When I changed the alternator on my 2000 plymouth neon, I crossed the wires for the plug. Now the fuel pump fuse keeps blowing, when it turns over, which isn't often. I turn the key and nothing happens.
View 2 RepliesMy R32's Fuel Pump Fuse keeps blowing. This started after driving my car in a bad rainstorm. I think water may have gotten in the door which could be causing the short, but I am not sure. This car has two fuel pumps as it's been modified. I know for a fact the main fuel pump works as it did prime after replacing the fuse (then letting the car sit over night then opening the door). Right after the fuel pump primed though, the fuse blew. I decided to replace the fuse and start the car. The car started and ran for maybe a second or two before the fuse blew. I took a look at this thread in regards to the fuel pump not working as I thought the fuel pump was dead till today. I was wondering what are the possible problems that could be causing the fuse to blow? Could it be the relay? Could it be the switch in the door shorting? Also, where would I find the relay? I know it's under the dash, but is it under the panel on the passenger side or driver side?
View 1 RepliesOk so I just bought this car, 1993 pontiac grand am se, from a neighbor. When I test drove it, the back seat was all unscrewed so I thought no biggie and it drove really nice for being a 1993. Ended up buying the car. I get the car home, husband puts seats back together and we go to leave for town and the fuel pump fuse blew. Put a new one in, go to start the car, fuse blows again! Tow the car home. Husband checks the wires to make sure there is no faulty wires. Has to reground the ground wire. Car then starts. Go to drive down my driveway and the dang fuse blew again! Mind you there is a new fuel pump in the car so we know this isn't what is wrong with it.
View 4 RepliesI have a 2000 F150 with @175K miles. Replaced the clutch about a year ago, replaced the front calipers a few weeks ago, due to the right front locking up on my way home from work. Since then, when I try to start, it blows the fuel pump fuse. (#10)...
View 2 RepliesI have a 1994 Ford Ranger king cab 4x4 with a three inch lift kit on it . My problem is the fuse is blowing that goes to the fuel pump . It started out blowing the fuse now and then when it was raining . Well I thought it mite be the fuel pump going bad but after I put the new pump in the truck it lasted about a week and started blowing fuses again . I put another fuse in and it go a few days and blow it . Last week on a 100 mile tripe I got almost there and it burned a fuse on the highway . I tried to put another fuse in and it would blow it as soon as I tried to start the truck . Burned five fuses right then . So I had it towed to mothers house and put another fuse in and it cranked up . I looked at the wiring that was not wrapped in that plastic cover stuff and have not found anything yet ...
View 14 RepliesI have a '96 Dodge Stratus that keeps blowing fuse #20, which is for the fuel pump and the ignition. How to isolate the problem? This happens as soon as the key is turned on. The car has 140,000 miles and runs excellent otherwise.
View 3 RepliesMy 1996 Ford Ranger's Fuel Pump- Fuse keeps on blowing... (Fuel pump is new)... We need to find where the short is coming from!
View 2 RepliesThe fuel pump fuse keeps blowing intermittently. I would assume it's a wire grounding out somewhere but I can't seem to find one yet. I do have a faulty purge solenoid on the canister but I don't think that would cause this. The reset switch doesn't seem to be tripped either.
View 3 RepliesI have just replaced a fuel pump on my 98 neon and it started up and then shut off after about 5 minutes. there is electricity running to the pump just not kicking it over what could be the problem
View 9 RepliesMy neon has a leak that was diagnosed today as a rear main seal. I realize this is an expensive repair and am wondering two things:
1) Can I limp it along until next Spring by adding oil as needed?
2) Can try stop leak additives? If so, which one?
I have a 1998 plymouth neon that is leaking oil from the filler cap, I have replaced the cap 4 times and it still leaks from this same spot. What it might be?
View 4 RepliesI have a 2001 Plymouth neon and the coolant fan cuts on and off about every 30 seconds .
View 2 RepliesI noticed a knocking sound from my 1996 Plymouth Neon when I hit some bumps. Poked my head underneath and see what appears to be the strut loose inside the spring. I am afraid that the "Damper Shaft Nut" came undone somehow? If so, how do I remove the quick-strut? Is the spring in danger of being sprung?
View 7 RepliesI have a 95 neon SOHC that drives with a very high Idle. Not all the time, but 85% of the time witch i find strange. This has been going on for the better part of a year and the car is almost undrivable. Its putting a hurting on my breaks for sure.
