I have a 1967 Cutlass. She ran great yesterday. Today she won't start. I have spark coming out of the coil but no spark going to the plugs. Plugs and plug wires test good as well.
View 8 RepliesWas running with a slight miss until reach 30 mph for about 5 days now this morning, turning over and over but won't start..checked 2 plug wires no spark to ground..how to fix and make start?
View 5 RepliesI'm driving an 87 v6 auto cutlass 130 000 km on it. Recently changed alternator and battery at mechanic.
After start up i put the car into gear but it wont shift into gear unless I give it a lot of gas and even when I do so it seems to have trouble keeping momentum /staying in gear. The shifts are rough. However after driving for a few minutes there are no issues at all.
It's been quite cold lately and I've noticed that if I let the car run for about 10-15 minutes before driving it's fine, no problems (although this seems a bit excessive).
Could this simply be an old car/cold weather issue or is there something else to consider?
i own a 67 old cutlass supreme and the fuel gauge, as you turn off the car goes down to 3/4 of a tank, when you start it up it goes to full. But the car is really empty! That is the only reading I get, no matter how much gas I have. I replaced the sending unit and I cleaned the ground wire, it still does the same.
View 4 RepliesI am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
04 intrepid cranks but won't start no spark at the plugs 2.7v6 could it be the pcm...
View 2 RepliesRecently replaced head on my 95 civic 1.6 Vtec, i had to replace the head gasket a few years ago so i know what to do. My problem now is that it will not start and has no spark to the plugs, i have new plugs, wires, rotor and cap, even tried a new distributor but took it back since it changed nothing. I pulled a plug wire, removed the plug and plugged it into the wire, turned the engine over and no spark.I've checked voltage to the distributor with ignition switch on and as far as i can tell it's getting voltage to the distributor. But when i try to crank it the engine turns over but will not start. It is getting gas, i took the fuel rail off with the injectors and checked for flow. I've taken timing cover off a couple of times to make sure all timing settings were as they should be. I even went ahead installed a new ignition switch which made no difference. Waste of time and money. I've checked several times to make sure all electrical connections are good. I really hope this turns out to be a simple fix but right now i'm at a loss. ECM maybe?
View 4 RepliesI just put an '86 5.0 engine from an F150 2wd pickup in my '87 truck of the same model. The motor was running when pulled but when I set in the '87, it won't run. I've replaced coil, distributor assembly, plugs, wires, throttle body, checked timing etc. I've got spark through the plugs and fuel in the cylinder but with no luck. Don't know where to turn next.
View 3 RepliesI have a 2005 Jeep Liberty with about 129K. The car overheated and resulted in changing the head gasket and piston rings. Now the car will not start with all six spark plugs installed. It will only start and run for a short period time with three spark plugs on the driver side installed.
View 19 Replies99 olds cutlass, this morning I drove it and the coolant low light came on. Stopped at autozone, grabbed some coolant and tossed some in. Kept driving, light was intermittently on and off. Drove it to work and around noon filled it pretty full with coolant. Drove away at 5pm, no puddle underneath the car. Stopped to get gas, didn't notice any puddle but didn't look closely. Drove it home, parked it, went to get the mail, came back, pretty impressive puddle of coolant leaking from under the car.
View 3 RepliesMy wife and I have a 1986 Cutlass Ciera with an engine size 4 -151, 2.5L engine with 41,749 original miles. Right after the transmission shifts at around 30-35 mph it locks up (for a lack of a better word.) This lock up can continue to about 40 mph. It feels like it 'misses or hesitates' until I let off the gas and increase speed again by going faster than 40 mph.
The GM service department said there was a recall sometime ago to solve this problem but the fix was only for the larger 4 liter engine and to use this fix would damage the cars engine. They said it was not a transmission problem and that we will probably have to 'live' with this condition which is more a nusiance then anything else. They go on to say this condition will not harm the engine. Are they right with their answer or can something actually be done to fix this problem? Other than this the car runs great. It has been tuned up, all belts and hoses replaced, new thermostat, etc.
Also, when we turn on the ignition, the engine would race at 2,000 rpm until we let it warm up and then put it in gear at 1000 rpm. A new thermostat keep the idle from going so fast when we start the car. Is the fast idle normal for this age of a car or could something be done for this also.
My wife's car is making a odd sound. I think it may be the timing belt. Her car is a 1999 Olds Cutlass v6 and I don't know if it has ever had its timing belt replaced. I can't tell from her records. So what kind of a timing belt does this vehicle have? How many miles before it should be replaced? The last question is, if she keeps on driving it, what it the worst thing that can happen?
View 8 RepliesHow do I replace the computer in the 93 cutlass ciera, 3.3 engine 6 cylinder,.I see the computer is behind the glove box..but a very tight spot.
View 5 RepliesI have a 1992 Oldsmobile Cutlass Ciera 6 cyl.The car starts up and runs with no problem. However every two to three weeks while I'm driving the motor will just die on me. It doesn't matter where I am or the speed I'm driving it will stall. It takes about a minute and the car starts again, but I need to get this fixed!! My mechanic says it isn't the fuel pump, fuel filter or the crank sensor. He is a good mechanic too.
View 6 Repliesi have 1992 v6 olds cutlass ciera. it likes to spit and sputter sometimes. no matter if it's hot or cold, up a hill or on flat, slow or stop?
View 3 RepliesI have a 1992 Oldsmobile Cutlass Ciera 6 cyl. This car just all of a sudden started shuttering and not wanting to take off. It will if I floor it but will still shutter a little?
View 10 RepliesWhat is the computer location on the 93 cutlass Ciera S 3.3 6 cylinder?
View 6 RepliesI have a 64 Olds Cutlass. I drive it once a week or so. That means it sits most of the time. Lately it's been very damp and rainy. I've noticed that when I start the Olds up there is white smoke coming from the exhaust. This lasts about a minute or until the car warms up and I start driving. Then it disappears. Is this just condensation burning off or, I hope not, a blown head gasket? How can I tell the difference?
View 2 RepliesMy car won't stay running. We've replaced the spark plugs, the air and fuel filter, the idle air control and beat on the catalytic converter (I know it's bad but it did make a difference).
View 4 RepliesI have 93 cutlass Cierra..6 cylinder..3.3.. when it's fully warmed up it stalls out on me as I'm accelerating from a stop. but then if I wait a minute and re start it it most times will run ok.. and is loosing power sometimes, when fully warmed up she gets bogged down in pressing the accelerator....it won't stall when Idling.. only when fully warmed up when Accelerating....the engine raced the other day as if someone was stepping on the gas when I wasn't.. Only did that once..hasn't did that since.. Service engine light is on..I have new Oxygen sensor, cleaned the maf sensor..new fuel pump and new fuel filter..new plugs and wires and air filter this past summer..
View 4 RepliesBack brakes don't bleed. car doesn't stop anymore. The passenger back brake stops even though it doesn't bleed, but the driver side brake doesn't make the tire stop and it doesn't bleed. The e-brake works. I just need to know what could be wrong. 1995 Oldsmobile Cutlass...
View 8 Replies