A local mechanic tells me I have a blown head gasket on my 2003 Saab 9-5. He also said there's coolant standing in one cylinder. If this is due to stretched head bolts, might I remedy the problem by replacing the head bolts and torqueing to specifications?
View 4 RepliesOk I got this truck from my mother-in-law for free with a blown head gasket cylinder 6 driver side. I did the replacement had the heads machined put it all back together by the book. Now I can't get it to fire on all 6 cylinders only 5 I think. Thought maybe bad gas (it sat since late November) put 5 gallons (over double the gas) fresh gas and half a bottle of b-12 chem tool. Dubble checked all plugs wires connections (coils plugs wires all new). I drove for about 10 miles oil pressure and temperature stayed perfect but no change in running truck shakes a lot and no real power. Don't sputter or backfire no engine codes other than imcr bank 2 open. Engine is 4.2l v-6 170k miles.
View 2 RepliesMy 2003 Chevy Impala stalled after driving it for about a mile. The 'low engine oil' came on. I noticed white smoke coming out from under the hood. I pulled the dipstick and it was out of oil.
I poured 2 quarts of oil and attempted to start the car. The car started after I pressed the gas pedal but shut off when I took my foot off the gas. I tried several times. It started butshut off when lifting the foot of the pedal.
I'm hoping it's not the head gasket.
My 97 f150 5.4 started missing on 5,6 it had antifreeze on top of the spark plugs but i cant figure out where its coming from my truck has been loosing coolant and it seems like the system is holding pressure because every time i take the cap off the radiator overfill i can hear it hissing then i see the antifreeze level plummet there's no visible leaks that i have seen when the truck is running an missing it steams out the exhaust but when its no missing it doesn't seem to be there's no milky oil or anything the thermostat doesn't seem to be leaking either the truck has over heated a couple times due to the antifreeze disappearing or the temp wont move at all then it shoots all the way to hot and cools down within seconds to normal i just put a new thermostat in. Also it sometimes misses on 4 and my exhaust smells like straight gas i put 4 gallons in it got 29 miles out of it .
View 10 RepliesI just bought a used 5.4 for my 99' F150 4X4. My current engine has a blown head gasket. Anyway, I was able to hear the engine run before I bought it, and was able to check it out some. (oil, anti-freeze) I was told that this engine was bought from a salvage yard with 50K, and 50K more put on it before I bought it.
I was also told that the intake manifold is newer, from Autozone, and it has newer Accell coils. My question for you all, is ..... What do YOU think I should do otherwise before I install this engine. Oil pump? water pump? seals? ...
I have my 4.6L engine on a stand in the garage. I think I have a blown head gasket. I am ready to remove the heads.
My Haynes book says: "Caution:Use the required camshaft retaining fixtures to lock the camshafts and leave the tools in place."
A google search shows nothing. Why, what does it do?
I just purchased a 2003 F150 Supercrew 4.6 that had been wrecked, but somewhat repaired. I knew the owner said it had a blown head gasket. It has water in the oil (small amount asi it is lightly milky) and water starts dripping from the exhaust after it has run for a few minutes. I did not run it long, but throttled it up to warm the engine. It started dripping soot filled water from the exhaust connections. I bought it to put a 4bt in it anyway, but want to sell the motor with the ability to tell the buyer the skinny on it. I drove it on the trailer and off with no apparent loss of power noticeable.
View 2 RepliesAm wrestling with the ever-present value/worth question. My '95 Saab 9000 Aero developed a leaky head gasket at 155,000 miles. I had it replaced (after driving it several hundred miles over a week or so). The engine then became and continues to be hard to start. It idles roughly, and even stalls out when decelerating for intersections. The shop says that two cylinders have low compression. (no details on why) They suggested adding injector cleaner to the fuel, which did not solve the problem, or installing a new (used) motor.
View 19 RepliesI have a 1997 Saab 9000 CSE Turbo. It has been a great car overall. Last summer, our water pump died while cruising on the highway, leading to a major overheat, leading to warped head. We decided to roll the dice on a rebuild, which was done by a reputable import specialty shop that has worked on many Saab 9000s. Since we got the car back 5000 miles ago, we have lost a few miles per gallon, and we hear a rough noise in the engine (particularly when it's cold). In the last few thousand miles, we lost a lot of coolant, apparently because the new water pump is faulty (the shop looked at it and agreed to replace under warranty). In the last 1000 miles (but no evidence of it previously), we have begun losing oil like crazy and occasionally (but not most of the time) smelling burning oil (the heater is on, moving air around). We are now adding about a quart per 200 miles. When we inspect the block, there is some small evidence of oil leakage, but not a lot, and there are never drips on the driveway.
Where is all that oil going? I showed it to the shop, we put it on the lift, and there is no spray on the underside, leaking oil pan, etc. I suspect the new head gasket is leaking, but there is little enough residue on the block that it's hard to be certain. What other explanations are there, and is it fair for me to blame the repair shop and insist that they redo the head gasket? The shop is a 6hr drive from my house, so I can't just drop by to discuss it with them.
I have a 03 5.4 F150 SCrew... The intake was leaking on the passenger side (water outlet tube meets plastic).
Putting in the Dorman replacement and noticed that the front cylinder drivers side (#5) had a decent amount of coolant in it.. None of the others did. I've drained the coolant already and was wondering should I just put this back together and see?
The water outlet crossing has a hole right next to this cylinder and I can't see any cracks and not sure if the gaskets were leaking under it.
Seems like if the head gasket was blown I would see it in more cylinders? It never smoked or run bad before I got this leak... Drove it maybe 10 miles with it leaking out onto Cyl#1. Ran fine, never missed.
