Pontiac - Grandam :: 2001 - Transmission Started Shifting Hard Then Just Went Out
Dec 7, 2012
I have a 2001 pontiac grand am se 4cyl with an automatic transmission and I've been having issues with my transmission, about a month ago the transmission started shifting hard then just went out so i took it to a transmission repair shop and the tech said that it was the pulling clutches and i told him to completely rebuilt the transmission including new electronics and torque converter and he did i got it back and it drove fine for that day then stared doing the same thing my transmission slams into gears and I don't know what the problem is sometimes ill be going down the road and the transmission slams and then the trac light comes on for a little bit then goes back out??? also some days i can drive it a mile or 2 before it starts slamming into gear.. what this could be causing it to slam i would think it couldn't poss be the transmission as everything has been replaced? could something else be causing it to slam into gear..
View 7 Replies
Advertisement
I have a 2001 Grand Am that I cannot get it started. At first it was an intermittent problem and now I cannot get it started period. When it was intermittent I took it to the dealer and they could not find anything wrong. When I got the car home and try the next day it now won't start. It tries to turn over but won't. I put a new battery because I drain the old one. Change the fuses but still no luck. The fuel pump I was told was okay.
View 4 Replies
I have a 2000 V10 2WD Excursion with 104,000 miles. Last week it started shifting hard between first and second, but only when I am between 1500-2k RPMs. If I rev the engine higher, it shifts smooth. I checked the fluid and it is fine. I rarely tow anything except my little trailer to the dump every few months. I have a few questions:
1. Should I drop the pan and change the tranny filter?
2. Should/Can I check the rear diff fluid? (haven't noticed any leaks)
3. Could an inline flush and fill work?
4. I saw a post about a speed sensor in the rear diff. Could this be the issue?
View 4 Replies
I have a 2005 Pontiac Grand Am that won't start. It was working fine. Then one day, it half started and stalled and won't restart. It will crank over and there is fuel getting to the injectors. If I shoot in starter fluid, it will start for a second and die.
View 2 Replies
I have a 2000 Grand AM cylin. Recently I was driving when my car started to shake violently. I drove it to the side of the road to a parking lot then it died. I started it up again and is ran but shacking a lot again. Once I got home, 3 blocks away the car died again. I tried to start it again but it would only turn but not start the engine. I have checked the gas pump, motor mounts, oil and anti freez for oil. I did check the timing chain but I don't know much on how it should be.
View 2 Replies
My check engine light started blinking on my 2000 grandam se last night and it was missing bad and now it wont start what is it.
View 13 Replies
About a week ago I was driving my Pontiac 2003 Grand Am V6 and it began to violently shake and the "check engine light" came on and started blinking. I then immediately took it to the mechanic It has been with the mechanic for 6 days and they were unable to locate the problem. They called me today and I was told that I have no compression in one of the cylinders (I have done business with them before and felt comfortable in that I wasn't being taken advantage of). Also, is there any problems in the future with getting a cylinder replaced i.e. other parts of the engine that might correlate?
View 17 Replies
My sister's Grand Am has been having a shift flutter issue (between third and fourth, around 40 mph it would shift rapidly back and forth until you either forced a downshift or reached 50-55 mph) for a while now. I read a lot about it online, and all signs and the experiences of others pointed to a bad shift solenoid or pressure control solenoid. I wanted to correct the issue before it caused any damage to the transmission. I removed the transmission from the car and replaced both shift solenoids, the torque converter clutch solenoid, the pressure control solenoid, and the manifold pressure switch with new ACDelco parts. I figured I may as well replace them all while the trans was apart. I also replaced the filter and fluid, of course. I got everything back together, and now the transmission slips in reverse and overdrive no longer works. Fluid level is full according to the method of pulling the level check fill plug while hot, idling in park. I used Valvoline Maxlife fluid, which meets Dexron VI specs according to the product label. I have double and triple checked everything and can't even fathom what I could have done to cause these new symptoms to crop up.
View 5 Replies
2001 Grand Am, 120,000 miles. Struggles to starts, when it does turn over it is only for 1-2 seconds and then cuts out. Even if I get it plenty of gas it still cuts out only it revs and then cuts out. It worked fine on Thursday and sat on the drive until this morning. If it makes a difference, we've had lots of rain recently and the remote keyless entry stopped working too.
View 3 Replies
My 2001 Pontiac Grand Am gt won't start. Turning the key gets no crank. Also there is no power that seems to be in the car at all. Nothing on instrument panel. Battery is good and all Ignition fusses are good.
View 4 Replies
I've got 95k miles on my 2001.5 and have been noticing that the transmission seems to shift pretty hard. Today it seemed like it was hardest in the 3rd to 2nd downshift. I got it checked out a couple of months ago and the dealer said it was the throttle body (which I haven't cleaned yet).
