Start - Ford - Explorer :: 1996 - O/D Off Light Flashing
Jul 8, 2011
Was driving into town today in my 96 Ford Explorer XLT v6 4wd, when I noticed my O/D off light flashing. I thought to myself, "Another problem I have to bash at with a wrench to get going again." I figured that meant I'd be stuck with gear 1 and would burn some extra gas on the ride home, but after parking and running an errand, woe behold me but my car won't start! The starter turns, but no other noises come out of my now very-large paperweight. I've tried shifting into neutral, moving the car to get the gearbox turning, starting the car in neutral and park, yet the stubborn car remains dead. Am I drawing a connection between the light and the failure to start where one need not exist?
View 4 Replies
Advertisement
1996 Explorer xlt 4.0l ... I ran into this issue a few years ago on a drive up through the mountains. Had the tranny replaced shortly after.
Rebuilt the engine once due to leaking head gasket.
Rebuilt it again 2 months ago due to leaking rear main seal.
Had a new torque converter installed during last engine rebuild, so tranny has been shifting and driving like a dream.
Just drover about 30 miles on highway, all pretty flat. OD light started flashing. I didn't notice ANY change in the way it was driving, sounding, shifting... anything! I know this is some sort of oddball error with this transmission in this vehicle, but i need to know if it requires further investigation.
Also, sometimes upon starting up (i am a pizza deliver, so i often shut it off and start it again 1 minute later) the OD and (i think) the 4x4 light flash at the same time, and my windows wont work for around 15 seconds. I've also noticed that my ABS will sometimes kick in randomly on dry ground during slow stops.
I am not in the mood to just start dropping cash on random sensors or modules or repairs if i can find any solid evidence of an issue (i've been battling an EGR issue for 4 years). I was thinking maybe the vehicle speed sensor?
View 1 Replies
My 1996 X with the 4.0 has developed a flare from 2-3, and the O/D light flashes. It still drives well, but it's bothersome, to say the least.
I'm hunting a replacement tranny, and am wanting to know which year X's to look at as a donor.
View 6 Replies
I pulled the wrong fuse, and now my air bag light is flashing a 5 2 pattern, and then stays on continuously.
it's a 96 OBD II - so I don't think I can do the "short the 2 pin gray connector" trick, or can I?
I pulled the right kick plate, and see the AIR BAG module, etc the fuel inheria switch mounted on the firewall, but no sign of that 2 prong plug....
so, how does one reset or clear this 52 code - I know that it was a result of me pulling that fuse, as the light was perfect before, and no issues.
I googled this topic, and still can't seemed to find this... will I need to take it to a dealer to have them flash the Air Bag Code?
View 14 Replies
I just brought a 1996 Explorer 4x4 V6 XLT from a friend thinking it was an easy fix by answers I found of the problem on the net. Even search threw the threads here. Right now my OD light is flashing and the speedometer is bouncing around not detecting the current speed. Also it's not going into gears smoothly. I've replaced the VSS as well as the gear on the end of it. What was the fix for it?
View 4 Replies
The air bag lite is flashing 3-3 when you start up the truck. After several 33 codes it stays on constantly. I look up on internet and 33 is "passenger air bag open circuit". Pulled the glove box door and disconnected the wires and wiggled and reattached, still have code.
View 7 Replies
My 2000 Explorer overheated and I had water pump and intake manifold replaced.. then it had a freeze plug rust out and its replaced, I'm holding water.. but now it just wont start.. we've tried everything from changing fuel injectors, fuel delivery unit on intake, now the fuel pump is changed.. still wont start and the theft light is flashing fast.. my dad changed computers while I was out of town,, is it the theft device or does the computer need coded for this explorer?? we have taken negative off battery but nothing.. And if I change the motor will that work or still not run because of theft light or computer??
View 3 Replies
My 2000 Ford Explorer O/D off light starts flashing after driving it after 3-8 miles from starting out. After shutting it off, it resets itself. It seems to stick between 2nd and 3rd (automatic trans) because I get a surge on my RPMs. I took it to two places, spent $200.00 and the problem remains. The tranny shop actually changed a "range sensor" and thought it was fixed. Nope - O/D off started flashing before I even got back home. I've been looking on the internet and it seems that alot of explorer owners have been having the same types of problems. The shops I have talked to have no idea other than rebuild my transmission. It only has 46,000 miles on it! It seems to me that the overdrive is not kicking in when needed and the light comes on.
