My son has a 2001 Forester that's engine will from time to time suddenly rev up while driving on the highway as if the clutch was suddenly disengaged. The clutch only has about 20,000 miles on it and there is no burned clutch smell. What else could this be?
View 7 RepliesI have a 2013 Forester with 39k miles, and last week I was 200 miles from home, put it in Drive and it didn't engage. After car was left running for a few minutes, and shifting between P, R, N, & D, it finally engaged. I was able to get it home and took to dealer the next day. They looked at the car, checked the computer logs, and told me nothing was wrong. Since then, it's happened 3 more times, and now I'm noticing it's not shifting smoothly from 1st to 2nd gear (engine will rev and then it'll slip into gear).
To make matters worse, my wife couldn't get it out of Park two days ago. She had to use the shift lock release button, and could only start it when it was in Neutral. She then couldn't get it to back into Park and had to park it on a level surface with parking brake engaged. Heading back to dealer now, but would love to hear others' input.
I have a 2001 forester. it had a misfire which has been fixed but I can't get the "check engine" light to turn off.
View 3 RepliesI've a 2002 Subaru Forester, manual transmission. The gear shifter is very loose. While in any gear, the shifter can move to anywhere. For example, when in second gear making a left turn, the gear shifter will flop to the right side near where third or fourth gear are. This doesn't change the gear of operation that the car is in. It just makes it a bit of a challenge to find where the gears are. Sometimes it is a challenge to find reverse.
We've had the shifter bushings replaced and that tightened things somewhat. But it is still very loose.
Mechanics have said that there is nothing wrong with the motion or the way the linkage operates the transmission. So the problem seems to be in the gear shifter.
Is this common on this car?Is it a sign of a bigger problem?What can be done about it?
Replaced original clutch on Subaru Forester at approx. 130,000 miles because of slipping. Drove car for a few days and clutch would judder once warmed-up when trying to engage 1st gear. Took car back to repair shop, they said pressure plate was defective/set too stiff and replaced that. Whole car now shudders when trying to engage in 1st gear once the car has warmed-up and particularly on (even a slight) hill. What's not working correctly? Seen some discussion on throw-out bearings, master/slave cylinders and oil on clutch. Unsure.
View 5 RepliesI have a brand new (2 months old) 2011 Subaru Forester 2.5x that has a 4 cyl engine and a 5 speed manual transmission. This past week it's been cold here in New Hampshire and in the morning when I first drive the car, I have trouble shifting from 1st to second gear. When I shift from 1st to 2nd, I hear/feel some grinding noise as I try to engage 2nd gear. This only seems to happen when the car has been sitting around in the cold for a long period of time. Our garage has been cold (34 deg this AM) for the past week and when I drive out of our driveway and on our street I encounter this problem.
Normally, this problem only happens the first time you shift out of first and into 2nd. However, the other day, when it was very cold (5 degrees out) it happened several times as I drove down the street. After it happened the first time that morning, I stopped the car and drove from a dead stop, shifting from 1st to 2nd. I had problems 3 or 4 times trying to shift to 2nd. I ended up double clutching the car to avoid making the grinding sound. I took the car to the dealer. The couldn't repeat it but I didn't expect it to, because the car was warmed up and it was warmer during the day (low 30's by the time I got to the dealer that afternoon). The mechanic changed the transmission oil and checked the magnet in the pan to see if there were any metal pieces. He did not find any metal pieces. That was two days ago.
Unfortunately, every morning since then the car has had the same problem. Once the transmission has been warmed up it runs flawlessly and I have no problems shifting. I've made sure I am fully depressing the clutch for each shift. The past few days I've been taking the car out on an early morning test run and like clockwork, it has problems on the first shift into second, and it usually works fine after that. I have an appointment next week to leave the car with the dealer overnight. They will test drive it to see if they can reproduce the problem. What might be wrong? I have a workaround solution to avoid grinding the gears. I simply double clutch shift into 2nd for the first few times that I shift after the car has been sitting in the cold for a while. However, this is less than ideal for a brand new car.
We have a 2006 Subaru Forester with approximately 118000 miles. My wife is the sole driver of this vehicle, we purchased it used a little over two years ago. When the engine is cold (only when it is cold) a loud "kick" sound comes from what sounds like the rear of the car when and only when switching from second to third gear. The dealership flushed and calibrated the transmission but the problem persists (albeit less).
View 5 RepliesI have a 09 Subaru Forester with 66k miles that vibrates like it is going over rumble strips when it up shifts from 3rd to 4th gear. It occurs under normal (not brisk) acceleration. I had the trans fluid changed at both the 30k and 60k services. I have owned this since new. It began before the 60k service. Also, sometimes the tach will increase revs during this as well. I don't know if this next thing is related but when I once need to merge quickly into interstate traffic I gave it a good amount of throttle and the tach revs increased but the trans did not follow with an immediate down shift.
