Subaru - Outback :: Grinding / Rattling Noise When Shifting And Cruising At Low Speeds


Aug 3, 2013

Three days ago my Outback started making this grinding/rattling (hard to describe) noise when shifting and cruising at low speeds. Is this the clutch or the transmission? No trouble shifting though. I got rear-ended by a big Lexus SUV last week, but wouldn't think that would have anything to do with it. Just damaged the bumper a little.

View 1 Replies

Advertisement

Subaru - Outback :: Loud Drone Noise At Cruising Speed

I get a loud noise from the rear of my 2005 Subaru Outback, 67k miles.(No it's not my dog Pete)Starts as a WHOP, WHOP, WHOP that speeds up as the car speeds up 'til it's a loud drone at cruising speed. I thought it was older tires but changed those Saturday. No effect.

View 1 Replies

Camry :: 2002 - Low Grinding / Rattling Noise In 5th Gear When Cruising On Highway

I've got a 02 Camry with a manual. In 5th gear, cruising on highway, there's a low grinding/ rattling noise. it doesn't do it if you try to accelerate, or if you have no throttle input at all, meaning it only makes the noise when trying to keep one speed, typically around 2000-2500 rpm. If i grab the shifter and apply pressure in any direction, the noise goes away. I've owned the car for 3 years now and its always done it, and hasn't gotten any worse or changed at all. I'm experiencing no performance issues and just chalked this up to gear noise, but recently read someone else was having same issue, and everyone was clamoring on about needing new bearings.

View 14 Replies

Touareg :: 2006 V8 - Grinding Noise Specially While Foot On Gas At Cruising Speeds

I have an 06 Touareg V8 with AWD, auto tranny. No leveling suspension. And when I drive it specially while my foot is on the gas at cruising speeds there's a grinding noise coming from under the car. When I step off the gas it is gone or when I am accelerating hard I can't hear it. What could it be? It's driving me and my ocd insane!! I think it is drivetrain related (differential, wheel bearing, etc.) but not the transmission as I can still hear it while coasting in neutral.

View 3 Replies

Subaru - Outback :: 2017 - Engine Rattling Noise Upon Start

I just purchased a 2017 Outback. I noticed a rattling noise (like marbles) coming from the engine upon startup in the morning only. The noise goes away after a few seconds. To me it sounds like bearings rattling due to low oil pressure, but the dealer says that every Outback and Legacy does this. It has a timing chain and the engines use 0-20 synthetic oil. Is this normal.

View 19 Replies

Subaru - Outback :: High Chatter Noise When Shifting From Neutral To First / Reverse

My car makes a high chatter sound when I shift from neutral to either first or reverse but no other time. what does that mean? should I stop driving it until I can get it looked at? it's not slipping or grinding at all, just makes a noise as I let the clutch out and engage the gear.

View 4 Replies

Subaru - Outback - Noises - Transmissions :: Noise For 1 Minute And 40 Seconds After Shifting?

Noticing a somewhat regular sort of light tapping noise from Subaru CVT Outback, when slowing to stop or starting out?

Some days it's noticeable only for about a second after the clunk from shifting, often you can hear it a bit longer.

You can hear it best at about 1 min, and last 40 seconds of this short trip audio-clip.

View 3 Replies

Subaru - Outback :: Grinding Noise And Vibrating After Front Axles / Boots Replaced

What would cause noise grinding type and feeling after having axles/boots replaced this morning on my 2005 Outback.Car seems noisy and vibrating

View 5 Replies

Subaru - Clutches :: 2003 - While Shifting There Is Creeking / Grinding Noise

I have a Subaru Baja 2003 with only 48,000 miles. It is a manual transmission.

My question has to do with the clutch (I think). If I am driving with the windows down and have something beside me that reflects noise ( a big hill, a wall, etc.) when I shift from first into second or second into third I sometimes here a "Creek" sort of grinding noise. I do not have to be moving the shift hence why I assuming it is the clutch. The noise is not bad, as I said I can only hear it occasionally and when I am next to something that reflects sound.

My questions are: Is it the clutch? Is it something I should have fixed or should I wait until it gets worse? I am not sure if fixing a clutch is expensive period or if there are some interim steps to a repair that prolongs the clutch and saves money.

