I have checked all fuses, relays, etc that I know about. In fact, I pulled all of the fuses out and checked. The switches test good for connectivity.
The sunroof is closed, but needs to tilt up (if that makes sense) to fully close it and seat the weather strip. I have tried everything and it was working fine last week with no issue. There is no sound from the motor when the switches are pressed.
The switch for CC works fine and will turn green and say 'on' when switched on, but it will not actually work (will decrease speed as soon as you let off gas, just as if it were not on). We replaced the whole gauge panel with one that had CC in working condition (exact same model) and this did not solve the problem.
View 3 RepliesI have a 2000 Nissan Maxima GXE four-door sedan, which I purchased new. In May 2008, at 39,556 miles I had to replace the alternator. In January 2011, at 45,201 miles (+5,645 miles) I had to replace the alternator again. Now, in December 2013 at 49,630 miles (+4,429 miles) I have to replace the alternator for the third time. It just doesn’t make since that the less I drive, the more often I have to replace the alternator. The replacement alternators were remanufactured and not purchased from a Nissan dealer. Do you know what would be causing the alternators to fail? Do you think purchasing a new alternator from Nissan dealer would solve the problem?
View 11 RepliesWhen I tried to start my car it wouldn't turnover, clicked and hummed. I took the starter out and had it tested and it was no good. I bought a new starter, put it in and same click and hum. Battery is OK, connection from battery to starter OK and the fuse is good.
View 2 RepliesI have a 2000 Nissan Maxima with 177K. I'm planning on getting a new car in a few months. The radiator has a small leak at the top. Is a product such as Barr's stop leak a viable solution to get me through a few months or will it cause problems?
View 1 RepliesI just purchased a 2000 Nissan Maxima GXE with 219,000 miles. I've had it less than two weeks, and the Service Engine Soon light just came on. I live somewhere that requires emissions testing in order to register the vehicle. My temporary plate will expire soon, so I need to get the car to pass emissions.
This is my first Japanese car and first non-American vehicle. I didn't know until after I had given the check to the guy selling the car that he used premium gas. He said that Nissan recommends it. I've never driven a car that required premium gas before and wasn't keen on the idea since here, it is 40¢ a gallon more expensive than regular unleaded.
I spoke with my landlord about it, as he is a certified Honda mechanic. He told me to first try getting half a tank of regular unleaded and putting it in with some fuel injector cleaner. He said if I didn't notice any decrease in performance or knocks, to then just add a bottle of of fuel injector cleaner to every other tank of gas.
I got a half tank of regular unleaded with a bottle of fuel injector cleaner and didn't have any issues. I then filled the tank with regular without any fuel injector cleaner. I used about ¾ of that tank when the service engine soon light came on. I took the car to Valvoline to get the codes read, and while they couldn't give me any code numbers, they said it was something to do with emissions.
Here are my questions:
Is it possible the light came on because I switched from premium to regular unleaded or perhaps because I would need to add fuel injector cleaner to every tank of gas I get and not every other tank as my landlord said he does with his car?
Should I try either adding fuel injector cleaner to every tank of gas or just switch back to premium? If I try either of those, and one of those was the problem, how long would it take for the Service Engine Soon light to turn off?
My car recently started showing an issue where the car shifter is stuck in parking. Temporarily, I used the shift lock release and was able to unlock it. Also, I think the switch lock control switch seems to be OK, as I hear the click noise when I press the brake with key in ACC position.
View 3 RepliesSoon after I bought this car, the water pump began giving out. It made grinding noises and leaked coolant. I replaced it with a new Bosch water pump. This water pump is driven off of the timing chain.
A week after replacing the pump, the NEW pump started going out.
What would cause the pump to go keep going bad, so quickly after replacement? Could it be a timing chain issue? Should I have bought a more expensive pump? Would replacing the timing chain tensioner make a difference too?
I have a nissan maxima 2000 that sputters and the problem is getting progressively worse. If I am at a stoplight or just stopped with the drive gear on the car sputters. It skips almost every second, but if i put in in park the it runs smoothly. Now I notice that it is sputtering even when I am driving( it was not doing it before). I have already changed the sparkplugs and cleaned the injectors. Now I am debating whether i should change coils and boots. The repair is quite expensive so i want to make sure I am doing the right thing.
View 5 RepliesMy 2000 Maxima manual, only in hot wether after driving for 30-40 min. revolutions start rising by itself and can go very high, becomes impossible to drive,have to shot off the car. I have this problem for 10 years and dealer is saying that they never heard anything like that.
