Nissan - Maxima :: Low Pitched Brake Noise At Start Up
Mar 3, 2011
A 2003 Nissan Maxima. The brakes were rebuilt about a year ago, and were fine for 6 months. Maybe 3000 miles. Then they developed the following behavior. In the morning or after being parked for a while (parking brake off) when backing out of the garage they'd make a low pitched but quite audible rubbing noise, and then also going forward, the same noise. Whumpa space Whumpa space Whumpa. There is no braking effect, and the behavior does not happen every day -- maybe once every three days. While driving forward at low speed, gently pressing the brake pedal or gently pulling up on the parking brake lever quiets the noise, and it does not recur that session. The noise seems to originate in the rear of the car, consistent with it's being affected by the parking brake. The brakes function perfectly otherwise.
View 2 Replies
Advertisement
We have a 2002 Maxima SE, 6 speed manual with 127,000 + miles. The noise is similar to what we used to hear from the spokes, when we attached a playing card or piece of cardboard to the wheels of our bikes. The noise only presents itself when the clutch is engaged and the wheels start rolling. It happens in forward and reverse.
The dealer replaced the right wheel bearing assembly and both outer tie rods. But that did not eliminate the noise. They then fingered the transmission. The transmission folks said it was not the transmission or the clutch release bearing.
Confused, we just keep driving the car. Whatever it is doesn't appear to affect the driveability - yet. The clutch engages smoothly, the shifing is smooth and it does not pop out of gear. We've been thinking of selling the car, but this noise has to be resolved first.
View 4 Replies
OK so when I'm driving on freeways or highways and I have to break hard for some reason my steering wheel always pulls in some direction I don't want it to go. forcing me to hold it straight I've lived with this problem for a while but I'm doing 500 miles trips this weekend in the car and am concerned about if I had to brake at higher speeds etc., what might cause my steering wheel to pull left and right... 2003 nissan maxima ...
View 7 Replies
My 8-year-old (2003), 134k mile Nissan Maxima has a new quirk. When the car is started from completely cold (as in over night), there is a distinctive intermittent squeaking noise (think water being rubbed against glass) coming from the left front somewhere near the tire. The car only does this for about 5 minutes or so until it's warmed up and it has to be going 20 miles an hour before it starts. Once the car is up and running you can turn it on and off all day, let it sit for a few hours even, and it's fine. What's going on?
View 4 Replies
my car won't start. It would try to turn over occasionally, The battery checks out. i tried to jump start it bypassing the battery with no results. multimeter reads current though cable going from battery to alternator. what is wrong with my car??
View 2 Replies
I have a 2007 Nissan Maxima and after changing the oil added Lucas Oil Stabilizer and when I went to start the car the engine shook for about 3 seconds and I was unable to start it again. Towed it to Nissan service and they said codes came up as the camshaft sensors were bad and engine was flooded and need to dry them out before testing it out. So on Monday I received a call from the service manager and he told me that they tried replacing the camshaft sensors but it would not start. He then said that his technions working on the car believe the timing chain jump causing vavles to get bent. Cause the engine has 107k the will not repair my car and recommend a new engine. I informed the service manager I find it hard to believe that any vavles could have gotten bent with the engine running only 3 seconds and had my car towed back to my house. I tried replacing the crankshaft shaft sensor and it still will not start. So before I attempt to open the timing chain cover wanted to see if the timing chain could have jumped only running for 3 seconds and to see if it might be something else? Still don't understand why after adding the oil stabilizer to the oil it would had stalled out like that when it was running so good and starting up with no problems. I read on line that Nissan has had many issues with their timing chain guides wearing out but can't see how the oil stabilizer would effect the guide.
View 4 Replies
My 1993 Maxima at times will not start. There is no rhyme or reason for it not starting. Either that or I have not found a particular reason or reasons for why it will not start. Sometime it is over night and at times it may happen when it sat for a couple of hours. Took it to a garage which they check the battery, starter, ignition switch, starter relay and all was okay.
View 3 Replies
I have a 1997 Nissan Maxima. The past few weeks, it sounds like it's getting harder and harder to start. Last week, it wouldn't turn over, and had somebody jump me. I took it to Pep Boys and they tested the battery and alt and said both were fine. Tonight, it wouldn't start again, I had somebody try to jump me and no sounds/no activity. About an hour later, I went back to get my car and it was able to start..
View 6 Replies
I bought a 1997Nissan Maxima from my cousin and as he tried teaching me how to drive stick I stalled and the car did not want to start back up we were able to pop start it it to get back to my house. I am unsure whether it is the ignition switch or the relay because the car will start sometimes after I keep trying to start the engine for a while...
View 18 Replies
The car is a 1998 Nissan Maxima. As you well know a car's interior in the summer is about 10 to 15 degrees more than the outside. When the outside temperature is 80 degrees or more I can't readily start the car. I turn the key and nothing happens. Sometimes I put the switch into the "on" position wait about 20 to 30 seconds, turn the key again and the engine starts. I think I need an ignition switch. My question is why does this happen? What does the temperature of the car's interior have to do with the poor operation of the switch? The interior of the car must be about 75 degrees or less for the car to start.
