Saturn - S-series :: 2001 - Car Only Goes In 1st And 2nd Gear / No Neutral
Jul 10, 2011
I was on my way to the store earlier today. Started the car, put in reverse, backed out, no problem---just like any other day. Put in first gear then started rolling. As I neared the RPM to shift to second, the gearbox was wobbly (which was strange), put it into second, then I had to downshift. It felt wierd. I pulled over. Car only goes into 1st and 2nd gear, I have no neutral and can't get into the other gears.
Some nice guy came up to me to see what the problem was. He told me it might be my clutch cable. He was nice enough to stop traffic for me so I could flip a u-turn in 1st gear to head back home.
So I'm home now, clutch can go into 1st or 2nd. Clutch feels normal, gearbox (where shifter is) is loose. I have a 2001 Saturn SL, I just hit 200,000 miles. I love this car. Runs great until today, just cant get into other gears or reverse.
View 30 Replies
Advertisement
I have a manual transmission and am having difficulties with my stick shifter. I had my car in neutral with my foot on the brake, and when I tried to shift into first gear I was unable to get it into gear. I wasn't able to get it in any other gear as well. Once the car was turned off though, I had no problems getting into gear. But when I turned the car on again, I wouldn't allow me to get anywhere but neutral. After about 10 minutes being off and not moving, the car shifted like normal again and I was able to drive it without a problem.
View 1 Replies
My car has 190,000 miles on it, automatic transmission. About 1.5 years ago I had issues where it would slide into and out of drive gear. I was told valve body had crack and it was replaced. Transmission worked well. Today I went to friend move and not long after leaving acted funny driving and then felt like something 'gave' in drive train and it only went up to second gear and then only first gear would work. Shifting up and down with lever wouldn't change anything, first gear works fine shifting in and out, just doesn't go up into second or drive, and reverse doesn't do anything. I was told if cv joint had given way, there would be clunking, no clunking. Told that maybe it was low fluid, but checked just now standing still and fluid is at or above the full line and looks very clean.
View 1 Replies
Rebuild on the Mazda 5 speed transmission. My 1986 Ranger 2.3 Four cylinder has 280,000 miles and the clutch has never been replaced. It's not slipping but I'm having trouble getting it into gear from neutral. Was told that the release springs on the clutch plate have weakened causing the clutch to not release completely so figured it's time to replace it. It's done well the last 280,000 miles. The question I have : overhauling on one of these Mazda trans and how difficult was it. Any special tools required, etc...I see Autozone has a rebuild kit which appears to have bearings, seals and gaskets. Figured while it was out I would go ahead and rebuild it myself if I can. Rebuilt a few engines but never touched a trans.
View 4 Replies
I have a 2001 Saturn sl. Within the past two weeks I've been having issues with my car needing jumped to start. I've replaced the starter last year. The battery is only a few months old and have had the alternator checked. I put my car in neutral and my car died...
View 1 Replies
Sons saturn will not go into gear after a hard braking action. The shifter will move, the car just acts like it is in nuetral, engine revs with gas, no movement in any gear or reverse. After waiting for a few minutes he can put it in gear and go as if nothing happened. I have checked the fluid, its nice pink and clear and full. He says it has happened 3 times in the past week, has driven it for over a year with no major problems. He is 17, but seems decent with a manual.
I have tried to replicate but can not the car drive good, no shifting problems on normal driving and no check engine lights.
View 5 Replies
I have a 2005 Elantra GT hatchback that I love with a 5 speed transmission. Lately every time I'm in 2nd gear, the transmission will pop out of 2nd into neutral. This only happens in 2nd gear. I heard it could be the shift collar (i.e. teeth?) that aren't grabbing in that gear.
View 5 Replies
I drive a 2001 Toyota Tacoma 5 Speed manual and as recently as last Friday it seems to have developed a problem with third gear. Occasionally the gearshift will actually pop out of third gear back into neutral. It has happened randomly, but also it has happened at least once when I hit a rather large bump, it seemed to have literally knocked it loose from third gear. On one occasion I tested to see if I could pull it out of third gear without stepping on the clutch, and it worked once, but I have tried it again and it doesn't always let me.
To counter this problem I have been just pushing on the stick all the while in third gear to prevent it from popping out and that seems to work, but I'd like to find a real fix for it, and as usual, if possible, a cheap one.
View 10 Replies
The title says it all. I have no CEL.
View 4 Replies
I had a problem with the CV Axle and the Wheel Bearings. I replaced them already and I ran into another issue with the Wheel Studs and the Ball Joint, so I ended up replacing them as well. Yesterday I put everything back together after replacing all the parts mentioned before and I made sure everything was bolted down and tightened, and then the tire back on and lowered the jack. I started up my car expecting it to drive just fine and it was harder to get into gear than before and it wouldn't move in reverse, neutral, or drive. I called a Monroe Muffler around here and they told me that the CV Joint is probably not seated all the way inside the Transfer Case.
