wouldn't turn off 50% of the time (I had too unhook the battery)
-Eventually the radio just stopped working and wouldn't turn on, and ALL the dash lights stayed on while driving, with none of the gauges working, while the odometer reads "error".
-After about a week of that, I decided to remove the radio. That actually worked alot. The MPH gauge and the RPM gauge now work, the front lights are back to normal. The car starts every time!
-However, the Gas gauge and Temp gauge still don't work, and the lights are all lit up on the dash and it still reads "ERROR"
I know it can be many things, but what steps can I take to find the "short" or "bad wire" or fix the problem. I know the hard part, is actually figuring out what is causing it.
View 4 Replies
Yesterday when I was coming home my '01 started going on the fritz. The ABS light came on in the console, the Brake light started flashing, and in the onboard computer I received three kinds of messages, "Brake Fault" "Service Manual" and "STOP". What is going on?
View 4 Replies
My factory gauge on the dash reads Zero. I have put on a mechanical external gauge and it reads normal.
View 2 Replies
I posted recently because my '05 Touareg had been in twice for a "coolant overheating" error when the car was driven less than three minutes after a long cold start. They replaced the main computer and I had it back for a week and everything was fine. This morning, the same error occured. We took it in. When my husband drove it to the dealer, the warning went away after several minutes. They said that the error never logged on the computer and there's nothing wrong.
One person had responded last time with the sensor issue but got it resolved. I am really concerned about the possible problem that they can't seem to fix. They seem to be ok with it.
View 1 Replies
My dashlights (Speedometer, Tach) always remain lit on my 2006 Grand Vitara. Dealer could not find problem. Suggested new dash. Only way to darken dash is to disconnect battery. Car has 10,0000 miles.
View 2 Replies
the flickering stopped after 10 mins and hasnt come back. is this an alternator problem or loose battery cables/ground strap?
View 1 Replies
1 Fault Found:
000372 - Fuel Trim; Bank 2
P0174 - 001 - System Too Lean - Intermittent
Freeze Frame:
Fault Status: 00100001
Fault Priority: 0
Fault Frequency: 3
Mileage: 136626 km
View 5 Replies
I have a 2007 Passat 2.0T with 5000 miles. I love the car, handling, comfort, power, refinement and all related but had a big shock when I went to the VW dealer for 5000 mile check. The service tech said my car had a optional computer software upgrade to regulate the intake valve (mostly to keep it from sticking open). I thought it was fine to do the upgrade EXCEPT when he said that if I did the upgrade , I would lose the gear indicator lights on the center dash between the speedo and tach! .....so, I would no longer have visual indication of Park, reverse etc....or indication of 1,2,3,4,5,6 for the tiptronic tranny mode. Why or if you have been able to do the software upgrade for the intake valve, WITHOUT losing the the indicator lights on the dash?
View 24 Replies