I just don't want to put this back together if the head gasket is blown but I don't know what to do.
I drove my car after the check engine light came on, stupidly without looking at the temperature gauge. When the car died, I had blown the head gasket, melted the spark plugs and did some other pretty serious damage to the engine. So now I am contemplating replacing the engine instead of buying a new car since I drive very infrequently (I take transit to work and do a lot of business travel by air). The car is 10 years old and only has 72,000 miles on it. The body is in good shape as well.
View 9 RepliesI have a 1998 volvo s70 with 273k on it. I am pretty sure the head gasket is blown. The shop I usually take my car to said i need to take it to a dealer and that volvo usually wants to replace the engine on a car that old. Would you pay the 6k for a new engine or think about a new car?
View 8 RepliesAfter replacing most of the underside of my Super Duty, Complete front end, backing plates, brakes, rotors and shocks, I have a misfire code on cylinder #4. I replaced the plugs, cleaned the MAS and filter and rotated the coil to cylinder #1. Still have a misfire on #4 and noticed the coolant slightly low and some condensation on the oil cap. Could this be the intake gasket? My mechanic is away for 2 weeks and I think the price at the dealer will kill me. I have 63K on the truck, don't tow and plow mostly family members. It's getting a little rusty but is still in good shape.
View 13 RepliesNew truck to me. Truck was advertised with a slow coolant leak. Figured I would trace the leak down and get it repaired no issues. Anyway, working on it this evening I take a close look around the oil filler area and notice the dreaded milkshake color.
I drained the oil out of the truck and the oil actually came out nice and black. Is the headgasket the only area that would cause the oil/coolant mixture? Supposedly the truck has never been overheated.
At any rate, on to find articles on how to pull apart a 4.6L Triton head. I'll see if I'm up to this challenge.
I got a 98 Subi Forester L, stick, 130k mi.
I've been thinking about what gs ragtop & tester mentioned about the silicate stuff and I'm ready to take the chance, but there's one thing bothering me: If that stuff is supposed to be drawn into the combustion chamber where the silicate comes in contact with the super hot temps that solidify it, thereby sealing the leak, that assumes coolant is going into the combustion chamber, right? Well, I've been driving this car with a blown hg for at least 2yrs maybe 3, (that in itself amazes me), and I've never seen any sign of coolant in the exhaust, no smoke, nor any rough starting issues to speak of.
So, my question is simply, HOW THE HECK DOES THAT HAPPEN!! How in the world can I lift the hood and watch exhaust gases bubbling up in the radiator, yet when I park on a hot, 95 degree August day with a fully pressurized cooling system, the next time it's started there is no sign of coolant. The physics of that defy me! I mean, it says that the head gasket magically blew a "one-way" valve in itself? What do you think? Am I missing something?
A family member has a 2002 Subaru Outback. Possible blown head gasket per dealership. Should we just get rid of it or fix it? I feel the car had problems when we bought it a couple years ago due to dishonest salesperson. I hate to keep putting money into it. It seems to use a lot of oil also. Fix it then sell? Or just get rid of it?
View 6 RepliesI believe my head gasket is blown, but no one really knows what's wrong with it.. Car stalled & then smoke came out the oil tank an coolant tank an muffler? I just got this car used a month ago.. where to start..
View 3 RepliesIt seems my head gasket is blown. I've got tonnes of foam and froth in my coolant reservoir and my conclusion is that it is likely the head gasket. I cleaned it out once and after about 1/2 hour of driving its full of foam again.
I can't believe it. I checked with an Indi mechanic and he was surprized too. I'm checking at the dealer tomorrow but I'm outside of the warranty so I'm not holding out any hope.
i have a 06 explorer with the 4.0 V6. 4x4 XLT with 106xxx miles. i just bought this thing back in January. of corse, i didn't get an ext warranty. well the past couple months its been loosing power, its got a stumble and seems sluggish. its losing water. no water in oil, no oil in water, don't smell coolant in the exhaust. yesterday i went out and looked and found at front of head on pass side at front cyl, there was coolant from head gasket down the block and also in the valley of the block. i started the engine and once warm, everything was dry. shut it off after about 20 minutes and still nothing wet. this afternoon the only wet spot was in the valley which was dry after running yesterday. is there anything else i can check before tearing it down? with the water in the valley, it looks like it could be coming from the thermo housing.
View 6 RepliesI have read all I could find on replacing a blown head gasket and and after absorbing everything that TigerDan posted on here, I dove in and began. After disassembling all the topside junk I finally got the intake manifold loose and got down to the head. I began undoing the head bolts and found two broken bolts. The head won't budge so I am calling in a cherrypicker. I don't know what kind of mess I'll find when the head comes off. I assume the head will be warped or the block may be damaged.
View 6 RepliesSaturday I was driving to my friend's house. My A/C is broken (just happened 2 weeks ago) so my windows were down. I hear a loud boom. I hear a clicking noise when I accelerate but it stops when I take my foot off the gas.
I am 5 minutes away from his house and he's a mechanic so I just wait until I get there but as I'm turning left, I notice my car is smoking. When I get there, I couldn't even put it in reverse to park and there was smoke coming out of my hood. He and another mechanic friend said it was a blown head gasket.
I had it towed to a mechanic and he said it was a blown head gasket and quoted me $1,800. I know nothing about cars so there's no way I'm fixing it myself.
Is this worth fixing or should I just get a used car and sell it as is or for parts?
It has 230,000 miles on it and I drive 80 miles per day for work. No other problems except the A/C as far as I know.