Nissan - Noises - Maxima :: Whining Sound When Cold?
Jan 28, 2011
Ok, so I started the car this morning and there was a whining sound that sounds like winding of gears, It changed in pitch along with RPMs and when the car was in neutral (it's a stick) and the clutch not engaged, it was still there with pitch appropriate for idle RMPs. Later, when the car warmed up, the whine disappeared.
View 13 Replies
Advertisement
Okay so I recently replace the rear shock absorbers and now every time I take a corner or when I'm going on a surface that's not flat or just if I go over a bump too quick. I here squeaking sounds I replace the shock absorber as well as the strut mount to no avail I've found the noise I've located location of the squeak if where coil meets the mount. I don't want to replace the coil it does look like it might need some replacing the protective metal sheet is gone on the top some of the bare metal is exposed but I would hate to replace the spring and have noise again
Car is a 2003 nissan maxima with 144k ....
View 6 Replies
Lately, I've noticed that my car starts fine in cold weather. But, once I put the car into drive or reverse, it stalls. Also, once I start the car let my foot on gas for few min, and then put into drive or reverse, it drives fine.
View 4 Replies
95 nissan maxima decelerated on highway, i heard a clunking sound, and then it shut off, i opened the hood and it smelled like burnt rubber. Checked all of the belts i could see..no problems. Car wouldn't start after this...and all i could hear was a clicking sound. Pulled 6 codes for the car including bad speed sensor and a misfire, as well as bad EGR...i think the timing chain/belt broke..but i can't access it.
View 3 Replies
I recently bought my Nissan Sentra from Carmax, and drove it cross-country from Maryland to New Mexico for a job. I noticed along the way that from a cold engine start, whenever I would reverse, shift to drive, and turn the wheel to straighten, I would hear a noise that sounds like pulling the parking brake coming from the tire area. The engine also makes a knocking noise when the accelerator is pressed, but gets better as the engine warms up (which I'm told is a gasket). Finally, when driving from a cold start and the transmission shifts from 1st to 2nd, I hear a metallic clunk that sounds like someone hitting a metal shaft.
Any thoughts/concerns? I've read something about a premature bearing failure, if that's relevant.
View 2 Replies
I have an 05 maxima which no longer wants to start. I've tried jumping it but that's no dice. When I put the key in the battery and brake light come on and when I try to start it there's a clicking sound from the passenger side and before the lights on the dash would flash but it has just been doing the clicking sound lately. Any guesses on what the problem may be?
View 13 Replies
My awesome 1990 Toyota Pickup (6 cyl., supercab), fondly named Ol' Rusty, has a measly 245,000 miles on it and still running strong. The one problem is that when it is very cold out such as this morning (-10F), I get a terrible noise coming from under the hood just in front of the steering column. It sounds like a belt rubbing, but I can't find it. It happens when I start going faster than 20 mph and goes away once the engine is completely warm. When it's happening, the speedometer jumps a bit. Interestingly, if I warm the truck up for 10 minutes or more so that the engine is completely warm, it still happens when I first drive the truck. Is this something I need to worry about or can I continue to ignore it like I have been for the last 3 years?
View 2 Replies
'91 Blazer, S10, 2wd, 300,000 mi ....when weather cold, and car cold, I hear a loud slapping sound that I thought was a fan belt, but checked and they are ok...when car warms up, or when weather warm, I don't hear the slapping..... sounds like belt against plastic,,,,???
View 7 Replies
This might just be car engine in general regardless of make or model, but upon a cold start, my GTI engine whines or buzzes for approximately 1 second before it stops. I had a 2009 Toyota Corolla that also did this, but I had it fixed with a TSB due to the oil not reaching the VVT-I gears or something in time. It's not the same noise in my GTI, but I was wondering about same sound almost every time upon a cold start?
View 13 Replies
When my truck sits all day and its cold out, my truck in 2WD will make a whining sound going down the road, sometimes its a grinding sound almost. Appears to be coming from the passenger side of the truck towards the front. Engaging 4x4 gets rid of the noise, and the noise will usually disappear after the truck has been running and warmed up. I've changed my ball joints recently and everything looked good and yes it had done it a time or two before hand. What causes this, and how do I fix it?
