Nissan - Maxima :: Clunking Sound - Broken Timing Chain / Belt?
Aug 28, 2012
95 nissan maxima decelerated on highway, i heard a clunking sound, and then it shut off, i opened the hood and it smelled like burnt rubber. Checked all of the belts i could see..no problems. Car wouldn't start after this...and all i could hear was a clicking sound. Pulled 6 codes for the car including bad speed sensor and a misfire, as well as bad EGR...i think the timing chain/belt broke..but i can't access it.
View 3 Replies
Advertisement
My 2003 Sante Fe has developed a rattling sound in the engine. The oil level has been good. I took it to a dealer for diagnoses and they told me that the engine was gunked up and the timing "chain" tensioner couldn't move to keep it tight and it was rattling. They put some engine cleaner in and changed the oil and wanted me back in 500 to clean it again. I did that again, but the rattle is still there. It gets a little quieter after I have driven it for a while.
My question is doesn't the Sante Fe have a timing belt? If that is the case what do you think the rattle is?
View 6 Replies
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies
Looking for info if the R32 has a timing belt or is it a chain and at how many kilometers shows it be changed.
View 5 Replies
Today I either broke timing chain or it fell off on the passenger side bank of my 08 F250 V10. Put a hole in valve cover. What to expect for repairs. Is this engine Zero tolerance.. unsure if I should expect bent valves or not and just how far I may have to go with this.. best way to test. I have a bore scope camera and mechanical abilities.
View 14 Replies
'90 Maxima...A couple of my exhaust studs broke (it was a problem for this model) and now I have an annoying exhaust leak. I tried to put a new gasket, but it started to leak again. I am thinking of using permatex copper sealant....drilling out the broken bolts and replacing them would be very expensive I think.
View 4 Replies
I have a 2009 Tiguan 2.0t 4 motion and recently has started having a very high pitched squealing noise coming from either the accessory belt area or the timing chain. The noise is constant until you are under acceleration and then it goes away. The CEL came on but when scanned it said no codes. and now sometimes the CEL will flash and the car has been idling rough. What it may be?
View 3 Replies
I recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 Replies
1999 Honda Accord EX, 224K miles, 4 cylinder. Timing belt broke yesterday and ruined some exhaust valves. Also needs new radiator. Should I spend quoted approx $3500 for fixed cylinder head and valves, 30K mile check (plugs, valve adj etc), new radiator, might also include piston rings, not sure? Completely trust the mechanic. Other recent work already done is one new front wheel bearing and axle, new bearing boots on both sides, oxygen sensor, new clutch a year ago. Interior/exterior are in good shape. How many more miles am I likely to get on this engine if I have the work done? Will I likely need ball joints replaced soon? Anything else I should be considering?
View 8 Replies
I have an 01 subaru impreza with 185000 miles. The timing belt broke while I was driving. I gave the mechanic five-hundred for parts and labor but then he told me the engine would need to be pulled to fixed damaged head and valves.
View 6 Replies
I recently broke a timing belt on my 1999 AEB 1.8t Passat. I'm in the process of doing all of the repairs myself while working around my college and work schedule. I have yet to pull the head off, and I'm scared of what I'll find when I do. Should I expect any piston damage? I have one completely broken valve and a bunch of bent valves.
View 12 Replies
I think the timing belt broke on my 2007 4.0 6cyl that has 99k on it. Is this an interference or noninterference motor?
View 5 Replies
2002 Toyota Solara SLE v6 w/ 209k miles
Drove the car home from church yesterday, this morning went to start and wouldn't start..
Tested the Fuel Pump and that looks good.. Pulled a spark plug and did a spark test and I get no spark.
After reading up I get the sense it is either the Crank Angle Sensor or the Timing Belt snapped .. I don't know the last time the timing belt was changed, we got the vehicle @ 190k miles..
Does a no spark symptom sound like a timing belt that could have snapped? I believe these are non-interference engines so it should be ok..
