The key will not turn to off, stuck in acc. I have no power to the windows, sunroof, seat and seat heaters, and no brake lights, and the mirrors have no power either. I took the car to the local GM dealer who told me the ignition was not in any recall and found that the Body Control Module was bad and needed replacement.
View 5 RepliesIt's a 2001 Chevy cavalier. The key is stuck and won't turn the car off. Already have tried shaking the wheel and wd-40. The wipers won't work and the gauges won't turn on until I jiggle the key.
View 4 RepliesI just got a new-to-me 2007 4.0L Explorer . When I turn the ignition to the on position, I get a message that says "Check charging system"...
Once I start the engine it goes away. Is this normal?
My battery reads 12.6 with the engine off and 13.8 with it on.
There are two 12V power outlets inside my 2005 Saturn VUE. They always have power available, whether the car is on or not. I'd like to change that. Is there an easy (or somewhat easy) way to make it so that the outlets only deliver power when the ignition switch is in the on position?
View 2 RepliesI have a 2001 Saturn L200, in great condition—other than that the wipers are in the upright position, like goalposts. They work fine, turn on and off perfectly, but they always return to the "up" position on the windshield. As far as I can tell the rest of the electronics (i.e., lights, signals, etc) still work fine. A couple months ago the wiper blades started to slowly inch their way up, stopping at increasingly higher positions until they finally stopped where they're at now. A mechanic I talked to said that the wiper switch is burnt out and it would require ripping out the dash to replace the wiper motor, while a friend of mine thinks resetting the switch is all that's needed.
View 7 RepliesI have a Saturn Ion 2, 05. I will intermittently not start. I put the key in the ignition, power comes on, turn the key, it clicks a couple of times and then everything turns off. The key is then locked in the ignition. It is a new key. My old key looked chewed up. The only way to get the care to release my key is to open the hood and wait a few minutes and then shut the hood. Power will come back on and it will release my key. I used to be able to start it after that but now it seems like it is becoming more and more difficult to start it. I have read about a loose fuse box under the hood, replacing battery, replacing ignition switch and resetting passcode. Im not sure where to start first. I do not have the extended warranty and am on a tight budget.
View 7 RepliesI have owned my Saturn Outlook XR (2008) for a short 2 months. My a/c stopped working about 3 weeks ago. Replaced the blower motor and air would then blow again but the a/c still does not work. Had a mechanic look at the vehicle for me and turns out that I have that haunting saturn outlook hose rubbing together causing a leak problem that so many of you have also experienced. My low pressure line is leaking. My mechanic explained what an extensive project this is, not due to the actual parts, but, the labor to reach this hose then replace it. I am not thrilled about this problem. I do not want to be paying more money out of my pocket to fix a vehicle that I haven't owned long enough to have these kinds of expenses. This clearly is an issue in more than just my vehicle and GM is not taking responsibility for this poor placement/planning of the hoses and recalling this part.
View 1 RepliesHaving problems with Saturn Outlook, sunroof leaking?
View 30 RepliesI have a 2008 Saturn Outlook, 88k miles that shudders at 35mph when accelerating. Does not matter if the car is hot or cold. This problem (there are others) started after I had my tires aligned. It does not pull to the left or right it just shakes and shudders at 35 mph and goes away. I thought maybe it was the spark plugs, but darn if this stupid car company did not build this so you (the regular folkd) can change their spark plugs. Have to remove the exhaust manifold etc. or pay a mechanic to replace them. After this started I had to have my water pump replaced, while it was in the shop I had them run a diagnostic and nothing shows up except the water pump issue and that my timing cover needs to be resealed.
View 2 RepliesI have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.
None of my 4 keys will operate my ignition switch.
It's stuck in off position. Steering wheel is not locked and I have pulled pretty hard on it to see if I could get the ignition switch to turn.
I have a new switch on the way but I have to get the old one out and don't know how to get old one out if I cannot turn the switch to on position.
How do you remove low beam bulb, on passenger side.
View 30 RepliesI have a 97 Bravada. Recently the check engine light came on and then went off. I didn't think anything of it at the time till the other day I drove it to work and back fine without any issues, then the next morning I tried starting it and nothing happened. No cranking, no interior lights, no sounds.
I tried jumping it thinking the battery was dead but that didn't work. Now my key is stuck in the ignition in the accessory position. It will not turn all the way back to release the key.
Quite awhile ago my key started to randomly get stuck in the middle ignition position but it was happening very rarely and some gentle jiggling was letting me take it out easily. Well a few days ago that went from very rarely to each and every time I start the car.