View 6 Replies
So I noticed that there is a type of whining sound coming from the ICE side whenever the temperature is below ~55F. This only happens from a cold start and only when I'm accelerating (pressing the gas pedal) and always go away after the engine warms up.
View 7 Replies
I own a 2013 ES 350 with 5000 miles.
On cold weather conditions, doing a cold start, I allow the engine to run and warm up for a minimum of 5 minutes before driving. In this time frame the engine goes thru the whining sound and then the engine noise is quiet (normal).
What do other owners allow for engine warm up time before driving.
View 4 Replies
I have a 2011 Nissan Maxima SV that has poor gas mileage. I took it to Nissan to get checked out but they said there's nothing they could do because the car is showing no codes or no check engine light. I got my spark plugs changed, it seemed like it worked but a week or so later, it went back to how it was (the gas mileage). 2 weeks later, my mechanic checked the spark plugs in front of me, no rust or leaks on them. I burn a half tank of gas every 2 days and that's just driving local to work and back.
View 16 Replies
The ac compressor on my 2003 Maxima keeps going out. Mechanic says the replacements are refurbrished, as the new ones are hard to find and expensive. 143,000 on the car.
View 1 Replies
I have a misfire on the number 2 cylinder on my 97 Nissan Maxima 5spd. The computer has been changed 3 times, and it'll work for a short time after the new computer is installed, but then the problem resumes. What would cause this to happen? The coil has also been changed.
View 7 Replies
my car won't start. It would try to turn over occasionally, The battery checks out. i tried to jump start it bypassing the battery with no results. multimeter reads current though cable going from battery to alternator. what is wrong with my car??
View 2 Replies
I have a 1998 Nissan Maxima, and when I brake or am moving very slowly in stop and go traffic, my car sounds like a foghorn. I am thinking maybe I need new brake pads, but I thought brakes were supposed to squeal when they are bad. I remember them squeaking a little bit, but nothing major. Then all of a sudden I'm starting to get this foghorn sound.
View 2 Replies
Keep getting the P0420 code on this vehicle. Have changed air filter, spark plugs, run fuel injector cleaner through the tank on Shell 93 octane fuel. Drove 430 highway miles to clean out the carbon and the SES light is still on and when we check the code it says Catalyst system effiency below threshold bank 1. How do i get this fixed?
View 1 Replies
2002 Nissan Maxima with 118K miles. Heating and A/C buttons that turn the fan on different levels doesn't work. It will cut on/off but the setting can be on low and it always blows on high. The temp. is correct(heat or cold) on what we set...it just always blows on high no matter what we set. It is a bush button kind of setting not a dial that you turn.
View 1 Replies
I have a 2007 Nissan Maxima and after changing the oil added Lucas Oil Stabilizer and when I went to start the car the engine shook for about 3 seconds and I was unable to start it again. Towed it to Nissan service and they said codes came up as the camshaft sensors were bad and engine was flooded and need to dry them out before testing it out. So on Monday I received a call from the service manager and he told me that they tried replacing the camshaft sensors but it would not start. He then said that his technions working on the car believe the timing chain jump causing vavles to get bent. Cause the engine has 107k the will not repair my car and recommend a new engine. I informed the service manager I find it hard to believe that any vavles could have gotten bent with the engine running only 3 seconds and had my car towed back to my house. I tried replacing the crankshaft shaft sensor and it still will not start. So before I attempt to open the timing chain cover wanted to see if the timing chain could have jumped only running for 3 seconds and to see if it might be something else? Still don't understand why after adding the oil stabilizer to the oil it would had stalled out like that when it was running so good and starting up with no problems. I read on line that Nissan has had many issues with their timing chain guides wearing out but can't see how the oil stabilizer would effect the guide.
View 4 Replies
My 1993 Maxima at times will not start. There is no rhyme or reason for it not starting. Either that or I have not found a particular reason or reasons for why it will not start. Sometime it is over night and at times it may happen when it sat for a couple of hours. Took it to a garage which they check the battery, starter, ignition switch, starter relay and all was okay.
View 3 Replies