Starting - Dodge - Dakota :: Starts If Hold The Key Fully Turned And Wait Much Longer Than 60 Seconds
Dec 1, 2011
I have a 2004 Dodge Dakota 2WD manual trans with 160K racked up. In the morning it does not like to start right away. I put the clutch down, key in the ignition, turn it to engage the electricity, say a prayer and turn. When it doesn't start nothing happens. No sounds. Nothing. If I hold the key fully turned and wait, sometimes much longer than 60 seconds, it starts and sounds just fine. Once it is running for some time I can turn it off and turn it back on again without hesitation. In colder weather it takes much longer to start.
View 4 Replies
Advertisement
I have a 2009 Hyundai Sonata GLS 4 Cylinder with roughly 100k miles. The car runs great, shifts great, drives smooth. The only issue I have is starting the vehicle. When turning the key the car cranks sometimes longer than normal and sputters a bit before fully starting. I feel somewhat of a jolt like the engine is firing but its not what I call smooth. The other day it cranked longer than normal started for 1/2 a second then died and I had to turn the key again to start. I have already replaced the spark plugs and air filters. A while back we had the fuel filter/pump replaced but I'm not sure what else to do considering that the car runs fine otherwise. I read something about an EGR valve and maybe it's a vacuum hose?...
View 8 Replies
Only started happening within the last month. 1994 V8 Dakota. When its warmer out, half the time I turn the key and nothing happens, doesn't even crank over, but if I tap the gas then turn the key, it starts right up. What this could be?
View 2 Replies
Here's what is going on with my 2000 Dakota V6 3.9L V6:
After sitting for at least a couple of hours, the truck will crank but not start. After 3-5 tries, the truck does start but idles roughly at a very low RPM for 10 seconds or so and then stalls. I turn the key one more time and it starts up great and idles and drives normally. This behavior is very consistent. I have only driven it about 5 miles after it started doing this, because on that trip, the engine stalled while I was driving. Occasionally the MIL comes on and gives P0443 as the code. Question is, can the evap purge solenoid cause this behavior if it is going bad? I have inspected the vacuum lines, and they seem ok.
One more note: When this first started, I was pretty sure it was the fuel pump. Replacing that has not fixed the problem, and the fuel pump relay is good.
View 1 Replies
I have a code scanner which indicated that I should change the MAP sensor. I did that, and just for fun changed the idle air control valve and throttle position sensor. Now the idle is extremely smooth in park or neutral, but once I'm in a moving gear it's up to the same shenanigans, antics and tomfoolery I described in my original post: 96 Dakota SLT idles rough & stalls. So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drivebelt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 Replies
i have a 96 slt v8 dakota im trying to fix myself. it wont start. put new batt. new starter motor. it just clicks engine wont turn everything in truck is working but when i turn the key to start its just clicks and my radio losses power. so i took out radio and still wont start...
View 2 Replies
'97 dodge dakota engine starts and vehicle will move and then engine dies. Just bought it and it ran fine. Coil was replaced by previous owner four months ago. At times it will run fine but is not reliable and wife will not drive in it. Had it towed to dodge dealer and they said it needed a new coil which they installed and still have the same problem and now think it might be the ecm which is mine even if it does not cure problem. Truck has 145k miles and otherwise is in good shape. When it does run, engine is strong, automatic shifts good and all accessories work. But, it won't keep running.
View 14 Replies
So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drive belt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 Replies
Cold start. engine starts but wont idle, just dies. rpms drop. Restart same. Must neutral drop to get going keep rpms up until engines shifts then things are fine until next cold start. Cleaned throttle, changed air filter, dry gas, injector cleaner, no warning signal, scans clean. 180k miles.
View 6 Replies
I have a 1995 Subaru Impreza that I have been nursing along for the past 14 years. Recently, if I drive for a decent length of time (~10 miles), turn the car off to go into a store, and then try to start it up again, it won't start. It turns over fine, but never fully starts. If I let it sit for 20-30 minutes, it will start back up again. The temperature gauge reads normal--between hot and cold. Is there another temperature sensor that might be malfunctioning, telling the car that the engine is too hot to start? Where/what is this called?
View 6 Replies
The truck had a hard time starting, turn the key over hear that it wants to, but won't. Once getting it started, truck would drive fine, but after about 10 minutes just dies while driving. It then took 6-7 tries to get it started again, drove back like no issue. What it could be? I have come up with, potential battery, fuel pump/filter, spark plugs, EEC relay, PCM, or AIS motor, O2 sensor....
