My drivers front signal does not work. its not the bulb. took headlight assembly out and then the passanger side did not work and the drivers side did. check passenger side. now it switched again. now drivers side is out and passenger side works. both parking lights work fine. no clue what's going on
View 2 RepliesMy turn signal on the driver’s side isn’t working. It clicks quickly like when the bulb is out. The rear one on that side still works, but blinks quickly…which is normal when the front one isn’t working. It didn’t just stop working all at once. Over the course of the last year or more, it has gradually gone out--it would work for a few days and not for a while. A few months ago, it worked about half the time. Now it won’t ever work and I’m due for an inspection. Here is what I’ve determined so far:
It isn’t the bulb…I’ve tried a new bulb.
It isn’t the socket. I took the socket in my hand in the picture and switched it with the passenger side and the driver side still didn’t work and the passenger still did worked.
The plug that the socket goes into on the picture…I cleaned it good and used a little lubricant on it, but that didn’t work either. If that plug is bad, the local parts stores don’t carry it and can’t get it, so I'll have to go to the Ford House.
I have a 1997 GMC Sierra. I had a turn signal out in the front driver side. the old bulb was rusted out so i had to remove it with needle nose pliers. replaced bulb, and now i have absolutely no turn signals at all. not even the clicking noise or the turn signal illuminator in dash. I have since replaced the turn signal relay, but that was no luck.
View 2 RepliesAs the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
I've got a 2008 GX470 with 38K miles. My problem is that the driver's side front turn signal has quit now for the fifth time! The first 3 times, the dealer's shop said that it was a loose bulb, the was some grit in the socket (which there should not be), etc. The fourth time they replaced the wiring harness. Yesterday, the bulb went out for the fifth time. This is occurring every 4-6K miles. I use my vehicle exclusively on city/highway driving. No off/rough road at all.
View 5 RepliesIt all began on my 1997 Camry when the driver's front turn signal began the rapid flashing thing, indicating to me that the bulb in the front was out. I replaced the bulb. The running light part works, but the flasher still does not. On the front passenger side of the car, the turn signal works, but the running light does not. I replaced the passenger side bulb at the same time I replaced the driver's side bulb. The flashing turn signal works as it did before, but the running light still does not go on.
The problem shouldn't be the bulbs - they are new. The flasher unit behind the fuse box should affect both lights flashing, so it probably is not that.
What thing or things can cause one light to flash for the turn signal but not be on constantly for the running light (passenger front side) and to work as a running light being constantly on, but not flashing as a turn signal (driver's front side)?
85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 RepliesIs there a way to change the bulb without removing the grill and headlight? Seems like a lot of work to replace a bulb. 2013 F350....
View 3 RepliesI was on the way home tonight and I noticed the driver side HID headlight turn off after putting my turn signal on.
I have LED DRL fog lights installed and they're wired with no relay and plugged into the Engine Compartment fuse box. The installer connected them on the left side (where the wires come in, from the two black components by the air filter).
Could this wiring setup be interfering with the HID's?
Yesterday my rear driver side turn signal just stopped working on my 2013 elantra. I replaced the bulb and it still isnt working. The front driver side turn signal is flashing at hyper speed.
The passenger side front and back turn signals work fine. Im planning on bringing my car into tomorrow for an oil change and to get this checked out hopefully it isnt an expensive fix.
I noticed some moisture in my driver side turn signal lamp the other day. Any experience out there on fixing this? It looked pretty difficult to reach in there and open the lamp up to let it dry. And fixing it - finding the leak - might be more fun.
View 7 RepliesAbout a year ago the passenger side window stopped working. It was not a huge problem and my husband kept telling me he would look at it. Well.......... as of last week none of the windows will work and the drivers side automatic lock button stopped working. I can lock and unlock it with the remote and the passenger lock button works. I just don't know. My husband looked at the wiring in the door joint and took the panel off and everything seemes secure. Also, the cd player is running an error message and I have had problems with the switch. This car is driving me crazy!!!!!!
