Plymouth :: 1987 - High Idle And Will Not Kick Down Until Warmed Up
Dec 24, 2011
I own a 1987 Plymouth Horizon, 70, 000 miles on it. Long story short, The car sat for 3 years without being driven. It would just be started up whenever the other owners wanted to. I have fixed a lot of its problems, and replaced tires, brakes, hoses, belts etc.. Problem I am having is when itis started up it is at a very high idle and will not allow you to kick it down till it warms up or it idles down on it's own after being warm. I have sprayed carburetor cleaner around the linkage and so on but it still does it. What could be causing it?
Like I said the car sat for 3 years and did have gas in it when I bought it and not being able to drain out the old gas I put HEET gas-line antifreeze & water remover in it. The fuel filter has been changed out twice. Once you get it on the road it runs like a champ for being 24 years old. It's just the high idle when you first start it up. The owner of it had some little quirks I guess you would say. He had and they are still there, two clothes pens on the gas rail/line and they were there because of vapor lock. They are located on two different parts of the line I guess to balance it out. Now I don't know if this is true or how even remotely possible two clothes pens could have anything to work with vapor lock. Now I do know that on occasion it will run a bit and stop when you cut off the engine, though not all the time....
View 4 Replies
Advertisement
I have a 1987 ranger 2.9 V6. Have a intermittent miss @ idle when warmed up. What is the proper way to pull the codes from the computer, i,st something about counting flashes or lights...
View 6 Replies
I have a 95 neon SOHC that drives with a very high Idle. Not all the time, but 85% of the time witch i find strange. This has been going on for the better part of a year and the car is almost undrivable. Its putting a hurting on my breaks for sure.
I had replaced the PCM 5 years ago. Replaced the timing belt 2 months ago. I have searched all around for vacuum leaks but am not able to find anything. I pulled the throttle body off and cleaned it very well. I replaced the IAC.
The car continues to idle out of control as if the IAC is wide open. The only way to get the car to idle correctly is to cover the idle hole in the throttle body 90% up with my finger. The guy at Auto Zone said if its not IAC or vacuum hoses, then I should start replacing sensors. How do I diagnose this problem?
View 12 Replies
I have a 95 neon that is running a very high Idle. When you remove your foot off the break & gas it idles around 40 mph. Iv just replaced all the breaks and its melting the new ones already. I am receiving the following check Engine Codes: 12, 25, 32, 15. I have completed the following repairs:
1) replaced all vacuum lines.2) removed EGR Valve to clean, replaced all lines. No more engine code 32, however, now I am getting engine code: 12, 23, 25, 15.3) removed intake manifold to replace the PCV Valve as well as all hoses from the oil separator.4) replaced the IAC sensor5) used ohm meter to check all wiring from IAC to computer. no issues.6) replaced the TPC sensor7) used a ohm meter to check all wiring from the TPC to the computer. No issues.8) used a ohm meter to see if the air temperature sensor was working correctly. No issues9) checked wiring from Air temperature sensor to computer, no issues.
The car continues to idle extremely high to the point it is not safe to drive. By feeling the throttle body where the IAC lets in air, it feels like its comply open. I pulled the IAC out of the throttle body while it was plugged in and ground to the engine block. When you turn the car on you can see the IAC move, but it never seems to want to shut off air supply.
It appears the computer is telling it to let more air in even though its very high idle. I replaced the computer about 5 years ago. what would cause this?! Im to the point iv put in way too much time and money already. but I don't want to buy a new car when it could just be a $50 fix.
View 1 Replies
My ranger 2.9 automatic 2WD has an high idle when started for about 6 min, engine can be hot or cold, still get the high idle, then it will drop to around 900-1000. I've changed the Idle control twice, checked EGR function. Replace temp sensor. Disconnected battery for 15 min. No code output.
View 7 Replies
I've replaced all (3) ignition coils, both O2 sensors, wires and plugs, air filter, fuel filter...Also experience some missing at low rpms as well...not sure what the problem is?
View 4 Replies
Ok, ready for a new head scratcher? After replacing the starter, the battery cables, the camshaft position sensor, several hoses that were broken and/or disconnected, a wire for the transmission "forgot the name of it, but technically it was a cable with a piece of plastic that connected to the throttle", air filter, spark plugs, spark plug wires, battery temperature sensor, ignition coil, several missing fuses, I got a new code.
This code came up and I believe it is the same code that came up before, but I think it got masked by the battery temperature sensor and the "random cylinder misfire." It only appears when I reach speeds of 60 mph or above, the code is P1899 and when I took it to Autozone, Oreilly's, and Dick Poe Dodge, they were unable to figure out what the code meant.
View 14 Replies
2002.5 VW Jetta GLI VR6 24V 6-Speed. Barely accepts a small can of Freon from full empty, and pressure goes to over 100 psi in the red, compressor does not kick in, idle fluctuates with A/C button on, small fan kicks on fine, some air pump turns on and off with the erratic idle and sounds like shot of compressed air. When I turn the A/C button off, idle comes back to normal and that psss sound is gone. I already changed compressors and that made no difference. Video below.....
View 5 Replies
Still trying to resolve this issue. I've replaced the coils and now the 6 month old NGK plugs with Bosch plugs. I bought a kit from ECU; the red coils and the Bosch plugs. Car revs smoothly no hiccups all the way on up. But sometimes the car won't start first kick, and the idle is almost always lumpy. CEL light has been on for more than several weeks. Last time I took it to the dealer to clear. It was back on the next day. 112 K (km) on car. 2009 TSI 2.0...
