Pontiac - Grandam :: 2000 - Running Rough / Loss Of Power After Getting Gas
Mar 2, 2014
My wife's 2000 grand am 2.4L engine is acting really funny. this is the first problem we've had with it. i was driving it to pick up my kids from school. on the way i stopped and got some gas from the marathon then drove about 5minutes and it started running really ruff lose of power wouldn't go above 30mph seemed like the transmission took longer to shifter to.
i made it to the school as i was about 2 1/2 blocks away. got my kids check the oil and it was really low so i got 2 quarts as it was a gas station in walking distance. i thought it was a lil better but i started driving it and it had the same results. i got it home about a 10minute trip regularly and parked it.
the next day day it ran then stumbled hard. and every time i tried to start it got the same think was like a lock up. it did crank but when it tried to start it stumbled or locked up. i pulled the plugs had some wet threads oil was on the first on and the threads and around the spark plug b4 i pulled it out.
2 of the other plugs had red stuff on them not on the threads though. here are some pictures also i will show a vid of what its doing. i did a compression test and here are the numbers starting with the first one with oil on threads.
190-194-200-190+ compression test with cold engine.
Also smoked puffed up not sure from where yet..
View 19 Replies
Advertisement
My Nissan Maxima GLE 2000 is showing CEL with code of P1320 ONLY, and the car is running rough/or loss of power. The shop that checked for the code advised that it could be something related to Ignition, and also provided me with the system generated list of reasons for the code. Before I decide to do anything, I wanted to check what option I have to address this in a most cost effective manner:
1) Is there a quick way to check which coil would have gone bad ?
2) Is it advisable to change 1 LH and 1RH at a time, and see if it fixes the problem ?
3) Could it be cam shaft sensor that could have gone bad ? Are there any symptoms of cam shaft sensor failure to isolate it to one way or the other ?
View 1 Replies
I have a 2002 Pontiac Grand AM for about 4 days now the car has been running hot. When it gets too hot the car dies and I have to jump the battery. Could this be more then a simple thermostat problem?
View 1 Replies
I own a 2004 Pontiac Grand Am V6... recently it has developed a rough idle - kind of like the car is hiccuping - and it hesitates when I accelerate from a stop. Now, it doesn't have issues changing gears so I'm not inclined to believe its a transmission issue...thought it might be the fuel filter, but I changed it and that did nothing.. I'm not getting a check engine light, which is frustrating because if I try to pull the codes it won't throw me any... so it's a guessing game now. I've gotten mixed reviews - anything from a bad catalytic converter to a faulty O2 sensor or idle air controller or a bad head gasket.. but my exhaust is completely clean...others say maybe its bad spark plug wires or other electrical issue (which is a whole other ball game) or possibly bad fuel injectors causing a misfire?
View 14 Replies
I have a 2000 grand am Gt with 3400 motor it started up just fine went to turn around in the drive way the dash lights came on where the ABS sensor is bad, but if u shut it off and started it back up they would go out so i shut it down and went to start it back up and all it does is click, so i thought it was the starter and replaced it, still only clicks. I called GM dealership they said more then likely it is the plastic piece the ignition switch goes in to so i just replaced it and does the same thing.
View 8 Replies
My wife has a 2000 Pontiac Grand Am, as seen above. The car recently started having issues, especially when cold, where the RPMs will rise when in gear but the car will not accelerate. It happened from 25 mph and lower while in a subdivision as well as around 45 mph on city streets. I have a feeling this is a transmission issue, but don't have much experience when it comes to transmissions.
View 6 Replies
I m having trouble figuring out why the radiator fans wont turn on, Even when the ac is turned on it still doesn't turn on, I changed the coolant temp senser. still nothing, i also ran a whire from the battery to the fan and they both turned on. I also stitched around relays and checked fused still nothing. 2000 pontiac grand am 2.4L engine 4dr auto trans.
View 14 Replies
I have just replaced an almost new oxygen sensor on my 2000 Grand Am. After about 40 miles, the check engine light came back on again. I have not had a chance to check it, but I assume it is the oxygen sensor again. What am I missing?
View 1 Replies
The Change Oil light was illuminated for a short time on my 2000 Grand Am. This morning, on the way to get the oil changed, the Service Vehicle Soon light came on also. After the oil change, the Change Oil light went off, but the Service Vehicle Soon light stayed on. I stopped by my mechanic, who doesn't like to change oil, since it does pay enough, and he said that there was something else that they should have done to reset this other light. He said it was in the manual, but I don't find it. How to turn it off?
View 4 Replies
I have a 2000 Grand AM cylin. Recently I was driving when my car started to shake violently. I drove it to the side of the road to a parking lot then it died. I started it up again and is ran but shacking a lot again. Once I got home, 3 blocks away the car died again. I tried to start it again but it would only turn but not start the engine. I have checked the gas pump, motor mounts, oil and anti freez for oil. I did check the timing chain but I don't know much on how it should be.
View 2 Replies
My check engine light started blinking on my 2000 grandam se last night and it was missing bad and now it wont start what is it.
View 13 Replies
I have a 2001 ford 7.3l powerstroke diesel. When I first noticed the problem I was towing a trailer going up a grade and got into the throttle almost to the floor and noticed a loss of power and the service engine soon light flashing extremely rapidly a few times and never came back on. I made it home, still lacking power but not running rough. I drove the truck to work the next day and the truck was running rougher and loosing power. It ran great through lower RPM's but seemed to trip as soon as you gave it over half throttle. eventually the truck wouldn't run right at all and lacked complete power. It idled rough as well. My mechanic threw the computer on it and it said injector pressure reading too high or too low.
