Subaru - B9-tribeca :: Navigation System Hard To Use - How To Turn It Off
Aug 19, 2006
I'm finding the nav. system on my o7 limited tribeca hard to use. First of all, I can't figure out how to turn it off. It seems to always require a destination, and the only thing I can do to avoid it binging and trying to redirect me is to turn the sound off. Any way to tell the computer "I don't need direction to this trip"? Also the only time I've tried to use it, thr route it took me on used only surface streets, even though the freeway and a tollroad were nearby and I had entered "allow tollroads".
View 30 Replies
Advertisement
Since dec 31 my Nav screen goes black while driving, they only way i can bring it back is by shuting down and restarting the engine. But keeps doing it. Took it to deal they said they rebooted whole navi system but still doing it.
View 13 Replies
We have a 2006 B9 Tribeca we purchased used in April. We have had no problems until September when the "puddle lamps" (small lamps under the doors) shorted out and made smoke go into the cabin of the car. Called Subaru dealer and found out there was a recall notice for this problem.Made an appt. and problem was fixed. Now...in the last two weeks though, there have been a dozen instances where the car will not start.It will crank over two/three times and quit. It never fires up and runs.I never know how many times I have to do this before it WILL start. Right now,it has not started since last night. Side note....there is now a strange noise coming from the heater fan box as well. Second side note.When I turn the key to start it,the "Info Center" display dims.
View 1 Replies
2012 Prius five Navigation system not giving verbal turn by turn instructions last 3 miles to destination. Also failed on new Prius at dealer. Toyota corp said navigation is working as designed.
View 1 Replies
I recently purchased a B9 Tribeca I had it completely checked out, brakes, engine everything. Everyone told me it was fine, this past Friday/Saturday was our first freeze and snow. I went to get into the car around noon, so it had warmed up to maybe 40 by then, and I put my foot on the brake pedal and it didn't feel right at all. Thinking I was imagining things I put it into reverse and took off the emergency brake, and realized rather quickly I had no brakes. quickly put it back into park and popped the hood. My brake fluid was full (right below the max line), I let the car sit there and pumped the brake pedal for like 2 minutes. After it made it all the way to the floor it eventually came back to where it should be and appeared to work just fine. I drove the car without any problems with the brakes for the rest of the day. My question is should I get the brakes checked out again, or is there something specific I should have them check so I don't have to worry about the brakes next time it freezes.
View 5 Replies
I own a 2006 Subaru Tribeca with 125,000 miles. It has been well maintained and a great vehicle. On a recent long distance trip, after driving about 7 hours, going 70mph, the car started to buck and the accelerator stopped responding. It continued to lose speed as I pulled off the side of the highway. I turned the car off and restarted it and attempted to drive it but it wouldn't go over 10-15 mph. I didn't have any check engine lights. Called AAA and had the car towed 4 hours to our final destination. The mechanic has had the car for 4 days and can not find the cause of the event. I have a 22 hour drive back home in a month and I am extremely concerned. Did some research and have found others have had the problem but had codes come up. Research says it could be throttle pedal position sensor/ pedal assembly.
View 12 Replies
I change my own pads as a good lifetime warranty with free replacement from Autozone is great!
But with the Tribeca... I changed the front rotors just like all my other cars over the years.. and now there is pretty severe pulsation when trying to brake... I've checked the rotors and pad replacement twice now and all looks perfect.
I searched this pulsation issue and saw on a Jaquar site that you can ruin the ABS on some cars when you don't drain excess fluid as you push the piston back to install then new thicker pads..
Is this an issue for B9? I don't see it anywhere... I'm ready to bring it in the shop.. the pulsation ONLY happens when braking and gets more severe when stopping from progressively higher speeds...
View 3 Replies
I have Subaru B9 Tribeca 2006. Week ago started the following problems - after starting up, engine is shaking (rough idle) for a few (20-30) seconds and then it's OK. Then I got Check Engine, Cruise and ABS lights on. Diagnose shows mistake in 1st cylinder. changed spark plug, air filter, checked all connections, cleaned injector and throttle. Lights went out and engine was working as new. but the second day car had rough idle again....
View 1 Replies
I have had my 2013 Santa Fe Sport exactly one month. Before I drove it off the dealer's lot the Navigation system was dead and would not turn on. The salesman could not get it turned on either. So he drove the car into the service bay, shut off the engine, opened the door and had a service writer come to the car. They got in the car and the unit worked. The same thing happened again 30 days later. I pulled off the road, turned off the engine. Waited a few moments and restarted the engine. Still dead. I turned off the engine again, opened the door and waited 30 seconds. Got back in and started the car and it worked fine. I talked to the dealer about this and they have no knowledge of the issue.
View 16 Replies
2008 Subaru trebeca suv with only 62000 miles, when going up a slight incline in drive you feel quite a shudder like you were driving over small bumps on the road. This is my daughters vehicle so she phoned about 400 miles from were I live & told me what I said above. I told her it sounds to me like the torque converter is not unlocking. And if it is the converter not unlocking would that be a very expensive repair ?
View 1 Replies
I've got a 2006 Honda Civic Hybrid with Navigation. This morning, the navigation system did not turn on, and the screen- which is also the screen for the radio- does not work. I can still listen to the radio, but I have to use the steering wheel controls to operate, and I have to use the voice command to turn the radio on and off... the navigation screen is completely inoperable. To be honest, the only idea I have is that the fuse needs replacing?