I had replaced the PCM 5 years ago. Replaced the timing belt 2 months ago. I have searched all around for vacuum leaks but am not able to find anything. I pulled the throttle body off and cleaned it very well. I replaced the IAC.
The car continues to idle out of control as if the IAC is wide open. The only way to get the car to idle correctly is to cover the idle hole in the throttle body 90% up with my finger. The guy at Auto Zone said if its not IAC or vacuum hoses, then I should start replacing sensors. How do I diagnose this problem?
I have a 1998 Plymouth Neon that will start after it has cooled completely, and be fine through out the day, but when I get home from school and I start it again, it makes a strange screeching noise, and after turning off the engine and trying to restart the car, the vehicle will not start again, but all of the lights work, the battery is fine, the alternator is okay, the starter is a brand new OEM part, new ignition coil, new spark plugs, new safety neutral switch, new speed sensor, new battery cables, new camshaft position sensor, the only extra thing it does have is fog lights that were not put in by the dealership, this was done when my uncle still owned this car back in 1999. The only other problem that it has is an Error code of P1899 (Safety/Neutral Switch Stuck) and at times when turning the steering wheel, it will make a screeching noise halfway turned until you let go a bit, and then it is able to completely be turned either way, and one last thing is that the speedometer was a bit erratic one time, while I was driving home on the freeway.
View 10 RepliesI have a 95 neon that is running a very high Idle. When you remove your foot off the break & gas it idles around 40 mph. Iv just replaced all the breaks and its melting the new ones already. I am receiving the following check Engine Codes: 12, 25, 32, 15. I have completed the following repairs:
1) replaced all vacuum lines.2) removed EGR Valve to clean, replaced all lines. No more engine code 32, however, now I am getting engine code: 12, 23, 25, 15.3) removed intake manifold to replace the PCV Valve as well as all hoses from the oil separator.4) replaced the IAC sensor5) used ohm meter to check all wiring from IAC to computer. no issues.6) replaced the TPC sensor7) used a ohm meter to check all wiring from the TPC to the computer. No issues.8) used a ohm meter to see if the air temperature sensor was working correctly. No issues9) checked wiring from Air temperature sensor to computer, no issues.
The car continues to idle extremely high to the point it is not safe to drive. By feeling the throttle body where the IAC lets in air, it feels like its comply open. I pulled the IAC out of the throttle body while it was plugged in and ground to the engine block. When you turn the car on you can see the IAC move, but it never seems to want to shut off air supply.
It appears the computer is telling it to let more air in even though its very high idle. I replaced the computer about 5 years ago. what would cause this?! Im to the point iv put in way too much time and money already. but I don't want to buy a new car when it could just be a $50 fix.
Ok, ready for a new head scratcher? After replacing the starter, the battery cables, the camshaft position sensor, several hoses that were broken and/or disconnected, a wire for the transmission "forgot the name of it, but technically it was a cable with a piece of plastic that connected to the throttle", air filter, spark plugs, spark plug wires, battery temperature sensor, ignition coil, several missing fuses, I got a new code.
This code came up and I believe it is the same code that came up before, but I think it got masked by the battery temperature sensor and the "random cylinder misfire." It only appears when I reach speeds of 60 mph or above, the code is P1899 and when I took it to Autozone, Oreilly's, and Dick Poe Dodge, they were unable to figure out what the code meant.
my wifes explorer is getting no fuel. (there is a valve I depressed similaR to a tire valve, I pressed it once some fuel dribbled out, and thats it, turned the key several times and not a drop off fuel. I went as far as checking the fuse, the fuse is not blown. what are my next steps of trouble shooting.
View 8 RepliesI have a 2010 V-6 Camry that has been sitting for a couple years, changed the oil (what a system that is !) and was wondering the location of the fuse or the relay for the fuel pump is so I can crank the car over awhile to build up some oil pressure before I start it .
View 4 RepliesWhich one is the Fuse for Fuel Pump on a 2014 VW Tiguan?
[IMG] [/IMG]
Long story short, my car died on me shortly after pulling out of the driveway a few weeks ago. Initially I thought it was my fuel pump because it wasn't priming when I had the key turned to the "ON" position. Here's what I know for sure:
The fuel pump works. It was tested and is not the issue. The relay is good.
The fuse from number 28 is good. There isn't any power at the fuse. The shop has been tracing wires and looking at diagrams and cannot find any breaks in any wires.
The ECU has been swapped for another one. When I turn the key to the "ON" position, the check engine light and EPC light come on, then turn off after about 3 seconds. They do not stay on.
What else could it be? Car in question is an 01 Jetta 1.8T AWD motor code.