View 1 RepliesMy left front turn signal stopped working. Rear turn and mirror light both work normally. Checked the socket and it is clean. Switched bulbs with right side to confirm. This one is driving me crazy and I don't want to spend a fortune at the stealer to fix it.
View 5 RepliesPut a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 RepliesI have an '07 Saturn Relay. The drivers side heated seat has quit working, the passenger side works fine. When I turn the warmer switch on, the switch lights up but the seat never gets warm on the high or low mode of the switch. After a while the light on the switch goes off, it used to stay on all the time. What could be wrong and how can I check it?
View 3 RepliesI have a 2005 F-150 and the tail lights and turn signals stopped working. Only the park light seems to work and it very dim. I replaced the bulbs and that did not fix the problem, so I checked with a volt meter and I'm only getting 6 volts to the socket. Fuses appear to be good.
View 1 RepliesInfo: 2003 Ion-1 165k+ miles
I'm hearing a clunking/knocking noise in my Ion that sounds like the front driver side. It's most audible starting about 30 mph. It grows louder as I drive faster and the rate of clunking/knocking is relative to the speed I am driving. It doesn't change when I push in the clutch or when I'm in a different gear. It does not happen when I rev my engine in neutral. I even shut off my car while moving in a parking lot and no change. The sound changes when I turn (sounds like a more muffled/dull sound but still loud if that makes sense), and in my mind it seems to sound worse when I'm turning right than left.
I noticed the noise on Thursday of last week. It was at the point where I had to have my radio off to notice the noise. Since then it has grown louder and as of yesterday is now overpowering my radio when at reasonable volume.
I just replaced both the driver and passenger wheel bearing in the last 18 months, and I just got new Tier-3 Cooper tires 3 months ago. (I wouldn't think the bearing would knock, but just as history fyi.) I was convinced by the troubleshooting guide in my Haynes manual that it was either the inner or outer CV joint so I replaced the whole Driver side CV Axle and topped off the Tranny Fluid with Dexron-III. No dice. I thought there's a chance it could be my new tires, so I Rotated the tires on the left side F->B/B->F as well and the noise did not seem to change. Spinning the tires by hand while up on my jack stands does not seem to tell me anything (I'm guessing I'd have to have them spinning at about 20/30mph to hear anything).
My next idea at this point is to put the front end up on jack stands and have someone put my car in gear and give it a little gas while I stand nearby and try to pinpoint where the sound is coming from. I'm a little leery about this one, and I'm not even sure if it's going to make the noise when not under load anyway.
This passenger side rear turn signal stopped working two weeks ago after a period of intermittent operation. All other lights work. I replaced the bulb and fuses. I am not an expert about auto electrical. The relay box is under the hood on the driver side. There is another fuse box under the driver side dash left of the steering column. Auto parts stores want to sell me a "flasher" that, well, I can't figure out where it goes. The "TNS relay" in the relay box is smaller than the flasher the parts stores are selling me. My little owner manual is not useful. Any theories about what is wrong? Wiring? Relay? Where does that flasher go? Somewhere under the dash?
View 2 RepliesI just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
2004 F250 6.0L!!
An issue I noticed right off the bat was that whenever I had the driver side turn signal on, and the brake was applied, the turn signal freezes.
I took apart the tail light and found a concoction of wires...I posted a diagram illustrating what it looks like.
There is this pesky Red wire that is spliced into the tail light bulb socket wire (specifically the green wire).
There is a trailer brake installed...if this means anything. I've tried disconnecting that with no luck on fixing the issue.
How to further troubleshoot would be great...electrical work is not my forte!
I have checked all wires for krosion and fuse's are good so confused! Just put brand new tail lights bulbs in! The top one comes on as a running light but nothing else works. I also checked under hood fuses too!
1.Only Hazard light that works is on the Right Front passenger side.
2 Drivers side Brake Light & Turn Signal Doesn't Work. But passenger works fine! Left turn signal is out and blinks really fast!
3.Passenger Side Overhead Outside Light on cab is out . Okay that's probably just a bulb!