View 5 Replies
I just got a 2004 hyundai santa fe 2.7l 2wd model with only 92k miles that I just bought off of Craigslist anyways when im on flat ground and cruising through town the transmission shifts perfectly. However when i went up an incline to get on the freeway it shifted hard around 40 mph but after i got back on flat ground again I got caught up in bumper to bumper traffic and once it cleared it shifted perfectly all the way to freeway speeds of approximately 70mph. Then after getting off the freeway and picking my friend up when i went to get back on the freeway (another incline) it shifted hard again around 40mph.
View 15 Replies
We bought a used 2001 Grand Am (V6 automatic) a few months ago. Mileage was just under 100,000. It was running decently at first, but that improved once we did more maintenance. It's gone from about 150 miles on the highway on a full tank to about 250. A lot of the problems didn't reveal themselves until we took it onto the highways. These are the parts we changed in the last 2 months:
-new battery (old one was 0.1 above fail)-all 6 spark plugs-catalytic converter-front oxygen sensor-oil filter-timing belt-pcv valve and breather hose (old one melted)-all 4 shocks/struts
Latest problem is OBD code P0301 cylinder #1 misfire. The entire car started to shake when we were in low speed in a drive thru. It only seems to shake in drive gear and it does it the whole time. It doesn't shake in reverse or any other gear. Found out #1 spark plug was cracked and a chunk of the ceramic portion was missing. It got replaced but that didn't fix the problem. Haven't noticed any white exhaust yet. The ignition fails 1/7 of the time since P0301surfaced.
The last problem we had was P0420. We went to 3 different shops and nobody was able to fix the problem properly. It wasn't until the pcv valve and breather hose were replaced that the code disappeared. The valve was actually cracked and parts of the breather hose were melted. I can't understand why nobody noticed that.
I know there could be a lot going on, but I was hoping the possible problem could be narrowed down.
View 3 Replies
I have a 2001 hyundai accent GL the transmission has started shifting hard when it shifts into drive. It shifts fine and smooth from first to second but when it shifts into drive it hits drive hard and sometimes it acts like it doesn't want to shift and if you let up on the gas it will go ahead and shift, but when it shifts to overdrive it seems fine but hits hard when it down shifts back to drive. Also I have noticed a couple times when it goes to shift into drive the engine seems like it revs up some but when you let off the gas it goes ahead and shifts.
View 3 Replies
2001 Super Crew
2x2 4r70w transmission
417k miles
4.6l
Transmission shifting hard when under strain. My truck has 417k miles and the transmission is shifting a little hard when it is under strain. For example going up hills when in cruise and such forth, no problems otherwise.
My question is kinda weird: Since the fluid has never been changed or added to for that matter (fluid level is correct) , should I change it now or just ride it out? It is still my primary vehicle and runs perfectly!
I have been blessed with this truck since I bought it new
No engine work
Changed DPFE a couple of times
Cleaned throttle body a couple of times
Couple of pairs of shocks
one O2 sensor
alternator
I know its a weird question but could putting new fluid in at this time make more problems?
View 12 Replies
I have a 01 GrandAM 3.4. I have a reoccurring problem with this car. The car will randomly not start, and die while driving. Some days I can drive the car with no problems, and some days it will only have starting problems. These problems are very random. When the car doesn't start it will crank and turn over however the fuel pump will not kick in. You can turn the key on and off several times, and it will fire up. This DOES NOT seem to be a problem with the passlock theft system. The security light has never came on, and you do not have to wait any amount of time for the car to start, you only have to flip the key back and forth several times. The car after running will occasionally die, after the car dies it will usually start back up on the first try. I am very puzzled by this problem not sure if it is the ignition switch, fuel pump, or something in between.
View 19 Replies
My buddy's 2001 7.3L F350 has had 3 transmissions. Rebuilt and used. Once the new trans is in he goes like 15 miles and then is starts shifting hard and grinding gears. What this could be?
View 8 Replies
My dad has a 2001 Century that started out shifting hard, like when you'd go from reverse to drive it would jump. He ignored it. It started slipping and not wanting to go up hill. It began to leak fluid. Got the lines replaced, he was driving home and said he had to put it in 3rd to make it go because it quit moving in drive.
View 3 Replies
I ran over a 18 wheeler tire , it knocked my exhaust a loose & a few days later my transmission started shifting into overdrive at 30 mph.
View 4 Replies
bought the truck about 3 weeks ago and still having problems with the transmission. Replaced the VSS and it didn't work. My problems are it shifting hard from 1st to 2nd, it feels like it falls out of gear ( i can floor it and the speedometer creeps up then shifts hard.) Now i read having the 3rd brake light out is a problem with the trans too, my 3rd brake light is out along with the interior dome light ( doesn't go on when doors open) i plan to replace the TRS on the tranny tmw is there anything else i can do? how do i solve the brake light problem?
View 14 Replies
Last night when I was driving home, I noticed that all of my "night lights" were off. The lights on the speedometer, gas gauge, gear shift, etc. did not seem to be working, but all of my system warning lights (Traction, Brake, etc) seemed to be fine. I tried to turn the car on and off a few times and also tried fiddling with the lights manually. Nothing seemed to be working.
View 4 Replies