I was told to replace the IPR on the HPOP and I did. (I also replaced the fuel filter and changed the oil). After replacing the IPR it ran great, had full power! then it began to slowly die like it did before until it sounded like it was running off 4 cylinders again. I pulled the ipr out, cleaned it and changed the oil again. It seemed to clear it up for an hour and ran great but then began ran rough again. I also replaced the CPS sensor. I feel like its not getting enough fuel or something, im just wondering if it could be the ICP or the lift pump. There is no check engine light at all. Its just got me stumped because cleaning the IPR clears everything up.... temporarily.
View 14 Replies
why my truck is running rough the problem I am having is when you push the gas peddle more than a 1/4 of an inch it shudders and has no get up and go and also if say I'm doing 40 MPH and hit the gas you can hear the engine rev up but I will lose all power and actually lose speed I thought maybe the cats were bad and I changed the plugs for good measure but I can't seem to figure it out also I had the fuel pressure checked and its pulling pressure is great/
View 6 Replies
I have a 2000 Pontiac grand am coupe GT with the 6 cylinder engine. It has been a very good car to me. I really like it and it "fits" me well ... and yet... it is now testing me. About a year ago the check engine light came on. The codes were P0327 and P0336 for bad Knock sensor and Crank sensor respectively. The were both replaced multiple times, the light still stays on... and the codes are still coming up. I have have been to different experts, and after the computer resets... there they are again. (someone even thought that the computer needed updated codes for those sensors... so he installed them.. with no better results). The code P1189 for an oil switch is now coming up too.Here in California, the car cannot pass smog with the check engine light on... so I'm not able to re-register it, and I don't think I can sell it for much because no one can register it now. So, what this can be? Is there some common thread between all these sensors (or a recall of some kind) that would explain this? My fear is that the computer will have to be changed at about $1000. My even greater fear is that that will still not solve the problem.
View 2 Replies
Was driving on the highway and all of a sudden my mph gauge just drops and my car slows down. This is the first time it happened and it didn't do it again after I got off the highway. Other things it has been doing: eating gas, shifting hard, and doesn't want to get up to speed. Not sure if they are related to this new problem or not.
View 2 Replies
I have a 2000 V6 3400 engine. I had the intake gaskets repaired with the "good metal ones" according to the mechanic I had do the job. Cost me $600. Car still has coolant leak it overheats every 3 days or so. Leaves no puddles under car when parked. Can smell coolant when stopping at stop light or stop sign or when parking car. No obvious coolant running down or pooling on the engine. Sometimes it seems like smell is coming from heat vents but no wet spots on carpet or liquid coming out of vent. Took to mechanic again and he said it was the head gasket leaking. Wants $1100 to fix it. Don't have the money. Was wondering if any of these additives you can get at Autozone Etc. may work. It wouldn't be my first choice but financially it's about all I can do right now.
View 2 Replies
I replaced the ignition key lock cylinder on my 2000 Pontiac Grand Am SE. I performed the re-learn process by cranking the engine over, then releasing to the ON position for about 9 minutes. During the 9 minutes the SECURITY light blinked the whole time, then at the end it went solid for a few seconds, then off. On the next cranking cycle I was able to start the engine and thought all was good. But now when I open the door the car beeps as if the key is left in the ignition and the automatic locks are disabled with the door opened.What is the problem and how do I fix it?
View 1 Replies
About three nights ago I had a complete power loss on the highway and the car began to bog down alot under throttle (and surge at points as well although with no boost). It also idled very rough/erratically. When I unplugged the MAF it cleared up right away; Idle was smooth and it ran without hiccup but in safe/limp mode so very tame (again, without boost really, gauge shows it stays in Vacuum and never passes "0" or goes into boost).
I scanned it this evening and got 2 misfire codes and a MAF code, along with a code related to traction control which I noticed had activated as a result of this and could not be turned on (by activated, I mean the light came on, disengaging T/C). These things make me think it is MAF related, especially because I have bolt down Hitachi coil packs so I do not think that is what it could be in relation to the misfire codes (which I think may be old and needed to be cleared).
Fast forward to last night: I can pretty confidently say my MAF is not the problem and I think I saved an unnecessary expenditure. I was able to meet a friend with a 337 as well and his MAF did not change my car at all and my MAF ran fine in his car so I think my problems are something else. Although with the MAF plugged in my car runs very poor and unplugged it clears up and just runs "limp" (no boost and slow but stable) from what I tested this evening the MAF unit seems to not be the issue.
I think there must be a vacuum leak of some sort between the MAF and the engine which allows more air in than the MAF signals when plugged in which causes the issue. Also, I know a common thing to think is "coilpacks" but I have bolt down Hitachi coil packs so I would imagine that would eliminate those from being the failure they tend to normally be. Agreed ??
View 14 Replies
I have a 2000 Pontiac Grand Am. It has a leak in the power steering system. Someone has suggested, before I get it fixed, to try something like Blue Devil or Bars Power Steering Leak fix. Is this worthwhile, or do I risk causing more problems?
View 3 Replies
Both power windows on my 1997 Grand Am are broken and the last time I had one fixed it cost $500. I would like to convert the windows to manual from power. What parts do I need to buy to do so.
View 7 Replies
I have a 00 Accent with 132k miles, I replaced the motor a year ago with a correct 2000 Hyundai 1.5 with 50k miles. I replaced everything that I could at the time, timing belt , starter, water pump, and clutch. It has been running fantastic getting 40 miles per gallon with zero problems , However in the last week I have noticed a rough idle that seems to miss with a vibration that it didn't have before. I have a noticeable loss of power and torque. My miles per gallon has also dropped to about 25 mpg. My check engine light is not on. I will check the plugs and change the air filter today but I would like to know what else could be causing the problem as I am not really sure what to check.
View 9 Replies
