I lined up all the colored links on the chain with the notches on the gears perfectly, the gears were all in the correct position also. Everything was done, then I rotated the crank by hand, and now the notches don't line up with the colored links. Is this normal ? does it have to go around a certain amount of times before they line up again?
View 3 Repliesmy car timing chain jumps up and down wen i try to start it.befor that i hard alot of clinking sound coming from the motor now the car wont start
View 7 RepliesI was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesI brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 RepliesOn Feb 2015 I had this oil leak developing around the timing chain cover/ oil pressure plug and so i replaced the oil pressure sensor and clean the area and though problem solved...
Fast forward today and the weeping has redeveloped and has gotten larger than last time , its only a weeping issue no visible oil droplet leaks, anyways I took a mirror and when probing around and found the leak origin from the rusty looking timing chain tensioner...that what i think it is.
My question is should I just remove and replace the Rubber O-ring on it or should I just replace the entire timing tensioner unit with a new one, my original timing chain tensioner is sitting at 85k miles. The O-ring is free (i have a kit) and i can do it right now or a New Timing chain tensioner w/ new O-ring is around $20 bucks but i cannot verify the part number ...
I have an '09 Tiguan that recently began to start hard. Two days ago, it refused to start and hasn't started since. It cranks and cranks but to no avail. I disconnected the fuel line at the first hard piece on the front side of the head. The primer pump when activated pours gas out of the line for about 5-8 seconds.
I also pulled the coil packs off and verified there is spark on them. I scanned the car with vcds and came up with nothing other than a couple voltage codes (battery is low at this point from cranking and is bulged and showing yellow in the spot window).
Tonight I borrowed the perfectly fine battery from my B6 and attempted to start it. No codes whatsoever and yet it still refused to run.
I read for a few second at start up ok . Have it checked : [URL] ...
I will be opening up the case in next few days. Chain still on holding by a few teeth. Metal wedge between teeth and chain.
I have a 2006 Honda CRV with 145,000 miles on it. It has been giving me warning lights for about 10 weeks. My mechanic discovered that it is burning oil, which he says all old cars do. But the lights continued. He put the computer on it and says that I need a new timing chain and it will cots $1,100.00. He also says he's not 100% sure that this will stop the lights. I don't want to sink that kind of money into the car if it won't correct the problem. The lights that come on are the check engine light, the VSA light and the triangle light. They do not come on all of the time. Maybe 3 time a week but they go off if I stop the car and re start it.
View 19 RepliesMy neighbor have a neglected 1995 Dodge Ram with the 3.9L V6. This engine is called a "Magnum" but I have to say it is pretty gutless overall. Anyway, it has the famous clatter caused by the timing chain tapping against the timing cover. Every one of these from this time period sounds like this and I understand it is a common problem. Is this a critical problem or not? I understand it can be fixed by replacing it with a newer style timing set with a tensioner. If this won't cause damage, I say leave it alone as the noise is just a minor annoyance. I was just in as far as the water pump and was tempted to tackle it but figured it could wait.
View 10 RepliesJust purchased a 2002 Camry for my son to drive to school. The car has 275,000 highway miles on it The car was well maintained by the previous owner. I have heard that the timing chain should last about 300,000 miles. However, the owner's manual does not mention any replacement interval. Since the cars mileage is approaching 300k, I'm wondering if the chain needs to be replaced. The engine runs great. However, I do hear a bit of a rattle from the timing chain pully area. I replaced the valve cover gasket and inspected the chain but didn't notice anything unusual. I have mainly driven import cars with timing belts and not sure if this rattling noise is normal for a Toyota with a chain or an early sign of needing replacement.
View 5 RepliesExperiencing a really bad rattle after changing the oil? It sounds like the chain tensioners are losing pressure during the oil change.
View 11 RepliesI just replaced the timing chain and water pump on my 1999 K1500 5.7L. After spending several evenings and a few early mornings working on it, I get everything back together and go to start it up. It starts then immediately dies. After double checking that the CKP sensor, two plugs on breather, and a/c and alternator wires (these are all that I unplugged) are connected I try in one more time before coming in to work today.
Timing chain was installed with No. 1 at TDC and mark on cam at 12 o'clock position as stated in the Haynes manual for the truck. I did not remove or even touch the distributor since replacing the intake gaskets ~3 years ago. Will check to see if any codes are showing in the morning when I have my laptop at home.
Changing timing chain tensioner? Mine is making the rattling noise on startup. Tried searching one internet for any DIY's out there. Haven't really found any good ones.
View 7 RepliesMy 2007 3.3l SF timing chain cover is leaking.It has 93,000Kms and is still covered by warranty.The Dealer said it was a 17hr break down job to do.
I am wondering if there are things I should get done/replaced when they open the engine up. I had asked at the dealer if there were other parts that should be replaced at this time, but was told that there was not.
What to do if your timing chain tensioner fails and wipes out the valvetrain. Go to www.vwusa.com and click the contact us page. Find the link for "online chat" and open a dialog with a vw rep. Have the vin, milage, purchase date info handy and tell them what happend.
Maybe I just got lucky, but I thought my (second owner) 2012 GTI with 46000 mi was toast, the rep (Bill H) told me not to worry and set me up with a case number and the location of a dearship that will confirm the damage and replace my engine.
My experience is in direct opposition of what I have read on forums when people take their GTI's to the dealership first, then after hagling with the stealership managers for weeks on end finally end up emailing vw corporate (which takes weeks to respond) and finally having the issue resolved.
Of couse, this is only if your car has not had the warranty run out. I thought that being the second owner voided the powertrain warranty...again that was false.
OK, I just recently discovered my timing chain was grinding. Now, there are metal shavings in my oil and filter. What would you recommend to flush the shavings out of the engine, so it doesn't cause further damage? Other than this, my truck is running perfectly fine. It has 106,000 miles on the motor. Are there any other concerns that I should consider?
View 10 RepliesLooking for info if the R32 has a timing belt or is it a chain and at how many kilometers shows it be changed.
View 5 RepliesI hear it's a problem on the Mk VI. Is there anything you can do or upgrade to eliminate the problem ... especially considering that it goes out of warranty after 5 years.
View 12 RepliesI have seen this minor oil leak on the left engine side that facing the firewall for sometimes, but just found time to bring to dealer. After some searching on Internet, I suggested to them that it might be leaking from the timing chain cover.
View 19 RepliesI'm told by my dealer that I must replace the timing chain by 100,000 miles. I've also been told by others who've driven multiple vehicles over 250K miles that they've never replaced a timing chain on any of their vehicles. Who's right in this case?
View 9 RepliesI posted my passat to sell/part out last week. So I talked to the mechanic today and he hasn't looked in the engine. He just says that when the timing chain goes it wrecks the valves and pistons (needs rebuild). HE WAS TRYING TO SAVE ME MONEY THOUGH...FAMILY FRIEND. My sister got lucky on her passat and only messed up the valves. But she was sitting still....I was doing 80mph on 95 going to work. Should I have the engine looked at or sell it.....what are the odds I got lucky??? I found a lot of posts/blogs about how everyones engine blew, but no one said they got lucky.
View 9 Replies