Parts Source will read the codes, and now there are plenty. I've looked at other threads re PCV valves and air leaks, but I don't believe they're related to the idle issue I'm having. More pronounced in the colder weather I might add.
View 3 Replies
So I have a 2002 Kia Spectra. I know the IAC has needed replaced for a while but It hasn't really been a n issue at all until today. So last night my car's transmission started to kick when shifting gears. Mostly between first and second but at other gears sometimes as well. This morning it was still kicking and I figured my transmission was going out. However when stopped at a stop light I noticed that my car was idling rough. So I turned it off and tried to turn it back on and it wouldn't start. At least not for about 10-15 minutes. So I was wondering if the IAC could be causing the transmission to shift rough at all?
View 3 Replies
1993 Plymouth Voyager LE 3.3 V6 Automatic. Bogging down when entering an incline, keeps running in idle, will bog down, if dropped in low it will take off, sometimes backfires. Runs very good when on level ground. What can it be, mechanics suggest fuel pump, transmission, had it checked out by my mechanic and the fuel pump is fine, doesn't seem to be the transmission either.
View 2 Replies
So I have a 2002 Kia Spectra. I know the IAC has needed replaced for a while but It hasn't really been a n issue at all until today.
So last night my car's transmission started to kick when shifting gears. Mostly between first and second but at other gears sometimes as well. This morning it was still kicking and I figured my transmission was going out.
However when stopped at a stop light I noticed that my car was idling rough. So I turned it off and tried to turn it back on and it wouldn't start. At least not for about 10-15 minutes. So I was wondering if the IAC could be causing the transmission to shift rough at all?
View 2 Replies
My toyota will not idle. The last time this happened, it needed a new battery. The idle is controlled by the battery. The alternator doesn't kick in untill 1500 to 2000 rpms. The battery checks out OK this time. It's an 03 4cyl.
View 5 Replies
I have a 97 Ford Explorer. I bought it in 07 and it was nice until like 2 years ago when it started to give me doubts. It never died on me,yet, but everyday when I first start it for the day, if I put it in gear right away, it will stay idle for a while and then kick into gear and just jump. I would drive but it keeps kicking off and on until it is warmed up, I guess because it goes away. Also the OD light would come on also.
View 2 Replies
I have a 87 Honda crx si that the blower works in setting 1-2 but in setting 3-4 it kills the car I check the altenator witch was bad and replaced it witch should of fixed the problem previous owner said he had replace it once before. when you turn the heater to the 3rd setting in idle the car lugs down a little and if u give it gas it instantly kills it 4th setting won't work at all...
View 7 Replies
I just replaced the timing belt and tensioner and idlers on my 02 camry 3.0 V-6. The car idles and runs fine until it is warmed up then won't idle, otherwise runs fine with good power.
View 1 Replies
My coolant was right below the low mark (it was right above 1k miles ago so it has a slight leak, but haven't checked the bottom core yet, most likely its leaking there?) so overnight it sat and in the morning ive filled it to the high mark and upon starting and warming up the engine the coolant went back to right below low. It doesn't look like its leaking at least not anywhere that fast, is this normal? I gotta check later again while car warmed up etc to check level, but how can the coolant go from being at the high mark to right below the low mark?
Regardless the radiator had previously been repaird by the lexus dealership for leaks, where it should've been replaced. Luckily lexus said they will take a look and replace, but Id rather not go through the dealership.
View 10 Replies
I have a 2013 F150 FX4. When the temperature is below 45 and the truck is cold the right high beam wont turn off if used, until the truck engine is warmed up.
View 6 Replies
I have a 1987 Convertible Celica GT, with Manual Transmission. The car will not idle at lower RPM. I had someone look at it, and they have it where it will idle at 2000 RPM, but anything lower than that, and the engine will die when not giving it gas.
The engine accelerates great and runs great at any speed, but if you push in the clutch without giving it gas, it will die, unless the idle speed is cranked up like it is now. What this might be?
View 4 Replies
it's really a 1987 Nova, but the drop down menu didn't list that option. I have been working on trying to figure out the cause of this problem for a pretty long time. During the last several years it had been running deteriatingly worse until I did an ignition tune up and replaced the spark plugs, plug wires, and the distributor cap (and rotor). That restored operation back to just the original problem of random but often poor or inability to idle. I have spent a lot of time on the carburetor and think that isn't the cause of the trouble. I'm pretty shy about doing this post, but here goes.
View 7 Replies
I have an '08 Ranger, automatic. For the last several months, the truck has been making an intermittent high-pitched squeal/whine, but only after it has been warmed up (10--15 minutes driving) and only while it is idling. As soon as I'm driving, the whine stops; whine will occur both in drive (but stopped) and in park. The whine will not happen every day I drove, nor will it happen at every stop. When it does squeal, the squeal will fade in and out in volume.
An interesting kicker I've found recently: it seems to be dependent on electrical draw. For example, if I'm sitting idle with the lights on, and the truck is squealing, and then I turn the lights off, it suddenly squeals less. Still squeals, but less than with the lights on.
I have had mechanics check all the usual suspects, belts, etc, but have not found anything amiss. Nor can I actually get the squeal to occur when I visit the mechanics.
View 4 Replies