So later the same day I took everything back apart and made sure that I put the CV Joint back into the Transfer Case and I put the pin back in and made sure that both CV Axles would turn at the same time, which they did. I figured it was good so I put it all back together again and went through the same process as before, making sure everything was tightened down, all the bolts and nuts and pins were where they needed to be. Everything seemed to be good. I put the tire back on again, lowered the jack, started the car and attempted to drive it again. It still won't move. Why this is happening.
View 1 Replies
Have a 2003 Saturn Vue with a variable transmission (rebuilt). It will only go in reverse even when in drive, or natural.
View 5 Replies
Have a 2008 Saturn - 30,000 miles. Most times it only starts in Neutral first time of day it is used. After this, fine. Had with dealer mechanics for 2 days and they say they can find nothing wrong. Can't do anything unless they have the problem.
View 3 Replies
Brother in law has the above truck with shifting problem. On a cold start, pulling out of the driveway, it will get to about 3-4000 rpm and will slam into gear. Sometimes its worse than others, but is consistant. Once it warms up, the problem goes away for the most part.
I've researched a little online and have found a few people mention the 1-2 shift accumulator (servo...?) and was wondering if any of you have ran into this or have replaced one on the A4LD.
And if you have, which servo is the 1-2 shift? I think there are 6 of the little suckers in there. Anyway, all i've done so far is fluid and filter. Old fluid looked/smelled fine.
View 6 Replies
My car will start up and go into reverse no problem. However, once the car is warmed up (which I think it warms up a little quickly) it won't go into reverse. The problem has been getting worse for a year or two, but always works fine when the motor/transmission is cold. Also, going down the highway, it runs great and the engine never gets too hot. Is it just a transmission going out, or is it a cooling issue?
View 2 Replies
I have a 95 Saturn s-series with trouble starting when cold. Sometimes it take 5-10 minutes to get it started. When it does start it is all you can do to keep it running. I have had it to 2 different repair shops spending way too much to not have the problem fixed.
View 30 Replies
I just put a new hydraulic system and clutch in my brothers 2002 Saturn sl1. Now we tried to start it yesterday and nothing. Just barely clicked a few times at the starter. I tried jumping it and checked all the connections I could think of that came off while doing the clutch. Nothing. So as I was pulling him home from the shop I had him try to jump it at a slow speed and what do you know fires right up. When we got it home . Turned it off and again nothing it just clicks. So my question is would it be the starter , maybe battery cuz it had a terrible looking ground connection or is something else misaligned on the flywheel. I wouldn't think so since it started and all the gears worked. Its a manual obviously.
View 1 Replies
This morning the button on my brake handle popped out. Any DIY fixes for this? I will be taking it apart and looking at it asap but wondering why this happen.
View 9 Replies
I have a 2002 saturn l series and we rebuilt the radiator because it had oil in it and know the car wont start but, their is no water in the oil, is it possible that the oil cooler broke.
View 3 Replies
I have a 2012 L100 Saturn with just over 189K miles (yes, it's been an awesome car). In October 2012 I both sets of breaks replaced plus rotors. About 2 months after the service, I started hearing a knocking and grinding sound coming from the bottom of the car, about 80% of the time when I apply the breaks. The car does not make the sound if idle or while accelerating. The knocking seems to be loud at times and less present other times. The grinding sounds like a large wire cable is being pulled right underneath the car.
I took it back to the break place and they replaced the Master Cylinder under the warranty. The sound went away for about a month and then came back with about the same frequency. Took it back to the same place and this time they replaced the Wheel cylinder. Sound again went away, but this time came back 2 days later. I'm puzzled because for some reason the sound seems to go away and come back when the car is serviced. It;s also not consistent, but it's there. Not sure what it could be related to if not the break job. I'm bracing myself for some really bad news as this car has been a life saver since I bought it.
View 1 Replies
My daughter just gave me her 2003 TB, about 180,000 miles. She never serviced the tranny but changed the motor oil religiously. She went to take it out one day and it wouldn't shift out of 1st. There was no warning, such as, sluggish shifting, hard shifting, slipping.
I dropped the pan, (no metal shavings just some grey slimy gunk) changed the 2 shift solenoids, filter and fluid. Now the TB has first and second but acts like it goes to neutral in third (no third). Before I give up on this tranny I was wondering if there is anything else I should look at: vacuum leak, known electrical issues with the tranny, PCM. It does not set any codes.
View 3 Replies
Do I need to do anything other than disconnect the battery to disable the airbags on this car so I can replace the ignition lock?
View 30 Replies
