Subaru - Forester :: 2002 - Check Engine Code For Knock Sensor - Motor Mounts?
Oct 16, 2013
2002 Subaru Forester I took my car to the Auto Zone to read a check engine code. It came back as being a "knock sensor". Besides that I needed a battery, and when the guy was putting it in he said my engine was moving too much and that I probably needed motor mounts.
I was looking at a discussion back in 2010 and the Subaru specialist told the person needing motor mounts is rare for a Subaru, is that true? I'm taking it to a mechanic, what should I expect? how many motor mounts does a subaru have?
View 7 Replies
Advertisement
Engine light came on two weeks ago. Had the code read at Advance Auto Parts. Code = P0420. The only performance issue was that it stalled when I started it the other day for the first time since I bought it last fall. Are there any other clues to tell what it could mean (catalytic converter vs. 02 sensor vs. anything else)? Is it really worth trying some kind of catalytic converter cleaner product?
View 1 Replies
The check engine light on my 2006 Subaru Forester with 92,000 miles came on recently. A scan revealed the engine was running lean. After three more trips the mechanic determined the rear O2 sensor was bad and replaced it. This was the only part replaced. Now the computer is sending code P2097; Post Catalyst Fuel Trim System Too Rich Bank 1. I have read it could be anything from the catalytic converter needs replacing to "resetting the adaptation values."
View 2 Replies
I have a 2002 Forester I have take it to 4 shops and each shop tells me something different. First 2 say to take it to the dealer and have them flash the computer. The dealer says that it is a faulty drain valve and the fourth states he has never heard of a drain valve. Hook up to a scanner and can not clear light. Unhooked battery for 30 minutes light was off for a minute but came back on. Getting extremely frustrated!
View 11 Replies
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 Replies
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
View 5 Replies
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 Replies
I have a 2002 Subaru Forester L with 178,000 miles on it. I just had the valves adjusted. I have replaced the coil pack, #2 injector, plugs, wires, and throttle position sensor. I have also cleaned the idle air controller. The car only shows sign of a miss when it idles. It gets great gas mileage otherwise. I am at a loss on what to do next as the car doesn't have a MAF sensor, I can't do anything with it.
View 19 Replies
So a letter history about the car and this car is a friends car. They owned the car and drove without changing the timing belt when the car hit 109k. So the timing belt snapped and they went out and bought a timing belt and also the timing belt kit with the pulleys and all. They installed it.. didnt turn over or what so ever.
They towed the car to us which we own an auto repair shop. We knew the valves was bent and so we tore off the heads send them off to have them put new valves and etc etc.. We put the car back together for them and now the car runs fine. They pick it up and about a few days later they brought it back due to a check engine. It threw the code:
16711 - Knock sensor 1-G61 Signal too low. (p0327)
now we replaced both knock sensors and when they came and got the car... the check engine light came back one showing the same code. We cleared it out and the next day it came back on showing the same code Again! So now we don't have a clue why that code keeps coming up because we replaced both sensors with a new one. Any clue why the code keeps popping back up?
View 1 Replies
I have a 2001 forester. it had a misfire which has been fixed but I can't get the "check engine" light to turn off.
View 3 Replies
Our beloved 2004 Subaru Forester has the check engine light on. We've been told that the 4th cylinder has either low or no compression. Is this fixable/worth fixing? Would you replace the engine? The car has 183K miles on it, and runs great! It is stuttering now, due to this issue, but otherwise - runs great and is in good condition!
View 11 Replies
Wife has a 08 solara 2.4 auto. Check engine light is on for bad knock sensor in bank 1. Now car is not pulling itself, it takes off fine then shifts and falls on its face, I think its missing 2nd and going to 3rd. It is also not shifting into 5th so its staying in 4th and using a lot of gas. I tried manually shifting but it still goes to 3rd and will not go to 5th. I have been told this knock sensor could be causing it all. Cant clear code, I hit clear but nothing happens. We don't have a lot of money to pay the Toyota dealer to fix it and I can do all the work but they wont even show me where the knock sensor is.
