Subaru - B9-tribeca :: Check Engine And ABS Light Came On Along With Cruise Light Flashing

I've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.

After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.

On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:

Camshaft position actuator A - Bank 1 timing over advan.

Camshaft position actuator A - Bank 2 timing over advan

Cam/crankshaft pos. correlation sensor A - Bank 2

Cam/crankshaft pos. Correlation sensor A - Bank 1

Camshaft position actuator A bank 1 timing over - advan

Camshaft position adctuator A bank 2 timing over -advan

Cam/crankshaft pos correlation sensor A - bank 1

I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.

Is there something more major going on here with the computer?