Repair :: Engine And Cruise Control Lights Keep Flashing Intermittently?
May 11, 2011
My engine and cruise control lights keep flashing....This happens intermittently (been going on like this for several months). I took it to my mechanic and he cleared the computer...was fine for awhile...but happening again. Mechanic said that if it happened again, it might be the catalytic converter. I hope not b/c this is a very expensive part to replace!!! Is my mechanic correct or could it be something else?
View 3 Replies
Advertisement
I just returned from a 4K trip through 7 states and my cruise control will go batty and make you pull over and re-boot the car. Basically I am cruising down the interstate with cruise control on. When I come into a town I will either pull the cruise lever forward or step on the brakes to disengage it.
The traffic comes to a stop or slows to a crawl for a short period of time. Once the traffic starts to move again and we are back to highway speeds I can no longer use the cruise control because it is intermittently flashing on the dash as a malfunction. The only time it doesn't do this is when I am slowing down if I turn the power off to the cruise control system.
I stopped in the middle of my trip at two different dealers and there were no codes stored. One dealer charged me a diagnostic the second didn't after I showed him my receipt from the day prior from the other dealer but then he wanted to sell me a brand NEW MFD.
View 8 Replies
I have a1994 Dodge 1500 Ram Hemi extra cab 4door. The brake lights on the bed of the truck not the high light will blink on and off and sometimes stay on the other day my son-in-law narrowed the truck and a trailer and the trailer also blinked but again not the high light. Also the cruise has stopped working about the same time this started. At one time it was infrequent now is most of the time. Wondering if it could be part of the alarm system or something else it is driving me crazy.
View 4 Replies
I have a 2005 Subaru Outback with 179,000 miles on it. My engine and cruise control lights flash on and off....have been doing this for 6 months now....intermittently. My mechanic said the he cleared the computer and to wait and see if it happens again. He said that it might be the catalytic converter. The car runs fine whether or not the lights are flashing.
View 3 Replies
I am the owner of a 2011 Hyundai Sonata GLS. It has approx 35,700mi to date.
Ive been apart of the forum for quite some time now. Ive been having an issue for a couple of months now with my Traction Control light being stuck on and intermittent flashes of the Brake light (as if parking brake were engaged) and ABS Lights simultaneously.
I'VE ALREADY HAD THE BRAKE SWITCH FAILURE RECALL PERFORMED. When i was having problems shifting and with my cruise control.
This all started this past winter during a bad snow and ice storm we had here in St. Louis, MO. I was on my way to work and the roads were slick with ice and snow. I was traveling no more than 15-20mph on a freeway and as i was approaching a light it suddenly changed to red and i had to slam on my brakes and make a swift right turn in order to avoid hitting anyone in the intersection. Ever since that moment, I've been stuck with these lights on in my dash.
Let me start this by saying I've done a couple of mods to my car. Hids, aftermarket remote start (professionally), aftermarket stereo, amps, new speakers all around, led lights inside, cup holder mod and led tail lights. That's all of my electrical mods.
Ive taken my car to the dealer several times for this problem. They tried hooking my car up to their code machine and they said the car wasn't communicating with machine and it was the first time they've seen something like this before.
They tried pinning the problem on my alarm and stereo. (as they usually do) They said it was a corroded ground. The dealer cleaned that up and said that fixed the problem. In actuality, it didnt. The issue still was there.
Ive had both the alarm and stereo removed to see if this were the cause my issues. NO...the problem still exists.
Here's a pic ....
View 12 Replies
My mechanic can't find the problem. Engine light comes on. Along with the flashing cruise control. His diagnostic doesn't show him the exact problem as the voltage changes. He has checked everything related, changed out the bank 2 sensor 1 oxygen sensor, but can't find the problem. I don't know the diagnostic code. But he says that it doesn't give him an exact code. Can only the dealer do this? Car runs fine.
View 10 Replies
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
Had an issue with "check" engine light turning on and "cruise" control light flashing, intermittently. Dealer said we had dirty oil contaminating some solenoid valves in the system but we had just done an oil change and do so every 3-5K (car has 170K). They recommended switching around the sensors and doing an "oil flush" with another oil change. The warning light problem hasn't recurred, in the past month, since we started giving the gas cap a few extra turns after a fill-up. We're getting ready to buy a new car and don't want to give what might be a serious problem over to the next owner.
View 6 Replies
I'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 Replies
Had an intermittent problem with my Cruise Control engaging. The CC light would come on when the CC on/off button was pressed.