View 14 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
How to reset the Anti Theft on my explorer? The light is flashing fast and the engine won't start. Without the anti theft being reset the truck won't start. Been checking around to find an answer but can't find one...
View 7 Replies
I have a 97 Ford Explorer. I bought it in 07 and it was nice until like 2 years ago when it started to give me doubts. It never died on me,yet, but everyday when I first start it for the day, if I put it in gear right away, it will stay idle for a while and then kick into gear and just jump. I would drive but it keeps kicking off and on until it is warmed up, I guess because it goes away. Also the OD light would come on also.
View 2 Replies
I have a 1996 ford taurus dohc v6 147239 miles..when i get over 60 mph my overdrive light starts flashing and the car still drives find..i did have new transmission fluid and new fillter put in and the light was coming on before i did that and still comes on when i get over 60 mph.
View 1 Replies
Parked in driveway and 2 hours later it cranks but will not start. Pushed on fuel rail Schrader valve and it squirts out. Turn key and the fuel pump runs for 2-3 seconds then off...... Thought I had fuel... assume electrical. Read posts last night and thought crank positioner pickup was a good place to look. Took spark plug leads off #1 and #4 at coil and set a 1/4 steel dowel in each so they were 1/2 inch apart. Crank motor and I get spark out of coils so I assume the plugs are getting fire... Took off intake hose and shot ether in the tube while cranking... no fire or pop at all.
Where to now ? Seems like I have fire to the plugs, and fuel available but will not start. I have only one code and that's PO1116 coolant temp out of range..I don't have a cam sensor code or a crank sensor code...I thought they might effect the timing ? With spark at the plug wires, you would think I would get a "POP" now and then, especially with the ether ?
View 8 Replies
Got an air bag code 41. Comes on and flashes the code a number of times, then goes off for the rest of the ride. It is a 96 Arerostar, XLT, 4LV6. From what I read it is a short someplace. Where are the crash sensors and how do you check them for "shorts"? I don't understand much about the whole system.
View 12 Replies
I am having a problem with my 96 ford explorer.
Usually this only happens on warmer days, but after a few starts, my car will suddenly not turn over. I have found that the only solution to starting it is by pumping the brakes about 6 or more times, fast and hard. Its not the battery because all lights and everything work.
Something it may have to do with, I just found out when going to get my car smogged, my monitors reset everytime I turn on/off my car.
View 1 Replies
I have a 96 v6 explorer that has lost spark and fuel press....
View 4 Replies
Just recently purchased a 2004 Eddie Bauer Explorer w/ 110k. Took a Snap On scanner with me to look at it. ABS light was on and I also get a 4x4 high flashing light every 2-3 minutes. Blinks 8 times then goes away. Scanner showed the RF speed sensor isn't sending any mph signal back. Just reads 0. Will my problem be a new sensor or is the sensor getting a dirty signal trying to read dirty teeth on the hub? Also, will fixing this stop out with the blinking 4x4 light?
View 1 Replies
I have a 1996 4.0L Sport - 2 weeks ago, stranded wifey at food store, had it towed home, and replaced the starter solenoid - it started and ran for about 4 days, and then stalled once but started back up (it was cold out)
Another day, I went out to start it, and the same thing... loud click when you turn the key to start position, seems to be coming from solenoid again...
so, I thought, ok, the parts a week old, but sometimes they do fail...
So, I bought the best one around: standard "blue" which had brass on the back to best couple to ground, etc...
Put it in, and reconnected everything - and the SAME THING... clicks every time I turn the key. (single click for each time I try to start it....
questions is - how can I check these to see if I had 2 bad ones in a row, or would there be something else wrong?
View 14 Replies
Any reason why the OD light flashes, and how to fix it with out spending an arm and a leg?
Light flashing on a 99 ford Explorer.
View 3 Replies
Recently my check engine light came on. I understand this isnt such a big deal, but then my engine started "skipping", and my overdrive light is now flashing. my car will stall if i come to a complete stop without putting it into park or nuetral. I dont know what to do.
View 7 Replies
How do I get abs light to go off? I removed and cleaned all sensors, checked all wiring, fuses, and diode. I also used a a scanner, and it tells me there are no error codes. What do i do now?
View 12 Replies