View 2 Replies

Ford - Explorer :: 1996 - Grinding / Rattling Type Noise From Front Driver Side At Low Speeds

I have a 1996 Ford Explorer (4WD model). Approximately 4 months ago I had a new set of tires put on it, and in the process of replacing the tires the shop noticed that I had a bad ball joint and one of my wheel bearings was going bad. They said the ball joints were known for completely failing, but the wheel bearings usually didn't, so they recommended that the ball joint be replaced first. That is what I had them do. I haven't had the money to get the wheel bearing replaced yet. This past week it got worse to the point where I can hear it now.

At low speeds I can hear a grinding/rattling-type noise from the front drivers side (that's the side that has the bad wheel bearing). At higher speeds the grinding/rattling-type noise fades away due to road noise, but I can still hear a humming-type of noise that is a bit loader than normal - this noise just started a couple of weeks ago so I'm suspecting that this might also be related to the bad bearing.

I won't have the money to get this fixed for another 2 weeks. In order for me to have the money in 2 weeks I will need to continue working at my job 2 days a week. It's approximately 2 hours round-trip from my home to my job. Obviously with the bearing sounding significantly worse I don't want to drive it any more than I have to, but the only way I can get the money to fix it is to keep driving it back and forth to work.

Here's my question. What risks am I running by continuing to drive this? Am I running the risk of the wheel falling off while I'm driving down the freeway at 70 mph? Am I likely to experience other damaged parts in that area of the vehicle?

View 14 Replies

Corolla / Matrix 2009-13 :: Rattling In Front Brakes When Cruising Along At Almost All Speeds

I have a 2010 Model S that has 38,000 miles on it. I am hearing a rattling in the front brakes when cruising along at almost all speeds. If i hold a little peddle pressure it goes away. Sounds like the pads are rattling to me. I am running the stock pads with about 45 to 50% remaining on them.

View 6 Replies

Subaru - Forester :: 2006 - Brakes Inconsistently Making Dragging / Grinding Noise When Coming To A Stop At Low Speeds

I have a 2006 Subaru Forester with 115K miles. It's been well-maintained and well-loved.

For the past few months, the brakes have been inconsistently making a dragging/grinding noise when coming to a stop at low speeds (<5mph). It sounds to be coming from the front half of the car - I can feel it vibrating a little near the driver side. We've taken the car in to be looked at three times - each time, the mechanics think they've heard the noise and report there is absolutely nothing wrong with the brake pads or rotors. Twice they reported a shim was out of alignment. After the last shim adjustment, the noise got a little better - instead of grinding, it's more of a dragging sound now. Because the noise is inconsistent, I haven't been able to crack the formula of the conditions that produce it, other than that it only happens as I'm coming to a stop at very low speeds.

Is there something besides the brakes we should be having inspected? Does this sound safe to drive?

View 10 Replies

Subaru - Outback :: 1999 - Front End Grinding After Replacing Struts

I recently replaced the struts and strut mounts (front and back) on my 1999 Subaru Outback (all wheel drive). Immediately after this was done, the car began making a grinding noise that comes from the front end when I either am coming to a stop (grinding begins happening at 5mph or so) or turning left (happens at any speed). However, if I am traveling along and, upon approaching a stop sign or left corner in the road, shift the car into neutral (it is an automatic transmission) the grinding does not occur. When I replaced the passenger-side strut I did not mark the position of the bolt that is responsible for adjusting the caliber. I did, however, do this for the drivers side.

I really have no clue what is going on here. I replaced the struts because the rear tires were wearing badly on the inside and I was told by a mechanic that the struts were bad (which they were). However, in an effort to save money I am unsure of how to proceed. If I go ahead and have the tires replaced and get a four-wheel alignment and it doesn't solve the issue, I will likely have to mess with the front end (or someone will anyway) which will then require another alignment.

View 6 Replies

Subaru - Outback :: Loud Grinding Sound That Goes Away After About A Minute When Starting

When I start my Subaru 2001 Outback, it makes an awful sound. Not as much as a screech, but more like a loud grinding, and then it wanes and goes away after about a minute. Then when the car is warm, the sound is all about gone. It's been going on for a few weeks now and wasn't there before.

Listen to the audio file below.

View 15 Replies

Subaru - Outback :: 2012 CVT - Thumps And Jolts In The Transmission At Low Speeds

I just bought this car (2000 miles) and I have noticed that it shifts gears oddly (hard to describe) and I get thumps and jolts in the transmission at low speeds, parking lot driving, going from reverse to drive.