When the CC would engage the "set" light would come on and the speed would hold. On occasion the CC would not engage.
I looked are reread the owners manual.....NOTHING! I was double checking to make sure there was nothing different with the hybrid. (I have owned Toyota for a very long time...since 88').
Since the Hybrid is new to me, "shifting" is a little bit different. There is a "B" on the shifter which is mentioned for "downshifting". There is no mention that once you are done with downshifting that you must shift back to "D" for normal operation. The only mention is not to run in "B" for an extended amount of time.
So, when you are in the "B" position, the CC with disengage.
View 9 Replies
First it wouldn't turn on, at times now it at times won't work even though the light is on, on the dash. At other times it works as expected. I dun think it's the 12V battery, because when only the center console is on in diagnostics the battery reads 12.2-12.4 and 14.5 + when the engine is on.
View 13 Replies
The cruise control on my '05 Avalon Limited was working intermittently for a while. I'd hit the button to turn it on and nothing. Then a few miles down the road, I'd hit it again and it would work just fine. Today I tried to turn it on and nothing. Three different trips today and no luck.
View 1 Replies
I have a 99 Passat 4 cyl turbo and the cruise control seldom works. Sometimes it works, sometimes not, and sometimes it shuts itself off. What could be the problem?
VWFahrer
85 Jetta Diesel
93 Eurovan
99 Passat
View 3 Replies
I had had intermittent issues with the cruise control not working in my excursion. most of the time it was fine though. after a recent 150 mile trip it stopped working half way through. i didnt worry about it too much..got back into town and checked under the hood. i found brake fluid running down the inner fender well! all over everything under the master cylinder. finally tracked it down to the cruise control switch on the master cylinder leaking. I pulled the plug apart and it was full of brake fluid.
Meanwhile the master cylinder was about half full, so i replaced it with the same switch out of a '96 parts explorer which is the same part luckily. also yes i have had the cruise control recall done. So if you have lost CC and you have a leak replace the switch! seems it can leak..and at a pretty good rate..alittle scary! glad i figured it out before my 800+ mile trip later this week/weekend.
View 5 Replies
2002 Ford Excursion cruise control inoperable. Problem began when cruise would come on intermittently. I would push the on button then set, at which point the green cruise icon light would either come on and the cruise would set or she would flash and not set. Sometimes holding the switch down worked, other times not. Now no matter what I do the cruise will not engage.
I have had the recall done for the cruise control by the dealership.
I have checked the fuse on the recall module, the 2.5 is in good shape and not blown.
I also found this guide to a self test (copied below). I used the test, turning the key on with the off button depressed yields a green speed icon light. Letting go and pressing on yields a green flash as well. But when I move on to pressing resume I get no lights at all, same if I continue through the other switches, no more lights.
Here is the self test guide -
*cruise control self test
Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo.
Release the OFF switch.
Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL. If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch. NOTE: There will be a slight delay when the last button is pressed and the lamp flashes.
A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective. If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
3 flashes - deactivator switch is open or circuit defective.
4 flashes - vehicle speed signal is out of range or circuit is defective.
Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.
View 1 Replies
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 Replies
I have a 2006 2.5 limited turbo outback wagon. Recently the engine light came on not flashing..the cruise control light is flashing. I live in a very remote area over a hour away from a dealer ship..and having problems finding someone with a diagnostic tool..Am I damaging my car by driving it still..I did just prior to the lights coming on filled the tank and after checking the cap I realized I did not tighten it as I should have.
View 6 Replies
On my 2007 Subaru Forester (100k miles) the CEL light is on and my cruise control light is blinking (cruise control does not work in this condition). Computer scan indicated front O2 sensor failed and my mechanic replaced it. No joy. Computer scan reported 0 data from EGR valve--replaced it. No joy.
View 2 Replies
My Prius cruise control will intermittently not activate when I try to turn it on. One day it will turn on and work fine. The next day I can not get it to turn on. I took the panel off of the back side of the lever and the contacts look ok for the on/off button.
View 8 Replies
The Cruise Control on my truck works intermittently. Sometimes it cuts out when I am driving and sometimes it fails to work at all (usually in the morning). Sometimes it will re engage if it cuts out and sometimes it will not re engage for hours.
View 1 Replies
2003 X limited 2wd 6.0L ... My cruise control was working intermittently. Could it be the buttons on the steering wheel itself? there is a cluster that I see. Does it pop off to expose the connectors/switches? Can these go bad? Can I buy new switches for the steering wheel?
View 2 Replies