View 4 RepliesBoth seats stopped heating at the same time. The lights on the switches don't light up anymore either. Winter is coming to Colorado- where do I start to try to figure out the problem?
View 2 RepliesRecently had a quickie oil change on my Forester (manual, 118K, blue) and have just noticed an unusual noise. After I drive a bit and the engine warms I hear a whir or whine even though the RPMs are normal. What I've learned is that the whir/whine isn't heard when I first drive the car (when it's cold), it increases in pitch with increased speed, and is most noticeable at 35/40 mph and above. The noise remains upon deceleration but decreases in pitch, and then goes away altogether when the car comes to a stop and idle.
View 3 RepliesMy son has a 2001 Subaru Forester that has a 5 speed manual transmission (transaxle) that is leaking from the drive axles . The question is how difficult is it to change these seals?
View 2 RepliesI'm getting smoke from the catalytic converter area on my 2001 Subaru Forester. The smoke smells of rubber or oil. I've only noticed it after the car has been driven up a long, steep incline of at least a couple of miles. I've never seen it happen after normal highway driving. The car runs fine, gas mileage is good, CE light is not on, 85K miles, regularly serviced.
View 2 RepliesI have a 2001 Forester with approx. 130k miles 5 speed MT. Sometimes when making a low (5-15mph) speed right hand turn I hear a mild thunk thunk thunk thunk emanating from the front pax corner. The frequency seems linked to the speed. Curiously, I do not hear the noise every time I make a right and I have yet to notice a trend. My partner drives the vehicle more often than I but doesn't make any connections either.
I am relatively certain that we replaced that cv joint/axle this past June.
When I make sharp turns forward left or right and when I back up and turn left or right my car feels wobbly/grinding. My mechanic says he thinks it "may" be the rear differential needing servicing. I have 135,000 miles. Does that sound right? There is no noise associated with this sensation.
View 19 RepliesHad the head gasket replaced and metal machined due to HG failure. 2001 Forester, 120K miles. After I got it back, a bad oil smell. Cleaned and sprayed it, still there, though less; seems to be on drivers side. Comes into cabin from the air vents below windshield when stopped.
Could it be the line from manifold vacuum to brake master cylinder ie servo amplifier? Or something else?Should I worry? The car seems to get about 15 mpg, used to get 18 mpg, and the check engine MIL is on.
I have a 2001 Subaru Forester which has 165K miles. I had the timing belt changed at 105K per maintenance recommendations. I had the car in for service recently for brake pads, etc., and the dealer recommended replacing the drive belt for the AC.. which I did. 100 miles after this service, the car broke down unexpectedly. The dealer told us the AC compressor seized up... and this caused the drive belt to get caught on it and be shredded ... and with that, the sudden resistance from the drive belt on the crankshaft pulley caused the timing belt to slip out of sync and damage the interference design engine. Can that really happen? I surprised that this happened a few days after replacing a drive belt and wondered if somehow the service work done with the drive belt could have caused the problem. The dealer states the service work did not cause the problem. Is my recent service and damaged engine a coincidence as the dealer said or are they related?
View 3 Repliesheadlights on 2001 Forester not working. I checked the fuses ,bulbs and they look good. The highbeams,taillights,and interior lights all work. I do hear the relays click when I turn on the switch.
View 1 RepliesAfter having changed the oil in my 04 Forester multiple times, I must have lost my mind and drained the transmission fluid. I realized this when I started it back up and it wouldn't move. Clearly I put an oil filter on with engine oil around the seal. Should I do a tranny flush or can I just replace filter (with correct one) and fill with tranny fluid?
View 16 RepliesI have a 2006 Subaru Forester with a little over 119,000 miles.
For the past several weeks, maybe a month, it has been making a weird noise... it comes from the 'engine' area... my husband thinks it might be a belt or something. Sometimes there is a burning smell, especially if we're on a long trip, going uphill... but the smell isn't always.
The sound sounds like... a remote control car that you push with your hands, instead of using the remote control. So it's kind of like a winding/whining sound... the sound happens when it is in park, and drive, whether I'm driving or at a stop.
A significant amount of engine oil was added to my automatic transmission line. I drove the car (2010 subaru forester) for about 10,000 miles. I noticed the transmission slipping. I brought it to the dealer. They found the engine oil in the transmission, flushed and replaced the fluid. The question is How badly is my transmission damage. The warrenty is now voided and I am afraid that I will need a new transmission fairly soon.
View 4 RepliesEngine light came on two weeks ago. Had the code read at Advance Auto Parts. Code = P0420. The only performance issue was that it stalled when I started it the other day for the first time since I bought it last fall. Are there any other clues to tell what it could mean (catalytic converter vs. 02 sensor vs. anything else)? Is it really worth trying some kind of catalytic converter cleaner product?
View 1 Replies