View 4 Replies
I just realized that I should be hearing the nav system giving me audible turn notifications. And I haven't been getting them. I have a destination entered, and am in the middle of being guided.
Having the audio system on/off makes no difference
I have the voice guides turned on (via Menu screen)
I have the voice volume set at 7 (via Menu screen)
Turning the speed-adaptive volume on/off makes no difference (via Menu screen)
I am on what seems to be the original DVD disc (v3.0?) that came with the car
I have what appears to be a dealer/aftermarket installed rear entertainment system (not OEM)
So:Does the nav system audio have it's own speaker and dedicated channel in the ML amplifier? Or perhaps it's own amplifier
View 14 Replies
Is it possible to turn off the display screen for the Nav system? I mean turn it completely off, so the screen is dark.
View 3 Replies
I just purchase my 2013 ES 350. Now got home and now I realized I don't know how do I turn on the navigation system without starting the car engine. I am sure there is a way to do that but I don't know how.
View 1 Replies
I've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.
After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.
On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:
Camshaft position actuator A - Bank 1 timing over advan.
Camshaft position actuator A - Bank 2 timing over advan
Cam/crankshaft pos. correlation sensor A - Bank 2
Cam/crankshaft pos. Correlation sensor A - Bank 1
Camshaft position actuator A bank 1 timing over - advan
Camshaft position adctuator A bank 2 timing over -advan
Cam/crankshaft pos correlation sensor A - bank 1
I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.
Is there something more major going on here with the computer?
View 5 Replies
115,000 miles, adult driven. Hard cranking, took into dealer. Replaced 4 injectors - cylinder 2 misfiring. Showed me return gas line clogged with brownish material. Dealer stymied.
Now, Subaru headquarters diagnoses replacing all steel fuel lines, fuel rails, fuel pump...full of rust from inside. Tank looks Ok, as does filler neck. Premium gas used always, added Drygas seasonally as needed.
Question: where the heck would rust come from? What can I do to prevent this problem again? Love the car...would like to get 200,000 from it.
View 16 Replies
I just bought a 2015 Forester Limited and have put about 1000 miles on it. I love it, and it's the first new car I've owned in a long time, as well as my first Subaru. I regret to say that I've had already had some trouble it, which I hope does not portend future issues. I have had some problems with the power lift gate not opening using the button on the dash- it beeps three times but doesn't open, regardless of the position of the key in the ignition (car is always in park when I attempt it, and the owner's manual indicates that it is supposed to beep twice before it opens).
If I first use the key fob to open and then close it, I'm able to get the button to open the gate but why the gate won't initially respond to the switch on the dash. It's worth noting that this doesn't happen every time I try to open the lift gate using the button, so I've been unable to reproduce the problem for the dealer. Is there a software reset that could fix this, or is it an electrical issue?
The second issue is another intermittent one: the entire heating and cooling system wouldn't turn on after being shut off. I drove a couple hours with the AC on, shut the AC off, parked the car and then restarted it after an hour. When I tried to turn on the AC, I was unable to do so- the entire heating and cooling system was unresponsive. The AC button wasn't responding, I couldn't adjust the fan level, and the mode selector (vent/floor/defroster) wasn't responding either. I pulled over, shut the car off and restarted it and was able to turn on the AC without incident.
View 3 Replies
I have a steering problem in my 2003 forester when i make an extreme right it scrapes and is hard to turn. I took it to morn and they said it was the timing belt, they changed the timing belts and the problem is exactly the same.
View 2 Replies
I have a 2004 VW Phaeton.
Today, the sound system failed, then shortly after, the navigation system failed.
On the console, if I press any map/navigation buttons, the error message "Navigation System Unavailable" is displayed.
If I press an audio related button, the error message "DSP system is unavailable". I took it to a private vw repair shop and a vw dealer. What was causing the issue.
I am now headed to a vw dealer with certified phaeton tech. I looked towards fuse issue, but they appear to be ok..
View 10 Replies
My sister says that her navigation has been going out. She brought the car to the dealership and they said her entire nav system needs to be replaced. They can give her a refurbished unit for $800 + labor. The symptoms are as follows:
The screen will turn black but she can still hear the voices. The screen will come back on its own. She also gets an error message "external system not connected". She says that this could happen at any time, not just when the navigation system is being used. Also when this does happen it is as if the whole system crashes because she cannot control the AC heat and the radio goes out.
In my research i would say this was a nav ECU problem but I want to double check and so I am posting. I would like to know if the ECU from other model years can be used (assuming you carry over the same DVD version).
View 1 Replies
I have had a problematic navigation system that loses it way some times (loss of GPS signal). However it worked for sometime without problems till I dent my rear left side and had to be in the shop. I guess they disconnected the batteries and now the unit has stopped working. This is the relevant VCDS output. Most importantly I checked the adv measure feature to find the following statuses
CD ROM OK
GPS Antennae OK
Available Satellites 8
Satellites in view 0
GPS Status None
This was a clear day and so the unit is not picking up the satellites. However VCDS output shows no faults or anything.
Address 37: Navigation
Labels: 3D0-919-887.lbl
Part No: 3D0 919 887 A
Component: NAVIGATION 9968
Coding: 0400000
Shop #: WSC 02134 444 59226
VCID: 326BD7F1AE43028E5D3-5140
No fault code found
[Code] .....
View 3 Replies