View 2 Replies
I drive a 1996 F-150, 188,000+ miles. Sometimes when you turn the key in the ignition, nothing happens. Absolutely nothing. But if you wait about 2 minutes, the truck starts O.K. This has occurred a couple of times when I was starting out and killed the motor by not giving it enough gas. But it's also occurred when the truck has been sitting for a number of hours or even overnight. It never fails to start after about a 2 minute wait. What's going on here? I've had the truck in the garage, but they couldn't replicate the problem and didn't do anything.
View 2 Replies
I have a 2006 Dodge Grand Caravan SXT with the 3.8 and 135,000 miles. Whenever it is hot out and the engine has been running it is hard to shift either from park or back into park. Today it completely froze on me and I had to wait for it to cool down before it would shift into park. Temp out is about 80 today.
View 2 Replies
The AC clutch on my 2000 Town Car has an intermittent engagement, when the AC is on you can see it clicking into position where it will hold ok for a few seconds, and then it disengages, and so on and so on. The AC puts out cool air and I checked the pressure connecting up to the low side port with a gauge yesterday. Plenty of Freon in the system. Right now I am operating on "vent" to keep the car inside cool.
The sales man who sold me the Lincoln thought it was low on refrigeration, but I thought it was the clutch. Could it be a wiring issue, or a faulty switch? Ironically the small Ford wagon with a 4 cylinder engine I almost bought the previous day had the exact same problem, and both of them had around 102,000 miles. So it is something that all Ford products can have.
View 5 Replies
97 Dodge Dakota Sport V8. Has spark, turns over, won't fire.
View 1 Replies
My dad has a 2001 Dodge Dakota extended cab with a 3.9L v6 (standard transmission). It will start and run for a while and it will die, if you turn the key it will start up again but will eventually die. He has changed the spark plugs & wires, the distributor cap & rotor, the MAP sensor, and the throttle valve sensor. It still does the same thing.
View 1 Replies
So, my oil light comes on after startup like usual then shuts off. Anywhere from 2-5 minutes of the vehicle running light comes back on and does not shut off unless I restart the vehicle. Have changed oil pressure switch and oil pressure is reading in the normal range..
05 dakota with 175000 kilometres
View 19 Replies
1999 Dodge Dakota
3.6 liter w/air conditioning
I'm pretty sure I made a mess of things. My Serpentine belt was all cracked and making noises while idling and driving. It was time to replace it. It's a long story, but my auto mechanic told me to drive my truck for a week and then give him a call. Well.... I didn't do that. My battery went dead and I charged it up and it lasted a month. Yesterday, it wouldn't start so I bought a Serpentine belt and installed it. As far as I know, I didn't damage anything while I was working on it.
The battery was still dead and I charged it, however, the key was turned on while I was charging it. I don't know how I did that, but I did.
The problem I'm having is that the engine is now idling at 2000 RPM. I scanned it and there are no codes or pending codes.
Today, I went out and drew a diagram of how the belt is routed and it's the same as the diagram under the hood. I had a friend take a look at it and he agrees that I put it on correctly.
View 7 Replies
I have had this truck in 3 different shops and none of them could figure it out. The codes say misfire in cyl 2 and 5 bank 1 too lean and primary and secondary circuits malfunctioning for ignition coil. I've replaced the ign coil cap, plugs,plug wires, rotor, pcv, fuel pump, pick up coil, cat, o2 sensors and all sensors under the hood. Switched out all vacuum lines, cleaned the IAC and checked the pulse ring. The truck loses all power and either dies or backfires and regains power randomly. If I drive at night, it will stall and keep cranking when trying to restart. Usually have to let it sit for ten minutes for it to turn back over. Last night it backfired and stalled every 50 ft for over a mile. During the day, it revs up and down at idle by about 100 rpms.
View 6 Replies
Have a 2002 Dodge Dakota automatic. This winter when temps. dropped into lows 10s and zero degree weather, the Dodge truck would start,but would not come out of park gear. Have replaced interlock solenoid and brake light switch. Still have same problem when Temperature drops into low 10s &below. Otherwise,everything ok. (not using ER brake).
View 5 Replies
I have a 2003 Dodge Dakota. A couple of years ago I was driving along and the radio just cut out, with no problems prior. I didn't go over train tracks or anything that would jar it, etc. It continued to not work for the next 6-8 months or so, but would occasionally cut in and out. After a period of time the radio suddenly began working again. The radio continued to work for a year or more. A month ago, I'm driving down the road and it again, cuts out. But now I can somewhat hear the radio amid the static. The best way to describe it is what happens to the reception when traveling under high voltage wires. Antenna is secure.
View 1 Replies