Any knowledge of this transmission and it is possible there is something wrong?

View 4 Replies

Subaru - Outback :: 2004 - Slight High Frequency Vibration At Highway Speeds

This has been happening for the past 6 months or so. I recently had new ball joints, 4 wheel alignment, and 4 wheel balance. Even with this I'm noticing a very slight high frequency vibration at highway speeds. I noticed on one of the front wheels that a weight fell off, so this might explain the high speed vibration.

However - When I'm starting at 0mph, and accelerate to say 50mph for example, the car vibrates rather substantially as the speedometer moves from around 25mph to just past 30mph. After those speeds it goes away.

I've also noticed that it tends to be worse if I'm going up hill, which, according to the laws of physics, would tell me that going uphill would put more pressure on the front end, given it's heavier with the engine there. If I'm going downhill it vibrates much less.

When I drive I tend to not accelerate quickly, meaning, I don't 'punch' it, and accelerate gradually instead. If I'm driving on a level, well-paved road, and accelerate quicker than regular, the vibration seems to not be as heavy.

Any other tests for this? Struts, control arm, steering knuckle, drive shaft ?

View 14 Replies

Subaru - Outback :: 2004 - Growling And Squealing / No Power Steering At Slow Speeds

My 2004 Outback power steering was growling and squealing, but it was working ok at the time. I decided to replace the power steering pump before it completely failed and 3 hours later I was done. the growling and squealing was gone. However, when I backed the car out it was hard to steer at first. When I got going it all worked great, until I turned at the corner... hard steering again. When I got around the corner and up to speed everything is great again. The problem did not go away with time. Every time I turn at idle there seems to be no power steering. What is going on?

View 6 Replies

Subaru - Suspension :: 2002 - Rattling Sound Noticeable At Low Speeds

I have 124,000 miles on my 2002 subaru impreza outback sport and this car runs very well and has been maintained well however the last couple weeks I have noticed a slight rattling sound toward the right front side of the car almost as if there were pebbles inside the wheel covers when the car is driven at low speed and I begin to accelerate. It also sounds as if the rattling could also be coming from the exhaust also as if it were loose fitting but the tailpipe is on the left looking from the rear of the car. Another possibility I thought of was the fender was loose or the tire was rubbing against the wheel well or something. It is one of those small annoying sounds that does not seem to warrant bringing in to a mechanic yet but I am curious about what that is.

View 2 Replies

Golf/GTI VI :: 2012 - APR Stage 2 Installed / Rattling Noise When Cruising

I have a 2012 mk6 and did stage 1 APR about 3 months ago and loved every single moment of it. It made a huge difference on the car but like all good things they don't last forever so it was time to move to bigger, better things so I went stage 2 this weekend ( apr stage 2 carbonio, APR downpipe and reflash ). I installed it at a VW dealer in Mount Prospect, IL, same place where I got my stage 1 installed.

When I drove off with the car everything seemed to be just fine and the gains were noticeable. Later on as I was cruising I started hearing a rattling noise coming from the front of the car, right under the DSG shifter. I was thinking it could be one of the clamps that was used to install the DP, I didn't get a chance to look under the car yet. What it might be? This morning when I turned on the car, I did not hear the rattle...

View 12 Replies

Toyota - Sienna :: 2000 - Grinding Noise While Cruising

My 2000 Toyota Sienna has been making some concerning noises. It makes a periodic grinding noise, the period is related to the wheel speed...i.e. the noise happens once each time the wheel goes around. I can hear it while I drive, and it's even louder when I roll down the windows. The weird thing is that the noise stops when I hit either the breaks or the gas. First mechanic says that the wheel bearings are shot, and the second says they're fine. There is no "jet engine taking off" noise that I am told is typical of shot bearings, but there is a wump-wump-wump noise at higher speeds.

View 1 Replies

Subaru - Outback :: 2006 - Loud Humming Noise

I thought it was the tired due to the cold weather. But now it is warmer the noise is still there. Bareknuckes previously mentioned wheel bearings as a potential problem. The car is driving (sound-wise) like I have some huge mud-bogger tires on or like crossing a cattle-guard continuously. so loud (in the cabin) that sometime I forget to shift because I hear the humming rather than the engine.

View 2 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved