I have 2004 Chrysler Sebring base model 4 cylinder with 90,000 miles. Paid off long ago. The schedule says its time to change the timing belt but no symptoms. No other issues and have kept up the maintenance. The cost is around $1000. I need the car to last 2 more years until our new car is paid off. Should I do the repair or play the odds that it won't break down?
View 19 RepliesI purchased a 2005 Opel Corsa C 1.8l with around 70k miles. The car is in a fantastic shape, I've had it for around 6 months, having driven around 6k miles. The first maintenance I did was changing all oils and filters, and changing the accesory belt (the one that powers the alternator, that one is not dented). I was told back then at the workshop that the timing belt (not sure if that is the correct name for the belt with dents that syncs valves, etc.) was in a good shape. I don't know if the previous owner/s ever changed it. I understand that the damage done when that belt breaks could get pretty serious, with bent valves, mainly. The question is, should I change the belt now? How long do those last?
View 13 RepliesMy camshafts got moved while replacing tb & wp.v6. Can I get TDC bringing #1 valves closed & #4 valves open & then bring crankshaft the TDC mark? Interference engine, valves not damaged!!!
View 7 RepliesI was wondering if the timing belt on my 05 RX 330 needed to be changed due to age and not miles. The car only has 72k miles on it but it is 10 years old.
View 5 RepliesAfter timing belt change code P0016 with Check engine light trac off and VSC light on.
Put on the entire kit...timing belt,tensioner, idler, and water pump. When I took it apart to put the new cam crank sensor I inspected everything and all looked good.
Changed the sensor and reset code, a few hours later back on. Car seems to run fine. I didn't think the sensor was bad. Car was running great...just due for timing belt.
I have a 2005 Chrysler Sebring. In December the timing belt failed while I was driving down the road. I had the dealership I purchased the car from replace the timing belt as well as the water pump while they were at it. Ever since I have had and issue with it vibrating at idle. At first it was making a whining noise as well. I took it back and they told me that they had installed the belt too tight. Afterwards I still had an idle issue although the vibration was a little different. I also could distinctly hear the belt hitting the casing a few times.
I took it back again and they stated that the belt had been put on too loose. So now they have adjusted the belt again and it I am no longer having the whining or belt hitting the casing. But I still have an idle issue. It has changed again and is kind of a pulsing vibration. I can feel it in the brake pedal when I am at stops. I seem to hear the pulsing while driving as well but this may be from my new tires as well.
During this whole readjustment process they have not mentioned actually checking the timing. Just the belt tension itself. When I first reported the idle issue after they put the timing belt and water pump on they told me that it could not be related to timing and that it had to be an ignition issue. But I asked a work associate who used to work as a mechanic and he stated that it would be a timing issue.
I am going to contact the dealership and ask them to check the timing belt again. I never had this idle issue before the new timing belt.
Earlier today i noticed a loop hanging under my car. When i removed the item it turned out to be my AC/Alternator belt. Thinking it was bad i went ahead and got a new one. Prepared for a hard battle i find that the part slips on easily. now i can not get the belt tight at all it had about an inch or 2 of slack. I do not have a repair manual and i do not have the money for one. I can not find a diagram for my specific engine. It is a 2001 Chrysler Sebring with a Mitsubishi 3.0L 24 Valve Engine. What am I doing wrong? I need this fixed to go to work tomorrow.
View 16 Replies2004 Accent 1.6L
Changed the timing belt and water pump this past weekend. I made sure the timing marks aligned before I put the belts on. They were still aligned after turning the engine by hand and still aligned after taking the car out for a test drive. I did not notice rough idle when I started the engine in the garage nor did I notice a rough idle during the test drive.
A few days later I am now noticing the car will idle roughly when I come to a stop. The idle will get rough enough to gently shake the car. No engine light and no unusual noise from the engine.
I am going to check the timing marks again tonight. I suspect the belt may actually be off by one tooth. I have driven over 100 miles since changing the belt so I don't believe it is off anymore than one tooth or else I presume I'd probably have already broken down or been hearing unusual noises.
Furthermore, I do not seem to have any loss in power. I still have good acceleration and no roughness unless at idle engine speed. I do, however, run rough at higher speeds (75+ mph) on the highway, but this was present before the timing belt change. Unfortunately the car does not have an RPM gauge.
Having said all of this, are there any other possible reasons why I might be idling rough now?
I was told that I must replace the timing belt every sixty thousand miles. Is this true?
View 24 RepliesI have a 2009 Elantra (automatic) that already has 52K miles on it. I drive a lot mostly at highway speeds. I know several people who recommend having the timing belt replaced BEFORE the warranty runs out at 60K miles.