View 5 RepliesI recently had issues with P1320 code, and after replacing a bad ignition coil by a local auto mechanic, the CEL went away. While changing the one bad ignition coil, he also changed all the spark plugs.
However, after driving for about 1000 miles, I started hearing this noise which is persistent, and I'm hesitant to drive it further without knowing if driving in this condition would cause any further damage.
What could be going wrong here for this noise. I tried to attach the video I captured, but couldn't.
My Nissan Maxima GLE 2000 is showing CEL with code of P1320 ONLY, and the car is running rough/or loss of power. The shop that checked for the code advised that it could be something related to Ignition, and also provided me with the system generated list of reasons for the code. Before I decide to do anything, I wanted to check what option I have to address this in a most cost effective manner:
1) Is there a quick way to check which coil would have gone bad ?
2) Is it advisable to change 1 LH and 1RH at a time, and see if it fixes the problem ?
3) Could it be cam shaft sensor that could have gone bad ? Are there any symptoms of cam shaft sensor failure to isolate it to one way or the other ?
I have a 2011 Nissan Maxima SV that has poor gas mileage. I took it to Nissan to get checked out but they said there's nothing they could do because the car is showing no codes or no check engine light. I got my spark plugs changed, it seemed like it worked but a week or so later, it went back to how it was (the gas mileage). 2 weeks later, my mechanic checked the spark plugs in front of me, no rust or leaks on them. I burn a half tank of gas every 2 days and that's just driving local to work and back.
View 16 RepliesThe ac compressor on my 2003 Maxima keeps going out. Mechanic says the replacements are refurbrished, as the new ones are hard to find and expensive. 143,000 on the car.
View 1 RepliesI have a misfire on the number 2 cylinder on my 97 Nissan Maxima 5spd. The computer has been changed 3 times, and it'll work for a short time after the new computer is installed, but then the problem resumes. What would cause this to happen? The coil has also been changed.
View 7 Repliesmy car won't start. It would try to turn over occasionally, The battery checks out. i tried to jump start it bypassing the battery with no results. multimeter reads current though cable going from battery to alternator. what is wrong with my car??
View 2 RepliesI have a 1998 Nissan Maxima, and when I brake or am moving very slowly in stop and go traffic, my car sounds like a foghorn. I am thinking maybe I need new brake pads, but I thought brakes were supposed to squeal when they are bad. I remember them squeaking a little bit, but nothing major. Then all of a sudden I'm starting to get this foghorn sound.
View 2 RepliesKeep getting the P0420 code on this vehicle. Have changed air filter, spark plugs, run fuel injector cleaner through the tank on Shell 93 octane fuel. Drove 430 highway miles to clean out the carbon and the SES light is still on and when we check the code it says Catalyst system effiency below threshold bank 1. How do i get this fixed?
View 1 Replies2002 Nissan Maxima with 118K miles. Heating and A/C buttons that turn the fan on different levels doesn't work. It will cut on/off but the setting can be on low and it always blows on high. The temp. is correct(heat or cold) on what we set...it just always blows on high no matter what we set. It is a bush button kind of setting not a dial that you turn.
View 1 RepliesI have a 2007 Nissan Maxima and after changing the oil added Lucas Oil Stabilizer and when I went to start the car the engine shook for about 3 seconds and I was unable to start it again. Towed it to Nissan service and they said codes came up as the camshaft sensors were bad and engine was flooded and need to dry them out before testing it out. So on Monday I received a call from the service manager and he told me that they tried replacing the camshaft sensors but it would not start. He then said that his technions working on the car believe the timing chain jump causing vavles to get bent. Cause the engine has 107k the will not repair my car and recommend a new engine. I informed the service manager I find it hard to believe that any vavles could have gotten bent with the engine running only 3 seconds and had my car towed back to my house. I tried replacing the crankshaft shaft sensor and it still will not start. So before I attempt to open the timing chain cover wanted to see if the timing chain could have jumped only running for 3 seconds and to see if it might be something else? Still don't understand why after adding the oil stabilizer to the oil it would had stalled out like that when it was running so good and starting up with no problems. I read on line that Nissan has had many issues with their timing chain guides wearing out but can't see how the oil stabilizer would effect the guide.
View 4 RepliesMy 1993 Maxima at times will not start. There is no rhyme or reason for it not starting. Either that or I have not found a particular reason or reasons for why it will not start. Sometime it is over night and at times it may happen when it sat for a couple of hours. Took it to a garage which they check the battery, starter, ignition switch, starter relay and all was okay.
View 3 Replies