Now its a tossup whenever I go somewhere whether the key will pop out like it should or I'll have to fiddle with it for anywhere up to ten minutes.
The car never has a problem starting, its only when I have arrived somewhere and need to take the key out that is an issue. I've managed to remove it every time so far but it has taken a fair amount of WD-40, jiggling the bejeezus out of the key and steering wheel and plenty of patience.
I have a 2003 2.4L 5 speed manual Santa Fe. I was parking my vehicle and removed my key as usual and realized that the car was still running. I put it into reverse rolled back and back into 1st to roll forward just to make sure I wasn't dreaming. I ended up pulling the fuel pump fuse and disconnecting the battery to turn it off.
When I replaced the fuse and reconnected the battery I was able to bump start the vehicle without the key in the car and drive it all the way home with no problem. I took apart all the plastic pieces around the Ignition and attempted to remove the cylinder but was unable to locate any sort of small button or pin to push on to remove it. Where is the release button?
What are my options here? Do I replace the cylinder first or get a new key, or is there something else that I should check first before I take it in.
I have a European Phaeton 3.2 litre V6 (gasoline) from 2003 that is giving me some problems. When I am finished driving I put the gear lever to parking position and turn off the ignition. I then get a message "Move selector lever to position p" and the key is stuck in the ignition.
So far, I have been able to get the error message away (and with that also been able to get the key out) by starting the car and move the gear lever around. Some times I have managed by only starting the system (by not holding my foot on the brake pedal). But tonight I couldn't get it fixed after numerous tries. I then simply waited in the car, because I didn't really know what to do, and after maybe five minutes the system shut down (energy saving mode?) and I could finally get the key out.
When I tried google the error message I found some topics about it on the Touareg forums, but they got the error message while driving and it had to do with the keyless system (which my car doesn't have).
What might be causing this problem? My local VW dealer is not very used to Phaetons (I am the only on in my town with one).
My ignition key is stuck / locked in the off position. The first time this happened I jiggled the key while moving the wheel back and forth and it turned. The next time in the truck nothing worked. I let it roll back a bit then tried, pushed the clutch in and put it in neutral, etc it did not move. (Just had the clutch and clutch hydraulics replaced.) The wheel is locked. The key removes from the cylinder.
I know it is easy to replace the Ignition Lock Cylinder when you can turn the key in the run position. How to remove it when locked in off?
Friday, 4/4/14: I have read many of the posts about this issue on this site. Didn't know this was such a widespread problem until I started doing my internet research today. Obviously there are many of us and this has been going on for a few years with this vehicle. I have had soaked floor boards twice and dealing with my third incident today(4 inches of rain last night). Have an appt with my GMC dealership on Monday. How I start this process with GMC to quickly get their attention. Obviously, I need to contact GMC first so that I can get their standard, worthless answer. But I've read I need to hire a "lemon law attorney", post my dissatisfaction on social media, contact the news media, etc. I am 62 yrs old, on disability, can't afford this inconvenience for something GMC should be RECALLING and fixing. Plus I have a small garage and this monster vehicle will not fit in it (didn't know that until after I bought it).
View 2 RepliesFive months ago I purchased a Saturn with 60,000 miles. Yesterday upon leaving my driveway it wouldn't shift out of first gear. Turned around , put it in the garage & tried to backup, put it in reverse & the vehicle would not move and the tranny made a loud whine. For the past two weeks the tranny made a loud " clunk " when it shifted into second, also on the highway it wouldn't shift into high gear & was running at 2500 rpm. Is this an electronic issue or more ?
View 1 RepliesI have a 2009 Saturn Outlook. The rear lift gate does not work anymore, as a matter of fact it tries to slam itself shut whenever it is lifted. I am not extremely mechanically inclined but I can do minor repairs so I also need to know if I can fix this problem or need to take it to a mechanic.
View 3 RepliesI've recently purchased an 02 Envoy from an auction. There are a couple of issues. The main one started last night. While at the store I put the truck in park and turn off the ignition. The ignition will not go into the lock position. I messed with the key and go it to turn off. Then started the truck to leave and couldn't put the truck in gear. I messed with the shifter and was able to put into gear.
At that point the gear shifter would move from park to reverse without me pushing the break pedal. I drove home and could not turn the key all of the way off again. Moved gear selector from 1st to Park a few times and then was able to remove the key. I restarted the truck and could not move the gear selector again; however I was able to remove the key easily.
I am leaning towards replacing the "Neutral Safety Switch" on the tranny but with my symptoms, I've seen brake light switch, ignition, and solenoid at gear shift selection.
Back up lights do not work either. Since I purchased the truck, I've replaced,
-Battery
-Ignition Coil