The dealership has a 60K inspection where they "inspect" the timing belt (plus a whole lot of "fluff" checks, tire rotation etc) I'd rather just take it in and get it replaced. What should a timing belt replacement cost?
My 2001Honda Civic EX (manual) has only about 46,000 miles on the clock and runs very well. My mechanic says I should consider replacing the timing belt (the manual suggests after seven years). I plan on keeping the car for many more years -- should I replace the belt now? How devastating is it if the belt breaks while driving?
View 5 RepliesI have a 2005 Toyota camry solara with 66,000. Does the timing belt need to be done now due to age of the car?? Or wait alittle longer?
View 4 RepliesSo after saying "We don't work on that model" when I asked for a timing belt / water pump change (yup, they actually said that), I went in today to try and get a second key made since the guy I bought the Phaeton from only had 1. I do not have the little code. I was told that there was nothing they could do without the code. My only hope would be to contact EVE directly.
View 2 RepliesI just changed the timing belt and everything runs great. I pushed the AC button and no light came on. I checked all the fuses and they are good I took the H and L caps of and tapped the pin and there was air blasting out. Don't know what it could be? All I did was loosen the compressor and remove the belt and put it back on.
View 2 RepliesMy dad changed the timing belt on my 99 CR-V in August and he had some trouble getting it in time (he had to tear down and put it back together 3 times!). Sometime after the timing belt/water pump/spark plug change, I noticed a vibration in the steering wheel while at a stop and a loss of MPG (went from getting 24 mpg to 22.7).
It did not happen immediately after the timing belt change (or at least i dont think it did) so i thought the mpg loss might be due to the changing weather and the vibration coming from a motor mount that i knew was broken, but I got the motor mount fixed and it did not do anything. I think that the vibration has gotten worse, but it seems to be at its worst when the car is really cold. (this morning the temp. was 9 degrees and it vibrated harder than it ever has).
The vibration only happens when the car is in park or at a stop, and it goes away when i accelerate, even if I only accelerate a little bit. I have not noticed a loss in power, or any sluggishness in acceleration. I have tried to research this, and I read something about the drive belt being out of time, but I'm not savvy with cars so I just don't know.
What could be the cause, do I HAVE to get it fixed, and what do you think a reasonable cost to repair is?
2002 galant 4cly overheating! So my Galant has 120k miles and I just had the timing belt replaced and I thought I'd be good and have the water pump replaced as well. When I got it back I made a few short trips with it and it was running fine then I took a longer trip about 30 miles and I noticed it was overheating, so I took it back to the shop they thought it was air in the cooling system so they preformed a few flushes, replaced the thermostat even though it was new and then replaced the pump again and the radiator cap, the radiator it's self was replaced maybe 1-2k miles ago. I don't believe the head is leaking since I'm not losing coolant and the oil isn't milky.....I'm at a loss, could the thermostat be the problem? Do I need one from the dealer? Is there a history with replacement pumps bad?
View 12 RepliesMy mechanic just did the timing bet, water pump and other belts. Also changed the tensioner.
Car runs fine and everything seems great until I get to a red light. The engine sounds louder then before. Not very loud but its louder and maybe a very slight vibration, not sure yet. No noises while driving, seems like its running the same or better then before. Runs fine though
I have a 2005 Toyota Camry with 120K miles that was bought used with 110K. The previous owner did not have the vehicle long and did not know if or when the timing belt had been replaced. I have read several blogs that recommend replacing the timing belt at 60 or 90K. To err on the conservative side I decided just to do it at 120K. Now my problem. Before the timing belt change there was a slight knocking from one of the cylinders. After the belt change the knocking is more pronounced. Q. How concerned should I be that the knocking is more noticeable? Could this be a by-product of the new belt and as it loosens the knocking will subside somewhat? OR, am I looking at valve job or worse?
View 8 RepliesWe just had our timing belt changed today as well as the waterpump and fanbelts. It has a loud whining noise now and I don't know if it is even safe to drive back to the mechanic...
View 3 Replies1987 Acura Integra AT with 158k... Water pump broke after 75k miles (in 18yr period)....
I am wondering what else should I have it done:
- thermostat
- oxygen sensor (is there one?)
- vacuum tubes (I hear that these fail due to age)
- anything else?
Are these near where they will be working on? Any other tips?
What is the recommended interval for the timing belt change? I have a '96 B2300 with ~85K on it and he original timing belt. I wanted to change the serpentine belt and my mechanic said he'll take a look at the timing belt. It's not cracked or anything but he says that after 8 years it should be changed.
View 14 Replies