Pontiac - Vibe :: 2009 - Check Engine / Vehicle Stability / Traction Control System Lights Came On
Jul 17, 2013
I have a 2009 Pontiac Vibe with 43,000 miles. Recently the check engine light, the vehicle stability control light and the traction control system light all came on simultaneously. Since then they have all come on or all gone off several times. Usually once they come on, they stay on for the remainder of the trip. Sometimes they will still be on when I next start the car, sometimes they will be off. What might be causing this?
View 17 Replies
Advertisement
I have 4 lights that came on simultaneously on my 2009 Pontiac Vibe. My check engine, AWD, Traction Control and my VSC Off is blinking. I had the codes read at Advance Auto and 2 codes came up and they are C1201 Engine control module performance and P0456 Evaporative emission system leak detected (very small leak).
View 6 Replies
Evertime I turn left the brake light, traction control and stability control lights come on and the car starts dinging. Mechanic says it could be front wheel bearings because they are tied to the ABS system??? But I have been seeing alot about wheel speed sensors?
Second, everytime I brake suddenly, a cloud of smoke comes from the front end and there is a burning oil smell. The oil is fine and no leaks. Again mechanic says it could be a cracked CV boot throwing grease?
Lastly everytime I put in reverse or when I lightly put pressure on the brakes when driving I get this noise like a humming (errrrrrr) noise. Its not the grinding/squealing noise you would get when brake pads needs replaced. I only have 60k miles on this.
View 30 Replies
I've got a 2009 Mazda3 hatchback, 31,000 miles. As I'm sure you know, it's very cold in the Northeast today. It was -12F on my drive in to work! I went out to lunch with a coworker today, and it had warmed up quite a bit to about 25F. As I was driving back to work - 40mph on a dry, straight stretch of road - my check engine light and traction control/stability control light came on. They aren't flashing, just steady. The traction control light will flash if I hit a particularly bad patch of slush, but it's never lit up on a dry road before.
Right after the light came on, the automatic transmission started feeling...funny. It was shifting hard, although downshifting felt okay. My coworker even noticed before I said anything. I don't think it was the traction control - it was specifically as the automatic transmission was shifting, not at any other time. I've read through the TSBs and didn't see anything relevant, and I've already made an appointment for tomorrow at the dealer. I've only got 5,000 miles left in my warranty so I'm a little nervous - the car has been terrific so far.
I would think the traction control light would be unrelated to the transmission, so I'm a little confused. Also, just to rule out a few other things - the last time I got gas was about a week ago and I still have a third of a tank. I don't think this is a gas cap problem or frozen gas, both of which I've experienced before (in other cars).
View 10 Replies
I never had a single problem with that great car, now at 164,000 km, but got my first check engine warnings last friday, with the VSC OFF flashing, as well as the stabilitrak and check engine signals being lit. The car was still running fine, so I disconnected the battery this weekend and erased the codes. But this morning (2 days only later), the warnings are back. I went to a local garage and they retrieved the following codes: P043F, PO43E, P2402, P2419, P2401 and P2402. What do I do with this?
View 19 Replies
VSC, VCS OFF and Check Engine Light .... all came on a few minutes ago while out for a Sunday afternoon drive. Depressing/releasing the "VSC OFF" button multiple times did nothing. All 3 lights now stay on. Checked the manual which said to take in to Lexus dealer asap but could continue driving....something about vehicle stability control system not activating.
View 8 Replies
So today I start my car, I get the check engine on (steady not flashing) and have stability control flashing with my traction control light on. I found out it could be the gas cap not on right so I removed it and screwed it on again, check engine light was still on though. However, after starting the car again after a drive it was gone .
I do turn off stability control sometimes if it's nice out?
View 1 Replies
Ok well I am not much for roasting the tires anymore but like to wheel a little, but how in the heck do I turn off the traction and/or stability control? Never done it before.
View 4 Replies
2009 F-150 FX4 5.8 .... Had a couple days of 20's temps, started truck last night and I have the brakes symbol and ABS light staying on, with the message "Check brake system" and the traction control symbol alternating back and forth. On a 16 mile trip, they all went out just once, for about ten seconds when I restarted at the gas station. Then came back on. Brake job done within the last two years by previous owner at the dealership.
