Oldsmobile :: 1941 - Speedometer Needle Bounce Up And Down And Then Stop
May 23, 2016
I was driving my Oldsmobile the other day and the speedometer needle seemed to "bounce" up and down and then stop. I removed the cable and it is intact I can spin it and the other end spins. I jacked the rear end up (both wheels off the ground and started it up and put it in HI. I did not see the output shaft turning. Which leads me to ask a whole bunch of questions. Can I get a new output shaft (aftermarket) or do I need to find another Hydramatic and cannibalize it. I also wonder if the fact that two years ago my speedometer cable came loose at the transmission and the road wore the end off so I replaced the core with an aftermarket one'
View 9 Replies
Advertisement
I just notice this behavior of my car recently (09 GS350 AWD). It usually happen in the morning when the engine still cold (Ohio winter weather 22-35 degrees in the morning). I noticed that when I let go of the gas paddle, my rpm needle dropped to about 1000 rpm and then immediately bounce back up. Is this normal??? I haven't notice this behavior after the engine get warm up. I was driving in normal mode.
View 8 Replies
A few days ago my 98 Cutlass had to be towed because of a broken brake line. It was towed 35 miles to my mechanic. Two fuel lines needed to be replaces and i guess it was a real problem getting to stuff to fix. When I picked the car up tonight I noticed that the fuel gauge didn't work right. When the key is off the needle points straight down toward the floor. when I turn on the ignition, the needle moves up and pins itself against the little metal pin below the "E" and can't go any higher. The only cause I can think of is that the needle bounced over the pin while it was being towed and when I turn on the ignition it tries to move to where it is supposed to but is stopped by the pin. The only way I can think of to fix this is to turn the car upside down and rotate it counterclockwise until the needle moves back over the pin.
View 3 Replies
My 2007 gs350 is acting up lately, I was on freeway doing around 70mph but speed needle only pointed at 40mph on the gauge. Could it be speed sensor?
View 9 Replies
Noticed this at speeds below 40 MPH. My speedometer needle will wobble a small amount, but over 40 MPH its is dead steady. I have noticed this a few times.
View 6 Replies
Our '91's speedometer needle wobbles +/- 5mph at lower speeds, but evens out and becomes steady at higher speeds.
View 4 Replies
When the weather is rainy or just very humid, the speedometer needle in my 2000 Accent jumps all over the place. According to the service dept. at my local dealership it is most likely the speed sensor causing the problem.
View 1 Replies
My needle is, lets say, vibrating..when I am driving more than 50 kph my speedometer needle is vibrating ,it is dancing up and down.
View 18 Replies
In my current speedometer the speed needle doesn't work i did everything and changed all sensors and checked all related issues and all is fine turned out the issue was with the speed gauge it self. So i bought my self a used speedometer.
Now my question is, how to dismantle the speedometer cause I want to take out the speed gauge from my old one a replace it with the new one i know its much easy to change the whole thing but I don't want to play with the mileage I have on my car.
View 4 Replies
Every now and then, when I start my car, the speedometer needle pegs completely to the right and then settles down and acts normally. Why does this happen and what does it indicate? The car is a 1995 Chrysler Concorde.
View 6 Replies
I have a 98 Civic with 218,000 miles. It's my around town car (the bigger more expensive car sits in the garage most of the time). The speedometer whacked out about a month ago. The needle will sit and quiver on 20 mph when I start it, when I'm going 60, and at stop lights. Suddenly, with no apparent reason the needle will jump to to the correct speed, work correctly and then as suddenly drop back to 20. I replaced the speed sensor (an easy job) and that didn't fix it. What else might be going on? Wiring harness? What would I do with the wiring? I do a lot of low level maintenance myself; oil, plugs, brakes, struts, but I've never done wiring work.
View 5 Replies
So my girlfriend got a 2002 Jetta Wagon 2.0 automatic (PRND321, no tiptronic). She noted when she was driving fast on the driveway highway one day her speedo stopped climbing and would wiggle around 60mph and not go any further even if she was going 80+.