View 5 Replies
last fall, the check engine light came on- Autozone states the knock sensor is bad. At the same time, odometer/cruise would work off and on. Now as months have gone by, the odometer RARELY works. Could all the electrical issues be connected? Is odometer controlled by Speed Sensor on the transmission or somewhere else?
View 2 Replies
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
I have about 200k on my forester. Friday when I was leaving work I cranked it up and it made a loud knocking sort of sound. I drove it home (about 15 miles) and on the way the sound lessened. It was louder when the car was idling but she made it home ok. Next day, started the car and it happened again. Not more than 50 feet up the road we stopped at a stop sign and it sounded like a semi was starting up around the corner. Much to my dismay it was not a semi but my own car. Engine shut off. We pushed it back to the house and tried to check it out the next day. This time, we started it, didn't go anywhere, and within 30 seconds it turned off. Same loud knocking sort of sound. The confusing part is that all of this happened within two days. There was no gentle sound leading up to it for a few weeks or even a few days. Knocked on Friday, shut off on Saturday. What could be going on?
View 19 Replies
I have a 2007 L.L. Bean Edition Forester. The cruise light is flashing and check engine light is solid. I am well into my retirement age and nearest dealer is about 2 hours away. Is this something that local mechanic can fix? He is very good, but not Subaru schooled. I'm afraid to drive it now.
View 2 Replies
2001 sub forrester. In 2009 it was intermittently stuttering: tuneup, new coil, finally O2 sensor (both) replaced which fixed it. In Oct started to do the same thing. First the back then the front sensor replaced but they commented the flow was low on the catalytic converter but wouldn't say it could be the cause of the sensor issue. Now the O2 sensors are on either end of the converter and the car is starting with early signs already. Is is reasonable that it is the catalytic converter? I am wrestling with just having them do the full tuneup and replace the converter or am I crazy?
View 7 Replies
Ever since it started getting cold here in the Northeast (mid December ish) my tire pressure sensor light is on. I know that it may be necessary to add air during cold weather as the air in the tire can contract in the cold but the pressure is fine - I had my mechanic check it out. Light does go out when it warms up - at least above freezing - but comes back on again when it gets cold. Normally I spend most of the winter in Florida but am usually here (in MA) until mid Jan. and this has never happened in previous years.
View 2 Replies
I'm suspecting that my motor mounts are going bad, but I'm not 100% sure. I have a video of the engine movement when slipping the clutch and revving the engine with the e-brake on. [URL]............................... I don't need high performance ones, but don't want to spend a ton on OEM ones either.
View 5 Replies
Is it necessary to check (or change) the fluid levels in the CVT and the differentials?
The manual has the following confusing statement for those:
Continuously variable transmission fluid. It is not necessary to check the transmission fluid level. Check that there are no cracks, damage or leakage. However, the fluid inspection should be performed according to the maintenance schedule in the “Warranty and Maintenance Booklet”.
The Maintenance Booklet list inspection every 30k miles for : Transmission gear oil, CVT fluid, front and rear differential gear oil.
Another question, how is the Transmission gear oil different from the CVT fluid? And should there not be a third differential, or is that part of the transmission?
View 10 Replies
On my 2002 Subaru Forester (137,000 m), the check engine light came on. They diagnosed and repaired O2 sensor. About 300 miles later it came on again, this time they said the catalytic converter was cooked, and they blamed whatever caused the O2 sensor to fail (or the O2 sensor failure itself). After the repair (about $1300 and 30 miles later), I discovered that the engine oil was so low that it was not showing up on the dipstick (tho the oil light was not yet on). The shop (after admitting that they did not check the oil while it was in there) said it was related to catalytic converter failure. Does this make sense? I have only gone another 60 miles since the oil was refilled, but so far it looks OK. Should I be on the look-out for anything else?
View 16 Replies
