Peugeot - 505 :: V6 Auto Transmission / Hard Shift
Jan 24, 2011
I own two of the most hated cars on this show, a Renault Alliance and a Peugeot 505 V6. On the 505, the transmission was shifting pretty roughly, it was knocking hard. I bought another 505 for spares that was shifting smoothly. So this summer, I decided to spend 4 weekends on hard labor and I swapped the ZF automatic transmission from the rough car to the good one. After all that job, I didn't notice any real difference. So I guess it was the torque converter that I left on the engine?
Anyway, I decided that it will stay like that because I will rather take a bullet than drop this tranny again. Now yesterday, it was -30?C outside, after 3 months of storage outside, just for fun, I tried to start it. It started right on! So I let it warm up for few minutes then went for a little ride. Big surprise, it shifts very smoothly now in cold weather... So what's wrong? Wrong type of oil? I filled up with the one suggested in the owners manual!
'87 Peugeot 505 STX V6
'87 Renault Alliance DL
'70 Renault 16
'97 Volks Transporter T4 (Eurovan diesel).
View 3 Replies
Advertisement
My 2005 Ford Taurus (3.0 liter engine, auto trans, 117K miles) recently began shifting hard (dropping suddenly, not smoothly) only on the 2-3 shift at 20 MPH. The check engine light is not on, and the car functions perfectly otherwise. A mechanic removed the trans pan, replaced the filter and fluid, and added Lucas additive. The interior of the trans was clean, and did not have a burned smell. The 2-3 shift did not improve.Could it be a valve body or a solenoid? Is it repairable? I drive it gently, and the problem hasn't gotten worse (2 months). What's up with my trans?
View 1 Replies
This is on my 7.3PSD. I've observed that the 1-2 gear shift drops about 1,000 RPMs and takes a good half second or longer to do so when given a lot of accelerator pedal input. And then the 2-3 shift is a very quick and harsh shift.
If I am accelerating gently the 2-3 shift is as unnoticeable as the 1-2 shift is quick. Is the slow 1-2 shift causing the trans to protect itself and affecting the 2-3 shift? And if so, what do I do to resolve all of this? I changed the trans fluid a week ago and there is no change.
View 2 Replies
Could my brake issue be related to my transmission problem? Neither are constant. Brake problem= sometimes the brake pedal feels hard, like there's no power brakes (I drove a car once. ..looong time ago. .. that had no power brakes or steering) but it will kick in after a short distance. Transmission prob= seemingly unrelated, is a problem shifting from 1st to 2nd gear. This has happened maybe a 1/2 dozen times, the first time and mostly when in heavy commute traffic and when going between 1st and 2nd gear because of the slow commute speed, but also at other times when not in lengthy slow commutes. When it doesn't shift, the odometer doesn't work (shows only dashes) and an engine light comes on (the sprocket/gear looking one). Usually the transmission will eventually shift and the light goes off.
I read that the brake problem might be a vacuum hose problem? Something about a booster? Is this dangerous? or is it like having a car w/ no power brakes? Going to have my transmission looked at this week. Read on another site about dropping valve seats on this year car. If there's a major transmission problem, I'm wondering if it's worth fixing? I changed, timing belt, water pump, front and rears brakes, tires. 143,000 miles.
View 1 Replies
Auto/transmission will not shift to overdrive. Is there a relay between the o/d switch and the solenoid? Is it alright to drive on the freeway?.1988 Volvo 240 DL.
View 1 Replies
How the auto gear shift works on a ford E350.Does it work by wires or does it have a steel column to change the gears.I have looked for pictures but with no luck. I have spent 2 hours looking.
View 4 Replies
My son has a 1987 Chrysler 5th Ave. The transmission (auto) does not want to shift in reverse. It does go in neutral and forward. And it drives well forward. How to fix this?
View 1 Replies
I have an 04 jetty with an auto Transmission. It doesn't seem to shift after the first time when speeding up. What might cause this?
View 5 Replies
A friends son just bought a 94 powerstroke. auto trans. it will not shift out of first unless you let off throttle. but once in second it shifts fine, until you stop and go back to first. I am thinking bad or sticking second gear solenoid, but do not want to give bad info.
View 1 Replies
i have a 94 vw passat vr6 that wont shift. when you start off in drive it takes a second for it to start to move. if you shift it manually from first on up it shifts okay but sometimes it slips in between 2nd and 3rd. the only time the car will shift is after driving it a few miles at about 65-70 it will shift itself into second gear and not come out you have to shut the car off and wait a few minutes to "reset" itself. after driving it on the highway it kicked itself into second gear, i pulled over and the fan was on and it looked as if there was some fluid on top of the transmission but cant recall if it had been there earlier. i checked the ATF and there was no shortage of fluid. could the fan be on due to the transmission over heating? what could be the cause of it not shifting?
View 2 Replies
I have a 2000 Ford Ranger 4X4 XLT with a 5R55E automatic transmission.