View 2 Replies
I have multiple O2 codes on my '02 gti. It is giving me a check engine lights as well as the traction control light on. I received 6 codes all but one of them had to do with the O2 sensor and a short except for one that came in as the MAF. Both O2 sensors have been replaced and the codes still won't clear. I bought it in this condition, it runs really well so i wasn't to concerned about it, but the lights are starting to get annoying.
View 2 Replies
2009 F-150 FX4 SuperCrew 4X4 5.4L
My ABS and stability control lights are on. I had the codes pulled today (listed in order):
1) C1298 (Right Rear Wheel Speed Sensor Input Signal Fault)
2) C1165 (Right Rear Wheel Speed Sensor Input Circuit Failure)
3) C1963 (Stability Control Inhibit Warning)
4) C1299 (Left Rear Wheel Speed Sensor Input Signal Fault)
5) C1175 (Left Rear Wheel Speed Sensor Input Circuit Failure)
I'll ignore the stability control code for now since I'm sure it is tied to the speed sensor errors. Anyways, I decided to inspect the rear wheels and I found this sucker just hanging beneath the right rear brake caliper:
Is this a speed sensor? Where does it plug into? Diagrams would be extremely useful! I am planning on ordering 2 new sensors for each rear wheel but I don't know where to begin.
View 3 Replies
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 Replies
My wife and I recently bought a 2003 Pontiac Vibe, a Toyota Matrix with slightly different skin, and shortly after we got a check engine light. When I inspected the car before purchase I noticed that there was black soot in the exhaust pipe. The owner told me that he'd put a cat back exhaust but I suspected I'd probably be replacing the O2 sensors soon and we negotiated the price accordingly. So now it's a month later and I bought an OBD II checker. I followed the instructions and after the checker and the cars ECU linked it showed no stored codes. I turned off the CEL and we went shopping. Mid way on the drive home, we live out in the country, the CEL came on again. Went through the procedure again, still no codes stored. I've read the instruction manual twice and I don't think I'm doing anything wrong. Is it possible to have a check engine light on and there to be no codes stored for the OBD tester to find? I could have bought many rolls of black tape for what the tester cost and I kept the receipt just in case.
View 5 Replies
I have a11 isf with 38k on it. The other day the check engine and traction control light came on along with a weird Oder in the cabin. secondly I was short the quarts of oil.... I see no leaks.
View 2 Replies
Alright i have a 05 1.8t GLI I just installed a 42 draft designs full 3inch turboback, and a eurojet turbo inlet hose, after I put the stuff on my check engine light came on which I thought was gonna happen and is normal but my traction control light came on as well, the cars running better then ever and pulling harder then ever, but when i hooked it up to the computer I'm throwing 18 codes? Ive triple check to make sure everythings tight and in the right spot? What could be wrong?
View 5 Replies
I cant find any info on this for the B6..
Is it just a standard LSD?
View 4 Replies
My car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
View 4 Replies
Is there any way to completely disable traction and stability control. I know pushing the button is supposed to disable stability control but I was told that you can't actually completely disable it.
View 5 Replies
Associated symptoms include no power steering, complete lack/absence of stability and traction control. This has happened to me a few times in the past, but has never stayed in after multiple start ups (and other remedial action). 2-3 times it's happened on startup, and cleared after a restart, one time while driving, and cleared on its own. This is going on the list of issues with less than 7k on the car.... 2012 3.6 sel
View 17 Replies
Yesterday, my vehicle stability control light came on along with the ABS symbol. I stopped the car and turned it back on and the car would not come out of Park.
I restarted the car and was able to shift into drive but, both symbols remained and the MFD showed no regenerative braking and the brakes were clearly mechanical only by sound and feel.
I think I took a rather short trip with the parking brake partially engaged, I was talking to my son who was home for the weekend.
I set and released it several times with no results. I finally parked the car, set the brake and checked for codes in my Scangauge-none. But, I did a "clear codes" anyhow.
I've only driven home yesterday and this morning to work. So far, nothing unusual, I have my fingers and stubby little toes crossed.
View 7 Replies
I own a Pontiac Vibe 2006 80K manual trans, and i hear a noise while i am driving down the road on the right side of the vehicle. It is a very slight or dampened sound that is a mild squeak. It makes the sound while going straight. Turning does not effect the sound. When i put on the breaks it does not effect the sound. What is it?
View 6 Replies