When turning the car over the RPM gauges doesn't look like it is moving but wanted to see for a complete spark failure.
View 2 Replies
The timing belt on my 2004 Chevy Aveo broke last week. I have it at a mechanic who got a new timing belt on to check the compression of the engine. Bad news: no compression. So far they haven't taken the head off to inspect the inside. This includes timing belt/water pump, cylinder head gasket removal and replacement, cylinder head check, some misc labor, lube, oil, and filter...
However, another mechanic is suggesting that I replace the engine instead with a used or refurbished engine with less miles. He says that it doesn't make much sense to put new parts on the top end of the engine. The engine itself has about 153k miles on it.
View 14 Replies
I recently bought a 97 960. i have had a s90 before in totaled it i loved the car so much i found another. i was driving and broke the timing belt tensioner which in turn lead to the breaking of 5 exhaust valves that i know of. I've taken off the head and noticed that one of the bottom of the valves had melted onto the number 5 piston head.
I called around and search but every motor is at least 1000 and i have been told anywhere from 3500-4500 to rebuild. My question would b is there an easy way to fix or should i junk it. i bought it for a 1000 it has only 140000 on it an its in almost great condition. I attached some pictures of the head and piston so u can see the damage.
Attached File(s)
2012_04_07_19.02.39.jpg ( 1.45MB )
2012_04_10_16.45.26__1_.jpg ( 1.43MB )
View 1 Replies
2.5 Litre ... Okay, I've done this on other cars, both Fords without a problem but now I'm stuck on the no start situation. I have spark and my fuel pressure is 60 psi. About to do a compression test. Only issue with replacing the belt is that no matter how many times I try removing and installing it I'm always 1/2 tooth off after rotating the engine a couple of times but that shouldn't be enough for a complete no start. Tried starting fluid. Replaced cam sensor. new plugs. checked firing order. I have spark at #1 according to my test lamp which plugs inline.
View 6 Replies
I recently bought a 98 CE with about 80k miles for my commuter car. Overall I am very please with it but today I started hearing a metallic type chattering sound from the left side of the engine (looking from the front). Sounds to me like the timing chain is slightly loose and maybe the cause of the sound but when I search all the auto pats websites it doesn't show a timing chain tensioner. So do I have a belt or a chain? What the sound is? it doesn't do it continuously but it does seem to only start when the engine is warmed up and at idle. I did a compression test and all the cylinders are in the ballpark so Im hoping that's means my valves aren't taping.I cant imagine it would have lasted this long if the valves were taping (driven it about 500 miles so far).
View 14 Replies
The car has a rattling sound on start up and I read here that is the timing chain tensioner. The quotes for fixing it has been huge(from 900-2000 just for labor).
And I changed front struts and had Monroe put on the car, the ride is very soft and a bit bouncy. I had a 2004 Altima and the ride was very stiff and I loved it. By the way, the car is a 2006 V6 with 111000miles.
View 9 Replies
I recently purchased a 2006 Hyundai Azera which has developed a rattling sound upon cold start up. Based on service bulletin 06-20-002 I believe the issue is with the timing chain tensioners. I am looking at getting a DNJ TK147 timing set kit to replace them with. Do this kit contains the updated tensioners? It is located on rockauto.
View 4 Replies
Ok, so I started the car this morning and there was a whining sound that sounds like winding of gears, It changed in pitch along with RPMs and when the car was in neutral (it's a stick) and the clutch not engaged, it was still there with pitch appropriate for idle RMPs. Later, when the car warmed up, the whine disappeared.
View 13 Replies
I have an 05 maxima which no longer wants to start. I've tried jumping it but that's no dice. When I put the key in the battery and brake light come on and when I try to start it there's a clicking sound from the passenger side and before the lights on the dash would flash but it has just been doing the clicking sound lately. Any guesses on what the problem may be?
View 13 Replies