Coming out of a stop the truck jolts at about 20 mph as it shifts from 2nd to 3rd gear. It feels like it revs too high in 2nd gear, up to about 2400 rpm, and then shifts hard into third. It feels like the truck gets a gentle hit from behind.
Earlier in the week, the O/D light flashed. I took it immediately to an independent tranny shop who pulled the code for me: P7033, incorrect ratio in 3rd gear.
They cleared the code for me. In limited city and highway driving (less than 15 miles each trip) the O/D light has not flashed again. But the problem remains. I plan to take it back to the shop later next week.
What might cause this so that I might have a more informed conversation with the tranny mechanic?
View 3 Replies
Why does the automatic transmission stay in 3rd gear and not shift into overdrive until it gets warmed up? It is so annoying. This is the only car that has ever done this. Even the camry I don't think does this. Especially the fact that the rpms stay above 1k rpm until the engine is warmed up.
View 7 Replies
I get a hard shift into second gear, it jerks into 2nd but not all the time. I only notice it after driving on the freeway for several miles. It has 60,000 original miles. Service Engine Soon light come on after the hard shifts with a transmission fault code. I reset the Engine light and let it set 20 or so minutes and it shifts like new.
1997 CHEVROLET TRUCK S10 2WD
6 Cylinders 262 X 4.3L SFI
Automatic
View 13 Replies
2009 Kia Sorento. The Transmission was replaced twice last week and the week before. For the same problem. 50K miles. Auto Transmission...
I have a hard shift between 3rd & 4th gears, I have had the transmission replaced twice. Could it be something else?
View 5 Replies
When I had other repairs done they told me that problem was in the number 2 cylinder and it was an internal problem. It was out of their league. I called Honda dealership, they had a girl on the phone and she said she couldn't give me a quote I would have to pay 85. to find out what it was. I don't think she knew what she was talking about. i need a quote how much this should be to fix it before I pay 85. for something that maybe thousands of dollars to fix. The car jerks when it is going into another gear especially in the 1st and 2nd gear. It like shoots off. Jerks and then kicks. If ya know what I mean. Like a transmission slip but I had that checked, that wasn't it. confirmed 2 places that is not the issue.
View 4 Replies
I asked a question about the E40D a while back about a hard 1-2 shift. However, I needed to replace the shift lever to get my OD light operational again. I fixed it and the issue seemed to stop for a while, so I just forgot about it. It's back again, last time it did it, it was hard enough to make the whole truck almost buck. It was a real good bang. So, could this be the 1-2 accumulator piston or the bore it resides in?
The next question I had is how long should an E40D take to shift from second to third? I've noticed on a steep onramp with some throttle, mine can have around 2.5-3 seconds of rev before it finally shifts (unloaded). I could of sworn I watched the tach climb a hundred revs or so during this once (real steep onramp), however maybe I was just dreaming, as I've never replicated it. Just wanted some opinion on this, wondering if I need to start putting some funds aside.
The truck has about 139K and the transmission looks to be original. It was used to haul a camper and a boat most of it's life, or at least that's what I was told.
View 3 Replies
Another problem with Bonne. My transmission has a very hard shift intermittently. The car has approximately 102,000 miles. The shop says it needs 2 new solenoids(1-2 & 3-4). The cost is going to be about $1050. I've read of a pressure control valve causing similar problems but not 2 solenoids. When the problem occurs all the shifting is hard in all gears.
View 5 Replies
At 37 mph and transmission shifts to 5th gear a violent shift occurs. The fist time I thought that I had hit a cement block! It only happens in triptonic or if I leave the shift lever in 4th gear and exceed 55Mph. My local VW dealer said a new Transmission would cure it.
View 8 Replies
2011 F-150 Scab 5.0L 25k miles. Why my transmission is waiting several seconds after being placed into drive or reverse before it actually slips into gear when first started in the morning and why it has a hard shift between 1st and 2nd than again between 2nd and 3rd and maybe why when it shifts into 2nd and 3rd gear it slips back out than back in?
View 7 Replies
I have a e99 7.3. had the transmission rebuilt a couple weeks ago by a local shop. have been getting some hard shifts between 2nd/3rd when lightly accelerating. Took it back already but they couldn't find anything. I am planning on taking it back again but what it is so it gets fixed right. What is causing this or what it might be? Should I be worried about having this shop try and fix this?
View 1 Replies
I have an 04' R32 with about 56k on it. Here's the problem; when I drive it hard and speed shift from 2nd to 3rd it grinds just a little. It doesn't do it when I'm just cruisen grany shifting. For awhile now I've been thinking that the synchronous from 2nd to 3rd gear was going bad, till I talked to a friend with a 20th GTI who said that the 6 speed trannies will start to do that, and there's really nothing you can do about it. Is this true that I just have to deal with it or can it be fixed?
View 12 Replies
