Nissan - Xterra :: 2000 - Front Driver Side Wheel Clicking In 4WD
Mar 24, 2012
I recently replaced my wheel studs on my 2000 nissan xterra (front drives side). In the process I had to take apart my wheel assembly and put it all back together. Now that all the pieces are back together I took the car for a test drive. When I put it into 4 wheel drive 2 to 4 clicks with every rotation of the wheel. I also noticed buzzing noise while driving in 2 wheel drive. while quiet it sounded like the noise you would get as a child putting a baseball card in your bicycle wheel spokes. The noise is coming from the wheel that I just did work on and I cant figure out what is causing it.
View 4 Replies
Advertisement
Truck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 Replies
Lowered my car yesterday. 23" FTG. I'm now hearing a clicking noise from my drivers side front wheel.. I mostly hear it when my foot is off the gas and I'm just coasting (usually at slower speed). Also, it gets louder (worse) and is accompanied by what sounds like a rubbing when I take turns.. Is it axle bind? Or should I be concerned?
View 1 Replies
I have a noise that has developed in the front drivers side(wheel area). When I turn right -- it can only be heard at slow speed, when I start from a stop-- there is a " tapping" type noise that appears to come from the wheel area. Is it possible that I am about to have problems from the CV axle?
View 1 Replies
Noticed a clicking noise when only turning left out of a parking lot today? What this could be? Sounds like it was coming from the driver side front wheel?
View 2 Replies
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
View 7 Replies
I have Nissan Sentra GXE year 2000 model and it has 143K miles on it. I get a hammering noise on the front passenger side wheel when I apply brake. I did replace caliper, brake master cylinder, rotors, brake pads and brake shims but no luck. The noise is like "ta ta ta ta.." and it gets louder based on speed of car. Brake pads and rotors been replaced 3 times in last 2 years to get rid of noise and been seen by 4 mechanics so far no one could find the exact problem. I also took the car to Nissan dealership they also recommend changing brake pad and rotors which I already did thrice.
View 5 Replies
Started hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
View 14 Replies
I just purchased a 2000 Hyundai Accent. I was told it has a bad wheel bearing on the front driver's side. I am assuming that would be the clicking sound that associates with speed. I was told the cv joints or axles were replaced but have a leak. I couldn't see a filler hole or one to check from. I also don't see fluid under the car from parked. Also, there is a humming which sounds like knobby mud tires. The humming disappears during hard right turns.
View 6 Replies
I have a 2000 Nissan Xterra. About a month ago it stalled while I was backing out of a parking spot. When I turned the key, the engine turned over but wouldn't start. A few minutes later it started and I drove it on a long road trip. It was fine until today when it stalled when my husband was going around a corner. He waited a few minutes then it started. Now tonight he started it, drove down the block and it stalled again. This time it won't restart.
View 1 Replies
I have a 2000 Nissan Xterra with about 100,000 miles. When I start out and get between 45 and 55 miles an hour, it sounds like I am going over speed bumps in the rear end. I noticed that it seems to come on more when I let up on the gas and barely gas it again. What the problem could be?
View 2 Replies
I have a 2002 Nissan Xterra SE (Silver). I have just a couple miles over 200K on her too! recently, I have had a chirping noise coming from the front left tire. It chirps upon rotating, as well as when i turn the wheel to the left. I only hear the chirp at slower speeds. Also, the breaks have been starting to screech, not a lot, but occasionally. Do I have bad ball bearings? Need new brakes? Both? Or is there a chance a rock is stuck up in there? The chirp goes away when it's wet outside, like after a rain!
View 3 Replies
Over the last few days I've noticed a clicking noise coming from the front driver wheel. This clicking has been getting louder, everything seems in check, no crazy vibrations, or vering side to side and all lugs are tight. The clicking stops when the break is applied, could this be break pad warning chippers? I have yet had time to take wheel off and look.
View 6 Replies
I've got this 02 Nissan Altima 126,000 miles. I did a front brake job on my self, new rotors and ceramic pads. Immediately after the brake job, I started hearing this horrible grinding noise when weight is shifted to the driver side. It happens when I take apply the brakes or make a right turn. When making a right turn I don't need to apply brakes to hear it. I can sometimes hear it faintly when driving normally.
I took it to my mechanic. He first inspected my brake job, disassembled the rotors and pads, applied brake grease, and reassembled everything. The problem continued. He lifted the car, and had me get in, put it in gear, accelerate, then applied brake, no noise. There is no sign of anything rubbing or grinding in the wheel assembly.
After inspecting the tie rods ends, he replaced the inner and outer on both sides. No Luck. He then replace the ceramic brake pads with regular pads which has reduced the noise but it is still there. I asked around and two other mechanics have suggested the wheel bearings, my mechanic believes this is unlikely.
View 1 Replies
My 2005 Prius has 95k miles on it. I've been hearing a cluck-cluck-cluck noise from near the front driver side wheel. I had an independent mechanic test drive it, who said the wheel bearing needs replacement. Should I have it checked out by a Toyota dealer? They're so much more expensive, but are is it worth taking it to them?
View 15 Replies
I just bought a 2007 LS460 with 90K miles on the clock. It replaces my 2006 LS430, which I loved, but it was getting long in the tooth.
So far, I have fixed the wind noise issue on the pass. side and the only remaining issue is this clicking in the driver rear wheel when the forward or reverse load is first applied.
So, to explain, every time I come to a stop or go from forward to reverse, I hear one or two clicks once I apply the gas. It sounds like some metal part is settling in place. The sound is not there once under way and there is no other noise at all.
The shop I went to spent couple of hours looking for the cause, listening with mechanics stethoscopes, feeling by hand, while the car was in the air with the wheel off and came up with either a rear hub or rear axle on its way out. It is hard to pinpoint the exact source because the click or metal ping is transferred to all the metal components of the assembly and there are plenty of them there.
View 4 Replies
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 Replies
I'm getting this clicking noise in the front drivers side of my car... it sounds like its related to the wheel because it's clicking in a rotation pattern, i.e. it slows down as I slow down, etc. The clicking noise dulls/goes away whenever I brake. Not sure if that means it's related to the brakes...or if it's something else.
View 2 Replies
Loving my Black on black ES350 so far with 4000 miles, bought July!
Having a very annoying rattle/creaking near the seat belt pillar on the driver's side? This occurs continously even on smooth highway roads. I will ask them to check it out at the 5k service.
Also, my steering wheel slightly "clicks" when turning the steering wheel 1 full turn to the right. It doesn't do it on the left side, and doesn't seem right. No turn signals or anything is on. Just seems flimsy with all these noises!
View 14 Replies
My 2002 Ford Taurus has 73,000 miles and was in good shape except for a small leak under driver's side. Has a new rack and pinion replaced one week ago. Have now noticed small leakage again. Also, when the steering wheel is turned it makes a clicking sound...almost like winding a clock. Rack and pinion replaced and alignment done. Why would it begin leaking again. This is a very comfortable car and has been maintained.
View 4 Replies
2002 Mountaineer, suddenly started making a loud clicking noise driver side front. Seldom in reverse. Struts and axle look good, nothing hanging down.
View 3 Replies