View 4 Replies
I have a 2007 Nissan Maxima and never had a problem with it until recently. My husband and I took a long drive to NJ from NH and went we stopped for gas and turned off the car, we could not start the car back up. We naturally called AAA, but once they came, about a hour later, the car started right up. Since that time, the car has repeated this several times. I take a trip to the grocery store, get back to the car, no problem, then make another short stop and then try to start the car and it does not start. I have no problem starting the car going to work every day and when I come home from work. It only happens when I make short intermittent trips, sometimes 2-3 stops. It always starts when there has been at least 1/2 hour between starts. I have taken it to 2 mechanics and they can never reproduce the problem I now have a car I have no confidence in. I am afraid even to get gas for this car.
View 8 Replies
1990 Nissan Maxima, i noticed that after changing the struts/springs on my car that when i make a hard right turn while accelerating the car makes a terrible grinding noise. I know this is a classic sign for a CV joint, but could it be anything else? It is definitely not tire rubbing, definitely metal sound. It doesnt seem to be getting worse.
View 1 Replies
My 2000 Maxima manual, only in hot wether after driving for 30-40 min. revolutions start rising by itself and can go very high, becomes impossible to drive,have to shot off the car. I have this problem for 10 years and dealer is saying that they never heard anything like that.
View 5 Replies
1990 Maxima. The car hesitates/surges occassionally after warm start, but only surges for about first 1/4 mile, then its OK. Sometimes it idles low, especially when I come to a stop and apply brakes hard. I believe the two issues are related. This has been getting progressively worse over past few years.
View 3 Replies
I have a 1998 Nissan Maxima. I just had both top and bottom valve gaskets replaced due to oil seepage. About a week prior to this repair, I noticed the car would have trouble starting, but it was very intermittent.Now I am experiencing the starting issue 50% or more of the time when trying to start.I'm horrible at describing the actual issue, but I am going to try. I turn the key and it has trouble turning over quickly. No tinking or clicking or anything like that. I have had the battery and alternator checked and both are fine. When i had the valve gaskets replaced, the shop i used checked the starter and told me it was o.k. I'm really having a tough time figuring this out and don't want to get "taken for a ride" money wise.
View 4 Replies
Have a 2001 Maxima GLE with 220,000 plus miles. Lately, at times I turn the key and hear nothing but a humming sound. If I keep trying to start it, eventually it will start. Battery was tested by AAA and is OK.
Sometimes, even on the chillier mornings lately, it starts right up the first time. Sometimes it takes two or three tries, at times seven or eight tries. On those occasions, like I noticed tonight at the grocery store, the lights on the clock (and maybe the dash, but I wasn't looking at that) are slow to come on as I keep trying to start it.
Took it to my mechanic a couple of weeks ago, and of course it started just fine for him. He thought it might be the fuel filter, but that's not an easy fix if we aren't sure. He thought that once it won't start at all, it will be easy to figure out.
View 1 Replies
I own a 2002 Maxima with 102,000 miles. For a while, the car has been making a rattling noise while I am driving and pressing on the gas pedal. The noise occurs frequently whether starting from stopped position or accelerating while driving. The engine has checked out fine and a suggestion was made that I use better gas. I filled up at Chevron with '89, which is the grade I have always used but at discount gas stations. The noise however continues. What may be causing the rattling, clicking, tinny noise?
View 3 Replies
I just recently replaced all 4 struts on a 2003 Nissan maxima with 144k and the front are fine its just the back drivers side it makes a clunk every time I hit a big pot hole or a medium sized bump the shocks are doing there job the car feels great its just I have excessive noise the top strut mount nuts were torqued in place and so was the bottom. When I put my hands on the rear driver side quarter panel and start bouncing the car it makes no sounds its only when I start driving. The strut came with the bump stop the only thing I reused was the spring and mount and bushings in between but I took pics of the strut before I compressed it and took it a apart everything is where it supposed to be I'm puzzled...
View 1 Replies
I recently had issues with P1320 code, and after replacing a bad ignition coil by a local auto mechanic, the CEL went away. While changing the one bad ignition coil, he also changed all the spark plugs.
However, after driving for about 1000 miles, I started hearing this noise which is persistent, and I'm hesitant to drive it further without knowing if driving in this condition would cause any further damage.
What could be going wrong here for this noise. I tried to attach the video I captured, but couldn't.
View 3 Replies
2000 Maxima - I just changed the head gaskets, got it back together and no start, no spark, solid security light and linking error to ecu. 50 miles to a nissan dealer. I have 12v to the injectors but no ground, I just checked spark last night and have none. I tried all three keys, will no battery for a month or two cause key security issues? I hate to drag it to Nissan and have them tell me I need a new ecu for a few thousand dollars. Does a security issue cause a linking issue?
View 13 Replies
I have an 05 maxima which no longer wants to start. I've tried jumping it but that's no dice. When I put the key in the battery and brake light come on and when I try to start it there's a clicking sound from the passenger side and before the lights on the dash would flash but it has just been doing the clicking sound lately. Any guesses on what the problem may be?
View 13 Replies