I would have thought first that the speed sensor would be messed up. Went to the junkyard and pulled 2 speed sensors for cheaper then 1/4 of new. Put the newer cleaner part on and the same exact issues. Locks up and wont climb past ~65mph and the needle wiggles. I am guessing its not the sensor. Question is what could cause it? Could it be the actual internal gear in that meshes with the transmission? Ill try replacing, i have extra i think. But could this be a cluster or a computer issue? And the odometer is also off. When it gets stuck at the slow speed, the mileage won't count at the full speed. She drove to a friends at a known 80 miles away and it only said its was low 70-something on the gauge when she got there. So there is a discrepancy of mileage count too.
I am going to head to the junkyard soon and thinking of pulling a cheap cluster to try it out, but I also heard you might need a VCDS for the immobilizer in the cluster. And the mileage is stored on the cluster or not? What should I pursue next?
View 1 Replies
So i noticed recently. The speedometer needle would jitters/shake/doesn't move smoothly when driving around 110km/h to 120 km/h. Approximately 75 mph. I'm in 6th gear when this happens. I haven't tried down shifting to 4th or 5th to see what happens, but maybe i should try that. This happens while trying to accelerate. The car has barely any power at that point. If i stay at a steady speed, the needle doesn't jitter.
View 9 Replies
I have a 95 Honda Accord V6, the D4 light is flashing and the speedometer needle does not work. When in stop and go traffic, the needle bounces around and makes the car stall and downshift and rev up. I replaced the speed sensor with no change.
View 6 Replies
I drive a stick Ford Focus 2002 and when I accelerate, the car hesitates/bogs down. This happens more when it is going up and heavily loaded. It happens more on low RPM but it also happens on high RPM. I can accelerate on idle and it does not have any problem. At the same time, I know when this is happening, or about to happen, because the radio volume rises suddenly together with the speedometer needle that goes crazy (up to 150mph) while the car is going at 30mph. The radio volume and speedometer needle settle down after the spurt.
View 9 Replies
I am having a slight issue with my cluster. When I turn the key on or start the car, the speedo needle goes crazy for about a minute then stops above 0mph (points at 5mph when im not moving). While that's happening, the other needles don't work until the speedo normalizes. It also does this when i turn the car off. What this could be? I heard about the VSS can cause speedo issues but what about the rest? I also heard the mk4's can have cluster failures. it's a 99' mk4 vr6 jetta 5spd.
View 3 Replies
It appears electrical. With it running and this first symptom usually guarantees that it will stall. You go from park to reverse or drive the speedometer needle will begin pulsating. I have notice if this is not happening it won't happen. Next standing still but in drive or reverse if you turn the heater, radio, lights or the AC pump kicks on. Boom the car stall and almost act like the key switch was turned off then back on. It also has happened while moving but it does not stall but all of the dash light pop on as if you just turn the car on.
View 3 Replies
2001 F250 SD, V10, Auto, 155K miles
While driving home from work I noticed the needle jump from around 55 to 70 on the display, then settle back in at 55 ish. First I just caught it out of the corner of my eye, but watched more closely, and it did it again as I drove. The tow/haul override button on the shifter was blinking also, (as if it was "Mad" about something)..
Then I noticed that the jump of the Speedometer needle was linked to when I changed from High to Low on the headlights, and vise-versaI was NOT in cruise mode The voltmeter did not EVER waver. (I thought that the increased current might be causing a temporary problem of sorts). Where to start looking?
View 5 Replies
It stop working for a while but i want it to work now. The needle is frozen in the middle and wont move for shizz. Is it something electrical or should i buy a new gauge? I found some gauges for the 740 so I thought to ask first before buying it.
View 3 Replies
After I turn left from a stop my 2002 Alero pulls hard to the left for a while. Then after a while the car tracks straight. The same happens when I turn right from a stop; the car pulls to the right for a short time - then tracks straight. I checked the tie rods - they are tight.
View 7 Replies
Back brakes don't bleed. car doesn't stop anymore. The passenger back brake stops even though it doesn't bleed, but the driver side brake doesn't make the tire stop and it doesn't bleed. The e-brake works. I just need to know what could be wrong. 1995 Oldsmobile Cutlass...
View 8 Replies